I own a 2001 F250, I bought a skid steer that weights 7000lbs and got a trailer that is 14,000lbs.
The truck was running fine, today was the first day I used it and I noticed by the end of the day I have oil dripping from my exhaust.
The dealership told me that the f250 is able to town that much weight, what caused it, as well as is it safe to continue to tow with it?
I have a 2005 f250 5.4 no mods. its got 120k and needs a wake up. the passengers side exhaust manifold is leaking to the point of fixing and would like to get some input before the big purchase. my question is, headers or new manifold, and what brands is preferred for both I really don't prefer one or the other i just want the best fix really. Changing coil pack and getting more performance out of them and if so what brand. I would like a boost in lower end acceleration and throttle response, like a programmer or such. and if so what brand once again.
View 10 RepliesWhats the best way to get at the driver side exhaust manifold? I have a leak and its tough to get at. Should I remove the tire and inner wheel well?
View 1 Replies I sold my truck couple years ago and just bought a 2001 f250 SD crew cab with the 5.4 110000 miles on it. when I got it the ball joints were completely shot on it so I replaced them. I done this before I ever drove the truck. it drove all over the road and was fighting the steering wheel to keep the thing up in the road.a couple weeks later my steering box was leaking, so I put a brand new one on there. no change in the steering.
I changed all 4 tires with used ones off my sons truck he took off when he bought new ones and still no change. ordered and put new drag link and tie rod ends and everything I could change on the steering and still drives the same way. my steering wheel is straight but seems like you turn a little one way to drive it straight and a lot the other way especially notice it going around curves.
I'm looking to install an aftermarket exhaust system (cat-back system) on my '01 F-250/6.8L/V10. I'm looking for recommendations....Ideally, I'd love to find a system where I don't have to remove the spare tire, and still have a dual exhaust where the tailpipes exit on the side (aft of the rear tires).
View 3 RepliesMy 01 f250 has a leak coming down my line of sight on the windshield. Not sure if it's the seal, or the clearance light above it. Ever run into this before?
View 3 Replies2001 F250 5.4L - I recently had my muffler changed and the pipe flange on the tailpipe up by the exhaust manifold welded back on. I haven't driven my truck much this past summer so when I took it in to get the muffler fixed the front caliper got temporarily stuck like it tends to do. It eventually freed up but in the meantime I noticed a hot oil-like smell coming from my truck from time to time. I chalked it up to either the new muffler or maybe it just smelled hot and it was instead the front brake caliper still being stuck. One day I'm driving down the interstate and I start uphill. I noticed smoke behind me and pulled over. The brake was not overheating so I got underneath the truck.
The smoke was rolling off of the exhaust pipe all the way down it all the way up near the manifold but mostly around the muffler. The smoke quickly went away while I was under the truck. I noticed it doing this only while the engine is under a load like going uphill. Just driving around town nothing is noticeable. When it does smoke I lose power. Once I slow down for awhile and then gradually speed back up things seem okay. I checked the oil.
Normally I don't lose a drop but this time I was a quart low but the oil on the stick was clean. It's been awhile since I had my oil changed but very little mileage on this change (my truck has sat awhile). My truck doesn't leave a drop of oil under it when it sits. From what I read you can remove the radiator cap and start the truck to see if it's a blown head gasket. At least that one of the things I can check easily without actually taking the plugs out even though the oil looks clean. The radiator has not lost any fluid. The transmission fluid is also good. It's been doing this for about 3 weeks.
I still drive it to and from work (about 15 miles round trip) everyday but I take it easy on the acceleration and stay on city streets. I looked into the EGR system online for my truck and instead found an EVAP purge solenoid/valve in its place on the passenger side. I don't have any service lights on the dash. I went to Autozone and had them scan it but nothing came up. I read somewhere that either the purge solenoid assembly or EGR (I can't remember) can burn up the board if it goes bad resulting in no code showing up.
I recently changed a vacuum valve out that went bad that controlled the vacuum chamber used to operate the hubs on the 4WD. The 4WD is now operational again. Assuming the head gasket is not blown, what to check for next?
Went to change plugs on my '01 F250 5.4. When I pulled the coils, there was antifreeze in the tubes. Intake manifold gasket? How big a job, both in driveway or at shop.
View 1 RepliesOK so my 2001 F250 was leaking power steering fluid from the lower portion of the gearbox (where the pitman arm attaches).
I found a thread on this forum where it showed how you could change the seals out WITHOUT taking the gearbox out.
So I got the pitman arm off with a heavy duty puller. Then I scraped out the 1st rubber seal hoping to reveal a snap ring behind it. Well, the seal is 99% scraped off, but there is not evidence of a snap ring. It does seem like there is some metallic ring holding another rubber seal in behind it. But again, I can't find the little open spots that you put your snap ring pliers in to get snap rings out.
How do I get this metallic thingy out???? I already broke a small drill bit trying to drill it out. It just doesn't seem like the best way to go about it.
The exhaust system from the downpipe back was stolen off this auction truck I bought, so I bought an even worse truck for parts but I'm struggling to get the exhaust off. Is there a trick to it? Does it come out going forward over the rear axle or pull out from the back? Should I just cut it and have a shop weld it back?
View 8 RepliesI am new to Super Dutys but i love them! Altho mine is not being so nice. It has the 5.4 in it. When its idling it has a stumble to its idle with a pop every now and then out the exhaust. It revs fine when its first started. If i pull out on to the road and start away easy its ok a slight miss but if i put the throttle down its just falls on its face. But if i get it up to cruising speed its ok as well. But even at cruising speed more then 1/8 throttle and it starts missing and falling on its face. What it could be? It smells like its running lean as well.
View 14 RepliesI have a early 2003 SD with the 5.4 triton. It has a oil leak on the passenger side, the oil blows back and gets on the exhaust.
I have been under the truck with the engine running looking at where the head meets the block and at where the valve cover meets the head and can not see a leak.
Sitting there running at idle it does not drip a drop off the engine but the entire underside of the truck is coated in oil.
I did notice that the depression around one of the upper valve cover bolts was filled with oil, I cleaned out the oil, let the truck run and it stays dry.
I plan on putting a catback exhaust on my 2016 F350 6.2 gas engine. I have always loved the sound of Flowmaster exhaust but over years have started to become slightly annoyed with the drone in the cab. Is there a exhaust system out there that is capable of sounding like Flowmaster but without the in cab drone.
View 2 RepliesI am not positive where it could be but I have a good bit of oil on the transmission (i think) i was trying to replace the strarter and noticed it. Where the possible leak could be from? No oil on the ground under the truck.
View 3 RepliesOK, so I have the brake pedal downshifting, but there is no real exhaust brake. Can I have one installed, like the latter model 2015 or even the 2016, with the button?
View 9 RepliesIs this the same thing as the regen? Got it for the first time yesterday at 775 miles. Just curious. On a related note, I've tried to run around town some with 5th and 6th locked out (speeds of around 55-60 on a regular basis, running about 2300-2500 rpms) to try to run this process...am I doing it wrong?
View 10 RepliesFirst 11,000 miles on this 2015 F-350 6.7 diesel was a love affair last 2,000 miles I hate the damn thing it has been in the shop three times in the last month. Exhaust filter over loaded drive to clean. Will not clean while towing a load gets to limp mode. What do I do leave trailer on side of road in order to regen and then go back to pick it up?
View 14 RepliesMy '08 S.D. (5.4) has a cracked exhaust manifold, which I've heard is fairly common. Crappy Ford design. The local dealer has them in stock (imagine that, just like the 'non-bad' coil caps from some years ago, that they were instructed by Ford to keep at least 10 on stock at all times) for the passenger and driver's side. What are the part numbers?
View 10 RepliesNot at the exhaust, but from the engine compartment. Have to open the windows at a stoplight. Can also smell it when I walk past the parked truck. What's up?
View 8 RepliesThe exhaust leak is not too horrible, but, enough that I need to address it soon. Only on the driver's side; (today).
I'm planning on having a lot of PB blaster on hand, torch, broken stud removers, screw/stud extractors (easy outs), ...a hammer. Maybe a few cold Budweisers
Well I have a 2011F250 powerstroke. I recently put a 5" down pipe back exhaust on it. I ordered a 5" to 7" tip and it came in today. Problem is that it's 18" long so the only way it would work is if it exits at the corner of the truck
View 7 Replies