I have a 2003 f350 4WD that studders or skips only when in reverse. I noticed it the other day while plowing. The noise seems to be coming from the transfer case but only in reverse. If I go real easy it won't happen but it will happen if I gas it a little. Happens both with hubs locked or unlocked. BTW it is a manual shift transfer case and manual hubs.
View 3 RepliesInstalling a back up camera and need to locate reverse lights on driver's side at rear bumper. What color wire is for the reverse lights on a 2003 F-350 (truck in my sig)?
View 4 RepliesI just picked up a 2003 F350 4X4 5.4L it has 130k on it. It drives ok, it doesn't seem to be able to accelerate very quickly and one thing I noticed is when i go into reverse it seems to stutter or feels like it scoots a little bit.
View 14 RepliesIt seems its the 4R100 tranny non pto of course and 2wd version. I drove down the rd. after bleeding the brakes, new caliper front right, came home let it idle for about 10 min, shut her down. Went to move it about an hour later, it went into reverse no problem, then when put it in Drive it revved like it was in neutral. There was no banging, no clunking, nothing to make it seem like something catastrophic happened.
I then did a line pressure test and Reverse was fine 200 psi for sure, in drive mode however it was low like around 50 but had to rev real high to get it to 150 like 3/4 pedal and it would want to seem to go forward at a crawl but nothing more. Next I did the obvious and cheked the fluid, it was about 1/4 quart low so added a bit. The fluid did not stink and was beautiful red like new.
I then tried again... no dice same scenario. Then took off the pan, no metal chunks and virtually no dust on the magnet??? Ok so I figure maybe something with the shift valves? Took them all off and the accumulators as well, all check ***** were in place and all valves moved freely.
Now onto the the solenoid pack, checked all per manual for ohms and all were perfect reads at about 27 Ohms, except the EPC solenoid that is the big one on the pack, it should read about 3-5 ohms but this guy is about 12.5 ohms.
I spoke to a tranny shop in town and they said it would not be the EPC and that I could "unplug" the solenoid pack and It would still move forward without it but not to drive like this as line pressure would skyrocket?
Why this thing would have 200 lbs pressure for reverse and so little for forward I mean? that should mean that the pump is working great, if there was a broken something metal I figured I would hear something rubbing or banging or see some shavings? Can this be a "worn out" valve? or gasket issue?
On one of the trucks in work, the salt has corroded the truck side plug for the reverse camera in the tailgate. Because of this, the camera no longer works.
Is this part of the whole rear wiring harness, or it the tailgate plug a separate pigtail that can be replaced? If it is a separate part, what is the part number so I can order it?
My daughter came home a bit ago and told me the backup lights on my '02 F350 were on. Pretty odd because the keys were in my pocket at the time.
When I opened the door to the truck, I noticed a faint electrical smell and noticed the fan for the environmental controls was running as well.
I'm guessing the light issue is probably a sensor or something at the transmission but why would the blower be running as well?
Early last week I finally decided to try and figure out why my cruise control hadn't been working and discovered fuse F2.34 was blown. Replaced it and went through the test procedure described here: [URL] ....
No issues and the cruise is working again. I had to take it on a road trip for work the following day and didn't have any issues for almost 1,000 miles.
I drove it last night and didn't have the issue. I drove it again this morning to several places and everything was fine.
I've got a tuner with a code reader. Would something like the above problem register a code?
I've not stuck my head under the truck yet (it's cold and dark out.) What sensors I might need to check out? Is there a testing procedure available to ID the faulty component?
The battery is disconnected for the night, but I'd sure like to get this thing sorted before I hit the road for work again this week.
I installed a reverse camera to my new Pioneer in-dash nav head unit this morning. I wired (at the rear of the truck) the power signal lead to the reverse wire at the trailer connector. I also need to wire a reverse signal input into the back of the head unit. I really do not want to run a power lead from the rear of the truck to the cab. Is there a wire under the dash I can tap into, or could I use the wire going to the backup alarm that’s somewhere under the dash (if I can find it). 2010 F350 deisel, crew cab, 4WD, long bed.
View 9 RepliesMy 2005 f350 reverse lights just started to not work . So I checked the fuse and it was blown and every time I put new fuse in it blows, where to check. Sounds like a ground issue am I correct .
View 4 RepliesThe engine was just rebuilt, 7.3L diesel. New bottom end, cam and turbo also new harness for valve covers and injectors, new #8 injector(#8 cylinder lost compression). The engine cranks and idles great. Run it up to 1800rpm - 2200rpm and you get a miss or skip. Almost like the engine turns off and back on very quick, and it makes a clank noise. No codes, reading it with a OTC Genisys 4.0. I also swapped the PCM and IDM with another truck and it still does same thing. Other truck runs fine. Year model 2000 w/ 230,000 miles
View 1 RepliesOne of our trucks, 2004 F350 Powerstroke, my company truck, recently the last snow even we had, my tow haul mode would pop on and off almost evertime I shifted from drive to reverse while plowing. I didn't want it on, it just kept poping on and off. Thought maybe the button was stuck, but it moved like normal. My other thought was there is a loose connection in the shifter or column causing it to go on and off.
View 6 RepliesIve got a 04 f350 that after u shift into 4hi or 4lo when u accelerate it it makes loud clunk noise in fwd or reverse hi or lo. With hubs unlocked it still clunks. Have checked, wheel bearings, axle U-joints, and driveshaft joints all good. So I am thinking I've got issues in t-case. Popped drain plug out and wow that dex merc 4 looks nasty. So thinking I need exploded view of transfer case.
View 4 RepliesI have a 2003 Ford F-350 6.0 it's srw lariat edition it has Manual hubs but electronic 4x4 switch I have changed all fuses and relays but still the light won't come on I've tried manually locking the hubs and still nothing....
View 1 RepliesI've got a 2003 F350 CCSB SRW V10 Auto 4X4 3.73 LS diff. The tranny doesn't always go into overdrive when I get about 40 or 50, even 60. I went down the freeway the other day at 65 in 3rd turning about 2500 rpms. Am I hurting anything here? One thing I have noticed is the overdrive light on the shifter does not work. Light doesn't come on. Leads me to believe that there is a frayed wire in the steering column. Could that cause the tranny to act funny? The cruise control works, so I'm thinking the speed sensor on the diff is ok, but I could be wrong.
View 3 RepliesI bought a nice 03 F250 V10 with apx 170k on Friday... After I got home (it was about a 4hr drive) I went to back up into the driveway and heard a loud (deep) rub noise.. Sounds like metal on metal... After a few feet or at a faster pace it goes away. I've tried seeing if it changed or went away depending on how the wheels were turned but it did not make a difference. At first I thought it was coming from the hub but now I'm thinking it could be driveshaft related..
View 6 Replies2003 f350 sd 2wd 5.4 auto cab chasis 40 gal rear tank (home depot truck//for real)
Wouldn't start/towed home/ran until it was parked ...
Bad fuel pump//replaced//new fuel filter ...
Starts but won't idle//will run if feathering throttle...
Code's po443/po1451/po1747/po755/po743 never had these codes before
I have a 2003 f350 v-10 drove it yesterday to get fuel, went to start it after fueling. No start, no lights dash was gauges were acting odd, and clicking under dash from behind fuse box. did get it to start after a while, put my foot on brake to go into drive, never made it ... truck died I do have remote start system thought it was that with the brake pedal issue. disconnected complete system. no change
Had it towed, home now no nothing, connect battery and just clicking from under dash no start ? not battery, wont even jump
I have a 2003 F350 with 7.3 L. I was driving down the road the other day and my headlights suddenly went out. I kept diving with my fog lights on and several minutes later the headlights came back on. Then the next day they went out again, came back on and then went out again and they haven't come back on. I have checked all the fuses and they are all good.
View 4 RepliesI have a 2003 F 350 Diesel. When the heater is on, I can smell diesel fuel through the vent. This happens mainly when I am at a stop sign and the fan is on high. I did some research on this forum and found some others with a similar problem. The question I have is it seems like some said it was the cracked injector cups or a leak at the reservoir on top of the motor where the filter is. What I wasn't sure of was the symptoms. If it is a crack injector cup, would the smell be all the time and not just when I am stopped at a stop sign? Or would it be intermittent as well? It is definitely not exhaust smell. It smells like fuel. If it is the gaskets in the reservoir, I think I will do the blue spring replacement cause that seemed to improve a couple things based on the treads of the forum. I do see drips on the pavement every once in a while at the front of the truck towards the passenger side of the truck. Not all the way to the side near the tire, but off center on the passenger side. Is there anything that could be leaking fuel on that side of the motor?
View 4 RepliesWhat size the pitman arm nut is? And where to get one? I am lifting my truck soon and I'm going to double nut that baby on there. I know they're prone to loosening. I just wanted to have all the parts before I started.
View 4 Replies2003 f350 2wd 5.4 auto cab and chassis with 40 gal rear tank replaced fuel pump/fuel filter/spark plugs/IAC no codes
View 7 RepliesIn my 03 F-350 my radio is cutting on and off . Have figured out problem is in dash cluster. Which wire do I use to run radio to battery and bypass the cluster???
View 3 Replies