Ford Super Duty (1999-2016) :: 2001 F250 Will Not Start When Cold If Forget To Plug In Block Heater
Feb 27, 2014
Cold no start goes nowhere. I have a 2001 7.3 that will not start in the cold if I forget to plug it in....like last night. I have to plug in the block hater and give it a while before it will start. I tested the glow plug relay,it works fine. I can not find a test for the fuel bowl hear, and I'm not one to throw parts until I accidentally fix it. Any test procedure for the fuel bowl heater? Why this POS is so bad in the cold? Glow plugs tested fine at diesel shop in December, and this problem has been around since before that.
View 14 Replies
Advertisement
I can't seem to get the engine temp to middle range on the marker, but yet my heater blows "to me" hot air. Even while sitting in idle for extended amounts of time I cannot get it to "operating" temperature. I would think if my thermostat was stuck open my heater would blow either cold or slightly warm air. I have the 5.4L engine with knn air filter and no cats.
View 14 Replies
I changed the IAC valve 2 months ago because my truck kept stalling when idling down on a cold start and that fixed the problem. A few days days ago when starting it started revving to 2 - 3 K and won't IDLE down now? I changed the IAC again and that didn't work. What else should I be looking at to stop it from revving so high?
2001 F250 5.4 111,000 miles super duty.
View 2 Replies
When I bought my truck it didn't have the block heater installed, asked the dealership to put it on with the deal, but they didn't have one there. How hard it is to install one? Also what brand should I go with? (On my '16)
View 5 Replies
The heater blows cold air from the driver side only. Very cold. Vey hot on passenger side.I have read that this is likely a blend door issue. Comments? Fluids are full. I hear slight noises from under the dash like "click click" like a door is trying to activate?? Truck out of warranty. If it is the door I heard the driver side is not as tough to install. Again comments? Instructions?
View 2 Replies
It got down to the low teens the other day and I thought I would use my engine block heater to see how well it works. But when I got in the oil temp was basically the same as the air temp (it may have been 5-10 degrees warmer but still not above 20*F) after being plugged in for 2-3 hours. Is something wrong here? I would have thought it would have warmed it up or does it not affect the oil temp? If not, what does it warm up?
View 7 Replies
2001 F250 5.4. The heater will blow warm air at idle and on the second highest setting, once you start moving or turn the fan up to full blast it instantly cools off. The coolant level is fine. The engine runs at a normal temp.The blend door does work. I just replaced the thermostat, and both hoses for the heater core are hot.
View 4 Replies
I have a 2006 f250 and the heater will blow cold air unless you are driving in like highway conditions. If you stop or drive slow it blows cold air only. What is causing this???
View 3 Replies
I recently replaced my heater core on 2001 F250. Would be a simple job if it weren't for the quick connects on the hoses. Any tool to take these apart on the truck where space is limited?
View 1 Replies
Sunday I bought a 2001 f250/5.4 to replace my 91 f250. I didnt drive it yesterday, but this morning on my drive to work the heater was very weak, it seemed to blow warm for the most part, but was barely pushing air even on high. I flipped it over to A/C to see if it blew any harder and it did. Does the blower motor need replace? if so why does the AC blow harder than the heater?
View 14 Replies
My 2011 F-250 just started having a weird heater problem. My truck heater gets up to temp just fine but after cruising down the highway for about 15 minutes or so it starts blowing out cool air. I can turn the controls to defrost and back again and it blows warm, not hot but warm then cool again. It just started a couple of days ago. Temp gauges show normal temp also.
View 8 Replies
I have a 2002 f250 superduty 5.4 4x4 around 317xxx original motor and trans. When it's cold out it won't start at all I have to use starting fluid but once started it will start right back up. Did the plugs fuel filter cleaned the intake and sensors still have a problem plenty of fuel pressure plenty of cranking amps brand new battery and Alternator. It just cranks and cranks when it's warm out fires right up. Runs smooth no lack of power or misfire no codes are being thrown also.
View 14 Replies
I just bought a 2000 F250 SD 6.8 v10 and its mixing coolant in the block and leaking oil. I'm debating on just dropping a newer v10 in it but im just not 100% sure that this engine is shot. It runs great when there's oil in it and I can't even tell there's any problems going on for well over a couple hours after i fill it up with oil.
View 8 Replies
When I cold start my 99 F250 7.3L PowerStroke extended cab long bed manual, I get diesel smell in & out of the cab. What is causing it?
View 3 Replies
My 2000 F-250 6.8L V10 has a choppy idle during the first 30 or so seconds after a cold start up in the morning then it smooths out and drives perfectly. If I were to place the truck in gear during the choppy idle, it would not die and throttle response would be fine.
I cleaned the MAF sensor and checked the PCV elbow for cracks (no cracks). It idles at about a 1000 rpm during a cold startup then drops to about 750 rpm according to the dash tachometer. The truck has 187,000 miles on it.
View 4 Replies
So, I have a 2007 f250 with the 6.0. When she's cold she starts fine but runs rough like she has a miss. When she warms up the miss goes away and it runs pretty good. But if I shut it off it won't start for about an hour or so.
ICP sensor has been replaced.
FICM is putting out 50v
View 11 Replies
Just bought a 02 f-250 7.3 with 115k miles. A couple days after I bought it I noticed a lot of white smoke on cold starts for about 20-30 sec at 50 degree temperature. So I tested the GPR which ended up being bad a replaced with the one that is double in size(name escapes me atm) and also did the 50 cent mod to keep the through-valve cover harness from losing connection since both sides were lose.
After that the temp warmed back up and it would only blow a "puff" of white smoke. The past two days it has gotten down to 30-32 and the truck has a rough time starting. Cranks fine but it's almost like it's getting choked or flooded then it will blow smoke for 3-4 minutes after it starts. The truck does have a FASS fuel system on it with stock injectors. Should I try to Ohm out the glow plugs again or where should I start trouble shooting?
View 3 Replies
I have a 01 f350 7.3 turbo dsl. will not start cold. engine turns over fine. plug into block heater over nite , will start! outside temp does not make difference. I have replaced glow plugs, glow plug relay, wiring harness under valve covers. Where to go from here?
View 14 Replies
My '01 f250 7.3 has gotten hard to start. It seems to maybe be due to cooler weather, but not always. I have been told that there is some sort of valve in the fuel tank that could possibly cause this when the fuel gets around a 1/4 tank or so. But, it's doing it at any fuel level. But it doesn't do it all the time. I do notice it more in cooler weather. Anyway, when I try to crank it, I'll let the "wait to start" light go off and then wait a bit more. I'll turn it over and it almost as if the batteries are weak.
I'll stop and give it a few seconds and turn it again and it will normally start. But sometimes I'll do this 5 or 6 times and it will finally fire. But the more I have to try, it's like fuel builds in the cylinders and it smoke like a coal train for a minute or so. Almost like gas motor that has been flooded. But the smoke burns off and it runs like a top. I was thinking the batteries may be weak , but sometimes the starter will spin the motor with no trouble at all. I'm at a loss. Is it possible for fuel to drain from the system causing it to have to reprime itself? Here lately the smoking has me concerned even though it clears up.
View 7 Replies
My 2001 F250 will not start (clicks). I verified its not the battery and even tried to jump start it. I have never replaced a starter- but before I do that I read where there is another solenoid under the hood somewhere. I always thought there was just the one on the starter itself.
Two questions:
1. where is that other solenoid located and should I replace that first?
2. How difficult is it to replace the starter? I am pretty handy.
The issue is that I cannot get it towed easily - I just need to get it started at least once since my plow is still installed and it's hooked up to a trailer..
View 1 Replies
My 2001 6.8 L V10 runs great all day & night without issue, but first thing in the morning when below freezing it has a hiccup. It'll fire right up and stutter and stall within less than 2 seconds. Usually twice. Third time it fires and keep running. Is there a fuel check valve somewhere on this thing? Not sure what that would have to do with the temps. Wondering if it's/there's an easy fix or not?
View 5 Replies
