Ford Super Duty (1999-2016) :: 2001 F250 - 4x4 Light Is Permanently Lit Up On The Dash
Mar 15, 2015
2001 Ford F-250 7.3 Lariat, Crew cab, 8 ft bed. Have had the truck since about 2007 and 4x4 has never worked. It has the typical ford "self rotting" vacuum lines (which have all been replaced along with the hubs themselves). Took it to a mechanic a few years back and he n-word rigged it (for a lack of a better word) and bypassed a lot of vacuum stuff and it still didn't work. The weird part is this-- the 4x4 light is permanently on on the dash, even if the switch is in the 2wd position. Flip the switch and nothing happens. No sounds, nothing. No mechanic can fix it and I have yet to find a forum with someone having the same problem. (Worth manual transfer case swapping it?)
View 10 Replies
Advertisement
Am I the only one who thinks the tire pressure monitoring system is a silly feature? Is there any way to delete this and stop the light from coming up on the dash? I want to do new wheels and tires on my 2008 f250 and I don't want to deal with the tpms. Can it be tuned out from the computer?
View 14 Replies
I'm from SC where we are currently getting our rainfall for the next 3 years, so it's an occasion to find leaks. My 2001 F250 has developed one right in the middle of the passenger side dash, I saw it running down a white vacuum tube and dripping off to the floor mat. Is there a place in the cowl that will hold water and leak?
View 3 Replies
I have a 2001 f250 v10 lariat ext cab. i was going to get wood the other day down a muddy road. My radio went out and all my running lights. i replaced the fuse radio and now the switch. Still nothing. Could it be a bad ground? i ran a jumper wire on my old switch and they worked then just stopped again. if it is a bad ground where would it be located.
View 3 Replies
I have an 2001 F250 SD with 7.3 Diesel. Headlight switch failed and I replaced it. But now I have no high beams and my dash lights that light the dash up don't work. Gauges, fog light, low beams all work fine. Fuses checked. Multi function switch checked. What to do next?
View 1 Replies
The light on dash for 4X4 stays on no mater where the switch is placed I have it in 2 wd and it stays on. Where I need to start looking.
View 4 Replies
2007 ford f250 .... 200k on it ....
Just had refurb engine installed with new oil elements as well. On a 9 hr road trip, the wrench light came on but no other warning lights.
No stock gauges showed any raises in levels.
No noticed loss of power at all.
The light would only come on once I drove at about 75 mph for about 10+ miles. It would not turn off when i slowed down, but when I would kill the truck and restart it, the light would be off. Just driving in town or on the highway briefly, nothing comes on. Took it in to oreillys to get scanned and they tell me a few codes pull up but none of them are valid. What would trigger the wrench?
View 7 Replies
1-11-11 built F250 with the 6.2. 45K miles. Took it to my local HD truck shop to have the code read. The reader said "Evap pressure sensor switch malfunction", "vac above pressure limit wouldn't bleed". He cleared it and it has now come back.
1. Where is said switch located? Is this something I can do as I'm a seasoned wrench but I'm not dropping the tank in my driveway in the winter.
2. Is it in the tank or outside the tank?
3. Has there been any TSBs or recalls on this before I attempt to repair?
View 6 Replies
We currently have a 2011 F250. During the day time, when you turn on the headlights all the way (not just on "auto"), the dash lights and clock shut off. Originally, I thought that they were just dimmed to the point where you couldn't see them, but the brightness is already turned all the way up on the dash lights. If I turn the brightness up any higher, the dome lights turn on, but the dash and clock remain off. If you return the headlights back to the "off" or "auto" position, the clock and dash return to their normal brightness.
View 4 Replies
I bought a 2002 f250 Crewcab bout 6 months ago. A couple of months back I noticed that after driving it and turning off ignition and opening door my radio would stay on and doors would not respond to key fob or switch on doors. Eventually it would reset and radio would turn off and key fob would work. It also makes the locking sound when press on brake. It doesn't happen all the time though and that's only issue. Truck is in awesome shape only 106,000 on it, belonged to an old man who only used it to tow camper twice a year. I've read a few posts that have similar problems and have heard could be gem or vsm.
View 2 Replies
I recentlyHad to replace the right front wheel bearing and after the install the speedometer and turn signals don't work, the ABS light is on and the overdrive light on the shifter is flashing. I've replaced the VSS on the rear diff, pulled and cleaned Speed sensors on front hub?
View 2 Replies
Tonight i noticed overdrive flashing. No changes in shifting, truck shifted fine. I shut it off when i got home, started back up, light was not blinking, not sure if its like the check engine light and stays on or not. Where light blinks but shifts fine?
View 10 Replies
I have a 2001 F250, 5.4, 4X4. My ignition key stuck in the start position and when I pulled it back to the run position, everything seemed ok. As I started down the road, my speedometer stopped working and my overdrive light was flashing. Also my turn signals had stopped working and my A/C clutch didn't engage. Figured I burnt a fuse. I looked in both the under dash and power distribution box and all seemed well. I checked the fuse for the turn signals/flasher and it was fine. The flashers worked. Thought I might have fried something so I replaced the ignition lock and switch. Also my service engine light came on throwing a code for the vehicle speed sensor.
Looking for solutions on this forum and the internet, I learned that the turn signal switch could have gone bad and the VSS sensor is on the top of the rear dif and an easy fix. Well replaced the sensor but nothing changed. So I went back to the fuse box. Examined every fuse, big and small and I found a 10a with a small space. This was #24 under the dash. From the manual, "#24, 10A, A/C clutch, Blend Door Actuator, Trailer Tow Battery Charge Relay Coil, Four Wheel Anti-Lock Brake System (4WABS), Turn Signal." Replaced it and everything went back to normal. Turn signals work, A/C clutch works, no flashing overdrive light and speedometer works. All from a 10A fuse. If you have any of these symptoms examine all the fuses carefully. There's a 20A fuse for turn/hazard lamps and this other one buried that's only 10A.
View 1 Replies
I have a f250 with 6.8l engine. I can get air thru the defrost and to the floor, but no air thru the dash vents on me. I have traced all vacuum lines and they seem fine.
View 1 Replies
Just bought this pickup is a 2011 F250 xl with the 6.2l. The service 4x4 flashes on the dash. The 4x4 shift motor fuse blows instantly when replaced even with the vehicle off. I then went and disconnected the plug ins from the shift motor and tried a new fuse and it blew again. Not sure where to go from here.
View 2 Replies
My 99 250 XL only has heat, and the blowthru vent air which in Florida, might as well be heat also. LOL.
Since the vents and everything is there, what all and how hard would It be? I have an extra dash control that I can put since mine doesn't have the ac option on it
View 14 Replies
2015 F250 diesel. I am hooking up an air pressure gauge inside the cab to report the pressure on my rear aftermarket air bags. The pressure reading will come from a tap on the actual pressure line, but I need 12vdc to operate the backlight on the gauge. I have found a bundle of loose wires under the steering column, 4 of which are firewall pass-through wires for the upfitter switches. Do one of the remaining wires in the bundle is an accessory power wire? I need a plain key-on accessory wire connection, not a dash-light connection.
I am using one of the upfitter switches to switch my on-board air compressor and a second switch to inflate/deflate the air bags. Want to save the other 2 switches for future use.
View 7 Replies
I am getting this check gas cap warning on the dash. I checked the cap, looks ok... Should I disconnect the battery for a minutes.. and see if it comes back?
View 4 Replies
I love my new truck. '15 250 CC SB. It would be nice if when I am backing up not to have the dash lights in my eyes once I turn off the head/parking lights at night. I turn off the head lights so as to make everything darker. Much easier to see what is in my mirrors.
View 2 Replies
Ever since I bought this vehicle, the dashboard lights won't light up unless it is totally dark out. For example, yesterday I am driving in heavy rain during daytime (but pretty dark out!) and Autolamp turns on the headlights...but none of the dash lights! I always thought the dash lights should be on if the headlamps are on. Sometimes just the needles light up. How do I know if my lights are actually on if no dash lights are on?
View 14 Replies
Bought a 02 F250 5.4L a few weeks ago. i have replaced the coils and plugs, put in some fresh oil and some other minor things. Last weekend i drove over to my neighbors and back with no issues, until i went back out to start the truck an hour later.
The dash lights come on, but the engine wont start up. i hear a kind of whirring sound coming from a black canister under the hood on the drivers side. I cant use my code reader and I have pretty much exhausted my little piece of diagnostic knowledge. i originally thought it may have been a starter and got a fresh one ready to install but after thing about it i don't feel that's the issue.
I live in a very rural area and bringing it to a dealership would be a 150 mile round trip. What that black canister is? Why it won't start up?
View 5 Replies
