Ford Super Duty (1999-2016) :: 2000 - Rear Brakes With More Power Than Front Brakes
Dec 6, 2015
I use a bottle hanging like an I.V. drip to flush the Brake Fluid in all my cars. I can pump all the old fluid out, as well as the air. My Superduty 7.3 has a good solid brake pedal after the flush. It seems to me the rear brakes handle 60% of the stopping load. Its been like this for so long I'm not sure if it's ever been different. i then go to a gravel or wet road and test the rear abs, and it seems o work, but definitely has a squirrely feel. I did some strong pavement stops with speed, and it stops, no skidding. Is that the way it should be?
View 14 Replies
Advertisement
Truck is 2007 6.0L 4 door F-250 FX4
So this started after some High water encounters around my area. All freshwater. Went to the store and then i notice the truck pulling Left and got home and checked brake temps and the driver front and rear were over 400*F passenger side was 150* or less. No trailer no load in the bed. I decided to clean everything. Pads are worn but still have life.
Rotors showed some signs of where the pad is dragging Not bad though just a small area close to the top hat. I cleaned pads, carriage, and clips and reinstalled everything with some anti seize on the edges of the pads where the clips are and at the same spots on the carriage.
Thought it was ok but the after more water and a day or two sitting the same thing happened again. It is only the drivers side and it's both front and rear. I am stumped on this one. Two calipers going bad at once? I need to tow a boat on Monday So I have got to fix this.
View 1 Replies
I don't know if this is even a problem or not. Do the front brakes get hot on the one ton dualy? I wouldn't have even noticed it except when I went to the car wash, when I sprayed water on the tires and rims to wash them, I noticed steam coming off the front brakes. Think I have a problem or not? I can put it into "drive" and it rolls freely. It doesn't feel like anything is sticking.
View 3 Replies
So a few week back I noticed my brakes were getting soft. Soft meaning that when braking for any distance, I would hear a kind of "pressure release, squeaking" sound coming from the pedal, and the pedal would sometimes go to the floor and the ABS would kick in. Let me tell ya, its a pretty crappy feeling when your brakes aren't doing what their supposed to! So, I replaced the pads all the way around, replaced the master cylinder (bench primed). I took it out for a drive, and it did the same thing. So thinking maybe the fluid is bad, I flushed new fluid through the lines. Took it for a drive, and it felt good right away, the pedal firmed up a bit, and then it did did it again.
Just so I give as much info as possible, the rotors are looking pretty rough and going to be replaced soon.
So, my question[s] are; What is the next step in identifying the problem? Is there a chance the new master cylinder is bad? Could worn rotors cause the caliper to max out and not apply enough pressure? Even though the calipers seemed fine while replacing the pads, could one or more be bad? If so, how do I know?
View 14 Replies
Truck pulls to the left while braking, pretty bad. So, pulled the front right wheel off thinking the pins are stuck again as last year. Bottom pin was fine, top pin pretty gummed up but not froze so I cleaned it up good, used thin layer of the good stuff, put back together and test drove........same thing. Pulls left upon braking just as bad as before. Caliper pistons seemed fine, didn't take much to compress them either.
View 8 Replies
was going to do a brake job on my f250 light duty and the rotors won't come off. At first I thought they were rusted on but after looking at them it looks like the studs are attached to the rotor. Need to confirm this because the new rotors I got don't have the hub attached. Don't know if it's the wrong part or what?
View 9 Replies
2003 F250 V10 4x4. I have a rear brake sticking so I assume I have to replace the calipers. Which brand should I go with?
View 2 Replies
99 F-250 Ext cab 4x4 7.3 285,000 miles.
I got home today opened my door and got snaked in the face with the smell of brakes. I got out of the truck then I heard the drivers side rear brakes popping as they are cooling down. I reached down to touched the wheel and it's crazy hot. Opened the garage and went to retrieve the infared thermometer. The rotor/caliper was 350 degrees, hub was 150 degrees, axle tube was 90 degrees.
I took the wheel off and inspected stuff. The rotors do have some heat spots, the caliper visibly looks okay but not 100%. The pads look like even wear. I am guessing that the caliper either is hanging up or I have a wheel bearing going? The passenger side was like 80 degrees on everything. There is a slight shimmy while driving which to me feels to me like the beginning of warped rotors. I don't hear anything to me that screams wheel bearing noise wise.Brakes or bearings?
View 7 Replies
I have a 2007 F350 XLT, Super Cab, chassis cab, V-10, 4x4. I ordered it new, it now has 97,000 miles. It is equipped with a 9' aluminum flatbed. I tow it behind my motorhome and also carry a truck camper (not when towing it!).
I don't think the front brakes are working 100%. I have 2 sets of wheels and tires (19.5s for hauling the camper). Every time I change over, I check the brake pads for wear. Over the first 80,000 miles there was very little wear on the rear pads. In 2014 I had almost a complete brake failure while traveling. I took it to a Ford dealer, and they determined the brake booster was bad. They replaced the booster and flushed the brake system. I didn't think the brakes felt right afterward, but I carried on. By 95,000 miles, the rear brakes were worn out. I feel like the rear brakes are doing most of the stopping now, thus wearing out much faster than they were.
I just ordered a set of service manuals for the truck (9.5 years late on that!) hoping to figure out something. I like the truck, it meets my needs, and I hope to keep it quite a while longer. I took it in to the local dealer to replace a leaking rear pinion seal. They found and replaced the worn pads. I trust them to the extent that the pads were worn, as I had already noticed an acceleration in wear. Local dealer that replaced the pads has no idea what could be up. They did clean and lube the front calipers at the same time, but I noticed no difference in brake feel. Stopping power is definitely worse than before the brake failure/ booster replacement.
What might cause this? The only things that come to my mind is a problem with the proportioning valve or maybe the master cylinder. I don't know much about the details of the ABS system. Is there anyway that might be causing the issue? I would rather not just start throwing parts at the problem...
View 14 Replies
I've replaced the brakes that weren't in that bad of shape anyways and even replaced one of the rotors as it was under federal regulations. I've even put the brake squeak goop on the back of the pads and it keeps squeaking and squeaking and it's driving me insane. Am i missing something here? I don't here any other super duty's squeaking on the road.
View 1 Replies
I just changed all the pads and rotors on my 08 F350. The brakes are much better now, only the rear brakes got quite hot after driving it for about 15 min. Turns out the rear parking brakes are dragging on the back brakes. I adjusted the parking brake on both sides so they no longer drag and the heat issue is gone. The problem now it the parking brake does not engage until the pedal runs out of travel. Any tips to get this just right? Will the parking brake self adjust like the old drum brakes and shoes use to do years ago?
View 7 Replies
The pads were replaced 5000 miles ago. Today the truck is acting hard to go, brakes are squealing, and I noticed a hot brake smell. I got home, grabbed a remote thermometer gun and the front rotors are 130 degrees, the back ones are 650 and 700 degrees! Super hot. I'm going to NAPA for new calipers and pads. I hope that fixes it.
View 3 Replies
Took truck out for a ride and stopped for gas. I smelled Brakes and upon inspection found the left rear brake pads were not releasing. Any take on what could be holding it? 2008 F-250.
View 10 Replies
Took the truck out the other night, got to town felt the slight drag but nothing alarming, got out of the truck and could smell it, rear drivers side rotor glowing red, pass side not glowing, pressed park brake then released, driver side freed on its own, pass side sticking, replaced pass side rotor and pads, found nothing out of the ordinary... Ford F250 4x4, 2005 ....
View 14 Replies
I have had the truck just under a year. It has 104k on it i only drive it on weekends. Last weekend going to Home Depot about 15 miles got out and could smell brakes burning. Felt the wheels and the right rear was very hot. Got back home no smell but still hot not as hot as earlier. Pulled the wheel off it looks as if the pads and calipers are fairly new paint is still on them caliper is a TRW. The pads were stuck in the carrier even the stainless clip ends look rusted.
Cleaned it all up both sides lubed the pad carrier with pin lube. Pushed the calipers back in some both sides went in easy. The right rotor has definitley been hot. Put it all back together and went for a test drive. Came back no problems checked the temperature with a laser type heat thermometer all wheels were around 140 f. Went out yesterday morning stopped and could smell the brakes again. Drove it back home and the right rear was 300 f. others 150 to 160 f.
Jacked it up put it in neutral and the you can spin the wheels by hand. Started the truck had the wife get in put it in drive wheels turning applied the brakes they stopped let go they turn freely again tried the parking brake it works fine also. So do I buy new calipers and brakes or maybe is the wheel bearing going bad causing the brakes to heat up?ied.
View 5 Replies
I have a 2002 f350 Super duty, 7.3. After I changed out the power steering box, I did bleed the system, I have now power steering and the brakes are very spongy. Any thing to check prior to replacing the booster? I have been told the power steering is probably just an alignment issue and I should bleed the brakes.
View 3 Replies
I have a ford f350 2000 7.3 powerstroke. I changed out the powrstwering hose because there was no powersteering. now my brake pedal is easy to push and don't have brakes. Reservoir stays full so I'm not leaking any.
View 1 Replies
Problem started with the front end shaking a little bit when braking like the rotors needed turning. Then the brakes began to intermittently hum when stopping. Then my ABS light came on. Put the truck up on the stands and disassembled the brakes on both sides. The ABS sensor was chewed up on the driver side. The less than year old hub felt sloppy so I changed it. Put everything back together.
New hub came with new ABS sensor. Went for a test drive ABS light is gone and I no longer shake or experience the hum when applying the brakes. However now when I go to stop right before I come to a complete stop the driver side (new hub/spindle side) I hear what sounds like the grade school class clown making a fart sound with his mouth, and the truck pulls to the driver side. Is the ABS system malfunctioning or is this a caliper issue? Calipers look like they are OEM.
View 3 Replies
2011 F-350 XL, I can hear a squeal coming from the front brakes when rolling forward slowly, believe the pads are dragging on the rotors. If I touch the brake pedal the squeal stops as it does when I turn the wheel. Took the calipers off and greased the slide pins and put it all back together, still got the squeal. What don't I know???
View 9 Replies
Was moving a boat on a trailer with surge brakes and found I could not back it up. Found that I had no power on the center pin on the round 7 seven trailer connector.
When backing this type of trailer the back up light power opens a solenoid that keeps the brakes from working in reverse. Don't know how long its been like this because this is the first time I moved this trailer. The question is where is the fuse and or relay for this. The back up lights on the truck do work.
2007 F350 6.0 ....
View 11 Replies
My 18 year old launched the little wire spring thing that applies pressure for the brake pads on front disc brakes. Could have gone in to neighbor's yard! Actually lost one on each side. He put it all back together without one on each side. I said it would still work fine. What's the deal really? Can't be that important are they?
View 14 Replies
