I have a 2003 e350 with a 6.0 lt. diesel and an automatic trans. The problem is when its cold there is no power ( 10 mph max ). When it warms up it does just fine. The other problem witch I think is connected is when it shifts I lose all power to my gauges and radio for a split second. I am thinking transmission but not sure.
View 2 RepliesI recently bought a van that has a hard shift problem. It is a 1995 E350 with a diesel. If I take off from a stop without babying the throttle, the shift from first to second is very hard. Second to third is hard but not as violent. What might be happening?
View 9 RepliesMy 99 7.3 has had a vibration / shake in cab as you rev up while in park in neutral around 1000 RPM -1700 mostly. Around 1500-1600 is the worst. At idle it seems fine and what you would expect from a 7.3 but then as you give it higher idle, it starts shaking cab and you can physically see seats start shaking and it all feels rough. It also translates to a vibration while driving in those RPMS down the road... It has new injectors, transmission/ torque converter, HPOP, exhaust and a whole lot more.......
View 4 Replies1999 E-350 Super Duty (figured the problem would be the same for van/truck)
Problem: Backup lights don't turn on when in reverse.
Diagnosis: Changed the fused (because it was bad) but didn't fix it. The bulbs are both good. Brake lights, turn signals all work. I understand the backup lights are connected to the Neutral Sensor Switch. To test to see if the NSS was working, I put the van in Reverse and cranked... Van didn't crank (and likewise for D, 1-3).
So I guess the Neutral Sensor Switch works. The fuse works. The bulbs are good. Haynes doesn't have much as far as troubleshooting for this issue. What should I look at from here?
I have a E350 5.4 with 200,000 miles and it ran great before winter, this spring I fire it up and it got a miss I drive it anyway it starts to clear up and now the 1289 code. Everything looks fine coolant engine temp. I wonder if you can bypass the Cylinder Head Temp sensor. I am thinking the engine management is causing the miss to cool the engine.
View 3 RepliesI had a post a couple of months ago about this E350 van I purchased with the 7.3. It would leave me stranded every few weeks and I replaced the injector oil pressure sensor and the camshaft position sensor. This truck has a intermittent running problem that cannot be pinned down to hot or cold.
It runs and idles well but sometimes during acceleration it will start to flatten out and smoke out the exhaust. Giving more accelerator pedal powers through the flat spot and the truck runs smooth. It does not do it every time. It does it hot or cold, wet or dry, city or highway, If this was a gas engine I would be replacing the fuel pump or checking a fuel starvation issue but the white smoke tells me that it has unburned fuel.
A cylinder contribution test passes fine. I monitored engine data with a Snap On Verus pro and compared oil pressures with another 03 7.3 I have and they are too close to the same. It starts fine, no issues there. It may take off great one time and buck and smoke the next. I swapped out the throttle position sensor with the other 7.3 and no change. I swapped out the injector control module and no change.
I've thought about injector Orings but I would think the problem would be consistent. I've changed engine oil, checked fuel pressure, changed fuel filter, and drained the fuel system to be sure no water is in the separator. This engine was rebuilt about 30k miles ago. If you floor the accelerator in park it will rev up, flatten out, smoke and buck for about 2-3 seconds, and then take off like normal. I pulled a trailer with it a couple of days ago and wasn't impressed at all. I have a 6.5 GM that seems to have more power than this.
I thought maybe a sticking injector and I added a half gallon of two cycle oil to the fuel to see if that might work. It hasn't. It just seems like it is flooding at a certain rpm and clears itself after a couple of seconds. There are no codes being thrown in the pcm. I am at a loss.
I have a 2006 E350 van, just recently had passenger side injectors replaced along with dummy plugs and stand pipes. I was at the car was spraying it off and noticed it started running rough, just figured maybe some water made its way into the engine bay and something got wet as it was running great. Well its stayed that way and i am getting codes p0264 and p0276. Digging around on the net seems like its ficm or wiring, ficm is 48 volts and 13.5 volts, connectors are on tight and i dont see any wire chaffing kinda stumped. hoping its not 2 bad injectors at once.
View 2 RepliesI have a 2003 F450 PSD which won't start cold. I leave it plugged in overnight and it won't start in the morning without starting fluid. I spray a little while cranking and it turns right over. It runs really rough for a few minutes but as it gets hotter it settles down and runs like it's brand new.
Once at operating temp it will start up again no problem. I changed the GPs, the GPR, the valve cover gaskets and GP harnesses, 2 brand new batteries, oil change, fuel filter, air filter. I can't imagine what the problem can be.
I know the icp sensor is bad, I checked it and it has oil in it, but it still won't start unplugged so that isn't the main problem. I noticed it has a minor oil leak, not sure of where it's coming from, but it seems to leak when the truck settles.
Need this software that would be willing to run a diagnostic on my truck? I replaced all the glow plugs a year ago and the relay a month ago. It idles really rough when it's cold (first start of the day with outside temps even at 90 degrees). It has no power for about 10 minutes. Sounds like an old John Deere 2 cylinder tractor for a few minutes. I have 370K miles on it. After it warms up it runs good. Plugging it in doesn't make a difference. There is no smoke while it is warming up. I have noticed when I accelerate quickly, it blows black smoke (not heavy but when following it you see and smell it).
View 4 RepliesThis morning while driving cold a fuel leak started on my truck it's a very heavy leak wondering what are the most common leaks on an 2003 F250 6.0L are so I can start there.
View 3 RepliesI have a 2010 F250 with a 5.4 gas. I wondered if a CAI would increase power and gas mileage. I have a friend who put one on his mustang and it worked a lot, especially with power.
View 7 RepliesThe truck I'm working on is a 2003 f550 with a 6.0, and 382000 kilometers. My service truck died on me couple days ago, while running. As I rolled to a stop, I noticed that my temp gauge on the dash dropped to cold. (Truck was hot). Tried starting, and I have a crank, no start situation.
After towing it to my shop at work, I hooked it up to my scanner, and found that the pcm will not communicate with the scanner (otc genisis). I have no injector buzz with key on, wait to start light comes on for an abnormally long time. I have 48.3 volts on the ficm,(4 screw), and haven't been able to find any chafed wires as of yet.
I have an 03 f250 6.0 150k milage and lately my A/C has not been working at its best. Its intermittent, and for some reason it will work fine until i get on the highway and it just blows hot air. Would this be a leak or clutch issue? One thing I have noticed if my oil/coolant is above 200 the A/C will blow hot air but not return to cold when the temperatures return to normal. I haven't done any trouble shooting so my first thing ill check are the fuses. As far as the compressor goes its an alien object to me I have never had A/C issues with any vehicle i have owned.
View 6 RepliesI have a 2003 F250 5.4 auto trans and I live in Minnesota where it has been -15 and my truck won't go. It has only half power it acts like its cutting out and it won't even hardly move in Drive if I put it in 1st or 2nd it will go or reverse but the engine is only half power the OD button is flashing the check engine light came on and I pulled the codes and there is 7 of them. I think its electrical issue but don't know where to start! Here are the codes, P0443, P0750, P0755, P0743, P0135, AND (P1747) which my book doesn't go that high?
View 7 RepliesI've got a 2003 6.0 that's got a rough idle and low power situation. Doesn't matter hot or cold it has a hard start issue but when it finally starts it has a rough idle, sometimes it has low power on take off but not always. FICM has 48.8 volts coming out, exhaust just had a new y-pipe (had a cracked bellow) absolutely no smoke coming out. When I drive it hard it's like a rocket no rough spots just did oil with filters and fuel filters, blue spring upgrade, and cleaned out the turbo.
View 2 RepliesI have a 03 F-250, 5,4L / AT trans, FX4 4X4 with power Windows/Locks/ Mirrors. I recently had a problem with my windows and radio wouldn't work. When I would start the truck the windows wouldn't move and the radio wouldn't work. (Noticed the clock wouldn't even light up indicating no power). I was reading on here about the battery saver relay could be the problem and found out it was, so that is fixed. However, before I found this website I went to hook up my truck to my code reader/ diagnostic computer and it gave me the error code of no power from the OBD-II port. I made sure everything was fine on the code readers side by using on a different vehicle. I recently installed a trailer brake controller but that uses a cable/plug under the center of the dash.
View 2 RepliesI can't seem to get the engine temp to middle range on the marker, but yet my heater blows "to me" hot air. Even while sitting in idle for extended amounts of time I cannot get it to "operating" temperature. I would think if my thermostat was stuck open my heater would blow either cold or slightly warm air. I have the 5.4L engine with knn air filter and no cats.
View 14 Replies2003 F350 6.0L ... 171,000 miles ... 5,100 since oil change 15W-30 at the shop ...
I was driving on the interstate (50 miles of driving) struggling to maintain 70-75 mph at 2,200RPMs. I would accelerate and RPMs would go up to 3,000 but no speed. Before I could pull off speed slowed to 50 before dying. Sat on the side of the road 30 minutes before I could get it started. Had to give it gas. No misfires just quietly started. Couldn't go over 30 mph. Towed it to my destination 135 miles.
Volts on 7Pin FICM read fine.
Checked the fuel fulters. Air Filter. Tank for debris. Nothing.
My coolant reservoir was lose and I noticed a lot of coolant in the driverside front wheel well and down the left side of the undertruck. Reattached after checking FICM. Hope that was all it was cause I couldn't find any leaks.
I had Planned to have the oil changed before the return trip before this all happened. New to Diesel engines but I like a challenge. Where do I go next?
I have an early 03 f350 with a 7.3 liter 298,000 miles on it
Replaced fuel filter
New oil change and filter replacement, New icp sensor .
Deleted the baffle and installed a cone air filter with the air sensor installed in the neck .
I Was driving home one day and the truck just slumped into this huge power loss . Couldn't get over 2200 rpms and barely made it over 30-40 mph.
Truck in park - idles like crap and still won't go over 2200 rpms when holding the pedal to the floor . And it has what sounds like a miss at a struggling "full throttle" (22-2500) rpms - thought it could be my icp sensor - replaced it -- no change
Checked driver side wiring harness -- no damage chafing found -- did a fuel can to pump test no difference - and today after I reinstalled the fuel line right after I ran my can to pump test I let the system prime . Started the truck and it ran for about 40 seconds and died and wound not fire back up and would just miss and spit and sputter -- lots of gray smoke though- but it fired up a few hours later after I let the batteries sit on charger .
Now before all this happened - I noticed the truck had a bit of a gutlessness to it as I would be piddling around around town and it would have this hesitation in power kind of like a slight jerking feeling , now this truck was so gutless since the day I got it ,I couldn't even burn out on a gravel road without the throttle going limp and the check engine.
Light kicking in so I figured I'd give it a bit of hotshots secret and see if It would maybe flush the injectors but it really made no difference...
I've got a 2003 F350 dually and wanna add more power that won't break the bank. What are some cheap things to do.
View 8 RepliesOn a 2003 Ford Superduty, 4x4, 5.4, supercab; where is the fuse for the power seat?
View 11 Replies