Ford Super Duty (1999-2016) :: 2001 F350 - Overdrive Light On Gear Shift Would Flash Intermittently
Apr 26, 2017
I have an '01 F350 super duty dually, 7.3L, auto trans. Over the past weeks my overdrive light on the gearshift would flash intermittently, maybe once every couple weeks. I chalked it up to a prior theft attempt where the steering column was damaged, and had turn signal/hazards issues after that.
Over the past few days my reverse gear has taken longer to engage, and is hard getting into the higher gears at speed. As of yesterday, reverse is out and won't shift out of second. Fluid level is good and clear. Could this be a PCM issue, or some sensor or relay?
View 1 Replies
Advertisement
I have a '99 F250 SuperDuty Diesel with an Automatic Transmission. There is a button on the end of the gear shift which allows you to turn off overdrive -- in other words the transmission won't shift into overdrive once you press the button.
Here's my problem. I start off driving normally. I've not done nothing to the overdrive button and the truck shifts normally into overdrive. 10-15 minutes down the road, the overdrive light (which indicates the state of the overdrive button) is FLASHING. Pressing the button doesn't stop the flashing. Once this flashing starts, the only thing I notice is a much more abrupt shift from 1 -> 2 gear.
View 14 Replies
1999 5.4 ... I was just driving down road and truck suddenly wouldnt shift into overdrive/higher gear. pulled to side of road and the motor was revving very high at 2500 rpm. shut truck off and on a few times...kept doing it until finally after a while it went back to normal....
View 1 Replies
The switch for turning overdrive off that's located on the auto trans shifter stopped working. I've taken off the column cover to see if the wires have been severed from the tilt wheel, but nothing wrong there. I also checked the fuses, and all is well. Is it possible that the switch is bad at the end of the shifter, or somewhere farther down the column?
View 14 Replies
I have been having some inconsistency with my transmission in my 2005 F350. I bought it used 2 months ago and have had the low/tow overdrive light blinking. a month ago I removed the pan and changed the filter in the transmission. I had a friend run the diagnostic test and found transmission solenoid code as well as both cat. converters as well as my Number 8 cylinder misfiring... I pulled the transmission pan and filter to find what appears to be 7 solenoids? Where to start?
View 1 Replies
I have a 2001 F350 7.3 4WD that does not want to shift into drive. When you shift to drive you can feel a slight difference in the trans but it will not move, it will rev freely but not move. If I shift it up and down it will engage after a lag period ranging from 10-15 seconds up to several minutes. Reverse is ok and after forward engages it appears to work as it should, shifts ok through the gears. I don't have much experience working on automatics.
View 4 Replies
F350 Super Duty sometimes the front driver side brake sticks and will pull to the left while driving and pull hard to the right while braking. It has a slight front end vibration when the symptoms are present. The wheel will be boiling hot to the touch and the smell of brakes burning is obvious.
After the truck sits, it will be good with no incident for weeks.
With the wheel still hot and on jackstand, the front wheel seems to turn freely until the brakes are applied, and seems to spin free again as brakes are released.
It seems to happen when I have a "hard braking" incident going forward until I park the truck and let it sit. If i consciously brake soft, the brakes seem to be fine.
I have read some of the posts and this is different in that it is intermittent.
I have replaced the brake hose as I thought it could be the "check-valve" symptom. No luck.
I have checked the sliders and re-lubed and they slide freely.
The caliper is relatively new and the fluid in the system is fresh as i recently changed the rear brake line and completely flushed and bled all four corners.
Do i just change the caliper, or, is there a way to find out if one of the pistons is intermittently binding? I would hate to invest in a new caliper if that is not the issue.
View 9 Replies
Tonight i noticed overdrive flashing. No changes in shifting, truck shifted fine. I shut it off when i got home, started back up, light was not blinking, not sure if its like the check engine light and stays on or not. Where light blinks but shifts fine?
View 10 Replies
I recentlyHad to replace the right front wheel bearing and after the install the speedometer and turn signals don't work, the ABS light is on and the overdrive light on the shifter is flashing. I've replaced the VSS on the rear diff, pulled and cleaned Speed sensors on front hub?
View 2 Replies
I bought this truck with 60,000 miles and have had about 3 months. I don't drive it very much but when I do I have noticed that when it sets for 4-5 days or longer the transmission makes a weird noise as you take off and does does shift into gear as it does when I use it ever day. The problem goes away very quickly (not even a 1/4 mile driving) and everything is fine after that. By the way I took it to the ford dealer who did a complete 60,000 mile service on it that was suppose to include changing the transmission fluid and filters-could they have screwed something up (I did not notice this issue until after the 60,000 mile service?).
View 7 Replies
The other day I was driving i was driving down the road when suddenly my truck wouldn't shift out of first gear, then the truck died and the motor wont turn over either. Acts like it is locked up. Its an 01 with v10 and 4r100.
View 6 Replies
I may be going to look at a 2001 F250, 4x4 with a V10 engine tomorrow. I think it is a shop truck for a business. The owner said that the mechanics told him that the trans won't shift out of low gear. It is an automatic. Maybe something as simple as a modulator valve (do they still use them)?
View 4 Replies
I have a 2001 F250, 5.4, 4X4. My ignition key stuck in the start position and when I pulled it back to the run position, everything seemed ok. As I started down the road, my speedometer stopped working and my overdrive light was flashing. Also my turn signals had stopped working and my A/C clutch didn't engage. Figured I burnt a fuse. I looked in both the under dash and power distribution box and all seemed well. I checked the fuse for the turn signals/flasher and it was fine. The flashers worked. Thought I might have fried something so I replaced the ignition lock and switch. Also my service engine light came on throwing a code for the vehicle speed sensor.
Looking for solutions on this forum and the internet, I learned that the turn signal switch could have gone bad and the VSS sensor is on the top of the rear dif and an easy fix. Well replaced the sensor but nothing changed. So I went back to the fuse box. Examined every fuse, big and small and I found a 10a with a small space. This was #24 under the dash. From the manual, "#24, 10A, A/C clutch, Blend Door Actuator, Trailer Tow Battery Charge Relay Coil, Four Wheel Anti-Lock Brake System (4WABS), Turn Signal." Replaced it and everything went back to normal. Turn signals work, A/C clutch works, no flashing overdrive light and speedometer works. All from a 10A fuse. If you have any of these symptoms examine all the fuses carefully. There's a 20A fuse for turn/hazard lamps and this other one buried that's only 10A.
View 1 Replies
Got an '01 f350 v10, auto. When using steering column shifter tends to be hard to find reverse and drive. Is it something in steering column selector or is it in tranny? The truck has 40,000 miles on it. Have a parts truck also so just trying to figure out where to start first.
View 3 Replies
I have a 2006 F250 with the 6.0 PowerStroke and automatic transmission. I just purchased this truck at an auction about a month ago.
Today I notice the transmission is not shifting into overdrive. No warning lights. If I press the tow/haul button in no change but the tow/haul light does come on. If I press it again (to turn it off) the tow/haul light goes out but still the transmission will not shift into overdrive.
This leaves me at about 2000 RPM at 68 MPH. I just had a Ford dealer perform Transmission service last week. (20,000 miles after the last recorded service.)
I am already not happy with the service I received at the dealer so I am really hesitant to take it back to them if it is something not related to the transmission service they performed.
View 5 Replies
My abs light is on. The guy I bought it from said he thought it was the sensor but who knows. Is there a way to test the sensors to see if they are working? Also can any other possible issues to look for? 2001 f350 7.3 xlt...
View 3 Replies
I currently am driving a 2001 F-350 V10 SuperDuty, and recently the battery light was blinking. I replaced the alternator in it, but it didn't work. I thought it was bad so I went and got another and it still didn't work. Turned out that the alternator wasn't big enough. I then went BACK and got a larger alternator, and it still won't work. Now the battery light is solid, and I'm getting absolutely no charge out of the alternator. I checked all the fuses and nothing is wrong. It seems like all the things you think could be wrong are running perfectly fine! What could be wrong. The truck will start, and idle, but will run off the battery only.
View 14 Replies
2001 F-350 4x4, 5.4 automatic.
Where to start , check engine light is on. Nothing seems wrong , trucks running good , nothing happened , just the light. I kinda like the truck so I would like to find out what its issue is?
View 2 Replies
2001 f350 v10, initial problem was when i came to stop at light it idled rough. I changed all plugs,injectors and COP, and bad connectors thereto. Changed the clock spring as well. Now the truck idles like crap at first start of of the day then run fine there after. Replaced IAC, TPS, Temp sensor. Condition getting worse and now the temp gauge does not work. I am thinking maybe CAT Converter loaded up?
View 2 Replies
2001 f250 7.3 crew
So, Saturday my abs lite comes on. Later that day I hear metal to metal sound for a couple of secs then it stops. Then the next day while driving I get intermittent sounds that sound like I'm dragging metal down the pavement. I see nothing but I'm thinking hub bearing. (Needle)
I remove the hub assembly from the knuckle and can find nothing wrong. I even picked up a new hub just on case. Now I'm stumped. Can't figure out what the sound was or is. Axle has a little play going into the housing but figure it would have due to the only thing holding it in place is the hub.
The only thing left in the area that could make the sound is major --the actual gears to to the front end. If the bearing isn't causing the metal grinding sound I've no other idea other than that....
View 2 Replies
2001 f350 7.3 diesel and I come up with the codes for upper and lower dual generator fault. I have only one alternator not the dual.. I checked the gauge and it is running at 14 consistently. But the service engine soon light keeps coming on...I clear them and they come right back... Alternator is only 2 years old and not a rmf..
View 1 Replies
