Ford Super Duty (1999-2016) :: 2000 F350 - No Oil Pressure When Truck Started
Jan 8, 2015
So I went to start the truck this morning around 8:00 and it was 7 degrees outside, when the truck started the oil light came on and oil gauge was on low? So I turned it off right away. few hours later I tried it again and still nothing I thought maybe the oil was frozen. After I started the truck the oil was higher on the dipstick so I am assuming the oil pump is functional. What could be causing this? Could it be the the gauge is not working? The truck is a 2000 F-350 V-8 5.4 gas. I'm hoping it is something simple I am suppose to work this afternoon
View 14 Replies
Advertisement
I have a 2000 f350 xlt and it has been very good until now. I can be driving normal and stop and park, when I get in and try and start it , it acts like the neutral safety switch is not working. the key turns and all my dash lights work, radio works, everything but the starter. I have to put it into neutral to get it to start. then after I stop again, it works fine. I don't get the problem all the time and I can't find a neutral safety switch.
View 8 Replies
We just bought a 2000 F350 knowing it has some issues. The #5 fuse (generator/secondary) under the hood consistently blows fuses the second it's inserted, meaning there's a dead short. Truck will crank but not start. As well, theres a 5 amp fuse under the dash, which when inserted, keeps the instrument cluster on as if the key was on, even with no key in the barrel. We cannot hear the fuel pump running, the fuel reset switch is fine, all ignition wires at the column are showing 12 volts at the right times. What could be wrong? I'm a 12 volt specialist, but not a ford tech.
View 6 Replies
2000 Excursion 4x4 v10 auto. Pulling the boat last weekend up the driveway from the lake and the truck started smoking under the hood at the top of the drive. Jump out and saw a fire under the pass floorboard. Go the hose and put it out in 30 sec. Thought i blew a trans line and it sprayed on the cat. Took it to the shop and he said lines are good it's not leaking. He said it is possible that the trans over heated and built up pressure and blew it out past the front seal.? What happened or how to prevent it from happening again?
View 13 Replies
I have a 2000 f350 v10 ext cab 8 ft bed 4wd,i replaced all 10 plugs all 10 coils at 40 mph the truck violently shakes an vibrates read on a few things that could be crack cylinder or bad pistons,i did a test on it an says low compression in 2 cylinders 1&2 what can I do an what is the best option for me as I just got the truck not even a month ago...
View 3 Replies
Question, my truck started to have a miss under normal acceleration, when I really get on it, it clears up? I also noticed a bad sulfer smell at idle. Im thinking the cat is possibly plugged? Truck had 172000ish on it, and the cat is original. I did do a big tune up this past fall, new plugs, coil packs, air and fuel filter. Should I put a new cat on it? And a new oxygen sensor?
View 9 Replies
All the sudden got home and now my truck wont go in park. All other gears are fine. My PRNDL on dash has always been off for the last 3 years park has always shown as reverse its never affected anything! I already checked the torq. bolts and that was not it. My shifter is very sloppy so is my steering wheel. I found a 00 whole steering column with wheel and shifter but its not a early 99 will it work or fix my no park. The guy didnt know if it would fit early 99 or my no park problem.
View 2 Replies
2007 f350. About 2 weeks ago my truck started smoking really bad, and I took it in to have it diagnosed. It was 4 injectors that were bad, so I had them replace all 8 and also install a bullet proof oil cooler. From the moment I got the truck back, it did not seem to idle as well as it used to, and over the next week, it began to blow a good amount of white smoke and run very rough.
But the weird thing is when I took it back to the shop to have it diagnosed, the minute I pulled into their driveway, it ran perfect, and they were unable to pull up anything. The next morning, I started my truck for work and as I drove down the street, the truck ran extremely rough, and seemed to be running in 2 cylinders. I shut the truck down, restarted it and it ran a little better, as I limped it back to the shop.
View 6 Replies
2005 F-350 6L diesel .... Put new batteries in it a week ago.
Been running good then the radio quit a couple of times. It came back on after truck was restarted. This morning I go to town and the battery light comes on. I stopped and started about 5 times and on the 6th it wouldn't start.
I got a boost and started home it , started to try and quit when I was almost home. Was so dead the power windows wouldn't even work. Have it on the battery charger now and it starts right up but the battery light is still on and the ABS light is on.
View 6 Replies
I have a 2005 f350 6.0 has 585000. Installed new hpop and lpop and new ipr .pressured oil system with air don't hear any leaks. After truck done started then put truck together no start same problem as before. No oil pressure on dash. All checks goqd except not enough high pressure.
View 2 Replies
My truck seems to shudder between 40 and 60 mph when it's in OD. If I turn off OD it seems to go away with the increased rpm's. Although I can't be sure if it genuinely disappears or if I just don't notice since I'm at 2100 rpms instead of 1500. Trans fluid is clean. Is this a common problem in these trucks? Just filled up from flat E the same day air temps about 4 deg. Truck was fully warmed up. Does this sound ignition related, tranny or fuel related?
View 14 Replies
I have a 2012 Ford F350 I've been looking to install a compressor on. I've poked a hole in the gasket that runs wires through the firewall and cut the tips off of a couple of the accessory wires. Went to go get some more parts and now the truck won't start! The lights and radio turn on when the car is turned on but the starter doesn't even click when I try to start it. What should I look at?
View 7 Replies
i have a 01 Ford F-350 7.3L quite and won't start I have replaced the ipr valve and sensor and the crank sensor and the truck still won't start...
View 1 Replies
Tried changing fuel filters on my 2008 F350 diesel. Tried primary - open drain - no tool to remove cap, closed drain. Removed top cap, replaced filter.
Started but immediately shut down. Did this twice. Put old filter back in - still no start. Wrench code light on.
View 9 Replies
What is the proper tire pressure for these trucks (F250)?
Sidewall says max is 80 PSI.
Door jam says 71 PSI.
This is coming from a guy who has traditionally driven passenger cars and trucks. I've never even gotten CLOSE to advertised max PSI ratings. 71 seems awful close to max PSI.
View 4 Replies
1999 F250 7.3 240k miles .... This is the second truck to act like this on me after I cleaned the in tank filters.
I had to cut the fpr spring to 30lbs for the truck to start fine cold and idle ok but has no power. When hot it wants to die and or dies at idle and has next to no power. ( I'm guessing from lack of fuel) but it's the only way for me to use it. With a new spring and 60ish lbs of fuel pressure, they won't even start.
I cleaned the in tank filters. New fuel filter. new oil. rebuilt the ipr. unplugged the ipc. no loss of boost. checked my uvch, wiggled all harnesses with no difference. I also tried dropping the tank again in case I pinched the return line but that made no difference.
I'm guessing that I need new injectors. I'm not close to anyone with a computer nor can I afford to throw away any more money at the moment.
Totally stumped and cannot seem to find a definitive answer online so far. Both trucks ran somewhat ok before and got worst once I dropped the tank and cleaned the filters which increased the fuel pressure. This is my second truck to act this way.
View 8 Replies
Just got larger tires on my truck and tire pressure monitor light is on. How would I go about resetting this?
View 14 Replies
I've looked at this 10 ways to Sunday, but the play on words have me questioning if it is the same thing. My truck says Tire Pressure Monitor Fault. I have a 2011 F350, if that makes a difference. I checked all my tires, they are about 80psi each, front and back. What could be the problem? Is it something to take to a Ford Dealer or something I can fix myself?
View 7 Replies
I recently came a cross a no start issue with my truck. It is 2005 ford f350 6.0 ... Found out I have a leak in the high pressure system. When I was taking out the bolts out from the manifold I stripped out two bolts. I know ford part # w301383 is the ford bolt. But I was thinking why use that same bolt and had have that issue again later.
View 1 Replies
I have a quick question regarding tire pressure. Where we work, we have a 2005 F350.
Stock tire pressure for stock tires 275/70R18 states 65 PSI for the front and 75 PSI for the rear.
The truck currently has 295/65R18 tires all around. They are some sort of Wrangler tire, not sure of exact model, but they are more of a all-terrain tire. The truck sticks to the road though.
What would be the recommended cold tire pressure with these? Can I stick with what the stock tires would be?
View 14 Replies
I have a 1999 Ford F350 5.4L 4x4. I had a check engine code on my truck a couple of months ago. The truck was running fine then. The light went away and I forgot about the issue. In the last week the truck began to run like crap; hesitation during hwy speeds. The truck is running with hesitation in 3rd, 4th, and 5th gear. In low gears the truck seems to run just fine. I have changed the EGR valve as well as the fuel filter. Check engine light is not on but the problem has not gotten any better.
View 3 Replies
