Ford Super Duty (1999-2016) :: 2000 F250 - Rear Driver And Passenger Windows Would Not Raise Or Lower
May 19, 2017
My son recently purchased this truck in Jan., 2017, upon inspecting the vehicle we noticed the rear driver and passenger windows would not raise or lower. When I asked the seller about this his comments were " I believe it to be a master switch issue". Ok so no big deal, I purchased and replaced the master switch with no luck. I didn't spend much time on it due to the cold weather. After digging into this a little more I'm very confused now. So here is where I currently am at with this issue.
Power is not the problem, I am reading approx. 14V at the master switch and at the rear door switches. I've checked and have power when the switch is toggled to simulate raising and lower of the window (approx. 12 to 13.5V). The window lift motors have been taken out and cleaned and inspected. The motor will operate properly with a 12V battery pack (both motors, driver and passenger side). I have power all the way to the motor itself, slightly less than 14Volts.
I can raise and lower the window in the truck by plugging into the back of the female connector with the outside power source but not with the power supply from the truck. I have continuity between the power(blue) and ground(black) wires at the switches. So this is where I am at, also just a reminder the front windows and door locks work fine. Just a side note, this truck has aftermarket mirrors on it so that branch of the harness is left hanging.
View 3 Replies
Advertisement
I bought my first vehicle last October, a '99 F-250 with a 6.8 V10. I later found out (AFTER hauling a big load of rocks in a dump trailer) that one of the bottom leaf springs was broken. So this winter I have been thinking on what I want to do about it when it warms up. This is pretty much on top of the "to do" list for my truck. I did make a thread about putting 1 ton springs under it, but I think I'll just stick with the regular 3/4 ton springs. So now this is where I have another question, and I think this pic will tell some of it:
Now I'm not sure if those rear springs are stock, but that rear end is way the heck up there! The truck itself is not level, the front looks to be correct height, but not the back. A buddy at school and I were talking about a leveling kit for the front. But the more I look at it, I think the rear end should come down. I don't want to get bigger tires, as I just put brand new Transforce AT's on the back and plan to put new ones on the front in the near future.
Another question of mine is, would this have been a truck ordered just for pulling a camper? It has holes for a fifth wheel hitch in the bed, the rear end sits high, and it didn't come with a tow package. The PO told me that he put the receiver hitch on it. I'm fixing up stuff on it one thing at a time. Springs just happen to be next on the list.
View 14 Replies
OK, I never heard of any "key" to lower the spare tire. However, the nice people at Discount tire weren't able to swap my tire because I'm missing some "key". How do I get a key for this and ELIMINATE the need for the key? 2000 F250 Crew Cab 4x4.
View 3 Replies
My truck is a 2008 F250 6.4 Powerstroke 4x4 King Ranch, CrewCab, Shortbed.
I don't know which rear axle ratio it has - maybe someone can help me. the tires mounted are 275/60R17 and in fifth gear (TC locked) the engine has 2000rpm @ 70mph. I think it is a bit to much so I want to install a kit with and lower ratio. I pull trailers just sometimes and here in germany these only have 3,5tons max weight. So I think I don't need this power at 70mph. 1750rpm would be enough. How do I have to modify the front axle ratio if I get a lower-ratio-rear-axle?
I want to lower the fuel consumption. After some modifications, the truck needs round about 12-13L/100km (18-20mpg) and I think it is possible to lower this as bit.
View 3 Replies
I just bought this truck,2013 f250 CC Lariat 4x4. The sliding rear windows opened and closed 1 time and has never done it again. I have read about the motor and cable setup breaking and needing to be replaced. I do not think that is the issue. I have also read that the channel the window runs in needs to be lubricated on a regular basis. I was going to try that first. What is the recommended lube for these window channels?
View 2 Replies
I have a 2013 f250 6.2, I bought the truck brand new only have about 3000 miles on it and the other day I noticed that the drivers side front is lower then the passengers side front, the drivers side is about one inch lower, this doesn't seem right, also my drivers side front wheel seems to be pushed forward about one inch to the bumper that also doesn't seem right.
View 3 Replies
I just got my 2000 f250 a couple of months ago and my passenger tire is going balled but my driver side tire is fine this is my first ford truck so I don't know much about them. I have a tug in the steering as well...
View 3 Replies
I have a 2000 f250 4x4 with 4 wheel abs. The front passenger side caliper keeps locking up while I'm driving and won't release and when I hit the brakes it pulls hard to the drivers side. I have put two calipers on the passengers side and put new brake lines on.
View 8 Replies
I have a 2000 F250 4x4 7.3 - About a month ago I drove across town and then noticed a strong hot brake smell from the rear of the truck. When I drove home about 2 hours later it was gone and didn't return until today. Today I stopped at a light with my window down and got the same hot brake smell, looked in the mirror and saw smoke coming from my drive's side rear wheel.
I carefully drove home (the smoke was now gone, all i did was cycle the parking brake release a couple of times) and pulled the wheel off. Rotor was really hot but smooth and clean. Brake caliper and pads looked great (no sign of the pads glazing or dragging, dry as a bone). The inside of the rotor was wet with oil. The brake shoes and components were soaked with the same fluid/oil.
Does this sound like a typical hub seal issue? Excuse my ignorance since I haven't had the rear hubs apart before but does the gear oil in the rear diff go into the axle tubes? I know the front tubes are dry but I didn't know if the rears are different. The amount of fluid on the brakes seems to be more than the little bit that is inside the hub. I need to pick up the parts and rent/purchase a couple of tools to replace the seal so I want to be as sure as possible that I'm on the right track...
View 11 Replies
Just became the proud owner of a used 2011 F-250 Supercab, 6.2L. Overall the truck is great but it does have a-few things that need fixing, the most annoying of which is a knocking sound from the rear passenger side cab corner. Sounds like the exhaust vibrating and smacking up against the floorboard but that's not it. Everything seems tight, even the front suspension.
The only thing I can see that may be the cause is the rear passenger cab mount seems worn. I can rotate the bottom rubber portion without too much effort and when I feel for the top rubber portion all I feel is the metal cup on the top, like the rubber has collapsed and the metal cup is sitting directly on the frame mount.
So... how many cab mounts there are for the Supercab? I think there are two on each side and two in the front. All of the information & videos I've seen describe the locations for the crew cab. Also, is it possible to replace the cab mounts and not have to mess with the ones in the front? I hear those are the real buggers.
View 2 Replies
Here's my problem while replacing brake pads i found that my axle has leaked fluid on the pss,side rear rotor and all over .. I been looking for any info on repairing it myself . I found Everything for every other truck just not for this truck.
It's 2003 F-250 w/5.4L all Stock rear axle has 12 bolts and gears are 7.73 ... I believe its a Dana 60. No tags or markings on the Axle to go by..
I live in the Freak-en woods here so i like to order all the right parts once and do over the weekend .. its my only ride so once apart im stuck here.... I did check the Vent Tube its fine..
View 14 Replies
So I've put about 1000 miles on my 03 F250 since buying it, and just the other day it's started leaking from the rear of the passenger head gasket. Enough to drip on the driveway and exhaust, and have some exhaust smell. 126,000 miles, 5.4
I've checked with my local ford dealer, and It also needs passenger exhaust manifold and studs, so the dealer price to tack that on would be a whole lot more too since there are already a couple studs broke. It would be best to get it done when the head is pulled.
I've checked with several local mechanics, and none of them are interested in pulling the head on this engine. That has me concerned about doing it myself too..especially since it fits in my garage with only a few inches to spare..
View 14 Replies
Got off the freeway today, driving along about 40 or so thought I smelled something hot like something burning. Stopped in a parking lot and smoke was rolling out from drivers side rear wheel. Look under and oil is dripping from inside of the wheel. Figure the caliper was hung up and got so hot it took the seal out. I can't get to it right now and the shop says I can't get in until next week, need my truck now. How long could I get by the way it is IF I take it real easy.
View 9 Replies
I've got a 2008 f-250 extra cab. A small bump will cause the rear driver side door to pop open. What I have to do to fix it, I don't want the grandkids falling out.
View 2 Replies
When my truck is parked, I go to the rear tire and shake it back and forth and hear a slight clunking noise from either the tire or rear end. Its like the axle is making the noise?
2000 7.3 Power Strke Super Crew 4x4
View 6 Replies
I have a 2004 F250 Lariat Crew Cab FX4 6-3/4' bed.
What is the procedure to remove the Driver's side Rear Sway Bar Link upper bolt? - the link attaches to the frame. The nut is on the inside of the frame with about 1/3" to 2/3" clearance between the frame and the fuel tank. Of course, the frame's "C" shape faces towards the inside.
View 1 Replies
On the F250 trucks, if I changed the mounting frame under the seat, will the passenger side seat fit on the drivers side? Basically, can I turn a passenger seat into a drivers seat?
View 4 Replies
I have a new 2013 f 250 gaser the truck I noticed sits crooked it is lower on drivers side by almost 2 inches and not from the fuel tank.
View 1 Replies
Passengers can roll down the power windows on front passenger door and both back doors. But, they cannot roll the windows back up. The only way they can do that is to have me do it from the driver door. The window lock button is unlocked. I am thinking some is wrong with the driver main window controller since it all goes back to it.
View 1 Replies
Vehicle: 2002 f250 xlt 7.3 powerstroke reg. Cab
Issue: door ajar light stays on, power locks on driver and passenger door don't work, radio stays on after truck is off an door is opened.
Events leading up to issue: went to temporarily hook up a wolo dixie horn to see if it worked. Wanted to do it fast so I took + cable, tied one end to the battery terminal and then connected other end to dixie horn relay. I then grounded both negative wires to the truck. One ground on the frame the other I temporarily wrapped around a one of factory ground mounts under the dash. Immediately after doing this the problems stated above started.
How can I fix this. I need to fix this by tomorrow. I have a guy from Craigslist coming to look at the truck. Now the 4x4 issue.
Truck has zf6 manual and the electric 4wd select ****. Just thought I'd list this if it was needed to be known for solutions.
4x4 high light stays on in while 2wd all the time. 4 low will stay on after switching back to 4 high and 2wd but it goes out if I ether stop the truck shut it off then restart it. or back up and slam on the brakes. Also when in 4 high the front driveshaft won't spin. However It will spin when in 4 low.
Another random issue I'd thought I'd just list while I'm writing this.... Cruise control does not work. And when I press the "on" button and the "coast" button at the same time the horn honks.
View 3 Replies
I just bought this truck and for some reason sometimes the power windows and radio will not work for awhile then it will start working. I replaced the relay on the accessory and I still have power to the dome lights and instrument cluster. I am kind of at a stand still on this matter. I have read that there is quit a few problems like this and not very many explanations to resolve it.
View 5 Replies
