Ford Super Duty (1999-2016) :: 2002 F250 - Running Board Lights Wiring?
Jan 18, 2011
Just bought a 2002 F-250 Crew Cab. It has the factory style running boards with the lights at each end. None of them where working so I changed the bulbs and still nothing. I decided to follow the wiring to make sure everything was good and found that neither one of the boards are plugged into anything. They both have about a 2' loomed harness with a plug on the end of each board and it is zipped tied to the frame. But there is no wiring nearby to plug it into, I have checked everywhere. I can run extra wiring no problem if I can find out where they are supposed to plug at.
View 14 Replies
Advertisement
I just purchased a '12 f250 Lariat w/ 39k miles. When I got home I noticed one of the three LED running board lights does not work on the passenger side. Can I replace this myself?
View 6 Replies
I have an 2002 F250 super duty that has leather seats. The seats are power but not heated. I bought seats out of a Harley Davidson edition that are electric and heated. They have an extra plug that my truck don't have. How can I make the seat heaters work?
View 4 Replies
The rear tail lights on my truck have been out for a while now. I wasn't doing much driving at night so it wasn't much of a bother but the new job is getting me home a little later and having to drive with my hazards on is getting old fast.
My radio wasn't working either and I disconnected it a while back hoping maybe it had something to do with my lights shorting out but no luck. It remains disconnected. Just in the past few days my front running lights have went out as well.
I've tested all fuses multiple times (and replaced a couple of them) and checked and replaced bulbs. My brake lights, headlights, dash lights and hazards all work fine. I have the trailer light hook up on the rear bumper and disconnected it at the wiring harness as well hoping it was the problem but it wasn't.
View 3 Replies
I have a 2005 Ford F-250. I have checked power to the rear harness and all is good except for the tail/running lights.
Is there a fuse for the tail lights? I have checked the manual and don't see one called out. And the relays under the hood are labeled stop lights/turn signals and those are working fine.
I will see if I can trace the brown wire from the rear harness backwards, but it may be a simple fuse.
View 3 Replies
I have a 2005 ford f250 with the factory installed brake controller and towing package,until recently all was well,I tow a fairly large travel trailer and last time I hooked the trailer to the truck I noticed the running lights on the trailer were lit, I checked to make sure that I did not have the parking lights turned on or the headlights. I did find posts about the running lights not working and was surprised to find there is a relay somewhere on the central junction fuse block that was integral to the cfb and not user serviceable. Could my problem be that this relay failed in the closed position or am I not going in the right direction in my quest to find this problem. Also looking for a diagram of where this relay is located on the central junction fuse block? I would also consider doing a work around solution rather than having to replace the entire fuse block.
View 7 Replies
I put on huge mud flaps front and rear, have the platinum running boards, spray inner fenders on rear .....thought I had it covered....getting rock chip on front of rear fenders can see impact marks on hard plastic protector and upto 8 inches above it.....thought of 3m on Monday morning but is there anything else? I think the gravel is coming off front wheel hitting bottom of running board touching off road and getting me....can't think of any other way.
View 4 Replies
I have an 02 f250 V10 with a rough idle (90K Miles). It's not horrible but it's obviously not running perfect. Everything seems ok when I am up and driving, especially at freeway speeds. I recently noticed that if the truck is in park and I run the RPM's to 1500 or 2K and quickly let off the gas it will die. It never throws any codes. So far I have replaced the IAC Valve, fuel filter, O2 Sensors, PCV valve, cleaned the MAF sensor and replaced the air filter. Plugs and boots were replaced 5K miles ago. Fuel trim levels on both banks are running around -3.1 to positive 3.5 based on what the computer is telling me. Also according to the computer the vacuum sits steady around 25 at idle (+ or - .2). I don't have a manual vacuum gauge, just relying on the computer. I've also gone around to every plug and disconnected both the injector wire and the COP wire and they all seem to equally affect the idle as well as the fuel trim levels.
View 11 Replies
I have an 02 f250 5.4. I just did the intake manifold. I also changed the spark plugs and the valve cover gasket. Following this I drained the oil and filled it with fresh oil.
It started right up but it felt like the engine was really vibrating and running rough. The check engine light than came on. I don't have one of those tools to diagnose it.
What could be wrong?
View 11 Replies
My truck has been doing this for a while now but it has progressively gotten worse from about three months ago when I went through some deep water. I don't believe it had to much to do with the water, I just think that the water is what didn't deal the situation and lead to the problem becoming more prevalent. But continuing, yesterday it got down into the high 20's and my engine started acting up (rumbling coughing, surging while at/leaving complete stops) and then it finally through a code for once and I head over to the neighborhood AutoZone expecting to get a lean code (because when the engine is acting up really badly I can unplug the fourth cylinder fuel injector without the engine acting any differently) but instead I received the p1152 (bank two lack of switching (rich)) code....
At this point I believe it is a faulty fuel pressure regulator, but without a good diagnostic obd2 reader or a fuel pressure gauge I'm not sure what to do. I'm currently in college, money is low, and I'm trying to take an accurate shot at the part that needs to be replaced so that I don't have to buy more than one part. Of course AutoZone says o2 sensor but I changed both about five months ago.. I've been chasing this diagnosis around for way too long now. (It's on a 2002 ford f250 5.4l super duty)
View 2 Replies
Looking for some info on wiring up some Day Lights Running Lights on a 2016 F250 with diesel engine? Thinking of adding LED lights to front of vehicle for day time use.
View 13 Replies
I have a 2001 f250 last night we had a good rain and this morning as i was backing down the driveway water came running down the passenger side floor board from under the dash i cant seem to find where it came from on the inside and can not find any standing water under the cowl where could it be coming from?
View 3 Replies
2002 F-250 5.4l 4x4 ... I am getting a P0171 code only, with strong fuel smell. No P0174 code. So it has to be something effecting just the one bank? Sprayed engine with starting fluid, no charge in idle. Replaced upstream O2 sensor, no change. Truck was running fine, and then just started this all at once.
View 5 Replies
I Have a 2002 F 250 That I recently changed the fuel pump. and now I'm having a tail light problem. when i start the truck, my tail lights and plate lights comes on (dim). if i turn my head lights on the truck stalls out. if i step on the brake or put the truck in reverse it stalls out. if i put it in drive it runs just fine. i checked my fuses and relays and the problem is still there even when the relay and fuse for the lights are out. when i turn the truck off all the light go out.
can't seem to find any info on this problem anywhere.
View 3 Replies
Got my 02 f350 stuck in the mud a while back and had to get a deuce and a half to pull me out (F250 couldnt do it). Anyway since then my front parking/running lights don't work.
-I have checked the voltage at the bulb socket....nada
-I have of course checked the fuse and its fine (checked ALL fuses)
-ALL other running lights are working including top clearance lights, dually fender lights, etc.
View 6 Replies
2002 f350 5.4L
No rear running lights or brake lights
No third brake lights
Headlights work
No signals or hazard.
I have power to the multifunction switch when I use a jumper wire to bypass the switch I can make the lights come on depending on which slot I put it in. I replaced the multifunction switch twice just to see if I got a new bad one the first time, but to no avail. I cant run my truck a night without the lights.
View 2 Replies
I have no 4x4 lights on in cluster when turn the key in the on position and it doesn't engage when I turn my 4x4 selector. And I don't hear anything in the relays .
View 14 Replies
Bought a 02 F250 5.4L a few weeks ago. i have replaced the coils and plugs, put in some fresh oil and some other minor things. Last weekend i drove over to my neighbors and back with no issues, until i went back out to start the truck an hour later.
The dash lights come on, but the engine wont start up. i hear a kind of whirring sound coming from a black canister under the hood on the drivers side. I cant use my code reader and I have pretty much exhausted my little piece of diagnostic knowledge. i originally thought it may have been a starter and got a fresh one ready to install but after thing about it i don't feel that's the issue.
I live in a very rural area and bringing it to a dealership would be a 150 mile round trip. What that black canister is? Why it won't start up?
View 5 Replies
I have a 1995 Ford f250 Powerstroke and i do not have turn signals, rear running lights, brake lights or reverse lights. i checked the fuses and they seem to be good but i dont want to tear everything out to check the harness if it could be a bad ground. any insight?
View 1 Replies
And now for something completely different....This just started, Close either door and the dome light and cargo light stay on much longer than they used to. Timed it and they do finally go off after about 1/2 an hour. Everything else seems to be functioning ok. I searched the forums and didn't come across anything the same, however I got the impression that there is some kind of solenoid/switch that controls this function. 2002 f250 XL 4x4 Regular cab.
View 3 Replies
I have a 2002 f250 SD v10 4x4. I had a ground wire break fixed that know noon of my instruments work. Dash lights up but nothing moves. Pulse my parking lights stay on when the truck is shut off or when I turn lights on then off. I have to disconnect the battery to get hem to shut off.
View 3 Replies
