Ford Super Duty (1999-2016) :: 2003 - Front End Vibrates - Steering Or Suspension?
Sep 29, 2016
2003 F250 4x4 5.4L with 35" off-road tires.
My problem is my front end started vibrating and got worst over the last 2 months. I noticed my front tires were wearing very oddly. Not the way they would if it were out of alignment. I checked the ball joints and the tie rods and all seem tight. There is no play in the ball joints or tie rods. Now I have noticed that I have play in what I think is coming from my steering gear box. I can wiggle the steering wheel and can hear it rocking but it's not from the gear box down. Could that be the problem or am I missing something. Also when turning out of a Parking lot that has a good angle to it I do hear a pop quite often but have not been able to locate where it's coming from other than it's in the front end somewhere. I just rotated the tires so now the front tires are smooth and worn evenly but I still have vibration just not near as much. It's hard to see in the pics but there's like lips on the end of the tread. The ones that were on the back are smooth and not worn like these.
View 13 Replies
Advertisement
Im working on a 03 f-450 that has a front end vibration, it starts when you hit 25 mph and its a humming / vibration that seems more to the passenger side than the drivers side. You can also hear it decrease when you come down in speed and it dissappears below 25 mph. Its a 2003 F-450 CC 4x4 DRW with the v-10.
View 7 Replies
I have a '99 F250 w/ PSD with 165k miles.
When I drive, I move the steering wheel and nothing happens for the first few degrees of turn and then I encounter resistence and it turns. It's the same either way. The vehicle seems to track nicely, doesn't pull to either side, just a lot of slop in the steering wheel.
Is there a way to determine if this is really steering related or is it just loose/worn front end suspension parts making themselves known? My guess is suspension items, but the fact the front end behaves itself when the truck is moving has me doubting that just a bit.
View 5 Replies
.I just changed out all the steering linkages due to a lot of slop and worn out tie rod ends. This problem existed before I changed them but I thought for sure changing the linkages would fix it. When I brake hard my front tires wobble very bad. I haven't ever experienced the death wobble that is common in these trucks, but the symptoms seem the same, its just only when I brake hard. I can look at my front left tire while braking hard and see it wobbling. The wheel bearings and ball joints only have about 15k miles on them. I can't tell if the front wheels are moving independent of each other back and forth, or if they are both shaking back and forth together. What might cause this? it's a super uneasy feeling when it happens, especially because whenever you are braking hard there is usually a reason.
View 14 Replies
I have a new 2016 F250, few months old, loving life. I noticed a weird noise/feeling when I am making turns while going over a bumps. There is a left hand turn on my way home that I take every day at approx 15 mph. There is a dip in the road and I can feel a weird grind kinda feeling through the gas pedal and a noise from the front right suspension. Being a brand new truck, I'm not sure what the deal is, or if I'm just overly critical.
View 4 Replies
2012 truck, started making a noise today. I cannot tell what it is, but seems to be coming from the passenger front suspension, its a crunching/light clunking sound, happens when going over bumps, when the truck pitches one way or the other turning, and coming to a stop....
Truck has 6k miles, I did a quick visual inspection this afternoon, didn't notice much, but the sway bar endlink looked a bit odd though, not sure if normal, its gota little bend too it and seems to just contact the vac line mounted behind it, seemed unusual...
Maybe its its just one of the crappy rancho branded shocks is junk?
View 6 Replies
2002 F-250 7.3 4x4 ...
I have a rattling noise coming from the front suspension (both sides) when going over small bumps. Most people point to ball joints, but I find my case odd because I just replaced
Upper/Lower ball joints
Track bar
Tie rod ends
Shocks
Front U joints
Drag link
I did not touch the leaf springs or the sway bar, except to grease the links, which otherwise looked good.
View 3 Replies
I have a noise with my new (2.6k miles) 2000 Diesel F250 Crew Cab. When I make low speed, right turns while crossing any type of depression in the road I hear a loud knock as if the left shock is bottoming out. There's an intersection near my house with runoff depressions across the road, I almost always hear the noise when making that turn. I've occasionally heard it coming from the right side when making a left turn.
View 14 Replies
I have a 2016 F250 6.2 XLT CC 4X4 that is mostly stock, except I did put on 18x9 wheels and LT275/70/18 Cooper ST MAXX tires. I have noticed recently on hwy driving and even in town driving, that the passenger seat rattles/vibrates quite loudly. Obviously if there is someone setting in the seat, it is just fine.
Is this a common issue? Is there a quick fix (tightening a couple bolts or replacing a couple clips?) Or should I take this back to the dealer for warranty?
View 3 Replies
My 01 f-250 4x4 diesel has some steering wander Ive been fighting for a while. It feels like the front end is stiff and not returning right. All four spindle ball joints were replaced in the last year and a half. The tie rod ends seem to spin easily enough with a wrench but are not loose. MY question is how hard should it be to rotate the spindles with no tires or tie rods on them, wondering if my newer ball joints are too stiff and causing the wander or if everything checks out it my alignment being a little off would cause poor return?
View 14 Replies
So on my 2003 F250 SCLB 4x4, I I was driving 70 or 80 miles to Huron in Ohio, to pick up a boat for a buddy with my truck. On the way up I heard a new clattering noise coming from the suspension or drive train, and we couldn't figure out what it was. After picking up the boat and coming back home without a problem, I looked under the truck and couldn't see any U-joints loose, But I saw that my right rear backing plate was disintegrated and gone. I took the truck to the shop and they said that the noise I'm hearing is the guts of the emergency brake pads and pins bouncing around in there when I drive and that my rear wheel could lock up at any time.
View 14 Replies
My 2000 f250 7.3 has pretty sloppy steering and noise in the front end when going over bumps. I have replace the drop links, swap bar bushings, both wheel hubs including new seals and the drag link. The rest of the front end seems to be in good shape. I put it up on jack stands and there is some movement in the front end but it seems to all be in the steering box.
Steering box appears to be original with 220k miles. I went to tighten it and it appears the PO did it at least once already. Is it safe to try tightening it again? Does tightening it increase the risk of failure? I'd like to try tightening it first but not at the risk of losing steering at 65mph with my kids in the truck.
View 14 Replies
My steering is "loose", All front end parts are in good shape but I can move the steering wheel 4 or 5 inches back and forth without the wheels moving. Ball joints and tie rod ends are good. Truck only has 185000 miles on it.
View 2 Replies
I have a 02 F250 4x4 5.4. As I drive and when pulling into a driveway I hear a clunk that can be felt in the floor and the steering wheel. I've replaced the wheel bearings and seals, shocks, ball joints, sway bar links and bushings, tie rod ends at the gear box and "right hand inner". The other two tie rods are tight and so is the track bar. I cannot duplicate the sound if I jack it up and move parts around with a pry bar. I can however move the steer box sector shaft upwards about an 1/8. I've adjusted the screw but it didn't do anything. Could it be the steer box or the springs? I've even mounted a GoPro underneath but everything moves and I can't tell why it is.
View 14 Replies
I have a 2000 f350 v10 ext cab 8 ft bed 4wd,i replaced all 10 plugs all 10 coils at 40 mph the truck violently shakes an vibrates read on a few things that could be crack cylinder or bad pistons,i did a test on it an says low compression in 2 cylinders 1&2 what can I do an what is the best option for me as I just got the truck not even a month ago...
View 3 Replies
I recently replaced my Ford Factory clutch with a new LUK kit, lever, pivot & hydraulics and I have to say it is absolutely perfect. If you are going to take the time to do the clutch, do it all. While we had it apart, I decided to push up my Up-Pipe replacement and do it while the transmission is out. What takes several hours to do is done in 30 mins this way. As we all know when we start in a job, we see other things and say well while it is apart I may as well do this, and do that. I decided to do the U-joints in the rear shaft. I had marked the shafts prior to removal for orientation but my assistant did not mark all 3 U-joint knuckles when he changed the joints and reinstalled the shaft.
I took the truck out for a drive and starting at about 15 MPH all the way to 60 ( I dared no faster) it was making me nauseous. Today I looked into it, marked current locations and started rotating front and rear joint 180 to no avail. I said lets just rotate the center joint and go from there. as I was pulling the carrier i noticed a HUGE but dull yellow arrow on the short shaft. I decided to look at the rear shaft and found a HUGE but dull yellow arrow 180 degs from the front. It looks like it could have been a factory mark. I repressed the center u-joint so the 2 arrows line up and the vibration went away. I can not express the aggravation this could have caused if not for those arrows. Take the time to properly index the drive shafts, it will save you tons of time and agitation.
View 1 Replies
I have a 2003 f250 with the 7.3 power stroke in it. It is factory height on a set of 285/75 16 tires. It already has a reman steering pump and I replaced the steering gearbox today due to the truck having a little slop in the wheel. Since I bought the truck it is dang near impossible to park in a parking lot and almost impossible at a stop sign or being stopped to get it to turn whether I'm on the brakes or not it doesn't seem to make a difference. What else could be affecting the steering on the truck? All the steering components are good. I'm about by to the point of just selling the truck because it's that hard to steer. Especially trying to back a trailer is hard too.
View 9 Replies
I have a 2003 f350 4x4 lariat lifted 3 inches on 35s. I am getting a a roaring and vibration in the right side of the front end when I make a hard left turn. Don't get it going straight or right and get it more in the throttle. My mechanic and I thought it was the front right hub bearing/assembly. So we replaced it and the noise and vibration is still there and now there a shimmy in the steering.
View 14 Replies
-2003 5.4 XLT. 178,xxx Disk brakes front & back.
Driving home from work, came to a long stop waiting for train. Started to drive away and my front right brake started to lock up pretty good on me. Drove it home as I was only a couple blocks away. Its just started to get above freezing here, and we've been between 0-20 degrees for a good stretch lately. That being said, I'm pretty sure it's my brake lines swelling with our "heat wave" of 35 degrees today. Also I've replaced the rear rotors & pads, as well as flushed the brake system a while back. Never replaced the front after purchasing used a while back, as they still had plenty of pad left.
Question : Purchased new front lines. Do the front calibers, "float" on pins like the back? (If so that may be my issue of the caliber getting stuck on the pins moving back and forth.)
At 178,xxx miles I'm going to replace the lines myself regardless of this outcome.
View 14 Replies
2003 F250 4x4 7.3L
While doing my brakes in the front, I tried to wiggle the front left, nothing. Solid. Then when I did the right, I was surprised to see it wiggle when I grabbed the tire. So I looked to see what was moving.
Not the U joint, not the ball joints, But it looks like what is a drive shaft.. (I am new to this stuff). On the right side a shaft comes out of the axle just before the U joint and the rest of the wheel assy. What is wrong?
View 6 Replies
I have a bad wobble/vibration coming from front end i think i replaced hub locking hubs u joints truck dont feel safe at all took it to ford they say its normal no way its not just starting doing it few month feels like the 4x4 is in use when hitting bumps when driving if you go slight left or right it seems too make act up more.
View 2 Replies
