Ford Super Duty (1999-2016) :: 2000 F350 V10 Would Not Turn Over / Alternator Is Shot
Mar 25, 2016
My truck has been sitting for 3 years and I want to bring it back from retirement. I changed oil, checked fluids, replaced the starter, starter solenoid/relay and tossed in a 2 yr old charged battery (800CA). She would not turn over and I jumped with another vehicle. She turned right over and with an insane dust cloud! I went to disconnect jumped cables and it died. I assume the alternator is shot.
Jumped again to bring up to temp so I could check tranny fluid. It was running for about 5 minutes and just quit. Nothing mechanically to my knowledge caused this. It quit peacefully. I went to fire it back up and all I get is a click at relay on inner fender. The new one. Even while jumping..... What I should test/diagnose next.
View 5 Replies
Advertisement
2000 f350 7.3 .. I'm having a horrible time trying to figure out why my truck is draining down the batteries. I can charge my batteries over night and put hem in and the truck will run for a few hours but then it dies completely. The alternator seems to be running really hot afterward like it is being over worked. I put in 2 different alternators and 2 new batteries and it didn't fix the issue.
I then put in a new starter relay. Still having the same issue. I believe I have a short because I tested for it but am unable to locate the short. I heard if you over work the bushings in the starter they can ground out on the casing which will cause something similar to this to happen. I work in ND and had to cold start it in - temperatures the morning this all began. I purchased a new starter but don't want to put it in if that is not the issue.
View 8 Replies
I just got a 2000 F350 cc drw 7.3l.
I did search but have had no luck. My turn signals do not work, unless my foot is on the brake pedal my green arrow indicator wont even turn on. When they do my bulbs work but don't cycle so I know all the bulbs are good as I had my wife check all four corners when I got them to come on for a split second. I have tried replacing the MFS and the turn signal relay under the radio in the dash.... When I do turn on my blinkers I can hear the relay click once but that is it, no more.
I tried checking the wiring in the column and tilting the column to its extremes while trying to engage the turn signals. Also, if I unplug the brake light switch then I do not get an arrow on the IC to light up so I am guessing the power flows through that switch. I don't have a chilton manual yet and the owners manual was not in the truck. I did check fuse 23 ?
View 2 Replies
2002 f350 super cab 7.3 diesel, replaced alternator because wasn't getting charge to batts, Napa guy checked batts and determined no charge, replaced alt, still no charge, have 12v at alt post with engine running or not. My ? is, is there a fuse in here somewhere that I'm missing? Went through all fuses in fuse panel all good.
View 7 Replies
I went to start my 2006 F350 6.0 this morning. 20 degrees outside. It nearly turned over, then it appeared that the batteries would not support another start - a slowing of the pre-engine start revving....
So I let it sit a while, now it won't start at all. When I try to start it, the dashboard flashes, clicking sounds occur and even after pulling out the keys, the needles on the gauges shake for a few seconds.
Is this more a battery issue or an alternator issue?
View 3 Replies
The V10 in my service truck took the long slow ride. I located and am in the middle of replacing said engine. My question is, how difficult would it be to install a second alternator in this truck, considering I have it torn down for replacement?
It a 2000 F350 with a V10. I'm looking for more power as I have mounted on the Knaphiede service body a IMT 1015 crane, 3200 lb capacity. I would like to install a power inverter to be able to run an air compressor in the field.
Am I looking for a new harness? Etc?
View 5 Replies
I have a 2002 F-350, 7.3 that is not charging. It has no power coming in on the big supply lead on the back of the alt. I traced the cable back, and it goes to intake heater solenoid. Cable is good, but intake and glow plug solenoids both have no power coming to them. I am guessing there is an open circuit between solenoids and starter. My question is, does the power come right from the starter, and is there circuit protection in there someplace?
View 2 Replies
I have a 2000 excursion that stopped charging. The battery light is on . I replaced the alternator but it still will not charge. I have checked all the fuses. Not sure where to go from here...
View 2 Replies
I have a 2004 F350. I go out to start my vehicle and it may or may not turn over. Other time it starts fine
View 1 Replies
OK I am pretty sure my warn locking hub is shot. I put it in the lock position and I can still turn my u joint by hand. I got the cap off and the otter metal ring out. There was No inner snap ring to take out. So now it should Just come out right?
View 5 Replies
I have a 09 F350 Lariat SuperCrew SRW 4x4, Last night the ignition key would not turn at all. Tried wiggling the steering wheel, (noticed it wasn't locked), wiggled the shift lever (auto trans). After about an hour of "beatn and jiggling, it just started working!?? What caused this, neither does my dealers service dept. It's working fine now.
View 11 Replies
I have a 2000 f350. When idling uo can't really hear the miss. Driving at about 40-50 mph it will shack and shutter real bad. Hooked up spanner and had miss fire codes for cyl. 1,4,9. Changed out all 10 plugs, and boots. Also changed out the coil on all three cyl also. Still have the miss and shutter. Also changed out #9 injector ...
View 12 Replies
I've got a 2000 F350 crew cab with a camper I bought in Chile and I'm going to be driving it from the tip of south america back to the US. It's a 9 month epic family road trip. It'll involve crossing the Andes several times and going over 15,000 ft. There are roads up to 19,500 ft in various places.
My question is am I going to have problems with the altitude? What can i do about it? I've got another truck which is a unimog, it's slow as hell but has a special kind of booster gas you can inject in to the engine to get it started in very cold weather and at high altitude. I chose the F350 for the truck instead of the unimog because a unimog is slow as hell (think 40mph max speed), but it handles extreme conditions well.
View 10 Replies
I have a 2000 f350 xlt and it has been very good until now. I can be driving normal and stop and park, when I get in and try and start it , it acts like the neutral safety switch is not working. the key turns and all my dash lights work, radio works, everything but the starter. I have to put it into neutral to get it to start. then after I stop again, it works fine. I don't get the problem all the time and I can't find a neutral safety switch.
View 8 Replies
I have a 2000 F350 cab and chassis 4X4 with V10 and a 5 speed manual (actually it's a 4 speed with overdrive). My problem is the engine seems to have a miss in it. When I first start it in the morning it usually runs good for 5+ miles till it warms up then if I am not pulling a load I can hear what sounds like a miss but the truck accelerates fine. If I am pulling a load I can also feel a slight steady consistent shudder and I can tell the truck doesn't have the power it should and the gas mileage SUCKS worse than it use to.
I ran a bottle of Lucas deep clean through a tank of fuel and that seemed to work a little but I will still encounter the problem sometime during the day. When the miss seems to be gone I can hear a very slight pinging noise when I accelerate or pull a hill with and/or with out a load. The pinging noise I hear sounds like an engine with a distributor that is getting to much spark advance if you have ever experienced that before.
I purchased this truck used several years ago and I don't know what the PO did but the check engine light is not coming on and it doesn't throw a code. I put 10 new ford coil packs on it about a year ago so I really don't think it's a coil pack, but I could be wrong. To me it sounds like maybe it an injector problem????? I know there are several sensors on this engine and I am thinking maybe a crank position sensor is not working right but I honestly don't know???? Is there a way to test this sensor?
View 7 Replies
I have a 2000 f350 5.4 liter I recently fixed a misfire in cylinder 1 since then every morning the truck runs perfectly fine however at night when I leave work around 6 o'clock the truck has a misfire again I stopped pullover pull the spark plug out put the spark plug back in and it runs perfectly fine all over again I don't know if this matters but when I replace the spark plug I only replaced one and not all 8 same thing with the new coil pack I don't see how that could cause this.
View 14 Replies
I recently purchased a 2000 F350 4wd, it's mainly used for plowing my driveway, and hauling larger items. I can truly say I love this truck. When I got it, it was in pretty rough shape, but slowly I've been bringing it back to life.
However, I have this loud front end rattling sound I can't seem to locate. Quick background the truck is 4wd with a v10 in it, and it has 215k miles on it, poorly maintained, so everything is suspect. Only new parts are all new brakes and new u-joints everywhere.
So back to the noise, it's most noticeable whenever I hit a small bump or dip at lower speeds, but the noise is still there at higher mph as well. It's loud and literally sounds like the whole front end will fall off, its a definite rattle, doesn't seem to be from one side or the other, best I can describe is in front of the firewall at it sounds like something is very loose.
But when I crawl underneath the truck, I don't see anything loose, the shocks, look OK, the sway bar links seem to be connected. IDK what else to look for, 4wd works fine and doesn't seem to alter the noise any when engaged.
Truck recently passed inspection, and no mention of anything being loose or worn was mentioned. I'm kinda at a loss, but the sound is so loud and noticeable I feel like it should be obvious as to whats loose underneath.
View 6 Replies
I'm getting a really choppy low RPM drive. If I'm above 2-2.5k rpm it runs okay but as soon as it drops under 2.5k it starts to run very choppy and loses power and Boggs in and out of power regardless of how much throttle input I give it. I had a tune up done last year and a recent oil change...
View 1 Replies
Started my truck this morning. 2000 F350, V10, 153000 on the clock. Immediately sounded like a shotgun went off under the hood, now it sounds like it's running a cutoff exhaust. Had a tiny manifold tick prior to this, but can it backfire hard enough to crack/destroy the manifold?
View 5 Replies
The 4wd on my 2000 f350 has just stopped working? I have used it a few times since getting it a few months ago and then last night I was going to play paintball in the woods and the 4wd would not engage? when i put it in 4wd it would act like the truck is in neutral and then it lurched forward? The front hubs have the option on them to turn, but I never had to turn them before and they do not move when I tried to? What could be causing the 4wd not to function?
View 4 Replies
So I've got a 2000 F350 7.3. Just replaced all the ball joints, sway bar end links, carrier bearing, balanced the tires... a bunch of stuff to try and eradicate this weird wobble I have and I just can't seem to figure out what it is.
The wobble happens at and around 35mph, and then once I break 70mpis on the speedo (I have a 4" lift and am running 35's so it's not actually 70). I've experienced death wobble before in a jeep I had, and it is nothing like that, and I can't see it being driveline related but I could be wrong.
View 1 Replies
