Ford Super Duty (1999-2016) :: 2001 F250 - No Voltage At Either Window Switch
Mar 24, 2013
Just picked up a 2001 Gas F250 4X4 XLT. Everything seems to work except for the electric windows and ABS. I pulled both window switches and cannot find any voltage on the Blue/black cables. I jumped 12v to the drivers side switch and the windows work up and down even in auto. I have voltage at the 30a circuit breaker in the PDB but nothing at fuse #7 in the PCFP. I've checked for voltage at another connector with a Blue/black cable and found nothing. I'm thinking bad cable or GEM. I have noticed that the bell system doesn't sound when you have the key in the off position with the door open if that matters.
View 14 Replies
Advertisement
I have a 2004 f250 6.0 diesel and my passenger window switch died today and I switched it with a known good switch and it still does not work but will work from drivers side .the switch doesn't even light up. Looking for a diagram or know the colours of the wires to switch Soni can test to see if the switch is getting power??
View 1 Replies
I have a 2001 F250 4x4 and the ESOF switch not engaging hubs, currently I have no 4x4 lights coming on in the cluster when i turn the switch. I am not experiencing any of the vaccum symptoms that most people are suggesting. I When I turn the switch i also do not hear any relays clicking. Relays have been tested, and i waited for the 45 second transfer delay that the manual mentions. ESOF switch has power, and is working properly (I know because I bought a new one in attempt to fix the problem) Basically I have no responses from any of my 4x4 indicators or parts.
View 14 Replies
My drivers window will not work at all but when I push the button I get a clicking in the fuse box. The other 3 windows partially work but will only go up or down in small increments. I have tried holding the button and slamming the door and this allows the other 3 windows to work. I thought it was the switch so I replaced it and that was not the problem. Fuse and relay seem to be fine. If it was just the driver window I would think it was the lift motor but with the other 3 windows on the fritz I have no clue.
View 1 Replies
Truck would have a miss that went away when warmed up past 180. Ficm voltage was low so I got a new one from diesel tech ron. After I installed it The truck would crank for maybe 5-6 turns then lock up and kick the starter out. The starter broke away from the motor from the kickback. I got a new starter in and set up my scangauge 2. In the few turns of the motor i can do before it kicks out, ficm is at 48.5 koeo and cranking, ipr at 14.4, and the icp shoots up to 1100. The ficm sync wont come on and I m stumped what to do next. Dont want to start throwing new sensors at it. 2004 f250 6.0 ...
View 1 Replies
Any easy way to disable the passenger window control? Being a 2 door supercab, I do not have the "window lockout" button on the drivers control. I would like to be able to control the passenger window only from the drivers side. The problem is, my 2 dogs will put there paws on the passenger arm rest to look out the window. Occasionally, they step on the window down button. Once he stepped on the window up button, while window was down and would have gotten his neck stuck in the window had I not pushed the driver control to stop the movement of the window.
View 11 Replies
I did a search and flipped thru the owners manual without any luck. But my 99 Super Duty is equipped with a rear power sliding window but I can't find the dang switch anywhere. Where is it supposed to be located...
View 10 Replies
1999 f250 passenger window went down but will not go up. Neither switch will make it go up. I was wonder if both switch could have went bad? Any way to test a switch?
View 4 Replies
2002, F250, 5.4L, ZF-6 trans.
Ok...today by accident turned the key with the truck in gear and clutch not depressed...much to my surprise the truck tried to start and lurched forward.
Is this a sign of a failing clutch safety switch or Could it be an ignition switch problem? Anything else that I am not thinking of?
View 5 Replies
When you turn the headlight switch to the headlight on position, you can pull it out exhibiting a positive click as if it is an additional switch for maybe optional fog lights. If the headlight switch is in the off or running lights only position, this will not pull out. I reviewed the elect. diagram but it does not show and addition circuit for the pull switch functionality?
View 4 Replies
03 F250. Passenger window is stuck up. When I have the door panel off, I can feel the motor trying to move up. Won't go down at all. When I connect test light to the plug, it lights up correctly for both up and down. Thought maybe it was the motor so I got a new one but it only tries to go one way. It's like the switch isn't sending the signal for the window to go down even though the plug appears to be getting the correct signal.
I took apart the driver's side switch and nothing looks crimped, bent, etc. From some reading, it sounds like possibly the regulator is bad, does that somehow send a signal back to the switch? Is there a relay or something that could be bad? I find it odd that test light seems to work but when connected to a motor, it doesn't.
View 1 Replies
I have a 2008 f250 with 6.4. Was sitting my truck with key on and motor off listening to radio on lunch and my wipers came on by themselves. Switch was in off position and we're in slow speed. If I turn switch they wouldn't change speed til high position. Turned key off and back on and they came on still. Pulled 30 amp fuse in battery junction box to shut them off.
View 3 Replies
I have a 2006 F250 Super, CrewCab 4 dr, 6.0 w/60K. Last month I tried the rear power window and .......nothing.
It tried to open 1/2 inch and then stopped, had to try to power it closed and it moved 1/4 inch and I pushed it the rest. Removed the rear cover behind the seats and I can see the motor and wires attempting to move but it does not move and I am afraid to burn the motor out or push too hard and break a cable or worse.
The track looks really dirty, I use that window maybe once every 2 months.
1. Can I replace the motor myself?
2. Can I put something in the track to clean/lubricate?
3. Should I try to open the window under power and some additional manual pushing?
View 14 Replies
Headlights work well w/ ignition switch off. High/low/passing all ok. When I turn the ignition switch on, there's a strange wheezing sound for a second.
When the ignition switch is on, there are no headlights.
What's the wheezing sound? Why does the power to the switch quit with the key on? The more I work on modern trucks, the more I like my 1968 f-250.
View 1 Replies
I just ordered a set of Hella 4000x driving lights for my 2006 F-250. I have an aftermarket bumper on it, so the fog lights were taken out as there was no place to put them once the new bumper was installed. The question is, will I have any issues hooking the new driving lights up directly to the fog light system so I can just run them off the fog light switch instead of having to install the new switch on my dashboard? I know the new lights are 12V, but I couldn't find info as to whether the fog lights were running 12V as well.
View 2 Replies
I have a 2010 F250 super duty. I use it for work so I am not sure what happened to it as others have driven it, but here is the issue. When i start it up in 2wd, the 4x4 Low light flashes continually. If I turn the switch to 4x4 high, the 4x4 high light flashes continually. if i turn it to 4x4 low, that light flashes continually. I have read the forums but haven't been able to find the problem/diagnosis for this.
View 2 Replies
here's the problem. The driver side front power window will only go down and not up. I checked the motor and the master switch with a multimeter and both work just fine. the motor is receiving power and the master switch is sending power. However when i plug the motor back in and re-install it, the window will not go up. Is there some sort of relay that might have gone bad that is not letting the motor raise the window up???
View 5 Replies
I am trying to change out my solid back glass for a power slider that's oem... My question that ford could not answer is, is the wiring all in place minus the switch for the install.. I have a 2012 F250 XLT. I am not even sure where the switch to move the window would go either...
View 2 Replies
I need to replace, its either a brake pressure sensor or speed control deactivation switch . Would like to know which it is and can I get a generic one from other auto parts beside a ford dealer Can post a pic of part as soon as I figure out how to do that exactly. 2002 f250 super duty....
View 8 Replies
2001 F450/6.8. The trim ring is missing on the shift lever switch and the switch doesn't seem to light up or take the truck out of overdrive when pressed. Truck shifts just fine in all other aspects. Fuses all appear to be good.
View 2 Replies
On my way home today I heard wind coming in around my drivers side power window. Its not seating itself straight in the weather stripping. The window is tilted toward the front of the truck. Do I need a new regulator? Or maybe re- epoxy glass to bracket? The window still operates, its just crooked. Also I haven't had those door panels off before..
View 1 Replies
