Ford Super Duty (1999-2016) :: 2003 Truck Started Losing Power When Going Down The Road And Then Died
Jul 16, 2014
I have an 03 with a 6.0 diesel, going down the road and started losing power and then died. Won't start, and I don't have a scan gauge. Several sources said ipr valve, and from videos on youtube I thought may be a good place to start. I bought a socket and pulled the valve, to check the screen. There is no screen whatsoever on the ipr. The oils clean, as I had changed it about 200 miles ago, and I ran a magnet in the hole looking for a screen, couldn't find anything so I used my fluid pump in the hole. No trash, screen or anything. Do some ipr valves not have screens? What would be my next step??
View 2 Replies
Advertisement
I have another very odd problem with my 2003 F250 7.3 PS with 206000 miles on it.
I am visiting my parents and every time I go thru this certain area my truck will act up. The first thing that happens is the truck starts losing power and then it starts bucking like water in the fuel or the cam position sensor is giving out.
WHAT I HAVE DONE SO FAR: I have drained the fuel filter assembly ( no water ) and a new cam position sensor has been installed (about 5000 miles ago, I even put old one back it to check it out same results). I have driven the truck all over the place and don't have an issue except in this ONE spot. I am beginning to think there is some kind of high powered RF going on in this area causing my truck to act up. I am thinking of hooking up my autoenginuity scanner up to it and hopefully see something going on.
Is there anything I can do to block this out if it is a RF problem. I think it is effecting my Pcm/ECM for then engine causing the truck to act up.
View 6 Replies
On the way to work, the truck seemed to have a miss at idle and the CE light came on. Long crank to start leaving work, and truck starts losing power and eventually died. No smoke while it was losing power. Towed it home and checked the fuel pump and lines for blockage and found nothing.
2003 7.3 F-250 430K miles
strong cranking but no start no smoke out exhaust
Oil changed recently
IPR changed
Both UVCH gaskets and pigtails have been repaired.
ICP sensor and harness changed, also disconnected no change in cranking.
fuel filter changed today (no oil in bowl)
3/4 tank of fuel
dash gauge for lpop goes up to normal range during cranking and oil light turns off.
WTS light comes on and turns off as normal
tach gauge moves up between 100-200 during cranking
fuel pump turns on and pressurizes system like normal and turns off.
Ordered AE for the truck, and it directed me to the passenger side bank high open. Fixed the harness on that side and still nothing.
Sent off the IDM and it passed with flying colors
So now i'm leaning towards the HPOP, but would hate to fork over the cash for it and still not get anywhere. I'm going to take the valve covers back off and check the discharge ports for the injectors tomorrow.
View 14 Replies
The truck I'm working on is a 2003 f550 with a 6.0, and 382000 kilometers. My service truck died on me couple days ago, while running. As I rolled to a stop, I noticed that my temp gauge on the dash dropped to cold. (Truck was hot). Tried starting, and I have a crank, no start situation.
After towing it to my shop at work, I hooked it up to my scanner, and found that the pcm will not communicate with the scanner (otc genisis). I have no injector buzz with key on, wait to start light comes on for an abnormally long time. I have 48.3 volts on the ficm,(4 screw), and haven't been able to find any chafed wires as of yet.
View 1 Replies
I was driving my truck then all sudden truck started losing power then slowly died. I restarted it, it was a lil shacky then died again. Iunscrewed the fuel filter and looked in the housing and there was lil fuel in bowl i turned the key to on position and bowl did not fill with fuel looked as if it were shooting some bubbles up(air) could it be outta of fuel???
View 10 Replies
2004 F-250. 6.0 I was driving down the road when the engine dies. It was like I had turned off the key. When I tried to restart it, it was no click, no starter sound, nothing. The glow plug light remained on, even while turning the key over. What could cause this?
View 10 Replies
I have 03 f250 v10. just replaced the engine and got everything all connected and started it up and it idles great...the problem is that when you press the gas pedal it starts to drive but then it looses power and acts like its missing. cant get it to go 30 mph. While keeping it floored eventually it gets up to 2000 rpm and then starts to pick up speed.
View 14 Replies
2002 7.3 powerstroke, no info about service or work done, looks to have a new hpop, know for sure that there was a new lpop installed, claims no gouging in front cover, died going down road oil pressure gauge on dash dropped and was taken to a shop and did not get complete diagnosis, where should i start? Shop drained oil to take sample and no metal shavings or flakes were present according to them...
View 3 Replies
I have a 99' f250 I purchased a few months ago. Here's what happened. Today I was driving down the road and it started to surge. I pulled over and shut the truck off. When I went to start it, the motor turned over slow for a sec and then clicked. When I put a jump pack to it, it fired up. I took it home with the jumper still hooked to it and checked voltage. The alternator was throwing 33.4 volts!! I went to the auto parts store and bought a new battery and alternator. Now the battery shows 11.7 volts steady. The alternator still reads 33.4. Also, if I unplug the positive lead while it's running, the truck shuts off. And one more thing. If the key is off and I reconnect the positive lead, I can hear the fuel rail pressurize. What is going on? I hate electrical gremlins.
View 6 Replies
2000 Super Duty 2wd. My truck has a lot of slop and wanders down the road. My rotors are also warped and after they get warm they shake like crazy. So I plan on new rotors, bearings, calipers, pads, dust caps and rear rotors, calipers and pads for the rear. I will also be doing factory wheels and new tires and shocks all the way around.
My questions is to rebuild the front suspension and do it to last what all will I need? I see some moog kits but I do not think they are complete for what I need. I only have 126,000 miles with a sound motor and tranny so I feel she is worth it. I know how to work on the truck but the suspension is my weak spot. At 126,000 miles I feel it is a good investment
View 10 Replies
It's an 02 f250 4x4 crew with 7.3, 6 in lift and 35 in tires. It has all ways wandered a little bit and I just accepted it. I changed everything in the steering from ball joints, tie rods and drag links less than 2000 miles ago. Everything still seems good and tight. Recently it has gotten a lot worse so I checked again and everything seems to be tight. Where to or what to check next? It's to the point I don't feel safe letting my wife drive it and I don't enjoy driving it.
View 7 Replies
Driving down the highway, battery gauge read fine power, but battery light came on. In a remote Alaska situation so I couldn't diagnose, plus truck is new to me. Kept driving towards civilization. All gauge dropped. Then lights dimmed, then truck died. This was over about 15 miles. At night with lights on. Truck has a plow with plow lights, aftermarket cranking stereo which I was using, heater on (Alaska). It sits 70 miles up the highway from where I'm at getting ready to go back and work on it. So...
Of course first thought it is the alternator, not providing enough power for all this. Looked inside, it is a newer looking reman. Belt is fine. My question is, if not this, what else could it be? I'm hoping to haul the alternator and whatever else out there and get it going without having to drive back and forth for more stuff I need. I can always return stuff I don't use. Probably I'll throw a new battery in it as well. But after that, anything else I should be thinking/ready for?
View 4 Replies
My truck ran and drove then I changed my Steering Gearbox. After all that, I went to go start it, the trucked cranked and the batteries died. Hooked up the charger then and nothing, No start no crank. F250 2006 diesel 6.0 ...
View 14 Replies
I have a 2003 F250 5.4 auto trans and I live in Minnesota where it has been -15 and my truck won't go. It has only half power it acts like its cutting out and it won't even hardly move in Drive if I put it in 1st or 2nd it will go or reverse but the engine is only half power the OD button is flashing the check engine light came on and I pulled the codes and there is 7 of them. I think its electrical issue but don't know where to start! Here are the codes, P0443, P0750, P0755, P0743, P0135, AND (P1747) which my book doesn't go that high?
View 7 Replies
My 2003 6.0 truck lost most of its power. It has the SCT programmer. It used to run great it would roll coal really well then it slowly started to run worse. Now it runs really sluggish especially when its cold. IT takes forever to warm up. On the freeway when ur going a constant speed it bucks and jerks a lot. It won't roll coal anymore and just runs like crap. A mechanic said I had 3 bad injectors. But I don't believe it.
View 2 Replies
I started up the truck. It cranked perfectly as always. Was half way out of the parking lot going give mph and a warning beeping started with a message "stop vehicle safely". I did and the engine died. When I try to crank it it will not turn over at all. No power to engine at all.
View 5 Replies
I was driving from home to work the other day and it was 6 degrees out. My heat was working good and everything was fine and then all of a sudden the passenger side started blowing cool air. Not cold not warm. Driver side was still hot. It is a lariat and has dual temp zones. Everything I read everyone says blender doors but what would make it stop working out of no where when everything was fine. Occasionally when I start my truck and turn the heat on it makes a popping noise under the dash when the blower kicks on. But it has done this since I owned it an never had an issue. It's 25 below today and I would really love to have completely functional heat. It's an 2008 f350.
View 14 Replies
2005 F-350 6L diesel .... Put new batteries in it a week ago.
Been running good then the radio quit a couple of times. It came back on after truck was restarted. This morning I go to town and the battery light comes on. I stopped and started about 5 times and on the 6th it wouldn't start.
I got a boost and started home it , started to try and quit when I was almost home. Was so dead the power windows wouldn't even work. Have it on the battery charger now and it starts right up but the battery light is still on and the ABS light is on.
View 6 Replies
So I went to start the truck this morning around 8:00 and it was 7 degrees outside, when the truck started the oil light came on and oil gauge was on low? So I turned it off right away. few hours later I tried it again and still nothing I thought maybe the oil was frozen. After I started the truck the oil was higher on the dipstick so I am assuming the oil pump is functional. What could be causing this? Could it be the the gauge is not working? The truck is a 2000 F-350 V-8 5.4 gas. I'm hoping it is something simple I am suppose to work this afternoon
View 14 Replies
We have replaced 4 fuel pumps on a row.
Voltage is good...even ran a fresh circuit.
Ran new supply lines
But, can't seem to understand the continued drop in pressure. It usually takes about a day of driving to crater after a new pump/filter is installed.
It never dies, just loses power and drops the truck to an idle. Funny thing...if I shut the truck off and turn it right back on...full power for a short period!
The truck is used on a ranch that has plenty of rough roads...thought inertia switch maybe but i believe that would stop fuel completely right?
I am totally stumped and so is the mechanic.
View 5 Replies
I replaced a rear rusted brake line a couple of years ago. It rusted where the line met the bracket. I'd never done this before but bought a flare (flaring?) tool and fixed it.
This week the longer line that runs down the length of the truck started leaking. It looks like the line was once held in place by a small bracket just in front of the rear wheel but it wasn't in that bracket anymore. I guess it rubbed against the metal and water/sand rusted it out.
A local garage said they'd need to drop the fuel tank and estimated that it would be several hours (and hundreds of dollars) to do the job. It looks like I might be able to cut the old one out and then fish the new line up through there and replace it.
Also, what is the diameter of the line? It is a 2004 F350. I can certainly cut it out first and then take a piece of it to the local auto parts place to get the replacement line.
View 9 Replies
