Ford Super Duty (1999-2016) :: 2002 F350 - ABS Light Is On?
Sep 8, 2016
I recently bought a 2002 F350 and so far, the only issue I've had with it is I can't find out why the ABS light is on. I've looked around and found that it's probably caused by the speed sensors. But this is where I run into issues. From what I've seen, a bad sensor will generally give a reading of 0 ohms, but none of mine do. The rear diff sensor gives me ~1800 ohms, which I believe is OK.
The front driver side reads about 700 which is I know is a little lower than it should be, and then my passenger side reads ~42 mega ohms. Both the front sensors kind of threw me off since what I've read says they should all read about 1200-2500 ohms. Any other things I should check or should I just go ahead and replace both front sensors? I've just looked around and have barely been able to find anything about the front sensors.
View 2 Replies
Advertisement
Just completed the rebuild on the front end of my 02 f350 and of course I had to take the abs sensors out, everything is good but now my abs light is on. Is there a method I can use or do i have to hook it up to scanner and erase the code.
View 1 Replies
My 2002 f350 diesel recently started acting up, the first sign was when my park brake light came on and the chime came on. I mucked around with a few things but still wont go away, while I was doing this a buddy noticed i had no brake lights at all and under further inspection no signals either, not even the clicking noise you usually hear also the cruise control has stopped working as well as the little screen mounted to the roof near the rear view mirror. I am fairly clueless with electrics (I don't even own a multi meter) but i do want to figure this out, i have noticed that fuse 20 was burnt and after replacing it it pops pretty much right when i push my foot on the breaks or signal.
View 10 Replies
My buddy has a 2002 F350 CC Longbed with a 7.3. Last night the overdrive light started blinking. He said he drove it today and it takes about a mile or so for the light to come on but then it is a steady blinking. Truck has about 254K miles on it. He said other than the blinking light everything seems normal. How to figure out what this issue may be?
I got AE hooked up on his rig.
When I pull (ALL) codes this is what I get:
When I pull (Current) codes I get this:
I tried to clear the code and the light stopped blinking, but he said it started blinking again on the way home.
View 2 Replies
Having a problem with my truck and I'm stuck. About 9 months ago my 4wd stopped working. Turn the switch and no light or noise. I took a look at fuses and everything was good there. I let it go but now I need 4wd. Today I checked every fuse and all of them were good. I moved to the relays checked them and they were good but for the heck of it replaced them. Checked for power at the pins. The one that needed power had power. Next I went to the switch had 12 volts there. Pulled switch and test with a multimeter and ohms were good. Went. Down to the motor and tested for power there not power to the motor. Is there anything else I'm missing Esof not working. 2002 f350 7.3 auto....
View 2 Replies
I have a 2002 f350 5.4l that has stalling issues, first some back round. Last week I pulled up the a stop light and the truck stalled I figured it was a iced fuel line as it was very cold so I put a bottle of drygas in the tank. Evidently there was a lot of moister in there because as soon as I started the truck check engine light came on and truck would not idle at all. I got through that tank and am now on my second tank. It is better but the truck will still stall when stopped at light (has never stalled in park or on the road only while stopped in drive) the check engine also light went off halfway through the first tank. What next?
View 9 Replies
About 6 months ago my 4 wheel drive stoped working and I wasn't worried about it because I never used it. I did mess around with it allitle bit to try and fix it the one time I did need it. Long story short I was involved in the floods near Houston these past few days but my truck was never in more than a a foot of water. I went up the store and grabbed a few drinks and went home. tuesday when I went to get in my truck to head back to college station for school it was stuck in 4x4 low. whick puzzled me because my 4 wheel drive hasn't worked in a good while.
When I turn the key on there is no 4x4 lights that come on momentarily and when I turn the 4x4 switch still no lighst come on. Again its been this way for 6 months. I tested the two relays under the hood and both of them have power. there is no power going to the switch in my dash and no power going to the solenoid on the transfer case. Wich is why I am confused on how it went into 4x4 low. I assuming it is in 4x4 low because of how fast the tranny shifts and I know its locked because I cant turn my front drive shaft while in neutral. The hubs are unlocked. I just printed out a shematic and am gonna try to figure out why my 4x4 isn't working.. to hopefully fix it so I can get my truck out of 4x4.
View 5 Replies
My truck seems to shudder between 40 and 60 mph when it's in OD. If I turn off OD it seems to go away with the increased rpm's. Although I can't be sure if it genuinely disappears or if I just don't notice since I'm at 2100 rpms instead of 1500. Trans fluid is clean. Is this a common problem in these trucks? Just filled up from flat E the same day air temps about 4 deg. Truck was fully warmed up. Does this sound ignition related, tranny or fuel related?
View 14 Replies
I have a 02 F350 V10 4x4. Tonight I went out to go to a friends house and the truck started fine but when I push in the brake it will not release the lock on the shifter. You can hear a click noise when you push in the brake pedal.
View 14 Replies
The batteries keep dying. I can charge the batteries and drive it to work a couple of days and by the fourth day, it's dead again. Have replaced alternator, batteries, and starter and I am still having issues. Just noticed this weekend, the instrument cluster going off, coming back on, shutting off again all while the truck had been running for about an hour. I'm not sure if it is because the battery was dying or what. As soon as we got home after the instrument cluster incident, turned the truck off and tried to start it. The battery was completely dead.
I have been looking up on sites and I keep coming across the GEM Module. I want to ask around before I buy it. I have also noticed small issues with my 2000 Excursion. Back windshield wiper starts up upon the vehicle starting. Goes a few times and stops. Not sure if this is the same type of issue as in the GEM Module.
2002 Ford F350 7.3l Diesel with 148000 miles
View 4 Replies
2002 f350 super cab 7.3 diesel, replaced alternator because wasn't getting charge to batts, Napa guy checked batts and determined no charge, replaced alt, still no charge, have 12v at alt post with engine running or not. My ? is, is there a fuse in here somewhere that I'm missing? Went through all fuses in fuse panel all good.
View 7 Replies
2002 F350 Super Duty 7.3 Diesel.Transmission trouble. Came off interstate - took foot off throttle at yield and hit gas as turn was clear. Did it fast and felt like hit wall. Immediately lost transmission engagement. Trans did not reengage until below 20 MPH. Tried to speed up and disengaged at 20 to 25MPH - just free wheel - engine wine. Went to 1st gear and would come up normally. Shift to 2nd and could get up to 30MPH and probably higher - didn't push. Shift to drive and trans disengage. No trans fluid leakage and level looks good and clean. What to look for? 126K miles.
View 1 Replies
2002 F350 7.3 intermittently wont start after I've shut it off, it runs fine but sometimes won't start when it's (warm)? Wait hour or more and it starts right up.
View 2 Replies
I have a 2002 F350 V10 and one night I turned the headlights on and when the ignition switch was turned to the off position the lights would go off. When the ignition switch is turned off the lights come back on. I changed the ignition switch but the problem still exists.
View 3 Replies
My daughter came home a bit ago and told me the backup lights on my '02 F350 were on. Pretty odd because the keys were in my pocket at the time.
When I opened the door to the truck, I noticed a faint electrical smell and noticed the fan for the environmental controls was running as well.
I'm guessing the light issue is probably a sensor or something at the transmission but why would the blower be running as well?
Early last week I finally decided to try and figure out why my cruise control hadn't been working and discovered fuse F2.34 was blown. Replaced it and went through the test procedure described here: [URL] ....
No issues and the cruise is working again. I had to take it on a road trip for work the following day and didn't have any issues for almost 1,000 miles.
I drove it last night and didn't have the issue. I drove it again this morning to several places and everything was fine.
I've got a tuner with a code reader. Would something like the above problem register a code?
I've not stuck my head under the truck yet (it's cold and dark out.) What sensors I might need to check out? Is there a testing procedure available to ID the faulty component?
The battery is disconnected for the night, but I'd sure like to get this thing sorted before I hit the road for work again this week.
View 10 Replies
My 02 F350 steering lost all resistance. I can almost spin the steering wheel to each stop. What would cause that? Recent front brake rotor/caliper/pad replacement is the only thing the truck has had done since I've owned it. (2 months now). It's way too loose to be safe.
View 11 Replies
2002 f350 7.3 ... problems started all of a sudden one day. I have an edge evolution tuner in my stroke. I have it set to make all of my shifts firm. One day it started shifting really sluggish between 1st and 2nd gears only. It don't do it all the time, but it does it more often then it doesn't. I have also noticed when i come to a complete stop and then start out again it seems that it doesn't downshift all the way back to first and when i hit the gas it seems to kinda be stuck between gears and it barely moves until i get the rpms up before it will ease its way into 2nd and the converter locks up.
It shifts a through all the other gears just fine nice and firm like it should, its just the shift between 1st and 2nd. Im wondering if maybe it might be the speed sensors or maybe the tranny filter is getting clogged up? The fluid in it is still nice and red and up to the level it should be. I just bought the truck in october and the fluid was nice and red when i bought it, but who knows if they changed the filter. I have had NO tranny problems with it up until a few days ago when this little problem started.
View 8 Replies
I was having a ticking problem with the engine under load so I went ahead and did my manifold gaskets. I had a new 5.4 put in my 02 f350 last winter, and at that time I also installed gibson shorty headers. The tech had to plug the egr port with a pipe plug. But any ways, I pulled the headers last month and I used Percy's aluminum header gaskets. I also took the time to wire wheel all of the flanges and the mating surfaces. The one on the ball and socket flange was leaking on the passenger side, so I permanently sealed it with some 1800* epoxy.
The leak seemingly went away for a week or so, but it has returned. I sprayed down all of the mating surfaces with soapy water, but I can't find the leak. It only happens when accelerating or when i downshift to go uphill. So, at my wits end, I went to try and retorque my spark plugs. I've done half of them so far. Haven't driven it yet, but i was curious as to others thoughts on the subject. This leak cannot be heard at idle, nor at any RPM while in park or neutral. It is only apparent when driving. Definitely sounds like an exhaust leak to me.
View 14 Replies
I pulled the battery cables this weekend to install a flatbed on my 02 f350, I did do some welding on the frame of the flatbed during install and the bed was in contact with the truck frame which is why i removed the batt cables in the first place, now after my project is finished i have reconnected batts only to have my gauges bounce around and an audible clicking under the hood when I try to start, gauges bounce back and forth several times, odometer comes on slowly.
2002 f350 7.3 diesel 4x4 auto
View 14 Replies
OK, I have a 2002 F350 with 160k miles that cranks fine, but has a hard time starting when it is cold. By cold I mean that it is not hot from being driven in the last 5 hrs or so. No problem starting after being at rifle practice for 3 hrs or after a trip to the store. Always have trouble starting in the morning, like this morning when the temperature outside was 49 deg. I have to crank for quite a while to get it to turn over, but once it catches, it runs like a champ. Afraid I'm going to wear my starter or batteries out because It seems like I have to crank for about 2 minutes.
I have a fairly new CPS replaced less than 15k miles ago, new glow plugs, and recently replaced the leaky bleeder valve on the bowl. This difficult starting condition came about some time before the bleeder valve seal repair, and is still doing it after the repair. This problem seems to have cropped up on it's own unrelated to any work I have done. I am using Mobile 1 5W-40 diesel oil. When the no start occurs, there is no smoke present out of the tail pipe like what you would get if you had bad glow plugs. There is just no fuel getting into the injectors.
View 2 Replies
I have a 2002 F350 with a V10, this just started happening where at times the truck will turn over but won't run... after a few times of trying to start it I pull the key out let it sit for 5 seconds then put the key back in and runs perfect..... now at the gas station the other day it started but ran like it was on 4 cylinders... I turned it off and restarted it and runs perfect. Heading to Kansas next week to pick up my boat and don't need problems....
View 4 Replies
