Ford Super Duty (1999-2016) :: 2002 F350 V10 - Truck Seems To Shudder Between 40 And 60 Mph When In OD
Feb 28, 2014
My truck seems to shudder between 40 and 60 mph when it's in OD. If I turn off OD it seems to go away with the increased rpm's. Although I can't be sure if it genuinely disappears or if I just don't notice since I'm at 2100 rpms instead of 1500. Trans fluid is clean. Is this a common problem in these trucks? Just filled up from flat E the same day air temps about 4 deg. Truck was fully warmed up. Does this sound ignition related, tranny or fuel related?
View 14 Replies
Advertisement
Ok so some one locked my hubs and put the truck in 4x4 4low i assume my aunt was driving it, truck wouldn't shift from 2 to 3rd is this normal since its in 4low. The shifter also seems pretty stiff and 4wheel isn't used much if there a way to know if 3rd gear toon a crap? Trans fluid seems fine not dirty or burnt...
View 1 Replies
I have a 2002 f350 5.4l that has stalling issues, first some back round. Last week I pulled up the a stop light and the truck stalled I figured it was a iced fuel line as it was very cold so I put a bottle of drygas in the tank. Evidently there was a lot of moister in there because as soon as I started the truck check engine light came on and truck would not idle at all. I got through that tank and am now on my second tank. It is better but the truck will still stall when stopped at light (has never stalled in park or on the road only while stopped in drive) the check engine also light went off halfway through the first tank. What next?
View 9 Replies
My 2015 F-350 Super Duty has a noticeable vibration between 5 and 15 mph when accelerating with my 5th wheel. The 5th wheel is heavy--around 14000 pounds. The pin weight is heavy--around 3000 pounds. The Owner's Manual says on page 191 "When driving with a trailer or payload, a slight vibration or shudder may be present due to the increased payload weight..." (This was brought to my attention by my dealer.)
Seeing the thousands of F-250 and F-350 Fords pulling 5th wheels out there on the road, I wonder how many have this "slight vibration or shudder" and what they have done about it.
View 11 Replies
Truck is 2011, F350, 4x4 CC Long box with a 6.2, 124,000 km on it. Was driving home last night towing my jet boat when I heard a sudden noise from the front end, kind of shudder, first reaction was a flat so headed to the curd. No flat, nothing running hot, no play in wheels, all looked good underneath the front end. Pulled out and drove away, got about 15 km and it happened again, looked all around nothing obvious so pulled out and drove home (25 km) no issue.
This morning wanted to investigate further. Drove truck down the block and heard a definite rotating type sound. Not a grinding more like a scrape sound. After a minute it went away. Went into a parking lot and drove in tight circles but no strange noise. Found that the auto locking hubs were not working but hub would lock in manual. No strange noises with hubs locked in either.
Jacked up truck rotate front wheels, no sound and no play or wiggle on either side. Pulled the hubs and the passenger side had water in it. Hub was not rusty but it didn't look as good as the other side. Not sure how water got there as I have never driven in water, although I am not original owner but have had it two years and put 25,000 km on it. Could the water have gone in deeper and caused a bearing to fail?
View 2 Replies
I have this bucking a jerking when pulling my Sundowner LQ horse trailer, primarily in the 40-50 mph range. I can let off throttle and it stops but resumes unless I feather the throttle.... 2008 f 350, 4WD, 6.4, 48k miles....
View 1 Replies
All the sudden got home and now my truck wont go in park. All other gears are fine. My PRNDL on dash has always been off for the last 3 years park has always shown as reverse its never affected anything! I already checked the torq. bolts and that was not it. My shifter is very sloppy so is my steering wheel. I found a 00 whole steering column with wheel and shifter but its not a early 99 will it work or fix my no park. The guy didnt know if it would fit early 99 or my no park problem.
View 2 Replies
I have a 2000 f350 xlt and it has been very good until now. I can be driving normal and stop and park, when I get in and try and start it , it acts like the neutral safety switch is not working. the key turns and all my dash lights work, radio works, everything but the starter. I have to put it into neutral to get it to start. then after I stop again, it works fine. I don't get the problem all the time and I can't find a neutral safety switch.
View 8 Replies
I have a 2012 Ford F350 I've been looking to install a compressor on. I've poked a hole in the gasket that runs wires through the firewall and cut the tips off of a couple of the accessory wires. Went to go get some more parts and now the truck won't start! The lights and radio turn on when the car is turned on but the starter doesn't even click when I try to start it. What should I look at?
View 7 Replies
i have a 01 Ford F-350 7.3L quite and won't start I have replaced the ipr valve and sensor and the crank sensor and the truck still won't start...
View 1 Replies
So I went to start the truck this morning around 8:00 and it was 7 degrees outside, when the truck started the oil light came on and oil gauge was on low? So I turned it off right away. few hours later I tried it again and still nothing I thought maybe the oil was frozen. After I started the truck the oil was higher on the dipstick so I am assuming the oil pump is functional. What could be causing this? Could it be the the gauge is not working? The truck is a 2000 F-350 V-8 5.4 gas. I'm hoping it is something simple I am suppose to work this afternoon
View 14 Replies
I have a 1999 Ford F350 5.4L 4x4. I had a check engine code on my truck a couple of months ago. The truck was running fine then. The light went away and I forgot about the issue. In the last week the truck began to run like crap; hesitation during hwy speeds. The truck is running with hesitation in 3rd, 4th, and 5th gear. In low gears the truck seems to run just fine. I have changed the EGR valve as well as the fuel filter. Check engine light is not on but the problem has not gotten any better.
View 3 Replies
We just bought a 2000 F350 knowing it has some issues. The #5 fuse (generator/secondary) under the hood consistently blows fuses the second it's inserted, meaning there's a dead short. Truck will crank but not start. As well, theres a 5 amp fuse under the dash, which when inserted, keeps the instrument cluster on as if the key was on, even with no key in the barrel. We cannot hear the fuel pump running, the fuel reset switch is fine, all ignition wires at the column are showing 12 volts at the right times. What could be wrong? I'm a 12 volt specialist, but not a ford tech.
View 6 Replies
I recently bought a 2003 f350 7.3, I ordered a tuner for it and tried installing it, at one point while the ECM was still connected I did something and it sparked. Then the powertrain relay (302) started clicking really fast. It clicked in the on position. I switched it with another and it was also clicking. So since I sparke the ECM I figured I messed it up. I ordered another one and it's doing the same thing. Then I pulled fuse 45 (which was good) and put it back in. When I turned truck to on position it wouldn't click anymore, but it still won't start... What it could be? OV ruled out the ECM, powertrain relay (302) and fuse 45, I don't know what else to check.
View 2 Replies
I am looking at a 2016 F350 that I found on a local dealers lot. It has most of the options I wanted MINUS the Rearview Camera.
It is an XLT Reg cab so I do not have the display screen (When built with this option installed, the display would be in the rear view mirror, not the display screen.)
So I am wondering if it is even possible to add this option after the truck was already built and have the dealer install it? Or is it one of those options that would have to be done before build/assembly?
View 10 Replies
I have a 2000 f350 v10 ext cab 8 ft bed 4wd,i replaced all 10 plugs all 10 coils at 40 mph the truck violently shakes an vibrates read on a few things that could be crack cylinder or bad pistons,i did a test on it an says low compression in 2 cylinders 1&2 what can I do an what is the best option for me as I just got the truck not even a month ago...
View 3 Replies
I have an 07 350 6.0 was plowing last night toward the end of the night i herd a popping coming off the front end of the truck. My esof does not work so I manually lock the hubs and then turn on the 4x4 from the dash when I want 4x4, ok so after the few pops I heard while slightly turning I straightened out and all seem ok till I pulled outta the parking lot started driving and i had a noise kinda sounded like driving on a flat while at speeds at around 25-35mph so I got out unlocked the hubs drove it and it drives fine unlocked. so what I've done so far is while hubs unlocked climbed under it spun the front driveshaft by hand and spins freely. When the truck is rolling with no issues i locked the hubs left the switch in 2wd turned the wheel and started to make a turn and POP loud and shakes the truck violently it feel likes the steering and the truck is binding when trying to turn.
View 4 Replies
About 6 months ago my 4 wheel drive stoped working and I wasn't worried about it because I never used it. I did mess around with it allitle bit to try and fix it the one time I did need it. Long story short I was involved in the floods near Houston these past few days but my truck was never in more than a a foot of water. I went up the store and grabbed a few drinks and went home. tuesday when I went to get in my truck to head back to college station for school it was stuck in 4x4 low. whick puzzled me because my 4 wheel drive hasn't worked in a good while.
When I turn the key on there is no 4x4 lights that come on momentarily and when I turn the 4x4 switch still no lighst come on. Again its been this way for 6 months. I tested the two relays under the hood and both of them have power. there is no power going to the switch in my dash and no power going to the solenoid on the transfer case. Wich is why I am confused on how it went into 4x4 low. I assuming it is in 4x4 low because of how fast the tranny shifts and I know its locked because I cant turn my front drive shaft while in neutral. The hubs are unlocked. I just printed out a shematic and am gonna try to figure out why my 4x4 isn't working.. to hopefully fix it so I can get my truck out of 4x4.
View 5 Replies
I recently bought a 2002 F350 and so far, the only issue I've had with it is I can't find out why the ABS light is on. I've looked around and found that it's probably caused by the speed sensors. But this is where I run into issues. From what I've seen, a bad sensor will generally give a reading of 0 ohms, but none of mine do. The rear diff sensor gives me ~1800 ohms, which I believe is OK.
The front driver side reads about 700 which is I know is a little lower than it should be, and then my passenger side reads ~42 mega ohms. Both the front sensors kind of threw me off since what I've read says they should all read about 1200-2500 ohms. Any other things I should check or should I just go ahead and replace both front sensors? I've just looked around and have barely been able to find anything about the front sensors.
View 2 Replies
Just completed the rebuild on the front end of my 02 f350 and of course I had to take the abs sensors out, everything is good but now my abs light is on. Is there a method I can use or do i have to hook it up to scanner and erase the code.
View 1 Replies
I bought a 2005 F350 in January of 2012. At the time of purchase, I noticed that the truck seemed slow to turn over. I talked the dealer into installing 2 new 750 CCA Ford batteries at the time of sale.
I have put less than 7,000 miles on the truck since the day I bought it. In August of 2012, I went to start the truck and the batteries were completely dead. I charged them, started the truck, and the next day the truck was dead again.
I took the batteries out, and took them to the dealer. They replaced both of them under warranty. They said that after they charged them, each tested at less than 85 CCA.
In July of 2013, the same thing happened. I used the truck one day, and then the next day the batteries were completely dead. I had them tested at the dealer, and the passenger side battery failed the test. The driver's side passed. They replaced the passenger side under warranty, again. This time, they also cleaned all battery / ground connections and tested the charging system. Everything passed.
Last week, I went to start the truck. Same thing again. Took the truck to the dealer, and both batteries, after charging, failed the test. They replaced both batteries under warranty.This time, on each battery, the dealer had written with yellow paint pen on the batteries AND on the radiator shroud "BATTERY NOT UNDER WARRANTY."
I asked the dealer about this, and they said that since they have replaced 5 batteries in the truck, and since it has 152,000 miles on it, the warranty is no longer valid. I argued that since they have checked the truck thoroughly, and found no issues with the charging system, they can't void the warranty like that.
So, what is the reason why the batteries would fail like that, and that frequently?
View 7 Replies
