Ford Super Duty (1999-2016) :: 2003 - Won't Start - No Codes?
Aug 4, 2015
I have a 2003 f350 v-10 drove it yesterday to get fuel, went to start it after fueling. No start, no lights dash was gauged was acting odd, and clicking under the dash from behind fuse box. did get it to start after a while, put my foot on the brake to go into drive, never made it ... truck died I do have remote start system thought it was that with the brake pedal issue. disconnected complete system. no change. Had it towed, home now no nothing, connect a battery and just clicking from under dash no start ?????? not a battery, won't even jump. The battery is good, power to starter, Posted this also in light-duty trucks wrong place think this is the better place. Gauges pinned to right with key off
View 3 Replies
Advertisement
My truck was running fine, it's stock as far as I know. Shut it off, it sat and cooled off for a while. When I tried to crank it, it wouldn't start, threw 2 codes. P2285 and p 2623. I unplugged the icp sensoran tried to start, no start. Plugged it back in and it started fine for the rest of the work day ( I work out of it). Drove it the next day without any issues. Today went to start before work and no start with the same 2 codes. What should I check first? I don't have any monitor yet. Bought the truck a month ago as a work truck. It has 164000 miles.
View 4 Replies
2003 f350 2wd 5.4 auto cab and chassis with 40 gal rear tank replaced fuel pump/fuel filter/spark plugs/IAC no codes
View 7 Replies
2007 F350 6.0 .. I let the truck sit for about a week went out to start it truck cranked right up then died now the truck wont start truck was running fine until this I wasn't having any starting problems. the codes are all eight injectors low circuit tested ficm had 48.3 volts...
View 1 Replies
2003 E-550 7.3L with IDM codes clear all code, do in injector buzz test P1276 and P1275. Start truck and SES light comes on. shut off truck code IDM code go to KOEF and have P1272, P1273, P1275, P1276. just replaced valve cover harness ohm wires to IDM put new IDM in. Truck shuts off while going down highway, turn key off then back on an usually starts on it own ....
View 5 Replies
I have a 2003 Ford f250 5.4l brought it to the shop today and they said the pcm isn't communicating with the trans. The truck hesitates and stalls out at a stop. idle is OK a little studder. OD light blinks also. I put new ho2s in, new oss from ford, new plugs and coils (motorcraft).
View 3 Replies
I've had DTC P0171 & P0174 (lean in bank 1 and lean in bank 2) for a few weeks now (check engine light cued me on it). Autozone scanned it for me. It's on a 2003 F250 SD 4x4 5.4L.
My first step was to clean the MAFS. Light came back on in about 30-40 miles. I then replaced the MAFS. 30-40 miles and the light came back on.
My first thought was disconnecting the battery wasn't resetting the comp and thats why the light was comming back on.
I went and picked up an Actron cheapy OBD II Scanner today at lunch. Cleared the codes with the scanner and drove back to work.
Checked the codes when I got back (no light on but was curious) and it shows P0171 & P0174 pending.
I've checked and the dipstick is seated properly. The hoses on the air intake appear to seated properly as well. The top hose is a pretty loose fit but it was seated all the way down. The top hose was oily. Not sure if this is normal or not. Could the loose fitting oily hose be the culprit?
Also, what is the lower hose? It comes off the back of the air intake and goes to the driver side valve cover. I know it's not the PCV hose as that is on the passenger side valve cover....right?
View 14 Replies
today I went out to start the F-250 2003 6.0L, and since I have a head cold and i was supposed to go to some job meeting and there's this weird beeping from a smoke detector in my house I can't turn off and it's keeping me awake= I was a total dip you know what and cranked the truck without warming up the glow plugs. So now it won't start. I don't know EXACTLY if that's why, or what. The batteries are fine. There don't appear to be any wires that jiggled loose. I drove home just fine last night.
I don't want to keep cranking it, obviously. Could this be because I forgot to turn the key and warm up the glow plugs? It's not that cold out, but, I know sometimes with my VWs you really had to do it no matter what.
Given that I may have made this stupid mistake, what are my options now? I don't smell diesel when I open the hood. Should I just wait a while, or should I try to open something up, or what?
View 5 Replies
I have had this truck for about 3 weeks now, and twice on hot days (95F) it wouldn't start. Both times I had not driven the truck that day, so this would be a "cold start." No "idiot lights" came on to give me any indications. The Haynes Manual does me no good on this. Other than this issue, the truck runs and drives great.
View 14 Replies
Just bought 2 new batteries as one was toast, and the 7.3 was really hard to start. After installing started like a new truck..This morning temp was 54 and would not start after several attempts, trys to run but after a few seconds stops. Just bought and looks like a new solonoid had been installed. What should I check??
2003 F-350 7.3
View 2 Replies
I have a 2003 f350 v-10 drove it yesterday to get fuel, went to start it after fueling. No start, no lights dash was gauges were acting odd, and clicking under dash from behind fuse box. did get it to start after a while, put my foot on brake to go into drive, never made it ... truck died I do have remote start system thought it was that with the brake pedal issue. disconnected complete system. no change
Had it towed, home now no nothing, connect battery and just clicking from under dash no start ? not battery, wont even jump
View 8 Replies
I have a 2003 f350 v-10 drove it yesterday to get fuel, went to start it after fueling. No start, no lights dash was gauged was acting odd, and clicking under the dash from behind fuse box. did get it to start after a while, put my foot on the brake to go into drive, never made it ... truck died I do have remote start system thought it was that with the brake pedal issue. disconnected complete system. no change Had it towed, home now no nothing, connect the battery and just clicking from under dash no start ? not a battery, won't even jump Battery is good, the power to starter, Posted this also in light-duty trucks wrong place think this is the better place. Gauges pinned to right with key off
View 7 Replies
I have a 2003 F250 with 157,000 mile. Left the house last week and got about a mile down the road when I realized I had forgotten something. Pulled off to turn around and had no power to get back onto the road. RPMs wouldn't go over about 1500. Finally got it on the road and it completely shut off. Was able to get it home and have been tinkering with it. Stats from Scangauge are as follows:
Key on not cranking.
IPR 14.81%
FICM 47.6-48.0
Sync=0
ICP 32
Data while cranking.
IPR 43-47%
FICM 38-42
Sync=1
ICP 1532
I'm leaning towards a bad FICM but the ICP pressure seems to be high to me.
View 5 Replies
I have a farmer with a 2001 F350 SuperDuty with a 7.3 broke down at his farm a few weeks ago. Asked me to come look at it. No start issue. I use the Matco Determinator in my shop, so I take it with me for starters,after running diagnostics I come up with p0340, p0344,& p1670. After googling these codes I make the determination idm is bad. Farmer agrees to let me try one, install a new BorgWarner unit from O'Reillys, and bam truck fires up. I reinstall inner liner clear codes and go about my way. Few days go by and farmer shows up again, truck run a few miles around farm,spits sputters, and dies again. Go run my checks and same thing. Farmer told me in nthe beginning he had CPS changed per the recall. I had idm replaced under warranty truck fires back up, so this time I drive it , and get bout 2 miles down road truck dies. Had to tow strap back to shop. Got a new cps from ford replaced truck fires up. Farmer takes truck drives for bout a week guess what truck gets towed back. 3 codes are back, along with a few others related to low voltage. This time I replaced idm for a 3rd time, truck fires up. Today I let it idle for 3 hours in lot, decided t test drive, got less than a mile down road, truck shudders chi engine light comes on and it wants to die but keeps running. I am able to get turned around but it dies before I can get back home. Run codes and get same 3.
View 1 Replies
03 F-250 5.4vStandard Transmission
Thought my battery was no good , so changed it. Didn't work it just kinda bumps the motor but doesn't turn over.
Thought it must be my starter then , bought a $200 starter and changed it , still doing the same thing. It did start after changing the starter but wont now.
Neutral safety switch?
View 9 Replies
I have a 2003 Super Duty 6.0. The trouble started almost all at once. It started fine, then I drove it for a while and on hot start, it cranked for a long time before starting. This went on for a few days, then today it wouldn't restart even when cool after not being driven for hours. I have a code P2285 and code P2285 P that has been on for a month or so. I know that the P2285 is the ICP. I don't know and can't find out what the "P" is at the end of the code. Anyways, I want to repair it myself. I have experience doing pretty major repairs, so it doesn't scare me. The problem is I am new to the diesel world. So come one and come all with possible scenarios and I will Go right down the list.
View 3 Replies
About 2 weeks ago it would turn over and cough and then just spin. After a few minutes it would crank. Last week it didn't do it at all, this morning when I am loaded and headed to Atlanta for work it wouldn't crank at all. I didn't have any starting fluid so I tried some cleaner and it would cough and just spin. I'm thinking fuel pressure but I just don't know.
View 4 Replies
I just bought an 03 f250 5.4l . I'm just using it to plow my driveway this winter. The starter just clicks , after multiple attempts it will start. The previous owner said it's been like that for a long time but always starts.
I'd like to fix this now while it's warm out , before I buy a starter I'm wondering if I should look into other causes and how to trouble shoot the issue.
View 6 Replies
I recently bought a 2003 f350 7.3, I ordered a tuner for it and tried installing it, at one point while the ECM was still connected I did something and it sparked. Then the powertrain relay (302) started clicking really fast. It clicked in the on position. I switched it with another and it was also clicking. So since I sparke the ECM I figured I messed it up. I ordered another one and it's doing the same thing. Then I pulled fuse 45 (which was good) and put it back in. When I turned truck to on position it wouldn't click anymore, but it still won't start... What it could be? OV ruled out the ECM, powertrain relay (302) and fuse 45, I don't know what else to check.
View 2 Replies
Shade tree mechanic, new to diesels and new to forum. I have the dreaded 03' 6.0 F350. It cranks over strong but will not start after its warmed up. I went to Auto Zone and they gave me the following codes: P2291, P132B, P0672, P0402, P0284. Once it's started it runs fine.
View 8 Replies
2003 f-350 had no dash lights and no start or crank. Found battery cable junction on left fender broken fixed, replaced starter. Drove it sunday, went about 15 mi and just shut off. Towed home was a battery, replaced battery, now I have lights but turn key and nothing? Was starting fine, all summer seems like a cold weather issue. Any relays I should be looking for? I was going to check power to started but raining too hard this am ...
View 4 Replies
