I have searched and tried everything that was suggested to open the hood on my 2000 and nothing works. When looking form the front you can see the hood release operate, but nothing happens. What part of the release do I need to operate to get the hood to open?
View 5 Replies2000 Excursion 4x4 v10 auto. Pulling the boat last weekend up the driveway from the lake and the truck started smoking under the hood at the top of the drive. Jump out and saw a fire under the pass floorboard. Go the hose and put it out in 30 sec. Thought i blew a trans line and it sprayed on the cat. Took it to the shop and he said lines are good it's not leaking. He said it is possible that the trans over heated and built up pressure and blew it out past the front seal.? What happened or how to prevent it from happening again?
View 13 RepliesI have a 4r100 in my 2000 f250 7.3. I am getting a P1746-EPC Solenoid, open circuit. Does this mean this particular solenoid in the solenoid body has failed and should i replace the solenoid body?
View 3 RepliesThe '99 F250 has the parking brake release under the dash, way down low. While I was in the wrecking yard, I noticed many Excursions and Econolines have them on the left, by the parking brake. Whether one of those might work, if I installed it on my '99?
View 3 RepliesMy 1999 F250 right rear brake caliper will not release. I replaced the caliper, caliper mounting hardware, pads, rotor, emergency brake pads, and I bled the system. For some reason the right rear remains activated when my foot is not on the brake pedal. The other three wheels appear to be functioning normal.
View 6 RepliesI have a 2006 Ford F-150, and when I pull the hood release, the hood won't open unless I'm holding on to the hood release handle while pulling up on the hood. I've been trying to figure out how to adjust it but I can't find any information on it. The cable isn't broken, as I can see the cable move, it just doesn't seem to move enough to open the hood release. How I can fix/adjust it so it will work? Do I need to adjust it at the handle, or at the actual release under the hood?
View 12 Replies2015 with a 6.2 and 1200 miles. I have a whistle coming from under the hood. I didn't here it at first with the windows up and AC on but now that its cooler I have the windows open. I only here it at 2000 RPM or under while accelerating. Doesn't seem to matter how hard I am on the pedal or how heavy the load.
Dealer is going to have to fix it but would like to get a heads up for what it could be.
I noticed a raw fuel smell today while driving. I came right back home & found fuel spread all over the under carriage. I popped the hood & found the fuel bowl and surrounding area wet as well as fuel puddled up in the valley.
Before I tear into things I'd like to get input about common causes. I've read that the separator valve gets it's o-rings eaten up by modern fuel. Could this possibly be it? If so are there special kits that deal with the low sulfur & biodeisel?
While engine braking I started hearing a squeal under the hood , when I started accelerating it became a little louder, I pulled over and when I rev it up it gets louder and has a little rattle sound, sounds like it coming from the turbo....
View 5 Replies5.4L f250 is dead. Went through a small mud hole and the he truck just died. The muddy h20 was about 1/2 way up on my tires. After getting pulled out I checked the air filter and its dry. I did notice that the insulation on the hood was wet towards the back half of the engine. Guess maybe the fan sprayed it up there. Tried starter fluid with no luck. Just turns over. Also checked the fuel reset and its normal. Where should I start.
View 14 RepliesSo it was -10 last night didn't have my truck plugged in fired it up this morning took a few cranks but started heard a wine under the hood figured it was cold let it warm up for a half hour went to a buddy's for a party left a few hours later driving home truck was up to temp running fine then I thought I heard a wine again turned my music off rolled my windows down and it sounded like a Cummings lopping shaking like crazy lost power couldn't make it up a hill and bogged out and died look under it and has some oil on the axle tube called for a tow truck ten time no answers so I tried to fire up again and stared and ran fine made it home no problems. My question is is it a fuel issue I use anti gel every fill up but is it still possible maybe water? Or could it be my hpop it hasn't thrown any codes or lights all pressures and gauges read fine. Also my rear main leaks along with oil pan was it just some water running through or should I be worried...
View 2 RepliesBattery tested good, tried jumping it as well with cables and with portable pack.
I hear two clicks under the hood (NOT a continuous type click you hear when the battery is dead). The first seems to be up near the passenger fender well when the key is turn to the start position, the second click seems to be down under the motor near the passenger side (near the starter I assume, couldn't tell very well) when the key is RELEASED from the start position. The motor doesn't budge, I don't see any belts flinch or pulleys move to indicate that the starter is engaging. I don't hear anything that sounds like a starter engaging to me.
If not, where the starter solenoid is on this thing? is it separate like the other older ford's I've owned or is it now on the starter? Is there any fuse-able links that could cause this? Wiring diagram? Is there a way to jump the solenoid like in the old school days (e.g. with a screwdriver or wrench)? would like to get this home without towing it or fixing what is really wrong with it in the parking lot.
It's in negative to single digit temps here in Indy now, I fired it up in the morning in negative temps, drove it work. Came out to go home, and now this. So something happened between this morning and now and it's not the battery.
I have a 2000 Ford F-350 V10 Triton that is currently not running. It all started when I was going to work at 7:00am it just shut off in the middle of the road. I had someone to take out of the road and found out one of the fuses had blown. It was replaced and not even a mile down the road it died again, luckily next to Orielly's. They came out and did a test and found out it was coil 10. I purchased and installed a new one and went down the road only to have it die again. I replaced the fuse again, and went back to Oriellys and just as I was backing into the parking spot it died, this time smoke coming from under the hood. The brand new coil had caught on fire but I extinguished the flame and got the coil unplugged before any damage happened. Replaced the same coil and it ran fine until I got home, let it idle and it was fine. Then, two days later I started it and it died, again smoke coming from under the hood but no flames or fire. Now cylinder 10 does not fire any more. What the cause is?
View 5 RepliesI got to replace mine because the hood won't stay up on it's own and is heavy to lift. I was wondering if these things fail often. Mine is an '08.
View 5 Replies03 F250. 5.4 2v ... I purchased it a month ago.
Squeak under the hood. It appeared to squeak in relation to the movement of the tensioner......simple right? Replaced Tensioner and Belt..... Still squeaking.
AC not working at all. Compressor never kicking on.....replaced compressor, accumulator, and orifice tube. AC works now!.....squeak still there....
Notice fan wobbling.....shut truck off.....fan clutch shot... replaced....STILL SQUEAKING!!
Obvious answer....sound still on that side of the engine....Idler pulley....I just replaced it and the dang truck is still squeaking!!!!!!!!!
All that's left is the harmonic balancer, alternator, and power steering pump.......What could it be?
Twice I open the hood of my SD and I see water pooled up around the intake manifold on my 2001 F250 5.4. This happen when we have heavy rain. My truck is sitting on my drive way that has some angle to it. When it rains, all the water from the roof flows down the windshield and somehow the water is getting into the engine bay.
I cleaned out all the leaves and made sure the rubber molding were in place near the firewall, but it happen again last night. Is there something wrong with my truck to keep the water out. I suppose I could turn the truck around so that the rain will flow from the roof to the bed. But, I like parking my truck the way I park it.
I have a 2006 F-250 5.4L (6spd manual). I would like to add a second battery. It would be a purely auxiliary battery for radio use, and would be connected to a battery isolator. It would likely be a 33AH SLA, and starting capabilities are not required.
Any clean way to mount a second battery under the hood? On the driver's side, directly above the wheel well, there is an adequate amount of room for a second battery, and there are even tapped holes that seem to have identical spacing to the ones for the factory battery tray.
This leads me to believe that some version of this truck is offered with a second battery (the Powerstroke, maybe?). The local Ford stealership was all but useless, which is pretty standard. They have a solid reputation of not giving a crap about you unless you want to purchase a brand new vehicle with dealership financing.
What is the part number for a second, driver's side battery tray? I really am NOT interested in any kind of solution under than under the hood (no frame rails, or relocation to the bed).
The dome light/under hood light keeps blowing the fuse. I can't tear the entire interior out to try and chase down the short. Just wondering if any common area this circuit shorts out!
View 4 RepliesHow to manage to open the hood when it wont "pop" from inside the cabin. There is not enough tension on the cable and seems as though either the cable has been stretched or either came off or broke its retainer under the hood... I noticed "TSB"s but to be honest I dont know what these really are or how they matter...
View 3 RepliesI picked up a new CSG GTI, 6speed with Xenon and Bluetooth on Thursday. Yesterday evening when I got home from work I opened the hood to make sure everything was cool I guess. Then this morning I was going to open it again, and the release inside the car is loose, like it's hardly attached to anything.
MKVI? I know it's probably a cable issue, but it sucks to have to drive back 50 miles to the dealer, 2 days after buying it, because the hood won't open.
Pic: ........
I have a 2004 Ford F250 Turbo Diesel, egr delete, headstuds, intake, dual stacks, etc and when i turn my wheel a loud whining noise comes from under the hood, I noticed it put tension in my brakes. When I accelerate it gets louder and when i let off the gas it goes away... i checked my fluid in my steering pump and it was low so i put some more in and the next day it was all sitting under neath the truck.... any quick fix or do i need to replace the whole pump?
View 2 Replies