Ford Super Duty (1999-2016) :: 2004 F250 - Motor Turns Over But Very Slow And Will Not Start
Mar 31, 2016
My dad has a 04 f250 5.4 auto. The motor turns over but very slow and will not start. He's put two new starters on. I went and looked at it and figured it was loose cables or corrosion, but it was fairly clean, and tight. We decided to pull the battery out of his van that he drives everyday, and I cleaned everything very good. Same thing. Pulled the belt to make sure nothing was lockup, same thing. Truck was running and starting great, then just did this one morning on him.
View 9 Replies
Advertisement
I have a 96 f350 that I just replaced the batteries on and now when I go to start it does not hardly turn over. Starter just barely turns motor over and definitely not fast enough to start truck. Battery connections are tight and starter was replaced about 4 months ago.
View 4 Replies
I have a '99 F-250 super duty with a 5.4 L engine and I am having trouble starting it. Initially it wouldn't turn over at all, so I had the battery checked, it was fine, and after charging it the engine would turn over very, very slowly once or twice then stop. I then replaced the starter and now it turns over very erratically but wont start.
View 4 Replies
My battery light on the dash came on so I tested the battery and it's OK. The last time the truck was started it was 10 degrees and ran for about 3 minutes and shut off because I knew the alternator had to come out. Next I pulled the alternator and had it tested and found to be bad. It was rebuilt and put back in along with a new belt. The motor cranks over well but will not fire. I checked the fuel pump shut off switch and it had not popped up so it seemed fine. The fuses look ok. I ran the battery down a bit so I put the charger on it to bring it up to full charge. When I pulled the alternator I touched it's battery wire to metal for a split second. Sounds like I need to do a pressure test on the fuel system or listen to see if the pump is starting. The truck has 130,000 miles on it.
View 14 Replies
I recently caught up on some maintenance with my truck, changed the turbo pedestal seals, replaced both batteries, brakes, e-brake cable etc and installed new 10k hid headlights. its a single cab 250 with a 7.3 and zf6 4x4 with 133k. a couple days ago I turned on the headlights and the truck died, restarted no problem and would die the next 5 times I tried to turn them on, then it worked fine. yesterday I got in my truck to leave for work and got no wait to start light, no glow plug chatter, no fuel pump running. turns over just fine but no fire.
I got a ride to work and tried it when I got home, fired right up. I pulled the pCM, checked it out, no weird smells and my TS chip wasn't corroded or anything like that, worked fine. drove to 711 to get a 6 pack and it did the headlight thing again. I removed the HIDs because this all started after I installed them and reinstalled my silvanias and it didn't die when I turned them on. this morning went to leave for work, same no start condition. I disconnected both batteries for 30 seconds to reset anything and same problem. I was about ready to light it on fire this morning.
View 1 Replies
So a truck that was running fine Sat for 2 weeks. Battery died so i sent some coworkers to jump it. They tried using a welder which they didn't get turned down enough. Now the wiper motor stays on even without the key. Radio doesn't work but the dash light still comes on. With a new battery installed it turns over but doesn't start. I know something had to get fried but where to start. Thinking about replacing all fuses and relays...
View 7 Replies
This is the first winter I'm driving my truck. I put it in in 4x4 HIGH the other night due to the snow (and I wanted to check out everything).
Seemed to work fine until I was backing into a parking spot doing a full lock turn. It didn't seem to move. I gave it a little more throttle and it "released" like it was stuck or going over an obstacle. Happened again when I did a full turn backing into my driveway (this time turning the opposite way).
It seems to work fine going forward with tight turns. Also and it doesn't "bind" in 4x2 mode. I haven't tried 4x4 LOW yet ... I guess I don't want to wreck anything if it's not operating properly. Is this normal?
View 10 Replies
Last few months my 08 F250 has been slow going up hills. The fluid checks out ok and it shifts fine.
It just seems to take forever to get up hills. Has 124K....
Also has a huge hissing noise thats RPM dependent on the passenger side. Will make the sound in neutral just revving.
View 10 Replies
I have a 1997 ford f250 HD with the 460 and auto trans lifted on 38s the motor keeps over heating Im not shear what the problem is I checked the water and thermostat water pump is good when I bout it there is a trace of stop leak in the radiator not shear if that can do any thing.
View 1 Replies
Ok, I have a 2004 F250 FX4 4wd 5.4L with almost 160K miles.
Sometimes, mostly when it's hot, and I go to restart it, it will crank and crank and crank, so I let off and then try again and it will start. Then other times I will have to do it 3-5 times before it starts, or it will start with real low RPM's for a second then cut out. I have been told this truck does NOT have a Fuel Pump Driver Module (My previous F-150 did). So I'm thinking the fuel pump is just temperamental. Having this issue or replaced a fuel pump before? What brands, places, etc. are good to buy at a decent price?
I tried to look online and was confused about a "midship, rear, and center tank". All I know is my truck is an extended cab and has about a 29 gallon tank.
View 6 Replies
I have a 2004 F250 5.4 gasser, 214K on it. It is my daily driver, and it gets around 6mpg. I feel like this is a lot less then it should get. However that's not the only problem. it wasn't always this bad, but now almost every time I start it, it cranks and cranks and cranks but wont start. I turn the key back, forward again, it turns over 2 or 3 times, and starts, but kind of spits and sputters at a low rpm before speeding up the rpms. I feel like these issues are linked, but its pretty annoying that the starting issue happens everyday. Its been doing this for about 3 years now and I feel like one day it will let me down. People start looking at me if I have to try to start it 2 or 3 times.
View 1 Replies
I have a 2004 Ford F-250 with the 6.0 egr has been deleted and so on. Truck has been very trustworthy until now... It all started last week. I would get in and it would fire right up, drive 15 miles to work all is still good. Time to go home try to start and it would act like the batteries were weak with a weak crank until it finally takes off and starts. This intermittent situation has been happening but I just assumed that the batteries were going bad. I drove to work this morning truck fired right up and now that it is time to go home the truck only has a weak crank and wont fire up. I tested the batteries and they were low on cranking amps.
Replaced them with two new batteries. The issue still exists and didn't change. After reading through threads I found that it could be the FICM I checked it out as was shown through the other threads. With the key on only it was reading 51 vdc with someone trying to start the truck it was reading 48-50 vdc... Yes the truck does have fuel in it and yes the oil is good to. It seems that there is something electrical going on for sure due to the way it has been an intermittent problem for a week or so. I am an aircraft mechanic by trade but can fix anything if I know where to start.
View 5 Replies
I just bought a 95 f250 4x4 with the 460. The guy i bought it from had a trans slipping towed it to the shop when the shop went to pull it in they started it put in gear and engine died. The motor is now tight w no movement either direction with a bar obo it. Is it possible the trans is holding the motor tight? What can I do?
View 10 Replies
My Blower motor is intermittently going on and off. After messing with it for a while it seems to stay on. Motor may be going out. Not real easy to change the blower motor on this 2008. Haynes manual says to take the 2008 and up trucks to the dealer.
2008 F250 4DR 5.4L
View 8 Replies
I have and 07 F250 and the #2 speed for the blower motor don't work (hasn't since I bought it) I read that the most common cause of this is the resistor under the hood on the firewall so I replaced that and still no 2nd speed??? Where I look next? Motor itself maybe?
View 11 Replies
A buddy of mine has a 99 F250, and the 4WD stopped working. The 4wd light in the dash does not turn on with the key with the rest of the lights. There is a Low Range light that does turn on. He took it to a shop/dealership and they said the vacuum was good. They also swapped in a different GEM module, which didn't change anything.
I swapped the relays under the hood - no change. I keep reading that there is a two wire plug on the transfer case I can test for voltage or to manually power the motor. Where is it? I see two plugs - the blue one on the left has 4 wires, the black one has more. Or is that not the shift motor I need to be looking for?
View 6 Replies
My HVAC blower motor stopped today while the wife was driving the F250. I thought I should swap relays (with the heated mirror relay - same Ford Part Number) to rule it out or identify it as the culprit. However, since these are close to the firewall, I have a hard time getting the grip and leverage to pull the relay out of the Battery Junction Box (BJB). How to make this a bit easier?
View 5 Replies
My 2005 ford f250 fx4 won't activate when I turn the key the light illuminates then turns off but when I start the truck and select it it doesn't go into gear
View 2 Replies
As I am driving everything goes dead radio, windows, dash, alarms, everything then turns on a usually 30 seconds later. is it a ground? is it a sensor that's getting to warm? is it a loose wire? where should I start??
View 6 Replies
Picked up a new to me 2011 F250 Lariat. She had a few odds and ends to take care of, but I was ok with that. So far I fixed the reverse sensors (2 were out) creaking in the back (leaf spring bushings needed a little Lithium Grease) Squeak in the back (tailgate step needed a little greasing). Now on to my next problem!
This is my first 6.2l (first f250 in general). Truck starts up great and idles quite. Taking off driving, it sounds loud as hell under the hood. To me it sounds like the Fan is making a loud sound as the motor is accelerating. It is more noticeable when you really floor it. Prior to this I owned a 2010 F150 and I know stomping on it the motor really revs up, but this other sound to me isn't right/normal. Googling around, the closest I found to it was:
Loud "Air" Sound Upon Accelerating 2002 FORD EXPEDITION - fan clutch! - YouTube
Granted it's for an expedition, but the sound is damn near identical. Looking on youtube at 1 or 2 videos of a f250 doing a 0-60 all I heard was the sound of the motor revving, so that has me convinced the sound I'm hearing is not normal. I'm 99% convinced it has to be the fan clutch.
View 8 Replies
160,000 miles and cylinder 7 is dead and 3 is dying, valves probably with rings right behind. Is it better to rebuild or buy a crate motor? Buying a crate motor, will a 5.0 fit? Should I spend the 5 or so grand beefing up this one, dropping in a 302 or putting it toward a newer model?
View 2 Replies
