Ford Super Duty (1999-2016) :: 2000 F250 V10 Shakes Up Until Second Gear When Takeoff From A Complete Stop
Mar 15, 2017
I have a 2000 f250 superduty gas v10 6.8L . I bought this truck about 4 months ago. Now when I take off from a complete stop the truck shakes up until second gear, shifts fine all the way up until the last gear it looses power "loosing power" i mean i can put my foot into the pedal and it takes forever to climb speed meanwhile the RPM'S never skyrocket like it the transmission was slipping if anything a couple times the RPM's dropped are stayed the same then as i take my foot off of the pedal once i have my desired speed sometimes not always the truck will give me a little jerk Also Just the other day I was driving on the highway and decide to put her on cruise control at about 70mph, I set the cruise control and the RPM gauge was just over 2,000 and the tach was fluctuating up and down about 1/16 of an inch. I been reading alot of forums and what I got out of them is it maybe pointing me to a misfire maybe the coil packs? Plugs?It's not something major like a transmission rebuilt.
View 6 Replies
Advertisement
Have an 06 F250. When I slow down to make a turn then accelerate it's like the drive shaft spins half a turn before it catches. Been doing it for awhile now. Now I'm get a clunk when I come to a complete stop. When you stop then truck settles there is a little clunk. Does this sound like the slip yoke problem?
View 1 Replies
2016 F250 6.7L 4x4
I getting some tranny noise when towing on incline from a complete stop. When I slowly press the gas pedal I hear grinding noise. If i press the gas more my truck starts to move and the noise goes away. It doesnt happen all the time. This started right after my 1000 miles recommended break in before towing per ford manual.
My truck now has 2800 miles and the grinding noise occurs intermediately regular driving. Mostly on steep incline or decline. I haven't taken it to the dealer yet because I cant recreate the issue all the time.
View 6 Replies
Alright i got a 2000 f250 with the 7.3 and its stick, when i let off the clutch to start moving, and at low speeds like mainly 1st and 2nd gear. Right below the cab there's a loud kinda growling or rumble, it shakes the truck a bit til i start moving good. Then it goes away. But what it could be? I think pilot bearing.
View 5 Replies
I have spent alot of time looking through threads about v10's misfiring and have not been able to resolve my issue. I recently purchased a 2000 v10 f250 with about 220000 miles on it I bought it knowing it had one miss fire but now I have a total of three. Te truck has no problems accelerating but at a little over 40 mph the engine shakes quite noticeably and after 60 i5 seems to smooth out. After alot of reading I replaced all of my plugs and ignition coils, ran a can of sea foam through my gas tank and my intake with no change to the miss fires. I have started my trials with the fuel injectors by switching them from miss firing cylinders to ones that aren't. Some other information is my truck has no egr on my intake.
View 4 Replies
I have a 2001 F250 V10. It idles around 1k and when stopped at stop lights or when put in reverse it stalls. I have replaced IAC, fuel filter, tranny filter, oil filter, plugs, coil boots, tranny fluid, oil, air filter, and PVC along with the PVC hose. I'm totally stumped. It doesn't stall if I do a rolling stop.
View 14 Replies
I've replaced the brakes that weren't in that bad of shape anyways and even replaced one of the rotors as it was under federal regulations. I've even put the brake squeak goop on the back of the pads and it keeps squeaking and squeaking and it's driving me insane. Am i missing something here? I don't here any other super duty's squeaking on the road.
View 1 Replies
I recently purchased a 00 F250 psd 4x4. Other than doing all of the fixes it needs to make it ride better I have been questioning the trucks "get up and go" and the EXTREMELY sensitive skinny pedal. Truck seems to pull very hard and puts out some black smoke under hard throttle but nothing like the really tuned trucks I have seen. But the skinny is so sensitive its hard to drive under 40mph in 3rd and once it gets up to 55 or so its real sharp getting on and off the throttle. Trans shifts great, TC locks and unlocks, truck runs awesome IMO but just a bit harsh. Is there a way to find out if it was tuned prior to me buying it other than inspecting for a chip, or is this the way they are and I just have to get used to it more...?
View 9 Replies
When passing or going up small inclines on freeway, my F250 seems to make the shift to the passing gear but then almost a complete loss of power. Jerks around for a few seconds and finally provides enough power to at least get back to the original speed. (It feels kind of like the lurching, etc. I used to get when those stinking GM diesel injectors would act up in the 1990's.)
It also stays in first/second as I punch it while entering the freeway and doesn't want to make the shift. I can put it in neutral and race the engine, so I don't think it is an engine problem, unless the transmission is electronically controlled. I have a lot of computer dashboard gauge resets after falling to zero and sometimes have to set and release the parking brake to get the auto door locks and windows to work. (That started after a car break in where the door electronics were apparently pinched, but that was a couple of years ago.)
Does it sound like the transmission or electronics? In the old days replacing an automatic transmission filter seemed to fix a lot of transmission issues. Not an option now, but would I expect to see any results doing a transmission flush and fluid change? It's probably been about 60000 since I had that done. (157000 now).
View 2 Replies
I just bought the truck 2 days ago and the power steering is acting up. When I test drove it I noticed the power assist seemed weak but it has gotten way worse over 2 days.
Truck is a 2001 F250 4x4 V10 auto. 60k miles and totally stock except for Harley Edition wheels and stock size tires.
Now at a complete stop the wheel won't turn at all. If I roll it works. Doesn't matter if I rev the engine. It doesn't matter if I'm on or off the brakes. Tires have plenty of air. The pump is quiet and does not make any abnormal noises.
This is terrible because how can you maneuver a trailer if you can't turn the wheels when stopped.
I noticed the fluid was low and not reading on the dipstick. I added a few ounces and that's all it took with no change. I then used a suction pump to empty the reservoir with the truck off. The fluid was very dirty, probably the original fluid given the mileage. I removed about a quart and refilled it with fresh Mercon ATF. I also changed the serpentine belt because I noticed the belt was probably the original and was cracked.
It went away briefly tonight as I was playing with it. I thought I fixed it but I was fooled. What I did was remove the reservoir cap and turn the wheel from lock to lock while rolling forward slowly. Suddenly it was fixed . But 5 minutes later the problem was back.
View 11 Replies
I have a v10 ticking on drivers side when I first take off in it. It doesn't do it idling and stops after you drive about a mile. I just had ford tune it up before this started so I took it back to have them check the plugs and they said it was a rod! Didn't sound right too me but I did check manifold bolts and they all was in place. Also if it was a rod would the noise go away???
View 6 Replies
Having trouble with a shutter upon take off in there drive train. It only happens when I am going straight. It does not do it when I am turning or anything. I just bought the truck used sat. It has around 18000 miles on it. I haven't had a chance to put a load on it yet to see if it does it then.
View 14 Replies
Purchased my first used Super Duty 2011 F250 6.2. Love the truck. This is my 3rd ford truck. I get home from work, so the truck is warm. Sit for 20 min, then leave to take the kids to their games. After turning onto the street then accelerating power is lost for 1-2 seconds, then the truck continues to accelerate. If I let off the pedal, then the truck will slow down, if I hold the pedal position of push down it does nothing. This is going to drive me crazy. Not sure if this is a TCM reprogram issue? It only does this on the initial take off. I want to start playing with my new truck, but want to fix this bug first.
View 5 Replies
Trying to find a bit of information for my dad. He has a 2008 F250 with the 6.4L PS. It recently started making this horrible screech on his initial take off from park. After he let's off the gas and brakes, the truck won't make this noise again for the rest of the time it's on. He ended up replacing the turbo, and that did not resolve the issue. I believe the Y pipe was checked and it was fine. What it could be that would cause it only on the first acceleration?
View 5 Replies
My 1999 f250 v10 automatic shakes really bad only when your doing 70-80 kmh unless you shut off the overdrive or go faster... why?
View 8 Replies
1999 F250 SD Ex 4x4 V10 has been intermittently not starting, both cold and warm, began last fall but only happened once a month or so or longer. Would then start after trying again either right away or after waiting a bit. Now it is doing it on a regular basis. Sometimes it will start right away, sometimes won't but if you keep trying or wait awhile it starts, sometimes using the extra key will start it right away after the first one didn't, sometimes neither one. It does not try to turn over, make any noises, no warning lights flashing, just won't start.
Now also on two occasions within the past week, it just stopped while driving. Radio, dash lights, etc., stayed on. I got it to the side of the road with the little power steering left where it started up again right away.
No codes showed up. First mechanic couldn't find anything obvious or replicate problem. Changed air and fuel filters (fuel filter really needed changed), plugs. Got truck back and it wouldn't start next morning. He checked it again and got a code related to ignition, tried the spare key and it started up. Truck back home, next day same problem.
Mechanic 2 checked, no codes, kept several days but, of course, couldn't replicate problem. I'm not even sure what all they checked, used to be an excellent repair place but now they seem to only really on diagnostics and throw up their hands, very disappointing. Replaced solenoid and starter last year myself. Otherwise, have had no problems until this.
View 7 Replies
I bought this truck with 60,000 miles and have had about 3 months. I don't drive it very much but when I do I have noticed that when it sets for 4-5 days or longer the transmission makes a weird noise as you take off and does does shift into gear as it does when I use it ever day. The problem goes away very quickly (not even a 1/4 mile driving) and everything is fine after that. By the way I took it to the ford dealer who did a complete 60,000 mile service on it that was suppose to include changing the transmission fluid and filters-could they have screwed something up (I did not notice this issue until after the 60,000 mile service?).
View 7 Replies
I have a 'new-to-me' Ford F-550 with the vaunted 7.3 Powerstroke diesel engine. The truck only has 120k miles and ran great when I bought it. Last week it began acting up. While driving on the highway, it lost power, began running rough, and once I pulled over, it died.
After a few minutes, I tried re-starting the truck, it started, but had little to no power....I could get up to 30-35mph and then it would slow down and lost all power. I let the truck sit for about 20 minutes while I refilled the diesel tank, it started right up and drove normally for another 10-15 minutes and then the same thing happened again.
The truck sat for a day and then drove normally for two entire days. This morning, it began acting up. It is the same as before..... what to do with this type of issue?
There is not a check engine light lit (yes, it works). The diesel is from a good source that is not causing problems in anything else. The truck is otherwise strong.
View 5 Replies
I have a 2000 f350 v10 ext cab 8 ft bed 4wd,i replaced all 10 plugs all 10 coils at 40 mph the truck violently shakes an vibrates read on a few things that could be crack cylinder or bad pistons,i did a test on it an says low compression in 2 cylinders 1&2 what can I do an what is the best option for me as I just got the truck not even a month ago...
View 3 Replies
Friend's truck started shifting wierd the other day, starts in second gear (maybe higher). The transmission is a fresh rebuild, the shop wouldn't warranty the rebuild and blamed electrical problems outside the tranny. Fuses are all good, engine light is on but the cheapo code reader won't show a code. Did a search and no answers. Had the overdrive light flashing from before, that code was for a wheel speed sensor.
1999 F250 (7 bolt) 5.4L 4x4
View 1 Replies
i just bought a 99 F250 4WD with the 5.4 in it i put a brand new starter in it. When i turn the key to try to start it, it just cranks the motor once and stops. The starter isn't grinding or clicking, the motor clicks once and move the belt and pulley a little but that's it. What would cause this?
View 13 Replies
