At work weve got an 02 F250 Lariat CC, and the overhead console has gone out. I looked in the owner's manual, and there was no fuse listed for the overhead console. Is there anything that I can do to fix it, or should we just go out and buy a new one?
View 14 Replies2004 F250 - My problem is that it started with no power on LCD (the one that shows the MPG,compass and outside temperature) but if I give toc, toc, toc with my knuckles the LCD works but it went off about 2 weeks ago and stop function,the other things like the sunroof switch and the 2 lights are ok...
View 5 RepliesI know that this horse has been beaten to death but after searching all the posts and web. I have recently aquired an overhead console and wiring harness from a 2000 F250 and want to install it in my 2001 F250 which did not come with one. The connector behind the passenger kickplate is different so I assume I'll be doing some wire splicing. After reading all the previous posts, I'm unable to find old bird. Apparently he's not around anymore. Looking for the template/wiring instructions for this retrofit?
View 3 RepliesHow to remove the overhead console on a 2012 F-250 ? I would like to tap into the wiring to power my radar detector.
View 7 RepliesLike most older superduty trucks my overhead console doesn't work. I removed it and got the thing apart. Low and behold there were 4 of the resistors loose in the plastic housing. Looking for a diagram that shows the location of these so I can resolder them? My truck is an 04 lariat with sunroof which seems to be different than non sunroof trucks.
View 2 RepliesMy overhead display quit working earlier this week. The truck has 120k miles. Is this display on it's own fuse? I only used it for the outside temperature readout but I would really like to get it working again.
View 3 RepliesJust got a 2008 F-250, truck has the center console jump seat and the console lid is missing. Can you just buy a new lid or do you have to buy the whole thing? Cost? Places to buy?
View 4 RepliesI have a 2002 f250 4.2 diesel with a 5 speed manual box and i want to put a 7.3 in it. Does it fit?and can i make the 5 speed tranny fit?
View 4 Replies2002 F250 SD 4x4 crew cab, v10. 4x4 not working. Replaced switch on dash, not the problem. Some of told me it was the vacuum control module. Not sure where to start.
View 4 RepliesI bought a 2004 F250 SD XLT 4X4 crew cab which was a a roll over. The cab was replaced with a KR cab, its believed this was from a 2 wheel drive truck. My issue, the electric 4x4 does not work on the truck I have to get out and put it on manually.
Also, the ABS light is on the dash is on and the ABS doesn't work. The overhead panel doesn't work either. A friend of mine believes it could be a wiring harness issue but isn't sure replacing it will have any effect on the 4x4 and the ABS.
Let me start out by saying that I have exhausted every option that I have read on every thread that I could find on the internet regarding my son's 2002 7.3L not starting. What I have is no 12v power to the starter solenoid at the starter when I crank the key. What we have done so far, had the starter and both batteries tested, all good. Swapped out the starter motor fuse and the starter relay. Tried a new ignition switch and a new trans position sensor. Found major corrosion in the fusible link junction box on the drivers inner fender so we cut out the fusible links and put in a temporary jumper wire, still no crank. I have power to the dash, power on the power cable at the starter. I can jump the terminals on the starter and the starter engages. I found the shifter linkage bolts loose under the dash and tightened them up also. We have been struggling with this for 3 days, out in the lovely Michigan weather, since it couldn't have died in his parking spot in our heated shop, and I am completely frustrated. Are we overlooking something glaringly obvious?
View 11 RepliesI have a 2002 ford f250 superduty and when I have my headlight switch set to auto to come on when it gets dark they will for awhile and then my headlights will turn off for no reason.
View 2 Replieshad a problem with their OD light blinking and shift problems. This past week my od light started blinking and when I shifted into drive, it was stuck in overdrive. When I shift into 1st it would go to 2nd and stay there. So basically I had 2nd and overdrive. I started replacing sensors like the VSS, and checking the wiring warness. Took it to a transmission garage and they told me it was toast. Then I decided to bite the bullet and buy a new tranny. After replacing the tranny it did the same thing with the same codes showing. Then I got smart and checked the fuses. Of course it was as simple as a blown fuse causing all the trouble. In my truck it was fuse 23 under the dash. A 20 amp fuse that was listed as engine control. Im not saying that in every case if the OD light starts blinking it's as simple as a fuse but in my case it was, so lesson learned. Always check the fuses first.
View 13 RepliesI have a 2002 f250 superduty 5.4 4x4 around 317xxx original motor and trans. When it's cold out it won't start at all I have to use starting fluid but once started it will start right back up. Did the plugs fuel filter cleaned the intake and sensors still have a problem plenty of fuel pressure plenty of cranking amps brand new battery and Alternator. It just cranks and cranks when it's warm out fires right up. Runs smooth no lack of power or misfire no codes are being thrown also.
View 14 RepliesI have a 02 F250 V10. When I am pulling a trailer and began to travel over 50 MPH the truck feels like its moving left to right almost like its sliding on ice. Its worse the more weight I am pulling. When I am not pulling anything there is no issues. The trailers I am pulling are gooseneck trailers. What would cause this.
View 11 RepliesIf you look at the top of the picture you can see the two bolts with fresh oil on them.
I have a 2002 Ford F250 V10 Pick up. I noticed oil leaking from under the oil pan. I wiped off the pan and bolts to see where it was coming from. The oil seems to be leaking from the rear of pan. There's always fresh oil on the rear bolts that hold the pan and I also noticed oil coming from one of the two hoses that go from the radiator to where the oil filter mounts.
But don't those hoses carry radiator fluid and not oil? I bought this truck in July and no oil leaking from underneath. It seemed to have started after I did my first oil change on it. I used regular Vavoline 5W-20 and motorcraft oil filter.
I have a 2002 f250 super duty v10 with the manual transmission... It has aloud squeak from under the truck when Im slowing down or maintaining a certain speed. The squeak goes away when I accelerate or if I push the clutch in. It does have a vibration to it when im speeding up. And shakes bad sometimes when I let off the clutch from a stop..
View 1 RepliesMy 2002 250 just got ball joints, bushings, sway arms, 4 wheel alignment and new tires to top it all off. Did All this to correct the shakes, shimmies, popping and grinding in the front end. Now they say I need a steering stabilizer up front. Does any other than ford make a bolt on one and haw much and where can I get one.
View 10 RepliesBattery tested good, tried jumping it as well with cables and with portable pack.
I hear two clicks under the hood (NOT a continuous type click you hear when the battery is dead). The first seems to be up near the passenger fender well when the key is turn to the start position, the second click seems to be down under the motor near the passenger side (near the starter I assume, couldn't tell very well) when the key is RELEASED from the start position. The motor doesn't budge, I don't see any belts flinch or pulleys move to indicate that the starter is engaging. I don't hear anything that sounds like a starter engaging to me.
If not, where the starter solenoid is on this thing? is it separate like the other older ford's I've owned or is it now on the starter? Is there any fuse-able links that could cause this? Wiring diagram? Is there a way to jump the solenoid like in the old school days (e.g. with a screwdriver or wrench)? would like to get this home without towing it or fixing what is really wrong with it in the parking lot.
It's in negative to single digit temps here in Indy now, I fired it up in the morning in negative temps, drove it work. Came out to go home, and now this. So something happened between this morning and now and it's not the battery.
2002, F250, 5.4L, ZF-6 trans.
Ok...today by accident turned the key with the truck in gear and clutch not depressed...much to my surprise the truck tried to start and lurched forward.
Is this a sign of a failing clutch safety switch or Could it be an ignition switch problem? Anything else that I am not thinking of?
I have no 4x4 lights on in cluster when turn the key in the on position and it doesn't engage when I turn my 4x4 selector. And I don't hear anything in the relays .
View 14 Replies