Ford Super Duty (1999-2016) :: 2002 F350 - Park Brake Light And Chime Came On
Aug 3, 2016
My 2002 f350 diesel recently started acting up, the first sign was when my park brake light came on and the chime came on. I mucked around with a few things but still wont go away, while I was doing this a buddy noticed i had no brake lights at all and under further inspection no signals either, not even the clicking noise you usually hear also the cruise control has stopped working as well as the little screen mounted to the roof near the rear view mirror. I am fairly clueless with electrics (I don't even own a multi meter) but i do want to figure this out, i have noticed that fuse 20 was burnt and after replacing it it pops pretty much right when i push my foot on the breaks or signal.
View 10 Replies
Advertisement
I have a 02 F350 V10 4x4. Tonight I went out to go to a friends house and the truck started fine but when I push in the brake it will not release the lock on the shifter. You can hear a click noise when you push in the brake pedal.
View 14 Replies
2002 f350 5.4L
No rear running lights or brake lights
No third brake lights
Headlights work
No signals or hazard.
I have power to the multifunction switch when I use a jumper wire to bypass the switch I can make the lights come on depending on which slot I put it in. I replaced the multifunction switch twice just to see if I got a new bad one the first time, but to no avail. I cant run my truck a night without the lights.
View 2 Replies
I recently bought a 2002 F350 and so far, the only issue I've had with it is I can't find out why the ABS light is on. I've looked around and found that it's probably caused by the speed sensors. But this is where I run into issues. From what I've seen, a bad sensor will generally give a reading of 0 ohms, but none of mine do. The rear diff sensor gives me ~1800 ohms, which I believe is OK.
The front driver side reads about 700 which is I know is a little lower than it should be, and then my passenger side reads ~42 mega ohms. Both the front sensors kind of threw me off since what I've read says they should all read about 1200-2500 ohms. Any other things I should check or should I just go ahead and replace both front sensors? I've just looked around and have barely been able to find anything about the front sensors.
View 2 Replies
Just completed the rebuild on the front end of my 02 f350 and of course I had to take the abs sensors out, everything is good but now my abs light is on. Is there a method I can use or do i have to hook it up to scanner and erase the code.
View 1 Replies
I have a 2002 f350 7.3 PS that every time I touch the brake pedal it blows the #6 fuse(trailer tow brake/turn signal). I need to use my trailer.
View 14 Replies
Pulled into parking lot this morning, 05 F250 CC 4x4 V10, truck starts dinging at me, Park brake light comes on. Ease off of gas and idle around to parking place, no sign of brake drag. Release Park brake, no difference, set the brake and release, no difference, guess the microswitch went bad. Not raining, never hit a bump, MAY have had my foot on the brake, but that shouldn't effect the P Brake.
After setting for the 12 hour shift, all is good and well. Did not come back on.
Where this switch is? Is it under the cover by the foot set or under the truck along the cable? Would like to know where to look next time this comes up. Did have 2 new tires installed on the front a week ago, new tierod and aligned at the same time.
Just wondering and curious, my last F150 had all kinds of electrical germlins in the windshield wiper arm.
View 8 Replies
My buddy has a 2002 F350 CC Longbed with a 7.3. Last night the overdrive light started blinking. He said he drove it today and it takes about a mile or so for the light to come on but then it is a steady blinking. Truck has about 254K miles on it. He said other than the blinking light everything seems normal. How to figure out what this issue may be?
I got AE hooked up on his rig.
When I pull (ALL) codes this is what I get:
When I pull (Current) codes I get this:
I tried to clear the code and the light stopped blinking, but he said it started blinking again on the way home.
View 2 Replies
I have a 99 F350 with a 7.3 diesel that will not shift into park.
View 10 Replies
All the sudden got home and now my truck wont go in park. All other gears are fine. My PRNDL on dash has always been off for the last 3 years park has always shown as reverse its never affected anything! I already checked the torq. bolts and that was not it. My shifter is very sloppy so is my steering wheel. I found a 00 whole steering column with wheel and shifter but its not a early 99 will it work or fix my no park. The guy didnt know if it would fit early 99 or my no park problem.
View 2 Replies
Having a problem with my truck and I'm stuck. About 9 months ago my 4wd stopped working. Turn the switch and no light or noise. I took a look at fuses and everything was good there. I let it go but now I need 4wd. Today I checked every fuse and all of them were good. I moved to the relays checked them and they were good but for the heck of it replaced them. Checked for power at the pins. The one that needed power had power. Next I went to the switch had 12 volts there. Pulled switch and test with a multimeter and ohms were good. Went. Down to the motor and tested for power there not power to the motor. Is there anything else I'm missing Esof not working. 2002 f350 7.3 auto....
View 2 Replies
I have a 2002 f350 5.4l that has stalling issues, first some back round. Last week I pulled up the a stop light and the truck stalled I figured it was a iced fuel line as it was very cold so I put a bottle of drygas in the tank. Evidently there was a lot of moister in there because as soon as I started the truck check engine light came on and truck would not idle at all. I got through that tank and am now on my second tank. It is better but the truck will still stall when stopped at light (has never stalled in park or on the road only while stopped in drive) the check engine also light went off halfway through the first tank. What next?
View 9 Replies
I got a 2013 f350 lariat long bed. Had a flat bed put on and now my check park assist is always on.. Dealer didn't install sensors. Is there any module or anything I can do to turn this thing off?
View 1 Replies
Parking brake light stays doesn't come on when the parking brake is engaged. The light DOES come on when starting the vehicle and the gauge cluster cycles through its start up procedure. Couldn't find a fuse that would fix my issue...does one exist?
Truck is an '02 F250 w/ 7.3TD and 6 speed manual.
View 2 Replies
Ok my dome light flashes and I get a chime first three times then one and it repeats. No other error messages or codes. What causes this?
View 6 Replies
I have a 2014 f250 gas engine that i was playing around under the dash and blew a fuse no dash lights or engine start. found a defective fuse on the passenger fuse box changed it engine starts now but no brake lights and cant get vehicle out of park. is there a fuse somewhere for the brake switch ? if not how can i test to see if this is the problem.
View 3 Replies
I'm having a turn signal issue with my '02 F-250 that started this morning out of the blue. Seems that when the signal switch is set for a right hand turn and the brakes are applied, the signal will then become solid, not flash, and then blow the fuse. Evidently something with the brake light circuit is overloading the turn signal circuit and not canceling when the turn signal is activated.
Here are a couple of things I have tried to narrow down the culprit.
1) Left turn signal works fine regardless if the brake lights are operating.
2) Brake light circuit operates fine by itself.
3) Right turn signal works fine but there seems to be a back-feed of power causing the center third brake light as well as the left side rear brake light to flash in unison. If brake lights are then activated, the flash stops and becomes constant thus blowing the fuse.
4) Emergency Hazard lights work perfect but the center third brake light again flashes as well which reverts back to some type of back-feed of power. Also, if brake lights come on, flashing turns to constant light and then blows the fuse again.
I guess my question is,. does this seem like the multi-function switch needs replacing or could this be a relay issue of some sort? I don' think its a ground issue simply because the left turn signal circuit as well as the center brake light circuit are both being breached when the right turn signal is activated. Your thoughts?
2002 F-250 Super Duty 5.4 V8
View 3 Replies
My 02 diesel has started popping out of park if i do not make sure it is completely in. Is this usually just loose bolts on the shift tube or something bigger?
View 4 Replies
About 6 months ago my 4 wheel drive stoped working and I wasn't worried about it because I never used it. I did mess around with it allitle bit to try and fix it the one time I did need it. Long story short I was involved in the floods near Houston these past few days but my truck was never in more than a a foot of water. I went up the store and grabbed a few drinks and went home. tuesday when I went to get in my truck to head back to college station for school it was stuck in 4x4 low. whick puzzled me because my 4 wheel drive hasn't worked in a good while.
When I turn the key on there is no 4x4 lights that come on momentarily and when I turn the 4x4 switch still no lighst come on. Again its been this way for 6 months. I tested the two relays under the hood and both of them have power. there is no power going to the switch in my dash and no power going to the solenoid on the transfer case. Wich is why I am confused on how it went into 4x4 low. I assuming it is in 4x4 low because of how fast the tranny shifts and I know its locked because I cant turn my front drive shaft while in neutral. The hubs are unlocked. I just printed out a shematic and am gonna try to figure out why my 4x4 isn't working.. to hopefully fix it so I can get my truck out of 4x4.
View 5 Replies
I have a 2002 f250 4x4 this snow plowing truck and going to be a pain if i cant figure this out before winter sets in. number 34 fuse (10amp) blows when replaced. cruise stopped working and can not get into gear from park after starting but turn ignition switch to 1 click forward and put into nuetral then start and go on about my business? Cruise recall completed in 06, brake lights work horn works.....
View 7 Replies
The truck in my sig. makes a clicking noise when it's in the park and I press the brake pedal down. The click is coming from somewhere up high in the steering column. It doesn't make the clicking noise in any other gear only in park. Might be normal but I don't remember hearing it before?
View 9 Replies
