Ford Super Duty (1999-2016) :: 2000 F250 - Vibration When Accelerate Pretty Much Any Load Above 1200 RPMs
Feb 22, 2017
I have a 2000 f250 crew cab short bed 7.3 on a 6inch bds lift and 37 inch tires. When I accelerate pretty much any load above 1200 rpms I can feel a vibration, kinda feels like it may be coming from the front left but I'm not sure. I have heard that a wheel bearing going out can cause this, would this maybe be what's causing it?
I thought wheel bearing because it kind of sounds like there's a howl when decelerating, probably when accelerating as well but the trucks too loud and I can't hear it. or also have heard motor mount gone bad, I've also heard ujoints but the ujoints were done this summer. the front ujoint is bad but the front driveshaft shouldn't be turning when out of 4x4 and hubs unlocked.
View 4 Replies
Advertisement
I have 2005 f250 5.4l 3v that was having miss problems between 1200 and 2000 RPMs. Changed VCT solenoids which worked, but then could hear chain hitting cover when powering down throttle on left side. Figured chain tensioner was bad, so tore down and removed timing cover. Found left chain was tighter than what seems normal, and right side had huge amount of slack. While taking off tensioner on left side, something happened to fast for me to see it, and still not sure if what happened wasn't just my imagination. I thought that the chain moved very fast for an inch or two. Anyways, I watched how to video on timing the 3v, but I am very confused about it. The left bank seems to line up on timing marks perfectly, but the right chain is off by at least 2 1/2 links. Not knowing any better, I removed three rockers on left bank (2 intakes and 1 exhaust) but only removed two intake rockers on right side. I don't know what I am doing and getting scared.
View 1 Replies
So basically I thought it would be a great idea to degrease my motor from the top down.... After washing I start it up and drive down the road to head abunch of misfiring under heavy load or high rpm's.
My problem is that the misfiring won't throw a code. I then proceeded to buy a new ignition coil (thinking this was the problem) but with no code to go off which cylinder was bad I just switched the good ignition coil into each cylinder and starting it.
Up each time. None of them seemed to make it better. Also the injectors all seemed to be good. So what to do ?
2002 Ford F-250 5.4l
View 3 Replies
My F250 6.4, 3.73 Crew Cab Short bed vibrates when accelerating from a stop with my 5th wheel on. The 5th wheel weighs 12K. It is a medium to high frequency vibration that is felt throughout the entire truck. It continues through the shift into 2nd (TorqueShift Tranny). The harder you accelerate the more you feel it.
It does not occur if truck is unloaded and you accelerate at full throttle. Is this normal or should I get it looked at?
View 8 Replies
2003 f250 crewcab 6.0 auto 4x4. I all of a sudden started feeling a vibration under the truck near the back when I accelerate and when I let off the gas no other time. No noises or clanking just vibration. I can wiggle the driveshaft inside the carrier bearing do you think that could be it or is it the rear end.
View 14 Replies
My 2012 F250 6.2L (Gas) engine developed a noticeable drone/vibration when in drive between 1600 - 1800rpm. RPMs above and below that range is fine. But when accelerating, as soon as the RPMs reach 1600, you can feel a slight vibration through the gas pedal and a noticeable sharp draon/moan up till about 1800 or 1900 rpm, then its normal.
I took it to my ford dealer and took the service manager out for a test drive. He said that there is a drone and slight vibration withing that RPM range. He thought that the engine mounts may be loose. But aside all that, he felt something was off and wrote up the service order.
When to pick up the truck and now the service manager changes his tune and said that the drone is normal and happens on all 6.2L super duties.
To be honest, I have the feeling he is pulling my chain.
View 6 Replies
I purchased a 2000 F250 7.3 4x4 (auto transmission) about 8 months ago. I've noticed recently that when I accelerate there is a slight hesitation like there is slack in the drive line. This does not happen when the truck is moving and I accelerate. There is not audible clunk and the hesitation is not in the motor.
I checked the u-joints and they all feel tight. There is a little slack in transfer case that allows me to turn the drive line slightly back and forth. Is this normal? Should I be planning on a transmission or transfer case rebuild soon?
Update: I was researching the leaf spring isolator pads (mine are warn out or missing) and it sounds like these can cause something similar to what I am experiencing. I am planning on pulling a 28' travel trailer from Colorado to Wisconsin next month and would like to avoid any issues if possible...... Obviously, I know ....
View 4 Replies
I'll try not to post an entire book.. But I bought a 2000 F250 not even 8 months ago, it did have issues before but I changed out the spark plugs and coils and it fixed it's original missing issues.. I also just recently changed the fuel filter but it didn't fix it's new problem.. It drives ok around town but if I get over 35 mph it doesn't run well... If I try to keep a steady foot on the gas but don't get the RPMs over 2000, the RPMs will stay where they're at for just a second then they will drop down and the whole truck starts shaking.. I push more on the gas and it shakes even more and the RPMs don't move at all until I really step on it.. It lacks in power going up hills as well... The dealership i bought it from said the Catalytic Converter was bad but my uncle who is a mechanic says it isn't.. It's the first vehicle I've bought so kinda wanna make it last..
View 11 Replies
Now that I use my truck as a daily driver I am noticing a vibration under acceleration at 30-35 and constant vibration at 45-50 accelerating or maintaining speed. I have replaced all three u-joints as well as new ribbed highway tires all around and still have the vibration. It seems worse in OD. I have done a little research and am either going to shim center support/machine a new one or have a one piece shaft made and need info on how to successfully gotten rid of this vibe on their truck mainly the amount of shimming required and the final driveline angle. It seems that most posts regarding this issue lean towards the fact that the 45-50mph vibe is normal for my year super duty and that's probably right but I want to remedy problem not "live with it!" (10 mile 45mph stretch to work @ 4AM, vibe bugs the heck out of me!)
Truck is 2000 f250 SC 2wd 4r100 3.73 gear currently 51000 miles.
View 11 Replies
1999 F350 7.3 Super Duty surges when going uphill with a load. The only time we drive it is when towing the horse trailer - also has a camper on.
The truck doesn't physically surge, just the RPM gauge goes up and down and along with it a humming noise.
Also, What conditions should I engage the towing button on the end of the gear shift? I've heard several answers. Should it be engaged when towing or off?
View 2 Replies
I have begun to notice a vibration when I am in first gear starting out with a bit of a load. The vibration goes away as I gain speed and the load reduces. None at any of the higher gears. If I take off real easy and allow the truck to gain speed without pushing it, the vibration does not exist. The truck is the one outlined in my signature. It is equipped with a 3 speed auto with overdrive. I am thinking this could be a U-Joint that might be starting to go out.
View 9 Replies
My current 08 duty was bought with what I believe to be a procomp 6" lift modified to an 8" lift. The 100 mile drive home after buying the truck showed a tiny "hop" in the rear. I ditched the 37s for some new 35s. Still a tiny hop, mostly noticeable while under a load like climbing a hill. I pulled the rear driveshaft and had it fully rebuilt with a new carrier bearing as well. Still gots the hop? The truck has a carrier bearing drop bracket but I think it may be insufficient for the lift.
The rear driveshaft still has a slight bend in the middle of where the two driveshaft pieces connect. Are the 2 piece driveshafts on your 8" lifted trucks sitting straight with each other or do they have this bend as well?? I am thinking if I get a bigger drop bracket it may cure this slight hop I have? Lots of lifted trucks where I live but they are dam near all shortbox with 1 piece rear shafts so I haven't been able to find one to compare. By the way, my truck also has pro comp rear traction bars..
View 7 Replies
My 2015 F-350 Super Duty has a noticeable vibration between 5 and 15 mph when accelerating with my 5th wheel. The 5th wheel is heavy--around 14000 pounds. The pin weight is heavy--around 3000 pounds. The Owner's Manual says on page 191 "When driving with a trailer or payload, a slight vibration or shudder may be present due to the increased payload weight..." (This was brought to my attention by my dealer.)
Seeing the thousands of F-250 and F-350 Fords pulling 5th wheels out there on the road, I wonder how many have this "slight vibration or shudder" and what they have done about it.
View 11 Replies
I have a 99 f250 that seems like it has a bad coil, under a load it starts surging or bumping ( like it has in the past and I found a bad coil), I went through and unplugged each coil one by one while idling, couldn't find a bad one, so I bought a new coil and went through and rotated the coils, nothing worked, no check engine lights on.
View 9 Replies
Just bought a 1999 7.3 f250 w/71000 miles and took it to a diesel guy and under load he said that the whistling was normal..is this correct?
View 3 Replies
About 20 miles into it, and it starts cutting out on me under load, over about 1/4 throttle. I baby it a ways further, and park at a wal-mart. Idles fine, but once again, after 1/4 runs like crap, acts like it's back firing through the intake spit and sputtering. Have the wife come pick me up since I was heading to work. Decided to shut it off, and restart, and it acts like its never had a problem.
Was messing with it today, and let it warm up in the driveway. Once it got hot, same story good 1/4 throttle, past that, not so much. Shut it off, started it back up and drove it to see if there's any codes at vatozone. Drove good (laying into the throttle) for about 2-3 minutes, back to same behavior. Hooked up code reader, no current codes, and no historic codes. Although I did notice (actually since I bought the truck) that the check engine light never comes on, even at initial start up. Looking at my spare cluster, it's an l.e.d. So no bulb out I guess unless the led is bad. Truck has around 130,000 miles on it. Everything is stock.
I'm leaning toward a fuel pump, a clogged cat, or a fuel pump relay or cutoff switch problem.. It doesn't have any other issues than that, and has been a good truck for the 10k miles I've owned it... 2003 F250 5.4...
View 7 Replies
I have a 2001 Ford F-250 5.4L V8. 117,000 miles. The problem I have been relentlessly trying to diagnose is a slight bucking that occurs under load when the truck is in overdrive. When the truck bumps up to higher RPM's it is fine but when it is around 1500-1700 RPMs on the highway it does a small buck like I'm hitting a bump in the road. I know there are many threads on this but none of them have gotten me any closer to a resolution. It also seems to have a bit of power loss when accelerating. Things I have done so far.
-Spark plugs and COP replaced about 1000 miles ago
-New fuel filter
-Cleaned MAF sensor
-Cleaned throttle body
-New PCV
-Seafoam treatment in gas and through brake booster.
View 14 Replies
I have a 2002 F250 CCSB Lariat 4x4 with the Triton V10, I'm up to 232,000 miles so far and fairly happy with the old girl. Just this weekend, I noticed some hesitation when at idle and even more rough running when under slight load. The misfire/hesitation is worst when going up a slight hill, when the truck is accelerating at low RPMs.
I am getting zero trouble codes or freeze frame conditions on my scanner. What should be my order of diagnosis? Vacuum test at line from PCV to TB, COP test? EGR inspection? Plug inspection? Also, how do you test a coil if resistance is not a reliable method?
View 5 Replies
06 250 5.4 40k on it, usually when cold and accelerating engine will misfire and stutter and then continue accelerating. The wrench light will flash sometimes but it wont store a code. This used to be vague in occurrence but has now started to be more a common occurrence even when up to normal operating temps.It seems only to misfire /stutter on hard acceleration or towing/hauling heavy loads. The only answer I got from a mech would be to do a computer reflash, not sure why /how this would fix whats going on.
View 1 Replies
I purchased an 1999 F250 Super Duty truck last Sept., it ran great all winter, now when I accelerate I notice a whining type noise (that's the only way I can describe it) it only does this during acceleration not @ idle, could this be a bad water pump? However there are no leaks or puddles of anything in my driveway.
View 2 Replies
2 wks ago I was running down I95 at about 95-100 mph (basically floored) in a rush to get somewhere on time. Since then my truck has been running for crap. It threw the p0171 code when I checked it. When driving under normal conditions it pings a lot and my mpg is down about 3 mpg and has this hesitation when you get on it. Even when you accelerate at a normal rate it surges a little, it pings a lot and has a loss of power, about 30-40%. It feels really sluggish and doesnt want to pull and then you will feel it starting to pull a little harder then it starts to surge/hesitate a little again.
Truck has 147k on it. I was having a similar situation until I had the plugs replaced at 125k, so I figured the plugs shouldn't be the problem. So I replaced the fuel and air filters, cleaned the maf w/maf cleaner and Throttle body w/tb cleaner and replaced the pcv with a new one from ford. Still pings bad under load and still has the hesitation/surging and crappy fuel economy. Its running smoother but no fix yet. This is crazy trying to pinpoint this issue. The detonating isnt crappy gas because I used super and it still detonates quite a bit.
Its a 06' F250 5.4 3V XLT Lariat SC FX4....
View 14 Replies
