Ford Super Duty (1999-2016) :: 2002 F250 - Diesel Leak On The Back Of The Engine
Feb 20, 2014
I have a 2002 Ford F2 50 that has a diesel leak on the back of the engine. I've already replaced the drain valve that was leaking. Then I noticed that the front of the engine was dry now but the back of the engine still has some pooling With a very small drip off the back of the engine between the transmission housing and engine. Not as bad as it was of course But still a small drip. Where this may be coming from? And how to fix it?
View 4 Replies
Advertisement
I have a 2002 V10 F350 6.8L that I recently purchased at auction and am fixing up. I've made good progress already and replaced many of the suspension components so that the tuck drives straight. It does however have an oil leak that seems to manifest of heavy acceleration.
I'm not sure exactly where from as I have not crawled under the car, but I can see a drip land right on the Y pipe coming out the exhaust manifolds. There is enough of a drip to create quite a smoke storm under the hood. Any common areas to look for?
View 3 Replies
2002 F250 SD 4X4 5.4L. 4.5 inch pro comp lift tire size 305/75/R16. K&N cold air set up. 208,000kms
I know the truck does horrible on gas but lately is been getting worse, maybe I am getting 350km to a tank. Mixed highway city driving. Sounds like I might have a vacuum leak somewhere but I have no engine light. I've had the truck since last year and put about 10,000km. on it done regular oil changes .. brake maintenance no motor work so far.
View 2 Replies
I have a 02 F250 V10. When I am pulling a trailer and began to travel over 50 MPH the truck feels like its moving left to right almost like its sliding on ice. Its worse the more weight I am pulling. When I am not pulling anything there is no issues. The trailers I am pulling are gooseneck trailers. What would cause this.
View 11 Replies
So one day my 4 wheel drive just stopped working, when I put in 4hi nothing same with low, the light on the dash doesn't even pop up and it doesn't engage. I've done about everything I could think of doing besides replacing the motor for it and the wiring, I hate getting stuck...
View 4 Replies
The truck has 64k miles and has developed a small leak on the engine side of the radiator with no apparent damage. There is no variation on the pressure test and the dealer was able to find the very small leak with dye in the system. It has lowered by about 3/4 of a gallon of coolant over the last couple of months. There are no visible signs of a leak but you smell the coolant when you stop the truck.
View 11 Replies
I have a ford f250 1997 with a 5. 4 triton engine in I bought a 02. 5.4. Out if a ford expedition he said it would fit but my mechanic is not sure . Would the engine out if the 02 fit in the 1997 and what would need to be done.
View 7 Replies
Just noticed a ticking sound coming from my engine... just turned 160,000. Hoping nothing serious...
View 11 Replies
I have an 02 f250 5.4. I just did the intake manifold. I also changed the spark plugs and the valve cover gasket. Following this I drained the oil and filled it with fresh oil.
It started right up but it felt like the engine was really vibrating and running rough. The check engine light than came on. I don't have one of those tools to diagnose it.
What could be wrong?
View 11 Replies
Need to diagnose my truck issues. On my 2002 F250 V10, when I try to start it, the engine just cranks and cranks and cranks with no fire or even hint if starting. I am not sure if it has no spark or isn't getting any fuel. I just replaced all ten spark plugs and coils less than 500 miles ago. I want to perform the fix myself, but I need to get the problem diagnose the issue first.
View 8 Replies
I have a 2002 F250 with 189,000 miles. Im having some very bad issues that im trying to fix. The truck idles rough, with fluctuating RPM's. In certain speed reanges it also shakes and runs rough. If I turn the overdrive off the shaking pretty much stops, but it still accelerates pretty slowly. There is also a whistling noise from the front of the truck until the engine warms up, someone told me it sounds like a bad intake manifold? Does that sound right? What could be going on with my truck? All spark plugs and coil packs have been replaced, as well as the fuel injector rails.
View 2 Replies
I have been leaking oil on one of my work trucks. I do not know what the part is called or named. the leaks seems to be coming from above or behind a part that the driver side motor mount. As you can see in the image, the part has a sensor and a concave dip that runs along the middle of it. Well, I stuck my fingers behind that and it has a dip on the other side too which face up and that dip was puddled with oil. I need to know what that part is called or named or what is directly behind it that can be causing the leak. I hope its just a gasket and it is not cracked.
Part that is leaking behind. 2001 Ford F-250 Super Duty V10
View 1 Replies
First tech post for my new truck. I just bought a hold-over but new 2015 F250 XL Supercab 2wd and love the simplicity of no unwanted options. That said, there are two features I am adding. The first is perfectly straightforward, cruise control (swap button cluster and have the function turned on by the dealer). The second is a tiny bit more involved, back-up camera, in mirror display with bluetooth hands-free (I like the simple AM/FM radio because I can work it all with gloves on).
So I basically need three things from the truck and my research has been inconclusive on a couple of things because most of the threads are for 2014 or earlier. I think I can pull switched 12V and ground (pin 1 and 4) plus reverse lights (center, or pin 7) all from the the trailer wiring harness. It appears these are not affected by the canbus load restrictions of other places to tap reverse signal (remember, XL so likely nothing in the overhead console for the auto-dimming rear view mirror). Are there any challenges with this when I do hook up my enclosed trailer or when it is not hooked up regarding the trailer brake controller/anti-sway?
I already found a good youtube video for how to route the wires so I think this is my primary challenge at this point.
View 14 Replies
I'd like to replace the back bench seats with something that has a headrest. Can I swap out the benchseat from a 2004 model and place it in my 2003 model?
View 4 Replies
I bought my first vehicle last October, a '99 F-250 with a 6.8 V10. I later found out (AFTER hauling a big load of rocks in a dump trailer) that one of the bottom leaf springs was broken. So this winter I have been thinking on what I want to do about it when it warms up. This is pretty much on top of the "to do" list for my truck. I did make a thread about putting 1 ton springs under it, but I think I'll just stick with the regular 3/4 ton springs. So now this is where I have another question, and I think this pic will tell some of it:
Now I'm not sure if those rear springs are stock, but that rear end is way the heck up there! The truck itself is not level, the front looks to be correct height, but not the back. A buddy at school and I were talking about a leveling kit for the front. But the more I look at it, I think the rear end should come down. I don't want to get bigger tires, as I just put brand new Transforce AT's on the back and plan to put new ones on the front in the near future.
Another question of mine is, would this have been a truck ordered just for pulling a camper? It has holes for a fifth wheel hitch in the bed, the rear end sits high, and it didn't come with a tow package. The PO told me that he put the receiver hitch on it. I'm fixing up stuff on it one thing at a time. Springs just happen to be next on the list.
View 14 Replies
I've been trying to figure out what is going on with my '99 F-250 V10, you can check out this thread for the back story
[URL]....
I did a compression check and the results seem inconclusive to me- see image.
Before I did the compression check I started to take the intake manifold off to change the gasket set and it's about 50% done. I'm at a crossroad now. Do you think I should finish switching out the intake gaskets or do you think it's more than likely a head gasket? I would hate to put it back together, it still smoke and have to take the intake and everything else back off to do the head gaskets.
Someone had mentioned a possible small crack in the cylinder wall that is closing up when the engine gets heat in it and obviously doing the intake and cylinder head gaskets would fix it if that's the problem.
View 14 Replies
I'm from SC where we are currently getting our rainfall for the next 3 years, so it's an occasion to find leaks. My 2001 F250 has developed one right in the middle of the passenger side dash, I saw it running down a white vacuum tube and dripping off to the floor mat. Is there a place in the cowl that will hold water and leak?
View 3 Replies
2004.5 F250 SD XLT 4dr 6.0L
CAI, 4" Straight exhaust
EGR Delete, 6.4 Injector pump
Coolant filtration system.
New injectors al around
New ICP, New IPR, New Oil Cooler.
Recently Bulletproofed on ARP head studs, and the stock Head gasket,
New injector harness and FICM from DieselTech Ron
SCT tuner, running innovative diesel tunes. EGT Sensor
37x13.5r18 nitto trail grapplers
Truck started bucking and stalling when warm and over 60mph. No codes.
View 1 Replies
1999 F-250 LD 5.4... There is a hole on the back of the upper intake manifold, just below the back of the throttle body, is a vacuum hose supposed to be attached here? Have a serious vacuum leak, no coolant loss, no overheating, just had cop's and spark plugs done, now she backfires, stalls and will not stay running, mech. says its an intake gasket but the gasket and lower intake manifold look new.
View 7 Replies
1999 F250 extended cab back doors won't open. The passenger side stopped opening right after I purchased it a few months back (168K miles). I removed the door panels and reached my hand in feeling around. I know the latch releases are activated by cables but cannot figure out how they work. While feeling and pulling on the cables one became dislodged from its holder. The driver's side stopped opening yesterday . Do the cables stretch, break, or what? Or are the holders the issue? Is there an illustration that shows how the cables are run and connected?
View 14 Replies
I've got a 2014 f250 xl super cab and can't for the life of me figure out how to remove the back seat back.
View 2 Replies
