Ford Super Duty (1999-2016) :: 2004 F250 - Most Of The Dashboard Electronics Stopped Working
Nov 2, 2013
I have an F-250 diesel 2004 and about six months ago it started acting really crazy. Basically most all of the dashboard electronics stopped working like the speedometer , odometer, gauges, etc. additionally all of the interior lights, and the radio stopped working. Now it looks a lot like the attached picture when I'm driving the truck. All of the lights are lit up on the dash panel but nothing actually works. I thought at first that a bunch of fuses might be blown but I have replaced nearly every fuse that has anything to do with any of the affected systems. What the issue might be.
View 11 Replies
Advertisement
2012 f250, fog lights stopped working and tried fixing yesterday. I'm getting 12.8v at the plug but as soon as you plug the light in it goes to 0. Ran a new ground from frame and the hot from plug and still nothing. High beams off, truck running and switch pulled out. Bulb is fine, hooked it straight to battery and it comes on. I though it was a faulty ground but by running a separate ground and still nothing. I'm at a lose.
View 2 Replies
I have a 2003 F250, 4x4, 5.4L and today my fuel gauge stopped working. I don't know if it had anything to do with a stall, I was on an exit ramp and the truck cut off, I quickly restarted and no issues after that. Other than the fuel gauge not working at this point.
I looked at the fuse panel diagram and there is no fuse for just the fuel gauge. The only thing I see is #35, instrument cluster. The rest of my instruments are working, so what else would cause the fuel gauge to stop working? It had a little over a half of a tank before the stall, after the stall it went down to less than half. I filled up shortly later and it's just stuck at less than half.
View 1 Replies
A buddy of mine has a 99 F250, and the 4WD stopped working. The 4wd light in the dash does not turn on with the key with the rest of the lights. There is a Low Range light that does turn on. He took it to a shop/dealership and they said the vacuum was good. They also swapped in a different GEM module, which didn't change anything.
I swapped the relays under the hood - no change. I keep reading that there is a two wire plug on the transfer case I can test for voltage or to manually power the motor. Where is it? I see two plugs - the blue one on the left has 4 wires, the black one has more. Or is that not the shift motor I need to be looking for?
View 6 Replies
My door locks stopped working new battery in fob, I can hear them trying to work. 2000 f250 crew cab .....
View 3 Replies
So one day my 4 wheel drive just stopped working, when I put in 4hi nothing same with low, the light on the dash doesn't even pop up and it doesn't engage. I've done about everything I could think of doing besides replacing the motor for it and the wiring, I hate getting stuck...
View 4 Replies
My drivers window will not work at all but when I push the button I get a clicking in the fuse box. The other 3 windows partially work but will only go up or down in small increments. I have tried holding the button and slamming the door and this allows the other 3 windows to work. I thought it was the switch so I replaced it and that was not the problem. Fuse and relay seem to be fine. If it was just the driver window I would think it was the lift motor but with the other 3 windows on the fritz I have no clue.
View 1 Replies
I'm hoping this might be a "quick fix". Got in the truck the other day and my power driver's seat had no function what so ever. Not a big deal for me as I drive with the seat all the way back but the complaints are starting from my wife so it's time to find a fix.
This is the first F250 I've had so the wiring is a little new to me. I checked the fuse panel and the fuse seemed okay I swapped #9 out for #22 as they are both 30A and I don't need the trailer at this time but still no luck.
Are there any other systems tied into the driver's power seat, any wiring harnesses I should check or perhaps a fuse that is not shown in the owner's manual? My truck is the 2013 Gas F250.
View 2 Replies
I have a 2001 F250, 5.4, 4X4. My ignition key stuck in the start position and when I pulled it back to the run position, everything seemed ok. As I started down the road, my speedometer stopped working and my overdrive light was flashing. Also my turn signals had stopped working and my A/C clutch didn't engage. Figured I burnt a fuse. I looked in both the under dash and power distribution box and all seemed well. I checked the fuse for the turn signals/flasher and it was fine. The flashers worked. Thought I might have fried something so I replaced the ignition lock and switch. Also my service engine light came on throwing a code for the vehicle speed sensor.
Looking for solutions on this forum and the internet, I learned that the turn signal switch could have gone bad and the VSS sensor is on the top of the rear dif and an easy fix. Well replaced the sensor but nothing changed. So I went back to the fuse box. Examined every fuse, big and small and I found a 10a with a small space. This was #24 under the dash. From the manual, "#24, 10A, A/C clutch, Blend Door Actuator, Trailer Tow Battery Charge Relay Coil, Four Wheel Anti-Lock Brake System (4WABS), Turn Signal." Replaced it and everything went back to normal. Turn signals work, A/C clutch works, no flashing overdrive light and speedometer works. All from a 10A fuse. If you have any of these symptoms examine all the fuses carefully. There's a 20A fuse for turn/hazard lamps and this other one buried that's only 10A.
View 1 Replies
My father-in-law has a 2008 f-250 with the 5.4. as he was driving a while back all the gauges of the dash quit. The engine still kept running without any noticeable difference but when he shut the engine off and tried to restart, it wouldn't even crank but the security light was flashing. He tried starting it again a few hours later and it started just like normal and ran fine.
He has had this problem occur several times in the last few months, but the other day it repeated the problem again and would not restart for about 5 days. He has tried charging the batteries, changing relays, checking all fuses and finding none blown, scanned it with his code reader, and checked the steering column for bare or rubbed wires.
View 10 Replies
I have my 2004 f250 6.8L. Recently my truck has been having issue with the oil needle. When im stopped or coming to a stop my Check Gauge light comes on and my oil needle drops all the way down. As soon i step on gas it goes right back up. What could it be?
View 7 Replies
My A/C has been working fine up til the end of last season and getting worse now. It comes on and blows really cold, then after a bit a electrical connection gets hot and looses contact somewhere. I can turn it off for about 5 miles then turn it back on, May last the rest of the day, may only last 10 min, then turn it back off, wait 10 min, turn on, does great! I thought it might be a dampener door,, but does the same whether in defrost, regular A/C, or max, so I think it has got to be a electrical connection getting hot and loose.
2004. F250 FX4. 198,000 miles,,,, runs great,,, just a little hot driving!!!
View 1 Replies
I just bought a 2004 f-250 checked everything out except for the headlights ... when I tried them the didn't work except on flash to pass ... I searched around and found some possible solutions and tried them .... first I checked the bulbs and all the fuss they are good then I bought a headlight switch ....that fixed the problem for about two days then they quit working again... so I took it back and got a new one ... when I first put it the new one in it didn't work then it started working a day or so later and I hadn't done anything to make it work... then a couple days later it went out again ... I have swapped the switch out several times and have had no luck I replaced the multi function switch and still no low beams ...
All the fuses are still good I have checked the wiring visually as much as I can see and see nothing... buddy of mine checked the pins on the headlight switch connector they are all good .. Read something last night about a guy whos alternator was going bad and caused his not to work checked mine its putting out around 13.4 at idle .. is there a relay somewhere ... my book doesn't show the function of any of the relays so I don't know ...not a mechanic but a pretty decent parts changer. Trying to fix this myself . Next week have to take the truck to pull the camper ..
View 1 Replies
2004 F250. Just got about 6 inches of snow. I use this truck to plow my private road. A few other residences on the road rely on my plowing.
I usually use 4WD Low and gear 2 on automatic transmission to plow. Hub manually locked. But today, when I shifted to 2, and pressed on the gas pedal. The truck was not engaging to drive, as if it were in park or neutral. And when I tried to shift to park, there is grinding noise and wouldn't allow me. I had to turn off the engine to be able to shift to park.
When I manually freed the hub and used 2WD High and gear D, I was able to drive the truck without problem.
Later, I tried using 4WD Low and gear D, and was able to drive a little distance before the truck no longer drives, and pressing on the gas is as if the truck was in park or neutral.
Previous to this earlier, I was driving down the private road to see how much snow we got. Without the plow on, I might have gone up to 10 or 15 mph, and still using 4WD Low and gear 2, maybe for 1/2 mile. Could I have damaged something by driving too fast in that setting?
View 9 Replies
2004 f250, brake lights except 3rd brake light do not work. flashers also do not work. turn signals work on both sides. when you turn on the flashers only the right indicator on the dash lights. checked all fuses for brake lights and am at a loss. On a float trip this weekend with my toy hauler and need brake lights to get home.
View 2 Replies
2004 f250 wipers and fluid not working Done the usual stuff checked the fuses in the cab and the 15amp fuse is good and the 30 amp fuse is good. Is there something under the hood i should look at?
View 3 Replies
How to disassemble the dashboard on my 2008 F250 FX4? I removed the few screws I could find. But most of the panels seems to be stuck behind the central panel (where the radio and A/C controls are). For the life of me I can't figure how to take it apart.
View 10 Replies
2004 F250 Crewcab 4x4 5.4 automatic.
My speedometer quit working - stays on 0, my odometer stays on 271006.5 miles. Everything lights up, when I do a gauge sweep, the speedometer goes from 0 to full blast then back to zero. On the gauge sweep, my odometer states off all the code stuff like I think it's suppose to.
Anyway, I was lucky enough to get a speeding ticket - driving with the flow of traffic, with the police officer behind me for a mile or more. Pulls me over, explain my speedo just went out, he said he can't let me off but the judge might. So I'm trying to fix prior to a court date.
Here is what I have tried so far.
1. Replaced the VSS in the axle - no change to problem.
2. Replaced the sensors on top of the tranny (2 of them) - no change in problem.
3. Sent the cluster off to a repair shop - they said it worked when it left there shop - no change in problem.
4. Replaced the battery - thought it might have a dead cell. - no change in problem.
5. Unhooked the battery, turned on the headlights, waited 30 minutes, put it back together. (did this probably 5 times) - no change in the problem.
6. Replaced the diff fluid. - no change in problem.
7. Replaced the front left abs sensor on the hub - the existing wire looked like it had rubbed on metal - possible short? - no change in problem.
So far I've just been what seems to be time and money at it with no luck.
View 12 Replies
I picked up a 2013 F250 back in Sept. currently about 5k miles. I've had in the shop twice. Once for a loud moonroof vibration when idling and just recently another for a PCM update(Engine light came on).
Here's the problem...
Something odd happened when I drove about a 1/4 mile... The dashboard lit up like a christmas tree and gave every error known to man. All dashboard lights came on, parking break, engine light, etc. Then the computer dash gave an AdvanceTrac Error, Oil pressure low and something else I can't recall. All my gauges went dead, including the Speedometer. Mind you, this was while driving... The only gauge working was the fuel gauge.
Turned the truck off, back on, everything works as normal. The truck has not showed any issues since (2 days of short distance drives).
I called the Service Dept and spoke with my guy. He never heard of this before and kind of wrote it off... Said, they won't be able to figure out unless it happens while they have it. This doesn't sound right to me.
My nose is pointing at the PCM update or a possible grounding issue.
View 14 Replies
My heater stopped working.
View 9 Replies
My 2000 F250 4 x 4 just started being almost impossible to steer to right when stopped. To the left it is ok. I was on a trip and when I got where I was going noticed the steering very hard. I checked the fluid level and it was almost empty. I filled the reservoir and let it sit 4 days. I am back on the road now and it is still doing it. Stopped to left is easy to right almost impossible.
My brakes are good. I noticed a couple times when I had to slam on the brakes on the tirp the rear tires chirped. I don't tow anything with it, just a family vehicle with 408000 miles. The power steering pump was replaced a few years ago. Pump, gearbox, etc? I need to get this fixed as I have another trip coming up in a few days.
View 2 Replies
