My 'new' 2004 F250 ExtCab SB w/5.4L sometimes 'drops' my keyless entry (key fob) for no apparent reason. Also, when I attempt to do the 'eight turns' of the ignition to get into program mode, it doesn't always work the first time (or second, or third, etc). Is this a common problem?
View 5 RepliesI recently purchased a 1999 F250 S/D v10 5 speed ext. cab and only received one ignition key (no keyless entry fobs).
The truck does not have a keypad on the doors, but if this truck has the remote keyless entry option, how can I tell?
I have the factory keyless entry on my '03 F-250 SuperCab. I have always had to be within about 5'-8' of my cab to get the doors to lock/unlock. I thought it was normal for the longest time, but recently learned it's not. I am out of warranty now so I need to try and fix this myself. What is the location of the receiver module, and what it looks like? Also, is there an external antenna w/ the factory keyless entry, and where is it at? Transmitters are fine, as is battery power. Only think it could be is receiver/antenna.
View 14 RepliesI have got a new 4 button key fob for my 05 F350. How to program this unit for the keyless entry and the remote starter.
View 9 RepliesThe key ring part of the fob for the keyless entry on the truck (2006 F250 V10) broke a while back. Finally got around to buyin a replacement only to realize that the keyless entry that came with the truck is not OEM. It's an Omega L2M 4410.
In trying to cycle locks to replace the fobs, the locks will not cycle. Tried everything that can be found on forums, youtube, etc. all to no avail. This leads me to believe that the aftermarket keyless was put on because there wasn't keyless from the factory.
I have experience with installing aftermarket systems, but this one stumps me - can't find where the system was installed in the first place. To me, this sounds like it should go to a shop for further investigation.
I can't remember my door code and don't want to take it to the ford dealership and pay. I know there is a code up under somewhere but I can't find it? 2005 f-250 lariat.
View 10 RepliesI am trying to put in after market keyless entry on my 03 sd wired up my relays according to the 5 wire alternating door locks found on this page
[URL]....
but it keeps popping my fuse when I try to put it in, if this is even the correct set up I found another guy on here that used the same set up but never said if it worked or not
Do the wiring for keypad keyless entry is in the harness and the programing in gem module on a 2003 F350 crew cab?? It would seems that is the same harness/parts as the excursion. I have not removed door panel yet, just trying to save some time.
This truck is one of my finest 4x4 rides yet, this would make much better!!! when i picked up my truck, included in the owners info was a factory keypad keyless entry code card, dealer told me that all trucks with keyless have that card regardless if it has keypad or keyless remote entry???
I have looked at many of the other treads and I can not find the answer. How do I locate the keyless entry code sticker in my 2008 F350? I just bought the truck used, I do not have the card that is delivered with the truck and I don't want to pay the Stealership to hook it up to there computer. I am looking for the RAP or the computer module as it is called in the owner's guide.
It is not behind the glove box, there is no longer a fuse access panel under the dash like the earlier SD's, the drink holder under the upfitter switches does not "pop out." Before I start with any tools, I am looking for input.
Is it possible to add the factory keyless entry without replacing the complete dash harness? I have an aftermarket unit I can add but I'd rather have oe if possible. Truck is an 2003 f250 v10.
View 1 RepliesI was driving and all of a sudden the radio died, battery light came on, Power windows and interior lights died, gauges died speedometer went all the way up to 100. The Head lights, turn signals and heater work. When I got home I opened the hood and the battery was boiling.
View 14 RepliesMy 1999 f250 superduty with the 5.4 was sitting in front of my house, and started all by itseft, did not have keys in it either and the doors were locked. I ran out thinking someone was stealing it but nope,? As far as I know it does not have a remote start either,i have owned it for the last two years and it has never happened before. It is a lariant edition also .
View 14 RepliesI have an 03 f250 5.4l that I've been having some problems with. When the engine is cold it will drive fine and everything. When it warms up, if I go to put it in gear it just dies right away. Why?
View 1 RepliesMy 1997 F250, 4x4, 460, auto has started dying with no warning while driving from 5 to 30 miles. Changed the fuel filter and the fuse under the hood. Where to start.
View 14 RepliesMy 2000 F250 SD 5.4 AWD's A/C wouldn't blow cold suddenly the other day. I confirmed the A/C relay (engine compartment, 3rd down from firewall)was "clicking" but compressor clutch was obviously not engaging with dash switch on Max A/C and engine running. When I take of the 2 wire connector to compressor to see if it is getting power, the truck won't start..if I disconnect the A/C compressor plug while running, the engine similarly quits. I have never had another vehicle do this on me before..I could unplug the compressor on my Jeep GC, for instance, measure 12+ volts with A/C ON w/car running and no problem with Jeep engine turning off.
I have searched for A/C wiring schematic w/o success. I checked every fuse in cab/engine for continuity since I don't know which ones might deal with A/C..jumped hi/lo pressure switch connectors with engine running/A/C ON w/o compressor clutch engaging. Clutch turns easily, have banged it a few times, and air gap looks good. More bizarrerly, I hooked the compressor to a 12V/ground via its 2 male prongs and didn't get the clutch to engage.
I have a 2001 f250 super duty extended cab with the v10. Over the past week it has been running fine and it will all of a sudden lose power and dies. I've been able to start it back up once right away and a few times it started up after a few hours of messing with it.
So, after the truck dies it will crank and crank but will not start. We have checked fuel pressure and nothing. Then we applied direct current to the fuel pump and it turns on. Then we applied direct current to the fuel pump slot in the fuse box and got a fuel pressure reading of 40 psi. But when we crank we have no pressure.
When we apply direct current to the fuel pump slot in the fuse box the truck will only crank and not start.
I have bought a used 1999 F250 4-door 4X4 7.3. Is there any way to tell if my truck came with a remote for the keyless entry. It has power door locks and windows. I was debating on calling my local Ford dealership and seeing if they could check by the VIN number.
View 7 RepliesWe have replaced 4 fuel pumps on a row.
Voltage is good...even ran a fresh circuit.
Ran new supply lines
But, can't seem to understand the continued drop in pressure. It usually takes about a day of driving to crater after a new pump/filter is installed.
It never dies, just loses power and drops the truck to an idle. Funny thing...if I shut the truck off and turn it right back on...full power for a short period!
The truck is used on a ranch that has plenty of rough roads...thought inertia switch maybe but i believe that would stop fuel completely right?
I am totally stumped and so is the mechanic.
My 2008 250 suddenly lost ability to adjust temp control of heat and A/C. I can adjust the fan speed and the defrost/dash vents/foot heater position controls, but no matter how far I turn the cold/hot dial left or right, the temp is the same. Even in the Max and Norm A/C setting, it's the same temp, which is stuck in the hot range.
View 10 RepliesMy F250 with V10 has developed an overheating problem. While driving, the temp gauge suddenly shoots to max, and the truck goes into limp mode. Turning off the truck and ignition, waiting a few minutes, and all seems to be well again - sometimes for only a minute, sometimes for several days. No steam leaking, the water in the reservoir seems to be normal temperature, the radiator is not overly hot, and the AC keeps on blowing ice cold. Me thinks it is not really overheating, it just thinks it is. So where to start? Change the temp sensor first, or the thermostat? It seems the hoses are fairly firm, I don't believe they are collapsing from suction.
View 14 RepliesMy 2002 F250 7.3 randomly dies while driving and seems to only be when I hit a bump no matter the size. I have checked the valve cover harness connector outside of the valve covers and they look fine. I checked the ECM connection took it off and reconnected it.
Changed the CPS censor twice, checked the ICP sensor, checked continuity of all the glow plugs through the valve cover harness. Checked the fuel pump, checked all related fuses, changed the fuel filter, checked glow plug relay, batteries hold good voltage and were recently upgraded to bigger batteries.
Engine runs just a little rough but not enough to be of concern. Air filter is clean and oil level is perfect. What could possible be causing my truck to randomly die when it hits a bump and not start back right away??? This truck is new to me and its the first diesel engine I have ever owned.