Ford Super Duty (1999-2016) :: 2004 - Blower Motor Speed Won't Work?


Jun 28, 2014

Have a 2004 F-250 and blower motor speed 3 is not working..replaced resistor pack with Motorcraft part and everything works except position 3 ....

View 6 Replies

Advertisement

Ford Super Duty (1999-2016) :: 2007 F250 - 2nd Speed For Blower Motor Don't Work

I have and 07 F250 and the #2 speed for the blower motor don't work (hasn't since I bought it) I read that the most common cause of this is the resistor under the hood on the firewall so I replaced that and still no 2nd speed??? Where I look next? Motor itself maybe?

View 11 Replies

Ford Super Duty (1999-2016) :: 2002 - No Difference In Blower Motor Speed

Currently My AC / Heat blower motor operates but, speed 1 and 2 are the same, 3 and 4 are fine. I replaced the blower rheostat that is located on the firewall, but still no difference in fan speed.. A few years ago the blower only operated on Hi and the rheostat was the problem then.

View 3 Replies

Ford Super Duty (1999-2016) :: 2008 - Blower Motor Went Out?

The blower motor went out on my 2008 F-350,? I can't for the life of me figure out how to get it out. Do I have to remove the dash? I am positive it is fried, I ran a hot wire straight to the motor and it still wouldn't come on.

View 2 Replies

Ford Super Duty (1999-2016) :: AC / Vent Fan Blower Motor Keeps Going In And Out

My A/C, vent fan (blower motor) keeps going in and out. Does not do it all the time, but when it goes out, it will come back on after a few moments, but will not run full speed. If you try to adjust the speed, it just cuts off again. What is causing this.

View 7 Replies

Ford Super Duty (1999-2016) :: Blower Motor Stays On With Off System?

my blower keeps blowing even when i turn off the system, it does stop when the motor is off but comes back on once i start the truck...relay is fine.

View 6 Replies

Ford Super Duty (1999-2016) :: 2012 - Blower Motor Not Working?

2012 F350 Lariat 6.7

The blower motor has quit. All fuses relays etc appeared to be ok. So I tested the connector going into the motor, I saw 13.9 volts so assumed it was a bad motor.

After removing the motor I bench tested it by connecting 12volts to one side of the connector and negative to the other. It spun up.

I re-tested the motor supply connector in the vehicle, it has 13.9 volts on the yellow wire, and 4.44 on the other. I adjusted the fan speed on the climate control, although the fan images on the display increased, there was no change to the voltages on either line.

I used the 13.9v connection on the positive terminal and a ground on the negative, the motor spins.

Is there a method for accessing codes that will display what is causing this failure?

So why do I have 4.44 volts at what should be a ground? Is this a bad resistor or is the climate control euchred.

View 4 Replies

Ford Super Duty (1999-2016) :: 2008 F250 - Blower Motor Going On And Off Intermittently

My Blower motor is intermittently going on and off. After messing with it for a while it seems to stay on. Motor may be going out. Not real easy to change the blower motor on this 2008. Haynes manual says to take the 2008 and up trucks to the dealer.

2008 F250 4DR 5.4L

View 8 Replies

Ford Super Duty (1999-2016) :: 2001 F350 - No Blower Motor / Just Defrost

Like the title says; I have a 2001 F350 with No blower Motor and Just Defrost, it is actually a friends, he is building a fence, and I am looking into the truck problem. The just defrost is probably a vacuum issue, but I do not have any book for this truck, so I have no vacuum or wiring diagrams. As far as the blower motor, I am thinking switch or motor, fuse has been checked? Is there any other "control" box involved with this year/model? Also any dash tear-out instructions, to make the access easier?

View 1 Replies

Ford Super Duty (1999-2016) :: 2003 - Blower Motor Loud Rumble Noise?

I have a 2003 super duty V10 4WD super cab long bed.

loud deep rumble noise when turn on the blower. both heat and a/c. removed the blower and seemed to turn ok. blew out all vents. removed heater radiator cover, checked most flaps to see if working. doesn't seem to be obstruction invent. the flap behind blower clear and functioning ok.

When on second speed, almost sounds like blower motor is out of balance. if run on high for 1 minute, smell electrical burning! Think to replace motor will work? will post another issue with radio and power windows

View 8 Replies

Ford Super Duty (1999-2016) :: 2001 F350 - Blower Motor For AC / Heater Only Works Sometimes

2001 f350 blower motor for (A/C - Heater) works sometimes and sometimes does not.

View 5 Replies

Ford Super Duty (1999-2016) :: F250 - HVAC Blower Motor Stopped While Driving

My HVAC blower motor stopped today while the wife was driving the F250. I thought I should swap relays (with the heated mirror relay - same Ford Part Number) to rule it out or identify it as the culprit. However, since these are close to the firewall, I have a hard time getting the grip and leverage to pull the relay out of the Battery Junction Box (BJB). How to make this a bit easier?

View 5 Replies

Ford Super Duty (1999-2016) :: 2003 - Second Position Of Blower Switch Does Not Work

I have an '03 F250 and the second position of the blower switch doesn't work. The first, third, and fourth are all fine.

I bought a Motorcraft YH-1670 blower switch, but can't figure out where it's located?

I looked behind the glove box, but didn't see it there. I did not remove the screws to the cover behind the glove box because I wanted to first confirm where the switch is located.

View 12 Replies

Ford Super Duty (1999-2016) :: Blower Is Not Working But LED Fan Speed On Dash Shown

2010 F350 DRW King Ranch CC

Blower is not working, but LED fan speed on dash shows it is. I've check all fuses and they are okay. This is dual-climate control, and neither works.

View 1 Replies

Ford Super Duty (1999-2016) :: 5 Speed - Tow Haul Does Not Work While Driving

All of a sudden my T/H doesn't work while I am driving. If I stop and put in park, I can press the button and it will go into T/H. Once I am driving, it won't go out of T/H, and visa-versa. Is this a sensor issue or something more serious? The tranny works fine in either situation, downshifts correctly.

View 2 Replies

Ford Ranger / B-Series :: Fan Only Work At High Speed / Blower Motor Hose?

I recently bought a 96 ranger.I noticed the fan did not work but for high. I search the internet and found how to remove it and discovered a mouse nest(village) which basically took over the housing where the evaportor core,blower motor resides. I bought a chilton but cannot remove the housing around the core so I cleaned it the best I could(air compressor and vacuum and disinfectant)...

I had to buy a new blower motor and resistor. However, I cannot find the hose that attached to the blower motor?-mouse had chewed a hole in the one- I've looked and found serveral differents names for it but seems I cannot find it at my local parts store.

My question is- is this intake hose? vent hose? I'm guessing I will have to go to dealer or, if I know the name I can look it up in a salvage yard?

View 14 Replies

Ford Super Duty (1999-2016) :: 2004 F250 - Motor Turns Over But Very Slow And Will Not Start

My dad has a 04 f250 5.4 auto. The motor turns over but very slow and will not start. He's put two new starters on. I went and looked at it and figured it was loose cables or corrosion, but it was fairly clean, and tight. We decided to pull the battery out of his van that he drives everyday, and I cleaned everything very good. Same thing. Pulled the belt to make sure nothing was lockup, same thing. Truck was running and starting great, then just did this one morning on him.

View 9 Replies

Ford Super Duty (1999-2016) :: 2004 - Overhead Console Does Not Work

Like most older superduty trucks my overhead console doesn't work. I removed it and got the thing apart. Low and behold there were 4 of the resistors loose in the plastic housing. Looking for a diagram that shows the location of these so I can resolder them? My truck is an 04 lariat with sunroof which seems to be different than non sunroof trucks.

View 2 Replies

Ford Super Duty (1999-2016) :: 2004 F250 Vibrate Up And Down At 45 Mph Speed

I have 2004 F250 6.0 diesel. I added 35s with diamo rims and I installed a front end lift which added a small leaf springs to the factory leaf spring to raise the front end 2 inches . The truck drives fine no problems at high speeds and low speeds except for right at 45 mph. At that speed the whole truck vibrates up and down . If I accelerate the vibration goes away. Discount tire rotated balanced etc and even replace a rim and nothing has changed. I did put the factory wheels and tires back on and the vibration went away. Put the big tires and rims back on and vibration is there at 45 mph. How to troubleshoot this ? I have 90,000 miles on her.

View 3 Replies

Ford Super Duty (1999-2016) :: 2004 - Low Speed Vibration 15 - 20 Mph On Acceleration / Deceleration?

2004 F350 single rear wheel with 8" suspension (springs) lift and 37" tires all put on in 2005. Having low speed vibration 15-20 mph on accel and decel. Recently put on thick aluminum rear dif cover and vibration seems to have come since that install. Used Mobile synthetic fluid and 4 oz of Motorcraft antifriction additive and 4 oz of off brand. The Mobile fluid and antifriction have been in my barn for over 5 years in the winter and summer. I just changed the carrier bearing and all U-joints look good. Any chance the fluid and antifriction additive could be causing this? Truck has 66k miles.

View 6 Replies

Ford Super Duty (1999-2016) :: 2004 - Changing Shift Motor - Transfer Case Stuck Due To Broken Bolt?

I'm in the process of changing my shift motor on my 04 f350. I can't get it off because of a broken bolt. The previous owner must have done this before, and snapped the head and some of the shaft off, so it's basically an alignment pin that's recessed into the hole on the motor. For some reason it's holding the motor on, even though I don't think the hole is threaded. Any way to get it off. I'm thinking that taking a MAP gas torch to the casting on the motor may be my best bet.

View 8 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved