I have an 2002 F250 super duty that has leather seats. The seats are power but not heated. I bought seats out of a Harley Davidson edition that are electric and heated. They have an extra plug that my truck don't have. How can I make the seat heaters work?
View 4 Replies2012 f250 diesel Lariat 4dr 4x4. He called me today cause he knows I do all the work on my own F250 diesel. He has heated seats in the back and he said that they turn on by them selves and they won't turn off. He had to actually disconnect the wire harness to get the heating elements to turn off so his wife's friends wouldn't burn their bottoms in the middle of august is Texas.. Any ways, he said both sides are staying on and wouldn't turn off using the switch.
I'm not very familiar with the heated seat wiring, especially for the back seats. I told him their may have been a relay that went bad, but now I"m thinking that they much have a controller or something that is acting up. He said that the front seats are acting normal. Also, he has the touch screen and navigation upgrade as well as auto climate control, not sure if this stuff matters for the back seats though...
Just bought a 2011 F450 king Ranch. really like the truck but the heated seats a REALLY slow to warm up and then just warm. I see that these work different than all the other heated seats I have used and use the blower motor to blow warm or cool air through the seats instead of an element under the seat covers. Is there anything I can do to get more heat? The blower filters look ok and will replace the when I can find a set. Tries without the filter and didn't see much of an improvement. Where is the heat element and is it east to get to?
View 2 RepliesJust bought a 2002 F-250 Crew Cab. It has the factory style running boards with the lights at each end. None of them where working so I changed the bulbs and still nothing. I decided to follow the wiring to make sure everything was good and found that neither one of the boards are plugged into anything. They both have about a 2' loomed harness with a plug on the end of each board and it is zipped tied to the frame. But there is no wiring nearby to plug it into, I have checked everywhere. I can run extra wiring no problem if I can find out where they are supposed to plug at.
View 14 RepliesComing back from a trip I got a e-brake light show up on the dash then noticed the signals stopped working and the heated seats no longer turn on. I scanned it with my AE and got a brake fluid sensor error come up but nothing about the signals .... is this a common problem or is there a connection between all this? 2003 F350 6.0L .....
View 2 RepliesI just bought a 2001 F250 XLT and it came with the standard power paddle mirrors. I would love to add the towing mirrors (preferably heated with signals), but what I am wondering is if the connectors for the mirrors are the same. Also would my truck that came with the standard paddle mirrors be wired for turn signals and heated options? How would I test for this? Also do all XLT's come prewired for the hardwire keyless entry pad if they have keyless entry?
View 1 RepliesI'd like to replace the back bench seats with something that has a headrest. Can I swap out the benchseat from a 2004 model and place it in my 2003 model?
View 4 RepliesWhere is the low side hook up to charge my a/c 2003 f250 v10
View 6 RepliesI'm trying to find out what the two connectors in the image are.. I've looked through the manual that I have and searched around on the web and find nothing.
They're on a 2015 F250. "upfitter" switches were installed from the factory.
First, need a wiring diagram for the outputs on the back of the brake controller module? I want to check and see if there is a problem with the connection to the rheostat. I can activate the trailer brakes with the slider bar but not with the brakes.
Second, where I can get a new OEM controller that will replace my old one if I can't "Cypher it out"?
When I hook my battery cable up to my battery when negative cable my truck automatically starts turning over without the key in it what could be the problem
View 1 RepliesMy four wheel isn't working. I have a 2002 f250. When I turn my esof switch the dash light doesn't come on and when I turn on the lights the switch doesn't even light up. I'm going to check for power at the switch but I was wondering to get a diagram for the 4x4 so I can see if there's anything else I can check or look at.
View 9 RepliesI've got an intermittent Trailer Wiring Error message that started appearing with a trailer connected on my '11 F250.
Brakes and lights work OK on the trailer, I thought I had read on the board here that there was a TSB for this, but I cannot find it.
I have a 2002 f250 4.2 diesel with a 5 speed manual box and i want to put a 7.3 in it. Does it fit?and can i make the 5 speed tranny fit?
View 4 Replies2002 F250 SD 4x4 crew cab, v10. 4x4 not working. Replaced switch on dash, not the problem. Some of told me it was the vacuum control module. Not sure where to start.
View 4 RepliesMy heated seat that quit. Pass side heated seat on my 07 went out. The light on the button stays on, where do I start diagnosing to figure out if it is the back or bottom that went out?
View 4 RepliesI have a '99 psd f250 crew cab lariat, I just purchased seats from a 2005 F350 that are lariat heated and power. My seats are power but non heated is there a way to hook everything up.
View 3 RepliesAt work weve got an 02 F250 Lariat CC, and the overhead console has gone out. I looked in the owner's manual, and there was no fuse listed for the overhead console. Is there anything that I can do to fix it, or should we just go out and buy a new one?
View 14 RepliesLet me start out by saying that I have exhausted every option that I have read on every thread that I could find on the internet regarding my son's 2002 7.3L not starting. What I have is no 12v power to the starter solenoid at the starter when I crank the key. What we have done so far, had the starter and both batteries tested, all good. Swapped out the starter motor fuse and the starter relay. Tried a new ignition switch and a new trans position sensor. Found major corrosion in the fusible link junction box on the drivers inner fender so we cut out the fusible links and put in a temporary jumper wire, still no crank. I have power to the dash, power on the power cable at the starter. I can jump the terminals on the starter and the starter engages. I found the shifter linkage bolts loose under the dash and tightened them up also. We have been struggling with this for 3 days, out in the lovely Michigan weather, since it couldn't have died in his parking spot in our heated shop, and I am completely frustrated. Are we overlooking something glaringly obvious?
View 11 RepliesI have a 2002 ford f250 superduty and when I have my headlight switch set to auto to come on when it gets dark they will for awhile and then my headlights will turn off for no reason.
View 2 Replieshad a problem with their OD light blinking and shift problems. This past week my od light started blinking and when I shifted into drive, it was stuck in overdrive. When I shift into 1st it would go to 2nd and stay there. So basically I had 2nd and overdrive. I started replacing sensors like the VSS, and checking the wiring warness. Took it to a transmission garage and they told me it was toast. Then I decided to bite the bullet and buy a new tranny. After replacing the tranny it did the same thing with the same codes showing. Then I got smart and checked the fuses. Of course it was as simple as a blown fuse causing all the trouble. In my truck it was fuse 23 under the dash. A 20 amp fuse that was listed as engine control. Im not saying that in every case if the OD light starts blinking it's as simple as a fuse but in my case it was, so lesson learned. Always check the fuses first.
View 13 Replies