Ford Super Duty (1999-2016) :: 2004 F250 Hesitates / Acts Like Missing Out
Apr 30, 2014
I have recently purchased an 04 F250 crew cab with the 6.0 power stroke, it has a cold air intake, 4inch exhaust from the turbo back and has a program in it but programmer didn't come with the truck. When I sit at a traffic light and go to leave on a green light the truck kind of hesitates or acts like it's missing out( maybe loading up) shoots out black smoke then runs fine, it doesn't do it at all the stop lights but does get irritating. If I get it flashed back to stock settings will the truck run normal with all the upgrades?
View 4 Replies
Advertisement
I have a 2004 F-250 with a 6.0 and a 6-speed with 140,000 miles. It has been studded, and has upgraded injectors. ( Not sure on the size, they bored them at at the diesel shop that studded my heads.) Also have an EGR delete, with the EGR turned off on the SCT as well. I also have a SCT Livewire set on the 65HP tow tune.
Truck has always ran great in the year and a half I have had it. I changed the oil three days ago, and now I am getting a miss at idle. The trucks cranks right up and drives normally. Once it is at operating temperature, when I stop at a light it has a very noticeable miss. There is no surging, or change in RPM's at all. Just seems like it is cutting out every few seconds. This is also somewhat intermittent. FICM shows 49 volts always, even when this is occurring.
Also, this may be unrelated, my oil temperature seems higher since the oil change. Was around 192 water/197 oil while cruising 70 on the interstate. Now, its' more like 192/202. I've always ran Motorcraft 15w-40, and that is what I used for this oil change as well.
I see some people have a similar problem, but all the posts I've read involved fluctuating RPM's or surging, or both. Other than this, the truck cranks and runs just like normal.
View 2 Replies
My v10 has a cold miss when i start it in the morning no matter what the temp. It misses until it gets up to operating temp.then it runs fine all day with a slight miss.
- Changed plugs,
- Changed pcv,
- Changed iacv,
- Cleaned map sensor,
- Changed tube to pcv,
No codes. Its running as if it had a carb and the choke is closed. No smoke, tach. idles between 750 down to about 500, until it warms up then tach. Stays steady.
View 4 Replies
I was washing my 2004 F-250 today and I looked down by the front passenger wheel well and I noticed a small chuck missing from the bottom of the frame. The other side in the same spot doesn't have it and at the spot in question, I noticed some sort of crack had been welded before. I never had any of that done to the truck. What about getting it fixed? get it fixed right away or keep an eye out for cracks. so far its just that hole and what looks like a welded crack above. everything else seems fine. I know a repair would be inexpensive and easy just to weld a steel or titanium plate on the spot.
View 11 Replies
New issue I've discovered , when stopping , the RPM's drop down to 500, truck acts like it wants to stall , then goes up to 750 RPM's . Then it's fine . Doesn't hesitate when accelerating . Idles slightly rough after start up , about 30 seconds . I've checked the air filter , cleaned the IAC and MAF. Fuel filter is only a year old . What I should check next ?
View 14 Replies
I'm having multiple electrical problems and not sure if all related or not but they started at the same time.
1) Occasionally (getting more frequent) truck acts like its almost dead and wont start, but if i remote start it cranks right up
2) Radio doesn't shut off when I open the door, but if i close it and open again it does
3) phone staying connected to bluetooth but its acting up when trying use phone for music
Pretty sure there is more but I cant think of them now.
View 2 Replies
I have a 1999 ford f250 with a 6.8 liter v 10 engine. At about 40mph the truck will start missing and lacks power to accelerate further. This problem is intermittent. Some days it runs great and others the miss appears. Well I scanned and the code reader said that I had a misfire on cylinder 7. I took a chance and replaced the COP and the boot for that cylinder . Ran great for a day and then the miss came back. Same code again. What else might cause this? Are plugs difficult to change in these engines?
View 6 Replies
Just got a 2008 F-250, truck has the center console jump seat and the console lid is missing. Can you just buy a new lid or do you have to buy the whole thing? Cost? Places to buy?
View 4 Replies
I have 2005 f250 5.4l 3v that was having miss problems between 1200 and 2000 RPMs. Changed VCT solenoids which worked, but then could hear chain hitting cover when powering down throttle on left side. Figured chain tensioner was bad, so tore down and removed timing cover. Found left chain was tighter than what seems normal, and right side had huge amount of slack. While taking off tensioner on left side, something happened to fast for me to see it, and still not sure if what happened wasn't just my imagination. I thought that the chain moved very fast for an inch or two. Anyways, I watched how to video on timing the 3v, but I am very confused about it. The left bank seems to line up on timing marks perfectly, but the right chain is off by at least 2 1/2 links. Not knowing any better, I removed three rockers on left bank (2 intakes and 1 exhaust) but only removed two intake rockers on right side. I don't know what I am doing and getting scared.
View 1 Replies
I bought a 99 f250 super duty with v-10. Ran great then I decided to hose off engine compartment. No pressure washer just running water trying to get all the dirt off now the engine sounds like its missing. Could I have a coil pack that got wet or is something else wrong.
View 3 Replies
So, I have a 2007 f250 with the 6.0. When she's cold she starts fine but runs rough like she has a miss. When she warms up the miss goes away and it runs pretty good. But if I shut it off it won't start for about an hour or so.
ICP sensor has been replaced.
FICM is putting out 50v
View 11 Replies
I have a 2008 f250 superduty with the v10. Just today I was driving and engine picked up.slight miss it's rainy. I thought coil pack, but it left me on side of road. Got fired limped home won't go more than 40mph. Runs rough, no power, checked codes and get P0340, p0357, p1336, and P2195.. Where to start.. My daily driver and have to get back on road.
View 1 Replies
I have a 2007 F250 4X4 6.0 diesel. When first started it idles extremely rough to a point it sounds like a old gas engine missing. But after it warms up for about 15 minutes it runs and idles like a new truck. I'm thinking it's the injectors if so is this something I can change/clean ....
View 2 Replies
I've got a 2006 F250 5.4l Super Cab. When I bought the truck the rear interior door trim panels were missing. I tried to order them straight from ford but it turns out they no longer carry them, and I can't seem to find them anywhere online. I've also looked at the salvage yards in my area- nothing. Where I would be able to find these elusive creatures?
View 3 Replies
My truck is a 2003 f250 / 2wd automatic, 7.3 powerstroke, 284000 well maintained miles.
Just last week I sprug a large oil leak and had to replace the hoop outlet o rings..problem solved. This week I can drive 15-20 miles on the freeway and the truck starts to act like ota running out of fuel. Bogs down to 40mph then starts missing. I pull over, and when revving I have un burnt fuel and oil smoking out of my tailpipe. I let it sit for 5-10 minutes and it will be fine for the rest of the drive and this happens intermittently, there is no pattern.
The truck has a ton of power, starts great hot or cold. I did a ton of research and found a IPR could possibly cause this, as could plugged screens in the fuel pickup. Then I read about all the injector harness issues but I don't think that I my issue.
View 8 Replies
I have a 1999 F250 Super Duty 5.4L, 118,000miles...engine seems to idle somewhat rough but tach doesn't seem to move off 1000rpm & when giving slight acceleration seems to act like its missing, shaking . But under acceleration moderate or high purrs like a kitten! Always starts good , few cranks. Any hints on the what issue might be?
View 2 Replies
hey I have a 99 v10 Super duty that won't start it acts like the engine us seized the guy I bought it from says, that it just shut off at avred light and he couldn't get bit started since then when I try to. Start the truck it acts like the engine is seized. I checked the oil and coolant both are clean and full.no signs of leaks I heard it could be the ac pump stopping the belt from moving, whats wrong with my truck?!
View 5 Replies
I just had the bed and tailgate on my 2004 replaced with a 2015. The body shop took my old lock cylinder out to put in the new tailgate. The old tailgate is only a year old and I wanted to sell it. The issue is that the latch will not open the tailgate. I can manually unlatch it by pulling the rods. Does the lock cylinder not being installed somehow affect this and need to be installed for it to function properly or do the rods simply need to be adjusted?
View 4 Replies
06 F550 w/5r110w. Truck and trans runs great then trans acts like it was shifted into neutral, rpm's flare up and if you don't get your foot out of it the trans will re engage aggressively. Changed the speed sensor on the rear axle, there are no codes, had a trans shop change the filters and fluids then change out all of the solenoids. They tell me its not a trans problem.
View 3 Replies
Just wanting to know what might be wrong truck will not go into 4x4. All fuses in panel looked good. Light on dash is not coming on was working last weekend just fine. Have the hubs in lock position not auto.
View 6 Replies
I have a 2011 super duty with the 6.2 flex. When shifting into reverse, it hesitates, then slams into reverse. Same on the lower gears when driving. This doesn't occur all the time, but the majority. Been talking to a couple other super duty owners (diesel owners) who have been having the same prob, but not as severe. We all have noticed the prob after having charcoal filter replaced. Is this a tranny issue or computer issue?
View 3 Replies
