Ford Super Duty (1999-2016) :: 2002 F250 - Turn Signals Quit Working
Feb 13, 2017
I have a 2002 F250, 5.4 extended cab 4x4. Factory lights. I have no turn signals. They were working just fine and without turning off the truck, all 4 corners quit working at the same time, as far as I know. The indicator lights on the instrument cluster don't work. I have checked/replaced all fuses. Replaced the switch lever and the blinker relay behind the dash. The hazards do work and always have. It might be coincidence but I believe the back-up lights quit working at the same time.
View 2 Replies
Advertisement
I have a 2004 350. Turn signals quit working don't come up on dash either but when I turn the flashers on the left turn signal on come on that's on the dash and the lights. I replaced the turn signal relay that's under the radio. The old one would buzz when I turned the turn signal on but nothing would come up the new one clicks as it should but I'm still not getting turn signals lights on dash nor the light it's self. The flasher is still like it was only the left one comes on.
View 1 Replies
1999 F250 super duty. I am having a problem with the front right turn signal not working. The indicator on the dash also does not work but I can hear the relay clicking double time and the rear signal works. I have changed the bulb and fuses and went under the dash and the column to be sure a connection had not come loose. I have looked through the forums to try and find an answer with no luck. What to try next?
View 4 Replies
I have a 2000 f250 with auto/manual locking hubs and today the 4x4 quit working. The light comes on the dash and the drive shaft and u joints turn but the front wheels don't turn even when its locked in. I assume its the hubs? And when I am going down the highway about 75 the front starts making a hellacious noise but stops if I slow down is this connected?
View 11 Replies
My air conditioning on my 02 is having a issue, when you first start it and run the ac all is well and it cools perfect but then after a while it will quit working all together no more cold air, shut it off for a bit then it starts working again and repeats the process, charge is fine, been doing this all summer, it verys on how long it will work somethings for 5 minutes other times 40 minutes give or take, any thoughts?
View 2 Replies
Coming back from a trip I got a e-brake light show up on the dash then noticed the signals stopped working and the heated seats no longer turn on. I scanned it with my AE and got a brake fluid sensor error come up but nothing about the signals .... is this a common problem or is there a connection between all this? 2003 F350 6.0L .....
View 2 Replies
I own a 1999 F350 CC SRW w/ 7.3L PSD engine. My turn signals stopped working suddenly. I've checked the fuse panel under the dash but it doesn't show any fuse for the turn signals.
My hazards do work although I noticed something very strange. When I tilt the steering column down the hazards stop working and when I tilt the column all the way up they work again. Still no turn signals though.
View 1 Replies
2000 V10 F250 - daughter is using my truck and called to tell me the turn signals weren't working. She called me shortly after and said she adjusted the tilt and hazard lights came on and now she can't turn them off. I had her pull the hazard fuse to stop them. She then noticed the brake light weren't working. I don't know if the brake lights were because she pulled the fuse or she just noticed they weren't working.
A week or two ago, she said she parked the truck, turned it off and took the keys. When she came back out, the truck had rolled across the street. Periodically, over the years, I would go to start the truck and nothing happened. I would shift the gear selector in and out of drive. Then the truck started.
Finally, since I've owned the truck, the when I activated the left turn signal, the selector frequently wouldn't stay "locked" till I turned. So, are these related? Do I have multiple issues going on in the steering column. Where to start looking when she gets the truck home?
View 3 Replies
I'm having problems with my front marker lights. The turn signals work but when I turn on the parking lights or headlights they don't work. They only work with the turn signals. And I can't get the front side marker lights to come on. I've tried everything...
View 2 Replies
I have a 2006 F250 Superduty 4x4 that the brake lights hazards and turn signals have stopped working in the rear.. The middle cab brake light does not work either.. The running lights do work as well as the turn signal and all lights in the front.. I also checked the trailer plugs and both work for running brake and signal lights.. I have checked all fuses under the hood as well under the dash with a test light and i have nothing blown.. I have replaced the Brake switch as well as the flasher module under the dash and picked up a new multifunction switch (Turn signal/hazard) and that didn't work either.. I'm stumped at this point.. I have not checked the bulbs yet but wouldn't think they would all blow at the same time.. (will do this next)..
View 3 Replies
My overhead display quit working earlier this week. The truck has 120k miles. Is this display on it's own fuse? I only used it for the outside temperature readout but I would really like to get it working again.
View 3 Replies
Funny thing - had the truck in the body shop for several weeks and when it went in, everything worked. Got it back, and some of the radio buttons don't work. These are rocker style buttons, and when I push the AM (left side) that works. Press FM, and it won't go to FM. Press the right side of the tuning button, and it won't go up the dial. Press the left side, and it will go down. Same for cd. Left side of button goes backward through the tracks, but right side won't advance. Bass/treble button: Press bass (left side) and that works. Press treble (right side), and nothing.
View 2 Replies
2004 F250. Just got about 6 inches of snow. I use this truck to plow my private road. A few other residences on the road rely on my plowing.
I usually use 4WD Low and gear 2 on automatic transmission to plow. Hub manually locked. But today, when I shifted to 2, and pressed on the gas pedal. The truck was not engaging to drive, as if it were in park or neutral. And when I tried to shift to park, there is grinding noise and wouldn't allow me. I had to turn off the engine to be able to shift to park.
When I manually freed the hub and used 2WD High and gear D, I was able to drive the truck without problem.
Later, I tried using 4WD Low and gear D, and was able to drive a little distance before the truck no longer drives, and pressing on the gas is as if the truck was in park or neutral.
Previous to this earlier, I was driving down the private road to see how much snow we got. Without the plow on, I might have gone up to 10 or 15 mph, and still using 4WD Low and gear 2, maybe for 1/2 mile. Could I have damaged something by driving too fast in that setting?
View 9 Replies
I have a 1995 Ford f250 Powerstroke and i do not have turn signals, rear running lights, brake lights or reverse lights. i checked the fuses and they seem to be good but i dont want to tear everything out to check the harness if it could be a bad ground. any insight?
View 1 Replies
I have a 7.3l 02 f450. The wipers won't work on any low speeds and only on the fastest will they work. And if you switch it from the fastest to any other speeds, the wipers stop right where they are.
View 1 Replies
Recently, I lost function of brake lights, turn signals, and hazard flashers. All happened at the same time. Some threads discuss flasher relays, short steering column wiring (position of steering wheel), and fuse failures.
I checked #18 fuse and a few others. All had continuity. I assumed my bulbs were all good. My hazard push-pull switch did not feel right. There didn't seem to be engagement. At this point, there was a good chance that the multi-function column switch had failed so I decided to try replacing it. I'm happy to report that this switch was the cause of all the light function failures and now, all is well again.
Removal is done by prying the key lock switch cover off,, removing three 1" Philips head screws that attach the lower column shield to the upper shield. At that point the upper shield can be completely removed. The lower shield was not totally removed because the tilt lever was left on. The switch is attached to the column with two 3/4" Torx 20 fasteners. The upper is easily accessible and the lower fastener can be removed by pulling the lower column shield down so access can be achieved. The two wiring harnesses have a conventional harness lock to depress and the connectors pull outward from the switch. Installation is the reverse of removal, noting the dowel locator and small plastic dowel on the lower shield.
View 1 Replies
2004 F250 Crewcab 4x4 5.4 automatic.
My speedometer quit working - stays on 0, my odometer stays on 271006.5 miles. Everything lights up, when I do a gauge sweep, the speedometer goes from 0 to full blast then back to zero. On the gauge sweep, my odometer states off all the code stuff like I think it's suppose to.
Anyway, I was lucky enough to get a speeding ticket - driving with the flow of traffic, with the police officer behind me for a mile or more. Pulls me over, explain my speedo just went out, he said he can't let me off but the judge might. So I'm trying to fix prior to a court date.
Here is what I have tried so far.
1. Replaced the VSS in the axle - no change to problem.
2. Replaced the sensors on top of the tranny (2 of them) - no change in problem.
3. Sent the cluster off to a repair shop - they said it worked when it left there shop - no change in problem.
4. Replaced the battery - thought it might have a dead cell. - no change in problem.
5. Unhooked the battery, turned on the headlights, waited 30 minutes, put it back together. (did this probably 5 times) - no change in the problem.
6. Replaced the diff fluid. - no change in problem.
7. Replaced the front left abs sensor on the hub - the existing wire looked like it had rubbed on metal - possible short? - no change in problem.
So far I've just been what seems to be time and money at it with no luck.
View 12 Replies
The interior lights, radio, and power window gauges and the ignition buzzer on my 2002 F350 quit working. What could cause this? Everything else still works.
View 7 Replies
2002 F250 SD 4x4 crew cab, v10. 4x4 not working. Replaced switch on dash, not the problem. Some of told me it was the vacuum control module. Not sure where to start.
View 4 Replies
I just bought this truck and for some reason sometimes the power windows and radio will not work for awhile then it will start working. I replaced the relay on the accessory and I still have power to the dome lights and instrument cluster. I am kind of at a stand still on this matter. I have read that there is quit a few problems like this and not very many explanations to resolve it.
View 5 Replies
Battery tested good, tried jumping it as well with cables and with portable pack.
I hear two clicks under the hood (NOT a continuous type click you hear when the battery is dead). The first seems to be up near the passenger fender well when the key is turn to the start position, the second click seems to be down under the motor near the passenger side (near the starter I assume, couldn't tell very well) when the key is RELEASED from the start position. The motor doesn't budge, I don't see any belts flinch or pulleys move to indicate that the starter is engaging. I don't hear anything that sounds like a starter engaging to me.
If not, where the starter solenoid is on this thing? is it separate like the other older ford's I've owned or is it now on the starter? Is there any fuse-able links that could cause this? Wiring diagram? Is there a way to jump the solenoid like in the old school days (e.g. with a screwdriver or wrench)? would like to get this home without towing it or fixing what is really wrong with it in the parking lot.
It's in negative to single digit temps here in Indy now, I fired it up in the morning in negative temps, drove it work. Came out to go home, and now this. So something happened between this morning and now and it's not the battery.
View 5 Replies
