Ford Super Duty (1999-2016) :: 2000 F250 - Brake Controller Tekonsha Voyager Wire Colors?
Oct 8, 2014
I 2000 f250 throughout a few years.
Anyways, I recently aquired a tekonsha voyager (for free) and went to install it, but have run into a problem with the installation.
I searched to find a wire color guide to figure out what wires are which on the under dash connector, but cannot find the answer I'm searching for.
Currently I have a red, green, blue, brown, and yellow wire on the underdash connector, while the tekonsha only has red, white, blue, and black. (I know what colors do what on the controller, but am completly lost on the under dash plug, and can't trace it back without tearing out the entire dash assembly.
View 3 Replies
Advertisement
I am looking at a 2014 f250, if has all of the options I want on a truck except the brake controller. Can a brake controller be added to this vehicle ? is it already wired for and do you just remove the blank plastic and pop in ? one ?
View 3 Replies
Where I can find a good used or a good deal on a new factory trailer brake controller to fit a 2006 F250 Diesel Truck?
View 1 Replies
I tow a 5th wheel with my 2014 F-250 that has an factory TBC. I just installed Electric over Hydraulic disc brakes on my 5th wheel and was trying to see if there was a setting I needed to change on the TBC to tell it that is now E/H versus E. In the Information section of the dashboard display it talks about the controller actuating electric drum brakes but the manual talks about it being able to do electric AND E/H. What I need to do here...if anything?
View 6 Replies
First, need a wiring diagram for the outputs on the back of the brake controller module? I want to check and see if there is a problem with the connection to the rheostat. I can activate the trailer brakes with the slider bar but not with the brakes.
Second, where I can get a new OEM controller that will replace my old one if I can't "Cypher it out"?
View 2 Replies
I've just bought a new 2016 SD xlt. The only extra I wanted that is missing is the factory trailer brake controller. The dealer told me it had to be programmed. I was expecting plug and play and planned to do it myself till they told me that. Is this true?
View 14 Replies
Have recently been getting a "TBC Fault" message and the Beep, as the message goes on and off(annoying) looked around think its the Controler itself,,If I move the slider, and Jiggle it,,the message Blinks on and off as I move the Slider,,,Looking for the method of removing it from the Cubby Hole,,,Gave it a tug,,,and wiggle did not move must have a Clip or Tab to release it.
View 8 Replies
I am having an issue with the under dash plug for the brake controller on my 2001 Ford F250 Super Duty. I plugged in my Curt Brake Controller and figured all was good.
As usual with anything I do it isn't that easy. There is no power to the controller or the plug.
Is there a specific fuse I should check or even look to see if it has been installed because apparently this truck never had one installed even though it has a 7 blade plug installed and is plugged into the wire harness in the rear.
View 5 Replies
We bought a 2012 f550 chassis and had a utility bed outfited. As far as I know the truck does not have a tow package (major F-up). They did install a receiver and electric in the rear. The 7 way pin in the rear does have the appropriate wires (including blue). I can not find the harness in the cab under the dash. I have looked near the radio where I have found the harness on our other trucks. I specifically looked for the red white and blue wire under there. Where is this harness? Is the harness still in the cab even without the tow package? This will be for the old school plug in controller, not the ford intergrated contoller.
View 4 Replies
My 08, when I connect my 7-pin trailer up, bouncing down the road that message and tone CONSTANTLY going off....drives me nuts! I have went thru the wire harness 2x now, cleaned all the contacts, etc. Any other thing short of a 12 gauge? When it does pop on, the controller starts flashing...I've reached down a few times and manually hit the brakes and it still hits em so whatever it is, I feel its very minor or whatever....just don't know where to go now! All contacts have been cleaned good as well.
View 8 Replies
Trying to find ground wire location on my 99 f250 super duty with the 5.4 triton I didn't unbolt it myself. Going to be doing the big 3 upgrade soon and would like to use the factory ground spots.
View 13 Replies
I have a 1999 Ford F-250 superduty single cab. I am trying to put in rear speakers into the stock speaker housing but there are no wires run to the area. Where are the wires located in the dash to run the wire from?
View 2 Replies
What color wire controls the high beams?
View 1 Replies
I have a 2013 F250 that I am installing a amber warning beacon on. I need to be able to get the end of the electrical cable into the cab of the truck but it has a 12 volt lighter plug on the end that cannot come off. Is there a rubber plug somewhere in the cab that I can route the cable through?
View 3 Replies
I'm putting a new double din stereo w/ backup camera in my truck, I have everything wired except the violet/white wire (from the stereo) that needs to be hooked to a wire (on the truck) that will activate the camera when you put it in reverse. I cannot figure where this wire is on the 2012 for the life of me.
View 3 Replies
I have a 2006 F250 and my 7pin and 4 pin connectors are just hanging loose. I'm not sure what happened to the factory bracket. What is the part number for this bracket? Also, where does it mount to? I looked under the truck and couldnt tell where the factory one mounts.
View 4 Replies
My 18 year old launched the little wire spring thing that applies pressure for the brake pads on front disc brakes. Could have gone in to neighbor's yard! Actually lost one on each side. He put it all back together without one on each side. I said it would still work fine. What's the deal really? Can't be that important are they?
View 14 Replies
The problem is I haven't seen one for a recent (2011+) SD. I don't see anything that resembles a rear drum. They look like 2 huge regular disc brakes.
I live on a hill. My old man taught me to put the trans in neutral, autos and manuals, put the ebrake on and make sure it holds the vehicle, then put the trans into park or 1st gear. This way the weight of the vehicle doesn't rest on the transmission.
How do I adjust the Ebrake? It's ALMOST holding the truck, just needs a minor tweak. I don't see the dust cover the write ups described at all. The one that reveals the Star Wheel. Are they different on these years then prior SD's?
View 14 Replies
I have a 2000 f 250 that will not start... I have replaced many parts all electronic sensorsm the past week i have spent in the neighborhood of 1800.00 on this truck. Cps, icp, idm, ebps, fuel filter, new oil, hpop level good, gpr, all new need starting........
View 4 Replies
2000 f250 7.3. Today I tried using the 4x4 and no light or anything. Here is what i have tried so far. Swapped the relays and also swapped them with the towing relays with no change. Not getting any voltage to the t-case shift motor at the selector switch testing between pins 2 and 3 there is 4.3 volts with switch in 2wd 2.4 volts at 4 high and 1.09 volts at 4 low. Where to go from here? it worked fine 3 days ago.
View 2 Replies
I have an 04 F250 with no brake lights. However the third brake light works. I've also noticed that my trailer brake lights don't work either. I do have all my turn signals and running lights. Another issue that could be connected is I have one out of four hazard lights. When I push in the hazards my front passenger blinker works but none of the others. Could this all be due to a relay switch?
View 14 Replies
