I just recently bought my 2002 F250 Lariat with the 5.4 and 76 thousand miles. I love this truck but I've started to notice a few things with it. When i go to start the truck it sometimes starts but then instantly shuts off. When i try it again it takes a long time to crank over. This has happened in cold and warm weather. What the problem could be and things i could do to prevent it?
View 2 RepliesI'm new to the 6.0 fords but have bought 1 its already been bullet proofed. I've put all 8 injectors in because cylinder 3 was bad. this is my issue now you can start the truck fires right up run for 30sec to 1 min and shuts of like you turn the key off starts right back with no issues and runs fine the rest of the time until you shut it off again and there are no codes. What it could be ? I have already replaced the ipr, icp, cam and crank sensors, egr o rings and the blue spring upgrade and still does it...
View 11 RepliesI have a 2005 F250 with a5.4 engine. When the engine is cold runs fine. When engine gets hot the vehicle shuts down.
View 1 RepliesI've got a 2004 f250 4x4 crew cab that is driving me nuts. It runs great, but sporadically it will just quit running. Tach drops to zero. Engine is still turning, because it usually restarts by itself as long as I am moving over about 45. If not I can pull over, put it in park and restart it. Sometimes it sets codes, never the same ones and usually not something even related to the problem (transfer case solenoid for example). Most times it doesn't set any codes. I have changed the plugs and coil packs on all cylinders. Right now it is showing the P1000 code so I am suspicious of the pcm or the wiring to it. I think the tach is the only thing dropping out on the instruments and all the instruments are powered through the pcm.
View 3 RepliesAbout 20 miles into it, and it starts cutting out on me under load, over about 1/4 throttle. I baby it a ways further, and park at a wal-mart. Idles fine, but once again, after 1/4 runs like crap, acts like it's back firing through the intake spit and sputtering. Have the wife come pick me up since I was heading to work. Decided to shut it off, and restart, and it acts like its never had a problem.
Was messing with it today, and let it warm up in the driveway. Once it got hot, same story good 1/4 throttle, past that, not so much. Shut it off, started it back up and drove it to see if there's any codes at vatozone. Drove good (laying into the throttle) for about 2-3 minutes, back to same behavior. Hooked up code reader, no current codes, and no historic codes. Although I did notice (actually since I bought the truck) that the check engine light never comes on, even at initial start up. Looking at my spare cluster, it's an l.e.d. So no bulb out I guess unless the led is bad. Truck has around 130,000 miles on it. Everything is stock.
I'm leaning toward a fuel pump, a clogged cat, or a fuel pump relay or cutoff switch problem.. It doesn't have any other issues than that, and has been a good truck for the 10k miles I've owned it... 2003 F250 5.4...
I have a 2000 Ford-F250, V10, 6.8 liter Gas. The issue is that when I try to start the vehicle it will start, but then start to idle real low and then die. If I try to restart sometime it will and sometimes you have to let it sit. I can also pump the gas and it will sometimes start.
View 6 RepliesI have a 1997 F350 460 7.5 automatic two wheel drive. I am having a sudden issue with the coolant being instantly over pressurized. Even when the engine is cold and I start it for a minute and then shut it off, the coolant comes under great pressure. I noticed this starting when coolant was being forced out of the overflow reservoir. The truck does not overheat.
I changed thermostat and radiator cap. This is my moving truck and we are about to go almost 2,000 miles with the truck full of our "stuff" (this has a 15' enclosed box on it to, like an old Uhaul). Anything I can do from my own driveway. I know it may be the head gasket but praying it is not. Lastly, do I dare take off with it doing this and just bring a lot of coolant with me???
I have a 2000 F-250 Diesel that has started acting strangely. It starts and runs well, but every once in a while the peddle just stops working. Might be a second or so and then the RPM will go up. Or you may be running down the road and all of the sudden it just stops acting like it is getting enough fuel. Same thing it might last a second or so. Sometimes it might happen 4-5 times in a row over a few minutes and might not happen again for a day. Truck does not stall when this happens. It just does not go like it should.
View 1 RepliesI have the gas 5.4l in my 01 F250 Super Duty. I had to change out the leaking Heater hose before I could attack this other issue. The truck starts when it feels like it. I changed the fuel filter and it started fine. Then the next day it wouldn't. Later it would. However each time it does start it dies when throttled up. I am down to thinking it is the fuel pump. My question is, because changing the pump sucks about as bad as changing the heater hose. Can I install an inline fuel pump and deal with the sump pump in the tank later? Are there any Cons to doing this?
View 5 RepliesI have a 2003 F250 with the 5.4 and I believe I am having a fuel delivery issue. I took out yesterday and stopped to get a drink at the gas station, came back out and the truck wouldn't start long enough to idle. It would start, barely bounce off zero rpms and die out. I checked the fuel interia switch and it was down. I tried turning the key back and forth thinking it might reset the fuel pump or something and that didnt work. I get the truck towed home and couldn't get it to start last night. I go out this morning and it starts, come home from work and now it won't. This happened about 2 years ago and I never did anything about it, but it took 2 years for it to happen again.
View 2 RepliesTruck was dead- 2001 F250 V10... Has a starter relay (solinoid) behind battery... put a new relay in there- no go- cleaner terminals... then I put key in start and shorted the 2 terminals in the relay and she cranked right up. That would mean the starter is still good correct?? something in the ignition system?
View 1 RepliesI'll try not to post an entire book.. But I bought a 2000 F250 not even 8 months ago, it did have issues before but I changed out the spark plugs and coils and it fixed it's original missing issues.. I also just recently changed the fuel filter but it didn't fix it's new problem.. It drives ok around town but if I get over 35 mph it doesn't run well... If I try to keep a steady foot on the gas but don't get the RPMs over 2000, the RPMs will stay where they're at for just a second then they will drop down and the whole truck starts shaking.. I push more on the gas and it shakes even more and the RPMs don't move at all until I really step on it.. It lacks in power going up hills as well... The dealership i bought it from said the Catalytic Converter was bad but my uncle who is a mechanic says it isn't.. It's the first vehicle I've bought so kinda wanna make it last..
View 11 RepliesI have a 2003, F250 SD, 5.0 with a weird problem no one can figure out. Now it doesn't matter what time of the year it is but after the truck sits a few days when I go to start it up it run roughs. Sometimes for a few seconds sometimes a few minutes then it "straightens" itself out. Recently it took almost a day to fix itself. No engine codes, no other symptoms.
View 4 RepliesDuring the winter, the truck would always start very hard. When it was trying to start it would pump out some white smoke. Now during the summer the truck will still start hard. At one point during the winter we were getting glow plug codes, now these have gone away that its warm. We did replace the glow plug control module, but that did not solve the hard start during the winter. We figured that there was a bad glow plug which is sorting out the rest. So we then figured the hard start issue would go away with the warmer weather but it has not.
View 3 RepliesMy truck is a 2003 f250 / 2wd automatic, 7.3 powerstroke, 284000 well maintained miles.
Just last week I sprug a large oil leak and had to replace the hoop outlet o rings..problem solved. This week I can drive 15-20 miles on the freeway and the truck starts to act like ota running out of fuel. Bogs down to 40mph then starts missing. I pull over, and when revving I have un burnt fuel and oil smoking out of my tailpipe. I let it sit for 5-10 minutes and it will be fine for the rest of the drive and this happens intermittently, there is no pattern.
The truck has a ton of power, starts great hot or cold. I did a ton of research and found a IPR could possibly cause this, as could plugged screens in the fuel pickup. Then I read about all the injector harness issues but I don't think that I my issue.
My 08, when I connect my 7-pin trailer up, bouncing down the road that message and tone CONSTANTLY going off....drives me nuts! I have went thru the wire harness 2x now, cleaned all the contacts, etc. Any other thing short of a 12 gauge? When it does pop on, the controller starts flashing...I've reached down a few times and manually hit the brakes and it still hits em so whatever it is, I feel its very minor or whatever....just don't know where to go now! All contacts have been cleaned good as well.
View 8 RepliesHaving an issue w/ my 00 550. When I lock in the hubs there is instantly a noise, More of a squealing then a grinding. The truck goes in and out of 4x4 no problem and the noise is there locked in 4x4 and not locked in, as long as the hubs are locked in. I can't tell if the noise is coming from the 4x4 driveshaft but there is no noticeable play in the u-joints or the u-joints in the front axle. I did notice when I spin the 4x4 shaft by hand the passenger side joint spins slower then the driver, not sure if that's normal or could be the problem.
View 2 RepliesI have a 2002 f250 4.2 diesel with a 5 speed manual box and i want to put a 7.3 in it. Does it fit?and can i make the 5 speed tranny fit?
View 4 Replies2002 F250 SD 4x4 crew cab, v10. 4x4 not working. Replaced switch on dash, not the problem. Some of told me it was the vacuum control module. Not sure where to start.
View 4 RepliesAt work weve got an 02 F250 Lariat CC, and the overhead console has gone out. I looked in the owner's manual, and there was no fuse listed for the overhead console. Is there anything that I can do to fix it, or should we just go out and buy a new one?
View 14 RepliesLet me start out by saying that I have exhausted every option that I have read on every thread that I could find on the internet regarding my son's 2002 7.3L not starting. What I have is no 12v power to the starter solenoid at the starter when I crank the key. What we have done so far, had the starter and both batteries tested, all good. Swapped out the starter motor fuse and the starter relay. Tried a new ignition switch and a new trans position sensor. Found major corrosion in the fusible link junction box on the drivers inner fender so we cut out the fusible links and put in a temporary jumper wire, still no crank. I have power to the dash, power on the power cable at the starter. I can jump the terminals on the starter and the starter engages. I found the shifter linkage bolts loose under the dash and tightened them up also. We have been struggling with this for 3 days, out in the lovely Michigan weather, since it couldn't have died in his parking spot in our heated shop, and I am completely frustrated. Are we overlooking something glaringly obvious?
View 11 Replies