Ford Super Duty (1999-2016) :: 2001 F350 - Front Right Brake Sticks Intermittently?
May 19, 2014
F350 Super Duty sometimes the front driver side brake sticks and will pull to the left while driving and pull hard to the right while braking. It has a slight front end vibration when the symptoms are present. The wheel will be boiling hot to the touch and the smell of brakes burning is obvious.
After the truck sits, it will be good with no incident for weeks.
With the wheel still hot and on jackstand, the front wheel seems to turn freely until the brakes are applied, and seems to spin free again as brakes are released.
It seems to happen when I have a "hard braking" incident going forward until I park the truck and let it sit. If i consciously brake soft, the brakes seem to be fine.
I have read some of the posts and this is different in that it is intermittent.
I have replaced the brake hose as I thought it could be the "check-valve" symptom. No luck.
I have checked the sliders and re-lubed and they slide freely.
The caliper is relatively new and the fluid in the system is fresh as i recently changed the rear brake line and completely flushed and bled all four corners.
Do i just change the caliper, or, is there a way to find out if one of the pistons is intermittently binding? I would hate to invest in a new caliper if that is not the issue.
View 9 Replies
Advertisement
I have an '01 F350 super duty dually, 7.3L, auto trans. Over the past weeks my overdrive light on the gearshift would flash intermittently, maybe once every couple weeks. I chalked it up to a prior theft attempt where the steering column was damaged, and had turn signal/hazards issues after that.
Over the past few days my reverse gear has taken longer to engage, and is hard getting into the higher gears at speed. As of yesterday, reverse is out and won't shift out of second. Fluid level is good and clear. Could this be a PCM issue, or some sensor or relay?
View 1 Replies
Any good info on front brake replacement parts to get better braking out of these beasts? My pads are now needing replacement but I would like to get better performance than that of factory parts....
View 1 Replies
When on my 2-post lift my front brake lines on my '11 4x4 are pulled TIGHT, like stupid tight. It's also dumb that the soft line points UP 'cause it gets tugged down to a brutally tight 180.
I've got the front lift pads under the control arms, too, but near the very rear of the control arms so the axle isn't even dropped out all the way I don't think.
There's a bracket down near the bottom of the coil springs that could just be sectioned/lengthened, which I think would alleviate my issue. I'll be working on this soon.
What manufacturer builds a vehicle that yanks on the brake lines under full suspension droop? Shouldn't this be on an engineer's final checklist before the vehicle is released? Oh wait, they gave that task to Team TTB and Engineering Group TFI Or maybe they gave it to the same Audi team that designed the Allroad with airbags that can be damaged if you don't "lock" them out before lifting the vehicle......
View 14 Replies
Tonight I went to check the air in the tires on my 2001 F350 Dually and saw that the front right rim is broken. Two of the five spokes are completely broken all the way through. So this means I am looking to buy at least one good stock rim for the front. Might buy two if the price is right. Didn't want to spend the money for 4 custom rims right now unless it is really a super deal. If you have some sitting there in your way send me a message. My Zip is 46347.
View 4 Replies
I have a 2001 f350 super duty with the 7.3 diesel. It seams lately I'm noticing the front end seams to be taking a beating when going over bumps or rail road tracks. It feels like the front is bottoming out. I replaced the shocks in april, and just recently replaced the sway bar links to see if that will work. My thought is the front springs have lost there arch, but I'm not sure. They do look like there almost flat. Don't know if this is a problem on other trucks.
View 8 Replies
Do a 2014 f350 front bumper will fit on a 2001 f350? Wanting to know if the bolt holes and body lines will match up? I put a 2014 rear bumper on and it bolted right up.
View 8 Replies
I have a 2001 f350 4x4 with7.3 diesel...I have recently noticed a low grind like noise coming from the right front. I have troubled shot the issue and I am 100% sure it is the wheel hub assembly. Did I mention I am running 37x13.50 tires..and now you say no it is the hubs...and they are the original hubs. My question is every thing I look for shows ABS is on my truck... I look at the hub and don't see it.. so with the Dana 60 front does it have ABS or not? Also, should I go motorcraft, Timken or moog wheel hubs?
View 1 Replies
I have a 2001 F-350 Diesel 4x4 crew cab 8ft bed dually 7.3 diesel 6 speed. The issue is that the parking brake pedal is extremely hard to push. One day it pushed down and ratcheted into a locked position as normal and the next day I couldn't push it more than an inch down. I have rear disc brakes with internal drums in the rotors for the parking brake assembly. I replaced the shoes and hardware (which were fine) and I still have the same issue. I removed the front single cable from where it splits into the two rear ones and the foot pedal depresses smoothly and with the touch of a finger with no load on it. What else is it? The only other thing is one of the rear cables unless I am missing something?
View 5 Replies
I got a 2001 f350 got a noise in my left front wheel i know its not the wheel bearings, it only makes the noice when the locking hub is unlocked i did jack the the truck up and spun the wheel got a faint grinding noises form what seems like the locking hub so my question is bad locking hub or needle bearing holding the axle shaft??
View 3 Replies
2001 f350 4x4 dually 7.3 powerstroke, I recently replaced the hub assembly, stub shaft and seal, u joint, ball joints on the front drivers side and now periodically the truck makes a grinding growling vibration coming from front drivers side and stops after hitting a bump...
View 3 Replies
2002 F350 7.3 intermittently wont start after I've shut it off, it runs fine but sometimes won't start when it's (warm)? Wait hour or more and it starts right up.
View 2 Replies
Quick question, 2008 F250, 6.4. If the EGR Valve sticks/malfunctions, can this cause the truck to go into constant/frequent regens? I am asking because I am about to replace my turbo for a seal failure. The only code thrown before turbo failure was EGR flow insufficient. I want to figure out what may have caused the seal failure so that I can get that fixed before I blow through another turbo.
View 10 Replies
I just bought this 2006 f350 lariat. The instrument cluster, radio, pwr windows (and prob other things) will go dead intermittently. No rime or reason, some days no prob, others, several time a day. Always come back by itself, cycling the power has no effect. I if it is shut down during a no power episode it will not run right till the power comes back to the dash, radio, windows. Looking on line seems to be a common problem with the "retained power accessory relay" circuit in the instrument cluster. I found nothing on a DIY fix...
View 14 Replies
I have a 99 f-350 , which i bought recently and either the calibers are froze up in the rear or the cable looks too tight.. Is there any adjustment.... Every place i looked it seems to be none..... on my old 1988. Icould adjust it where the 2 rear cables joined the 1.... Am I missing something or cut the 1 main cable and add a turn buckle....
View 14 Replies
I went out getting firewood in my 2001 F350 4X4 6.8l V10 auto . Backed up to the slash pile, put the truck in 4X4 Low and went to work.
When we finished I flipped the switch to 2WD, but the transfer case would not dis-engage and the IDIOT LIGHT on the dashboard stays on 4X4 Low... I can't get the truck out of 4X4 Low. I turned the hubs from auto to lockand its still stuck in low range.
View 8 Replies
I recently purchased an '08 F-350 4x4 Lariet Supercab 6.4l and was told by the 3rd party inspection that it needs rear brake pads (2mm left). Are the caliper pistons retractable without having the pistons seize down the road? HOw about the fronts? See below.
I ask as on my '06 F-250 XLT 4x2 5.4l the rear calipers seized without even doing a pad change and the fronts seized about 100 miles after a pad change. Come to find out it is a common problem with the '06 and the calipers either have to be replaced or rebuilt when changing pads. Now I've been "told" to expect the same with the '08.
View 8 Replies
I'm putting new brake pas on my front and I want to know what is the best type to put on there. I ave a 2006 F-350 Dually.
View 3 Replies
At low speeds, I notice a squeel sound in all four wheels. Ford tells me that it is due to the type of metallic pads they use and is essentially brake dust noise that warrants no repair.
Any after market pads that are good quality for towing heavy loads, yet aren't metallic in composition? For instance, are porcelin pads a good choice.
View 2 Replies
my dads front drivers brake caliper was dragging so last Thursday he had the local Ford dealer install a new one WHY i don't know since i always work on everything of ours plus my friends Fords. Today he said he pushed the brake and it went to the floor then he let up and pushed it again and they worked?? I haven't looked into it yet but the dealer cant look until Friday morning so my dad asked me to do it today after work..... what should i check for? leaking brake line, maybe air in the system still?
View 4 Replies
We have a 1994 350 ford dually. the brake light and the abs light came on and it has no brakes. replaced the master cylinder ... still no brakes. what next?
View 1 Replies
