My defrost is stuck no matter which way I turn the control it won't come off. It just started doing this today. I think it might be a vacuum leak. When I turn my switch on the pump still clicking whether or not it's pumping.
View 2 RepliesMy 01 SD won't blow air anywhere but through the defrost vents.
View 9 RepliesLast Oct. I noticed that my ac/heater started to intermittently stop blowing from AC fresh air/recir/vent/etc. mode and stick to defrost only. Do I have a bad switch and or a vacuum issue here? It's a '01 F350 CC 7.3 .....
View 6 RepliesFinally finishing up my 2001 F250SD 4X4 project. Decided to pull down the front axle to replace the dust seals. I've got everything apart including the large knuckle seals. Tried to pull the passenger side axle out but it only moves about an inch to an inch and a half before it stops. Took off the differential cover to look for damage or something obvious but I don't see anything wrong. The axle is moving within the splines of the spider gear but that's it. Stumped and sitting on jacks!
View 14 RepliesSo I just got an 01 f250, 5.4. Really loving this truck so far. Noticed as I was driving my gas gauge is stuck at full. One time it randomly dropped down to about half tank where I think it should be, but it jumped back up to full. Anything to suggest trying? I tried nailing a speed bump to knock the float loose at 30 and I'm not sure if it worked. Gauge goes to E when I shut the truck off, but as soon as I turn it on it jumps up to full. Should I try hitting the tank with a mallet?
View 6 RepliesI am a few DAYS into a project changing my ball joints on my 2001 F250SD 4wd.
Latest issue is I can't get the brakes back on. One of the pistons was pressed out making replacing the calipers onto the rotor impossible. Fiddling with things has only made it worse.
The higher piston is stuck extended, and the other piston doesn't even budge.
The truck is our only vehicle, and I have been working on it since Tuesday night. It looked like it was going to be done today, but I can't put it all back together now.
That piston will not move. I've tried opening the bleeder and taking a clamp to it but all I get it a few more drops of fluid, no visible movement.
A while ago it looked like this. I got it to move in a little, but it is firmly stuck.
I'm wondering if I can pull it all the way out and clean/sand polish it. Can I use a quick-clamp on the rubber section of brake line to isolate the calipers so I can pull the piston out without draining all the brake fluid from higher in the system? And what do I do about the other piston that doesn't seem to be moving at all? Grab with big pliers and twist/pull?
Some of us just have a knack for finding layer upon layer of problems on projects...
I have a problem with my vent selector on my truck. It's a 2005 f350 lariat. The vent is stuck on defrost, some times after a few mins I can get it to switch to floor but not always. I have replaced the pump, checked tank for cracks, disabled and plugged the auto hubs. The pump will shut off so I assume it's not a leak. I believe it's in the switching unit, can these be repaired? I found a lot of dust and dirt in the vac tank that had been sucked through a bad hub. I think it may need to be disassembled and cleaned. I have seen videos showing how to replace the orings in the older units. Are the newer style remote ones the same?
View 5 Replies1999 F250 7.3 4x4 switch on dash with manual hubs. No visual vacuum hoses cracked.
Not sure what this component is but when I wiggle the wire at the orange cap a small motor kicks on.
I have a 1999 F 250. When I accelerate my AC from the vents changes to the defrost. Other than that it works great and is ice cold. Why it's doing this.
View 5 Replies2006 F250 5.4 - While driving ac changes from vent to defrost on it own..let off gas and it will change back to vent. I replaced vacuum can under hood.. no luck.....
View 1 RepliesI know there is a motor or switch that I can remember the name of that is in the dash somewhere that controls the Defrost and regular cabin flow. I am not good with A/C, and was wondering, what is the name of it, and is it something I can get to behind the glove box or is it very complicated?
View 7 RepliesThe A/C on my 05 F250 6.0 recently would not blow out through the vents. So, I replaced the vacuum pump and the reservoir tank. Once I replaced them the A/C still starts through the defrost vents but, after a minute or so starts to blow through the vents. I also noticed that the vacuum pump never stops running. Is this normal or is there something else I need to look for?
View 5 RepliesMy 2005 F-250 6.0 liter Diesel FX4 Lariat is blowing AC through defrost only all the time. I have manual locking hubs and when I engage 4x4 it works perfectly through the ESOF switch. So I am assuming the vacuum pump and lines to the hubs are in good working order but there is possibly a cracked line or fuse blown? I've only had the truck for 2 days and it just happened after purchase. I'm a little unfamiliar with checking vacuum but have done reading and I believe I can do it. I am going to get a manual hand pump and pump to 20lbs and loss shouldn't exceed 1lb per minute. I just need to know which direction to look. Everyone else had their 4x4 not working and I seem to be the only one posting that has ESOF 4x4 capability when the defrost only issue is on.
View 11 RepliesMy 2005 F250 just had the cab off in December for head studs and gaskets. Its a Crew Cab short bed FX4 so it has ESOF. When I engage 4x4 the blower will switch from blowing air out of the vents to blowing air out of the windshield defrost. Is a vacuum line plugged in wrong somewhere, or is one cracked? Trying to figure this out, its rather annoying
View 2 RepliesMy truck at idle sounds like it has aftermarket cams and the exhaust coming out of the tail pipe smells really rich. when driving down the road my heater controls default to defrost. Also when I fill up with gas it takes forever to get it to fill all the way. I am lost on where to begin with the problem [ I did check the tank vent hose and their is no blockage] Possible vacuum issue?
View 10 RepliesMy 2005 Ford F250 6.0 diesel CLIMATE CONTROL DEFAULTS TO DEFROST mode all the time now. For some reason I'll turn on the AC and it is either already in defrost or changes to it no matter what I do. Is the head unit in the dash the problem or is it a vacuum leak or an electrical issue?
View 2 Replies2006 F250 with the dash controlled 4x4. I typically keep the front hubs locked on this truck. I have recently noticed that when shifting into 4x4 that the a/c or heat will switch from blowing out of the vents to blowing out of the defrosters. Any clues how to fix this?
View 1 RepliesI have a 2006 F-250 Super Cab with climate control. The last three years when the temp exceeds about 85 degrees outside it acts up. It will switch from the AC vents to defrost and blow normal air through, not ac cold. Then it will switch back, when doing so I can hear the internal deflector shudder. It will do this every few minutes. It is extremely annoying. All other times of the year it works fine. My local dealer had the truck last year, but could not find anything wrong. I have used the search and also Googled and while I find similar problems nothing exactly the same.
View 12 RepliesLike the title says; I have a 2001 F350 with No blower Motor and Just Defrost, it is actually a friends, he is building a fence, and I am looking into the truck problem. The just defrost is probably a vacuum issue, but I do not have any book for this truck, so I have no vacuum or wiring diagrams. As far as the blower motor, I am thinking switch or motor, fuse has been checked? Is there any other "control" box involved with this year/model? Also any dash tear-out instructions, to make the access easier?
View 1 RepliesMy father has a 2009 Ford F-250 Superduty with the 5.4l V8. Two days ago, he frantically woke me up from a nap because he could not get the truck out of park nor are the brake lights turning on when the pedal is pressed. I instantly thought Shift Interlock, did a quick google search and found that it can be the shift interlock or brake light switch on the brake pedal. I have since then replaced both to no avail as well as checking all fuses. I put a multimeter to the brake light switch connector and am getting a steady 10.2v. I am aware there is a bypass switch but that doesn't address the fact that he has no brake lights.
View 9 RepliesMy Ford 250 is currently stuck in park, it starts but I can't move the shifter. It sounds like it is a fuse issue from what I have read, but I bought the truck at an auction and I don't have a book. Do the brake or parking brake fuse? And where is it located? I know there is a panel under the hood and under the dash, which fuse to look for. It's a 2008 extended cab gas model.
View 13 Replies