I've got a 2005 f350 with a 6.0 starts when it wants. I have checked the ficm and 48 volts when key is on and cranking! How do I know if my icp is bad? Some days it will start no problem but most days it will just crank over. When it does start i run it for a while shut it off and try to restart it and it wont!
View 3 Replies2003 f350 sd 2wd 5.4 auto cab chasis 40 gal rear tank (home depot truck//for real)
Wouldn't start/towed home/ran until it was parked ...
Bad fuel pump//replaced//new fuel filter ...
Starts but won't idle//will run if feathering throttle...
Code's po443/po1451/po1747/po755/po743 never had these codes before
2003 f-350 had no dash lights and no start or crank. Found battery cable junction on left fender broken fixed, replaced starter. Drove it sunday, went about 15 mi and just shut off. Towed home was a battery, replaced battery, now I have lights but turn key and nothing? Was starting fine, all summer seems like a cold weather issue. Any relays I should be looking for? I was going to check power to started but raining too hard this am ...
View 4 RepliesSo I 2003 6.0 F350 that is a Dually. Been sitting in my yard for about two years now. I turn the key it just clicks and it doesn't crank. The starter solenoid is not on the firewall so I use the trick with the battery connected positive straight to the starter with the whit The starter solenoid is not on the firewall so I use the trick with the battery connected positive straight to the starter with the wire on the engine bay. It cranked for a while and that started ran rough. Then it just died. I did not start again. I did this during winter so the engine have time to cool off it was about below freezing. Done this multiple times and drove up and down in my backyard but not on the road. What could be wrong with it. Either way I put in diesel 911 and more fuel but and I change the filters with Motorcraft OEM filters. Sure that the caps were right.
View 14 RepliesI have a 2000 f350 5.4 liter I recently fixed a misfire in cylinder 1 since then every morning the truck runs perfectly fine however at night when I leave work around 6 o'clock the truck has a misfire again I stopped pullover pull the spark plug out put the spark plug back in and it runs perfectly fine all over again I don't know if this matters but when I replace the spark plug I only replaced one and not all 8 same thing with the new coil pack I don't see how that could cause this.
View 14 RepliesI have the gas 5.4l in my 01 F250 Super Duty. I had to change out the leaking Heater hose before I could attack this other issue. The truck starts when it feels like it. I changed the fuel filter and it started fine. Then the next day it wouldn't. Later it would. However each time it does start it dies when throttled up. I am down to thinking it is the fuel pump. My question is, because changing the pump sucks about as bad as changing the heater hose. Can I install an inline fuel pump and deal with the sump pump in the tank later? Are there any Cons to doing this?
View 5 Replies2001 F250 5.4 ... I'm losing my mind chasing a Gremlin. I've been having mostly intermittent starting issues with my truck. I've had the truck for a little over a year, after someone totaled my previous one.
It occasionally wouldn't start on the first attempt, but it got really bad in the last couple weeks.
I first thought it was a faulty inertia switch or wiring in that vicinity, as at one point after manually tripping and resetting the cutoff switch it would start, UNTIL I put the trim panel back. At this point I think that may have been a coincidence.
I eventually probed the switch and it tests as it should electrically.
I put in a new fuel filter and things were fine for several days, but it acted up again. That time was last Saturday. Got it to start and all was good until tonight. Now it won't go, and I've tried so many times that I can see the battery power is dropping.
Last Saturday I pulled the relays from behind the radio and cleaned 'em up real nice. Also, just to check another variable I swapped the two that matched.
I'm about ready to change the fuel pump, but I've heard so many people say they did that but the problem was something else. Not only will it costs hundreds of dollars, its cold out and we'll have to drop the tank in the driveway.
In addition to the relay, inertia switch and fuse, I have found some mention of faulty fuel pressure regulators causing issues. I'll pry the vacuum line off in the morning to see if I can detect fuel residue on the vacuum side. (There is some noticeable corrosion on the fuel rail in that area).
I REALLY want to make sure I rule everything else out before spending hours under the truck in freezing weather dropping the tank and changing the sending unit out.
On key-on there is a noise from the gas tank, but someone else listening described it as a click but no whirring.
I do hear the relay clicking behind the radio. (Also, I pulled them again tonight and put a meter to them. With 12V on the primary side, they click and the other side shows continuity on diode check, and about .2 Ohm on resistance mode.)
I went through a lot of trouble to get my spare out looking for the fuel control module before finding out my truck is about 3 years too old to have one too. What else to check?
I have 99 f350 single rear wheels 4x4 . I went to start it this morning and it would crank but not start b/c it was cold. I plugged it in and still wouldn't start then it wouldn't even crank. I checked all fuses swapped relays and I have new batteries. The last thing I did was hit on the starter a few times and it started. So I went and bought a new not remand a new starter and put it on and now it won't crank!? I get 12v at the little wire on the selenoid on the fender. So now what?
View 4 RepliesI have a 1999 f350 7.3. Turn the key lights and fuel pump come on but the starter wont crank. I replaced the starter and checked all the fuses i could find. The only way i can get the truck to crank is by jumping the relay under the hood .
View 5 RepliesIt's a 2001 F-350 Crew cab short bed. Got it from the second owner which had a large file from the original owner on documentation and maintenance records. Truck has 280k, tranny about 80k. Question I have is, I kinda thought it would "feel" more powerful then it does. Temp got to about 35f last night after work and it cranked for about 15-20 sec before it started (yes I let the "Wait to start" light go out).
Then pulling out of work it would hardly get out of its own way. Does this sound normal? When it is warmed up it goes ok, but still I figured when the turbo winds up it would feel a bit "peppier". I get its a diesel and not a hot rod but I was expecting a bit more pep.
MODS on the truck that I can tell: AFE cold intake, 5"? exhaust turbo back, about 4" lift. Stock PCM. In cab controlled rear air bags, nice deck with back up camera.
2015 F350 6.2, 4 door 8' bed FX4...... 17,200 miles.
This morning when outside to start it (nice sunny morning) and turned the key and all the dash lights went on and also went crazy. Said it had all kind of problems on the dash, Trac system, Over heating and so on. The starter did not crank over at all. Tried this about 8 times in 45 minutes, no worky. Call Ford, they towed it to the dealer. I last drove it 2 days ago. All stock, no programmer.
I have a 2005 Ford F-350 with the V10 4x4. I was backing out of the driveway and it just died. I stopped put the truck into park and it wouldn't crank. The dash lights up and everything else works but the truck will not crank. I continued to attempt to start it and eventually it turned over and ran. It has been doing this intermittently for a couple months but never this bad. I've taken it to mechanics and nobody has been able to rectify.
View 3 RepliesWe just bought a 2000 F350 knowing it has some issues. The #5 fuse (generator/secondary) under the hood consistently blows fuses the second it's inserted, meaning there's a dead short. Truck will crank but not start. As well, theres a 5 amp fuse under the dash, which when inserted, keeps the instrument cluster on as if the key was on, even with no key in the barrel. We cannot hear the fuel pump running, the fuel reset switch is fine, all ignition wires at the column are showing 12 volts at the right times. What could be wrong? I'm a 12 volt specialist, but not a ford tech.
View 6 RepliesHaving an issue with my 04. Wife got in the truck to move it and no dome lights no crank nothing. Swapped the battery for a new one. Still nothing.
I checked all fuses. I literally was just driving it 10 months prior to her getting in it. Said dome came on for a second then shut off. 2004 F350 5.4 ....
So here's the deal, crank no start its getting fuel. Has base oil pressure and i put a ficm on that test good with a voltage meter key on engine off and cranking. I haven't hand any trouble finding info on this issue so. We can keep picking away. Just cant find anything about this.
A buddy of mine who has been trying to figure it out for me, Got it to start using a starting fluid. And it would run if someone was pushing the gas peddle but wouldn't idle. Or start without the starting fluid.
Best truck I ever had but around 200k would occasionally blow a bunch of smoke when pulling a heavy load.
My 2000 f 350 xlt triton v8 has done the same thing a couple times (about 200k miles).
The (cough) "truck expert" at my local dealer has never seen that before but its happened in 2 different trucks for me. It never caused a problem other than scaring me.
I sold the 02 last year when i got a 2011 f 250--it was 12 years and 300k miles old and never was hospitalized except for a fuel pump due to my negligence of filter.
I'm just a shade tree mechanic try to diagnose a hot crank no start condition on my 2006 F-350 6.0 that I purchased second hand about six months ago. I first took it to a diesel shop to have them fix it and the mechanic told me that the stand pipes and dummy plugs needed changing out but couldn't tell me 100% if that would fix the hot no start problem.. I have been reading a lot about this problem and it seems that the snap to connect fitting on the HPOP is the most common problem on these trucks. It seemed easy enough to do so I went after it only to find it was already replaced with the updated part.
I went ahead and changed it anyway but it obviously didn't work. So today I pressurized the system through the ICP port with my small harbor freight compressor up to 80 psi and forced the IPR valve closed with 12v. I then listened for a leak in the passenger side valve cover with a hose stuck in the oil fill cap, the driver side cover from some drain hole under the air filter housing and in the oil filter housing. I could hear a mild hissing from the driver side and the oil filter housing but it was clearly louder from the oil fill on the passenger side. This leads me to believe I have a top seal leak from one of the injectors on the passenger side, but not 100% sure. Should I be hearing anything at all from the driver side and from the oil filter housing if its a bad seal in the passenger side?
Another problem I just found out I have seems like maybe fuel in the oil. I done a oil change this week after 3500 miles since last change and drained out five gallons of oil!! The oil seemed really thin. My coolant level is still good so the only thing I can think of is fuel dilution. Could this possibly be the same o ring or injector that is causing my hpo leak or something else? Will a bubble or balloon test diagnose this?
I bought a cheap OBD2 reader that works on my Ipad with a app called Dashcommand so I can see what codes were stored. The codes are...
P0401- Exhaust Gas Recirculation A Flow Insufficient Detected (EGR has been deleted)
P0528-Fan Speed Sensor Circuit No Signal
P0670-Glow Plug Control Circuit/Open
P0683-Glow Plug Control Module to PCM Communication Circuit
P2290-Injection Control Pressure Too Low
So far my thoughts are to replace the injector and nipple cup seals to take care of the hpo leak. Once I have the valve cover off, clean the injectors real good and cycle the fuel pump with turning the key on and inspect the injectors for a fuel leak. Is there a better way than this?
So I just purchased a 2011 F350 6.7 this week...I've had absolutely no problems until I drove it to the dealer just to get it detailed...I give the salesman my key and he comes back and says it won't start...we tried numerous time to start it...put jump boxes on both batteries and nothing...had full power to all accessories but when attempting to crank it would black out on the dash screen and give me a "stop vehicle" warning....does this deal with security?....also after hassling to get rental for a hour or so,we tried agian and it fired right up?!?...also it started double honking when locking. ..is that due to the hood being up?
View 3 RepliesI have an 06 F350 6.0 and I am having long cold starts. On the gauge the ipr is maxing out at 85%. This only happens when cold and have never had a no start issue. When hot the engine cranks right up and the ipr stays in normal range. FICM has been replaced. Does this sound like needing a new ipr only?
View 4 RepliesMy buddy's 2001 7.3L F350 has had 3 transmissions. Rebuilt and used. Once the new trans is in he goes like 15 miles and then is starts shifting hard and grinding gears. What this could be?
View 8 RepliesI recently bought a 2001 f-350 xl 4 door with the 8 foot box it has the 5.4L triton v8. I was heading to a job up in northern Alberta about 10 hours away from where I live. On the drive I lost control of the truck on some black ice I was doing about 50 miles I went into the ditch but nothing crazy drove right out after. Now my truck won't do over 30 mph the engine starts to sputter and back fire I loose all my power, what's going on. At idle she revs fine but as soon as I put her into drive it's like she wants to die what can it be?
View 6 Replies