Ford Super Duty (1999-2016) :: 2001 V10 - Knocking Noise And Oil Has Water In It
Mar 11, 2010
I have a 2001 6.8l v10 and have nothing but problems. now i got a knocking noise and the oil has water in it. i have no clue what is wrong and on start up it blows white smoke till its warm i have looked at the coolant lvls and they have not changed. the oil pressure is fine while driving but at idle and stop lights and stop signs it drops and the light comes on. i have not had a check engine light yet? what could be wrong? i have blown plugs 5 time 3 coils and 2 head replacements. I hope its just old oil or bad oil i have no clue it is due for an oil change but would just oil oil make all this happen. I also am seeing oil coming form the intake on the throttle body but the oil breathers are right there too.
View 14 Replies
Advertisement
Have a knocking noise on my right front when I hit a hole or when the wheel comes up like when I turn I to a drive way that has a little hill the right tire hits and I hear a popping Boise sounds like its under the truck but I can't place it? I have a 2003 f250 crewcab 4x4 with 6.0 and 6inch lift with 37 inch tires....
View 3 Replies
Twice I open the hood of my SD and I see water pooled up around the intake manifold on my 2001 F250 5.4. This happen when we have heavy rain. My truck is sitting on my drive way that has some angle to it. When it rains, all the water from the roof flows down the windshield and somehow the water is getting into the engine bay.
I cleaned out all the leaves and made sure the rubber molding were in place near the firewall, but it happen again last night. Is there something wrong with my truck to keep the water out. I suppose I could turn the truck around so that the rain will flow from the roof to the bed. But, I like parking my truck the way I park it.
View 1 Replies
I have a 2000 F250 5.4 that has a ticking/knocking noise. After about 30-60 seconds of first starting the truck in the morning, the ticking/knocking noise appears. It sounds like its coming through the exhaust system and seems to be louder under the front passenger side wheel well. When I rev the engine up, it seems to go away. Does this engine have a cam phaser? Could it be timing chain slap?
View 11 Replies
While driving today, 2006 Ford F-250 5.4 L V8 138,000 miles , I experienced a problem. Started with the truck acting as if it was running rough, possibly missing. This was approx. 10 Minutes after starting. Checked the dash, no warning indicators and all gauges were normal. Approx. 4 more miles, the oil pressure alarm signals and I see the oil gauge has dropped to zero. I pull over, turn off and check the oil. Oil is clean and at a normal level. I restart the truck and the oil pressure goes back to normal.
Rev the truck up while sitting there and after a few seconds i hear a knocking noise in the engine and oil pressure drops again. Call the tow truck, driver used to be a mechanic . He asks me to start it again and the same thing happens. If you start it and let it idle oil pressure seems to go up to normal with no engine noise. Finally get to the mechanic and he calls me later saying the oil pump and screen may need to be replaced or the engine may need to be replaced.
View 3 Replies
I just picked up a 2001 F350 with the 5.4L with 200k miles. When I test drove the thing the engine sounded fine. I got it home and noticed that it occasionally has a loud knocking noise that is coming from the Left Valve cover area. It sounds like an old Chevy 6.5L Diesel ...
It comes and goes, Hot or Cold. It seems like it usually goes away when driving with RPMs above 1500 or so, however I took off with it yesterday and the noise would not go away, it seems like it might be low on power when the noise comes on, but then again it always feels low on power, so who knows.
I have changed the plugs, oil, and verified there are no exhaust leaks at the manifolds.
Here is a video of the noise: YouTube....
I dont think it is the timing chain, as it seems like its coming more from the center of the cover, when placing my hand on the cover near the timing set there is no vibration or anything that would lead me to believe its the chain.
All of my searching so far turns up 3V stuff, and little info on the 2V engines. The valve cover looks like a nightmare to get off, who have to work on these things (including me).
View 14 Replies
I have a 6.8l V10 that ..... seems.... to be knocking. I am used to hearing v8 knocks but not so sure about a v10. The knock seems to double tap sometimes. Could this be a bad valve or lifter instead? Video is linked.
Also oil pressure seems to be fine.
[URL] .....
View 14 Replies
I have an '01 F250/4X4--How can you tell if your rear drum brakes are bad? Do they make a noise?
View 8 Replies
My dad just bought a 2001 F-250 Crewcab 4x4 w/V-10. 72,000 miles. Anyways i noticed a small almost exhaust leaking sound on the test drive. I had the dealership put it up on the rack so I could see the underside. I noticed that it has the famous broken manifold bolt. So I kinda wrote it off on that we would have to get that fixed soon. Anyways the noise hasn't gotten worse just now noticing it that it has set times when it happens.
It happens around 25 mph then goes away then back at 45 mph, then goes away. I am having a hard time describing it. Almost like the exhaust is building up pressure then releasing it when it gets too high. But then I starting thinking transmission something since it kinda has a delayed shift when the noise happens.To clarify I am not saying it anything to do with the torque converter. I am just rolling to find out what is going on.
View 5 Replies
My 2004 powerstroke recently started making a loud knock during the process of starting. Will make the sound warm or cold, however I mostly hear it when the truck is warm as it cranks a little longer and about two seconds into the crank something starts knocking. After the truck starts it runs perfectly fine.
View 4 Replies
I have a 2010 6.4L turbo diesel. Without a trailer on a mtn incline I have no issues. She will fly up the hill and she is quiet when I'm not pulling the 10,000 Lb trailer. When pulling the trailer, I have a loud howling noise and reduced performance. I had it at the Dealership and I had them check the engine/turbo and they found no problems? I asked if they tested under load and they said yes?? Someone suggested that the "Waste gate valve" was defective.
View 4 Replies
I have a 2001 f250 v-10 4wd with 117,000 miles. I just replaced drivers side front hub bearing assy and not sure if it's the new bearing or what but now I keep hearing this crazy noise from suspension area. It has had bangs and pops for a while now. It almost sounds like abs motor going off but louder. Does it going slow fast or whatever. Brakes on or off. Trucks ball joints were done about two months ago and new shocks, trac bar replaced this summer only thing not done was tie rod ends and all bushings. Brakes are good new rotors and pads this summer also. It's like taking two inflated balloons and rub them together real fast. It may be the timken bearing maybe bad from get go.
View 14 Replies
I have a 2001 f350 4x4 with7.3 diesel...I have recently noticed a low grind like noise coming from the right front. I have troubled shot the issue and I am 100% sure it is the wheel hub assembly. Did I mention I am running 37x13.50 tires..and now you say no it is the hubs...and they are the original hubs. My question is every thing I look for shows ABS is on my truck... I look at the hub and don't see it.. so with the Dana 60 front does it have ABS or not? Also, should I go motorcraft, Timken or moog wheel hubs?
View 1 Replies
I have had this truck for several years. I have only had a few issues. I've heard of engine noise issues but I have never had any until now. My 5.4 is making a knocking sound that just started. It goes away if I tap the accelerator. It has over 200,000 miles on it. I change the oil every 3000-4000 miles. No additives and always conventional 5-20. Is this a serious issue? I've seen people talk about using thicker oil but I'm very hesitant.
View 13 Replies
I just got a 2003 f250 5.4 triton and it has a terrible knock. I've hear of the cam phaser problems but this thing knocks at high rpm and at idle so I doubt it would be a phaser, I thought it could be a rod bearing but I'm not losing any oil pressure. Its a pretty loud knock I don't have money for a mechanic to diagnosis it...
View 3 Replies
Does it need a diesel fuel injector?
View 2 Replies
Here's the deal. I have a 2001 F250 4x4 and I am getting a noise in the front drivers side wheel. The noise is not a grind or clunk, but its like a u-joint is rubbing inside an empty cylinder kind of. Anyways, it seems like it does it only with small bumps. I took off my oem hubs and re-installed them and the noise went away for about a week. Now I replaced them with manual locking hubs and the noise is back. One other thing I notice is if i put the switch to 4x4 the noise goes away. I checked all major components for the steering and suspension and nothing was loose. The front end is tight. Is there anything inside the axle that would cause this? I dont know what to check for anymore. Where else to check?
View 4 Replies
Have an f350 4x4 diesel that when I drive slow and especially turn to the right it makes a grinding noise. It seems to either go away or just gets muffled by road noise when cruising. The ball joints were bad so I replaced them and I figured with this especially when I turn right it had to be a wheel bearing so I replaced both of them and still same thing. Don't want to throw money at it hoping to fix the issue. Also front duff is full of oil.
View 5 Replies
I got ready to change oil in our '09 5.4 SD and I ran across a passage in the owners manual that stated that if you use a non-Motorcraft oil filter it may cause engine knocking upon start up.
Our truck knocks for a second or so when it starts. Kinda' reminds me of the piston slap that occurred at start up with the old Ford 300 inline 6 cylinder engines of the past after they got some miles on them. Sounds somewhat similar. This engine has 35,000 actual miles so I wouldn't thing excessive wear would be the culprit.
I'm using a Bosch Premium oil filter now after having heard and read how they are superior in their filtering ability.
Just wondered if any of you guys have run into a similar situation and if the Motorcraft filter in fact makes a difference in reference to start up knock
View 14 Replies
2002 Excursion 4x4 7.3. I've read about this on here before but I've forgotten what the problem is. When the wheels are turned and the vehicle is going forward at some speed, there is a knocking sound, like a ba-doomp ba-doomp ba-doomp. Does it in both directions, sounds like its in the front hub area. I don't have the time to fix it myself, how much should I expect to pay a dealer and/or independent shop to do it?
View 2 Replies
I got a 2001 f350 got a noise in my left front wheel i know its not the wheel bearings, it only makes the noice when the locking hub is unlocked i did jack the the truck up and spun the wheel got a faint grinding noises form what seems like the locking hub so my question is bad locking hub or needle bearing holding the axle shaft??
View 3 Replies
