Ford Super Duty (1999-2016) :: 2002 F250 - Alarm Won't Stop Going Off And Cannot Start Truck
Jul 11, 2014
I have a 2002 F250 7.3l with an aftermarket alarm. I can't read what the third letter is on the decal MV? 2000 Modular Vehicle Security. I added a pic of the alarm decal below. The key fob it had was aftermarket for the alarm and stopped working about a year ago. Today I unlocked the drivers door with the key and the lights started flashing and I can hear a clicking sound. It done this a few times back when the key fob still worked and I just kept hitting lock and unlock until it finally stopped. It won't let me start the truck at all and I have tried unhooking the batteries with no luck.
View 4 Replies
Advertisement
Just picked up my F250 a few days ago and it's been great up until yesterday when I hopped in to start her up and nothing. It's a brand new battery and all lights worked, but the dash was dead. I attempted in vain for an hour or so to diagnose as to why this was happening and just happened to open the door with the key in the ignition and hit the door lock button....all of a sudden the truck starts beeping and the message on the dash said "to disable alarm start vehicle". I turned the key, the dash lighted up and away I went. What I may have done to cause this or has it happened to you? I'm thinking it's something with the key fob but not sure.
View 6 Replies
I have a 2002 F250 7.3L and it wont start. Its been sitting for the past few days in the cold because the batteries were shot but was plugged in the whole time. I replaced the batteries today and even poured diesel 911 5 hours before trying to start it in case the fuel was gelled. It cranks fine but just wont turn over.
View 2 Replies
My truck was sitting in front of the house, unlocked and the alarm disarmed. For no apparent reason, the alarm on the truck went off. I tried pressing both arm and disarm button on the FOB and the alarm would not shut off. I opened the door, started the engine and the alarm immediately turned itself off. I need to look in the manual and see if there is any condition that would cause that particular event. Strange to say the least.
View 3 Replies
I have a 2008 F250 crew cab lariat 4x4 with 20 inch factory wheels that the steering wheel shakes during normal driving left to right. I bought this truck with 1500 miles on it. This shaking started at 50k miles and I was thinking it was a balance issue so I got new tires a month later since mine were about worn out anyways. They were factory replacement nitto terragrapplers. Shake was still there, swapped out for another set of nittos and shake still there, swapped to BFG AT KO's and shake better, but still there. I have gone through 10 or so balances, 5 roadforce balances, 2 alignments at 4 different shops including the ford dealer through the 3 sets. My wheels are scratched to hell and back from the careless people at the tire stores from so many balances.
My truck sat at the Ford dealer for a week just the other day and they changed the steering stabilizer. I thought it was gone, but a a few days later shaking started again. It almost feels as if every little bump, rut, crack in the road the steering wheel feels and shimmies (doesn't matter the speed, gets worse and more noticeable at higher speeds). The Ford Dealer says can't duplicate, but then when I go down there and test drive with them it's "oh yeah I see that, it shouldn't be doing that". The Ford Dealer says they can't find anything loose in the front end when I tell them to check tie rods, bearings, etc.
My truck has 62k miles on it now and it's driving me to the point of thinking about trading it on a Chevy. I love my truck, but it kills me everytime I make a payment and it rides like crap. I am still under extended warranty so I need to get this fixed before it goes out. I've also noticed that if I turn my steering wheel back and forth real quick while driving like warming up for a Nascar race I can feel a bumble in the steering wheel. This is NOT the death wobble as I use to get that around the 20k mile range and it disappeared and has never been back.
View 14 Replies
I have a 2002 f250 super duty v10 with the manual transmission... It has aloud squeak from under the truck when Im slowing down or maintaining a certain speed. The squeak goes away when I accelerate or if I push the clutch in. It does have a vibration to it when im speeding up. And shakes bad sometimes when I let off the clutch from a stop..
View 1 Replies
It's an 02 f250 4x4 crew with 7.3, 6 in lift and 35 in tires. It has all ways wandered a little bit and I just accepted it. I changed everything in the steering from ball joints, tie rods and drag links less than 2000 miles ago. Everything still seems good and tight. Recently it has gotten a lot worse so I checked again and everything seems to be tight. Where to or what to check next? It's to the point I don't feel safe letting my wife drive it and I don't enjoy driving it.
View 7 Replies
Can get up to speed about 55-60 in my 2003 f250 6.0 4x4 truck and hit the brakes hard and the pedal gets hard almost like you cut the truck off and the truck doesn't stop well I can let off the pedal and hit it again hard and it works like it should. Also when it does this the power steering doesn't work. I was on an exit ramp and almost wrecked when I exited off the interstate I hit the brake pretty hard and couldn't steer I let off the brakes then hit them again and it worked fine and so did my steering. It would seem that the two are connected somehow. What's wrong?
View 2 Replies
I just changed out my IAC. Truck is still idling too high. When I squeeze the host to the IAC it idles down. When I unplug the IAC the truck immediately dies.
Does the IAC talk to the the Throttle position sensor? Should this be my next part to change?
2002 F250 5.4L ....
View 4 Replies
Today I was going to launch my new boat and when I backed down the ramp, the brake went to the floor almost sinking the truck. Long story short, the brake line that runs along the frame to the rear brakes rusted through at a bend that I couldn't see. Seems the line is about 8 feet long. What I'd like to know is can I replace it without dropping the fuel tank which of course I just filled yesterday and can I obtain one at a ford dealer or will I have to order one. My truck is my only transportation.
View 1 Replies
My 2002 F-250 v-10 sat for over a month with me in the hospital for spinal reconstructive surgery. Battery was dead but has been charged and tested as good. The truck cranks strong but will not turnover. I am unable to do other diagnosis, what might be the problem.
View 2 Replies
I have a 2002 f250 SD v10 4x4. I had a ground wire break fixed that know noon of my instruments work. Dash lights up but nothing moves. Pulse my parking lights stay on when the truck is shut off or when I turn lights on then off. I have to disconnect the battery to get hem to shut off.
View 3 Replies
i just bought a 99 F250 4WD with the 5.4 in it i put a brand new starter in it. When i turn the key to try to start it, it just cranks the motor once and stops. The starter isn't grinding or clicking, the motor clicks once and move the belt and pulley a little but that's it. What would cause this?
View 13 Replies
I just bought a 2000 F250 SD, 4x4, 5.4, Quad Cab. I drove it off the lot, stopped to put air in the tires, jumped back in and it wouldn't crank. All of the dash lights worked fine. Tried jumping at the starter solenoid and got nothing. Got under the truck and jumped it off the starter, vroom, fired right up. Replaced the starter solenoid and had no issues for about 2 hours. Then it did it again. This time it wouldn't start at all. I towed it back to the dealer and they had it for 3 weeks.
Then yesterday I called and they said it was done. Picked it up, drove to the barber shop, got my hair cut, came back out and it did the same thing AGAIN. After jacking around with the shifter and turning the wheel back and forth 100 times it started. The key is kind of hard to turn sometimes in the ignition, so I'm thinking that the ignition cylinder needs to be lubed real good, but that shouldn't stop it from cranking the motor over, right? I was going to swap out the ignition switch, but I don't know if that will do any good either.
View 3 Replies
I have a 2008 f250 with 5.4v8. The truck starts intermittently. Put key in turn if no dash lights it doesn't even crank or hear a click. If u put key in and turn and dash lights up to starts and runs. U can watch the different lights (instrument cluster) light up independently like a xmas tree. When truck doesn't start if u disconnect battery when touching power wire to battery. Post truck lights will flick on/off if u tap cables to battery and leave on. Lights flicker on/off and then stay off. (Don't know why shouldn't flicker at all) after disconnecting and reconnecting battery truck will or will not start still depends on if dash lights come on before cranking.i replaced battery, starter, alternator, all the ground cable connections and wire cleaned. I haven't replaced the power side but are clean.
View 3 Replies
I have an 08 f250 with 6.4. when ever it rains the truck will not start. None of the gauges will work, door chime doesn't work and the only error light is the airbag light. Lights, radio, turn signals, horn all work. There is no clicking of the starter relay, the truck in dead. There is no water on the floor board nor is the floor moist. If I place a ceramic heater on the driver side floor board and blow hot air towards the firewall the truck will start in about 30 min to an hour depending on how long it sat in the rain. I've removed the air intake vents and there is no debris blocking the drains.
View 3 Replies
I have a 2002 F250 with 189,000 miles. Im having some very bad issues that im trying to fix. The truck idles rough, with fluctuating RPM's. In certain speed reanges it also shakes and runs rough. If I turn the overdrive off the shaking pretty much stops, but it still accelerates pretty slowly. There is also a whistling noise from the front of the truck until the engine warms up, someone told me it sounds like a bad intake manifold? Does that sound right? What could be going on with my truck? All spark plugs and coil packs have been replaced, as well as the fuel injector rails.
View 2 Replies
I have a 2010 F250 V10 4x4. about every 3-4 times when you start the truck....it seems as though the starter "sticks". If I catch it and shut it off and then turn the key right back it fires up and does not stick. Its as if the gear is staying kicked out into the flywheel. Are we thinking the starter itself? I'm thinking starter...but looking for input before I crawl under it.
View 1 Replies
I have a 2001 F-250 XLT 4x4 with V10. Truck will not start. No fuel pressure. My Haynes manual does not show ignition or fuel delivery wiring. I have found the relay box behind the radio/dash. I need a wiring diagram and info on which relay is the fuel pump relay. Want to know so I can jump relay to see if fuel pump is okay.
Truck had sat for a few weeks being ran very little, so had to jump start yesterday. Ran for about 15 min, the shut off, re-started and ran for 30 min. Truck sat for about 1.5 hours then would not start. Charged battery overnight and it is 100%.
View 3 Replies
Ok truck shut down wouldn't start back. Put fuel filter o. Frame cranks but won't start. Was told has high pressure oil leak in engine?
View 8 Replies
Let me start out by saying that I have exhausted every option that I have read on every thread that I could find on the internet regarding my son's 2002 7.3L not starting. What I have is no 12v power to the starter solenoid at the starter when I crank the key. What we have done so far, had the starter and both batteries tested, all good. Swapped out the starter motor fuse and the starter relay. Tried a new ignition switch and a new trans position sensor. Found major corrosion in the fusible link junction box on the drivers inner fender so we cut out the fusible links and put in a temporary jumper wire, still no crank. I have power to the dash, power on the power cable at the starter. I can jump the terminals on the starter and the starter engages. I found the shifter linkage bolts loose under the dash and tightened them up also. We have been struggling with this for 3 days, out in the lovely Michigan weather, since it couldn't have died in his parking spot in our heated shop, and I am completely frustrated. Are we overlooking something glaringly obvious?
View 11 Replies
