I have a 2000 F250 and the blower motor stopped working, the a/c clutch locks in but the blower will not run. I back tracked and I have no power at the motor or the resistors, or the speed switch. There has to be a relay that is turned on by the a/c selector to power the blower circuit. I guess my question is need a schematic of the a/c circuits? Or the location of the relay?
View 7 RepliesAll 4 crew cab door locks are not working...I see and hear them moving a little but not enough to get the job done.....Ive read a good fix on this forum but have a few questions...... 1. Could the problem be in the switch or wires ... 2. If I try to fix---do I need to fix all doors or is one door somehow messing the other up.
View 6 RepliesI just bought a 2000 super duty F250 Triton V10 and the auto door locks don't work. They try to work as in tug an eighth of an inch but won't successfully engage or disengage. Thought it might just be the switch inside the door handle but they don't work on the passenger side etc either.
Also two days after I bought it I found out first hand that these motors spit out spark plugs and i had to replace the plug and coil. I was told that there is a tool that I can tap out the heads with and then put inserts in so i no longer have this problem. Where do i get that tool and how much are they? Is it true that pulling the plugs can strip out the heads because i bought all new plugs for the truck and was then told that it will strip out the heads.
How many quarts of oil does this engine hold and should i use a certain type of oil? It has high miles but purrrr'ss like a kitten.
2000 superduty. When you hit the door lock/unlock button, they try but won't move up or down on any of the 4 doors. The switches no longer are illuminated either. Where or have a wiring schematic for the drivers door with power windows/locks? I have done some testing for power, which seems to me there isn't enough voltage going to the actuators, but I can't seem to find power anywhere. The power mirrors don't work either. All fuses are good.
View 8 RepliesMy door locks stopped working new battery in fob, I can hear them trying to work. 2000 f250 crew cab .....
View 3 RepliesMy dad has a 2000 f250 4x4 with the 5.4. he said his blower would only blow on high. I told him it was his blower motor resistor. i thought it was under glove box. he took it apart and said no but there was a little box thing with wires he took off anyway and put back on. I then told him it was under hood below a/c lines. he replaced old one with a new one from auto zone and replaced the pigtail( plug too) fan works on high and a little bit on low very very little when u switch it to medium it stays the same. High works great. So we replaced the fan switch. (Radio was a bitch to remove) and it still does the same thing. I checked all fuses . when I check the plug at the resistor there is power to the center pin it stays on when u switch to low and medium but when u turn high on power goes out( on test meter) is there something I am missing? the blower blows on high even when u remove the plug from the resistor. Is that normal?.
View 4 Replies2000 crew cab powerstroke 4x4... It's a XLT, six inch lift, weld wheels, BFG all terrain (50%). 277,000. One owner. Clean Carfax. All service done by purchase dealer. Mostly stock other than that. Dealer just replaced AC compressor and charged system. Interior is good, except for driver's edge seat. Good cleaning and ok.
The (my?) Truck.Downside. Power door locks make noise but don't work, remote mirror switch intermittent, stereo broken. During my test drive (alone) it drove straight, stopped straight and hard. 4x4 engaged and worked well. No noise in system. Good acceleration. No rattles or noises. Doesn't drip anything on the ground. Cruise and all accessories work.
I'm supposed to go in Monday. My girl is afraid of the mileage. But it seems well maintained for 17 years old. Is 10k an acceptable price? They wanted 11,900. Anything I should be looking for?
2000 f350 7.3 Door locks unlock and lock constantly. Wait to start light and 4x4 lights don't come on. Gauges stopped working and clicking behind dash.
View 1 RepliesI have a 2000 F-550 w/7.3. I am having a bit of a problem with the hvac system. When I turn the selector switch to floor heat only or put it on vent or both the a/c clutch kicks on and off. Not when I put it on defrost but as I said only when it is in the other positions. I do know that the clutch will kick in and out when on the defrost position. That is fine. But why would it kick in and out when in the heat only position?
View 2 RepliesMy batteries drained twice and now I prob. need new ones but with the key off I can turn the blower on any speed and the passenger airbag light blinks. I hear the clicking from a relay under the dash when I do this. I have checked for leaks in the windshield and found none . The fuse box and the GEM are completely dry. My ignition switch will pull out with the key in it . I noticed this just the past few weeks . Now yesterday my odometer speedometer quit. It did pull a code for this. Maybe it is connected maybe not . My odl light is flashing but still works. My cruise doesn't but I realize it is connected to speedometer.
2000 F350 supercab diesel....
I recently purchased this truck so I don't have any history on it. It's the V10 motor, automatic, 4 wheel drive, with a crew cab. I took it to Advance Auto to have them read codes and it came back with torque converter solenoid fault and 2 other codes related to that part. I didn't get to see the actual code numbers.
I've talked to 2 transmission shops and they said they could throw a solenoid pack into it, but that it might not even fix it. The truck drives fine, shifts fine, the tranny oil looks and smells fine, so I'm tempted to not worry about it until something else happens.
The truck has 217,000 miles on it...
2000 Ford F250 crew cab 4 x 4 with 7.3. 6 speed transmission.
I just had a new clutch installed and now I am have a grinding noise when putting it into 1st gear and when I change from granny to first it will grind also. I did not have this issue before having the clutch replaced.
I have also just had a new hydraulic clutch kit installed.
I've got a 2000 F250, 5.4L 4x4 with the ZF5 5-speed transmission. Three years ago I replaced the complete clutch assembly, pressure plate, throw-out bearing, etc, and had the flywheel re-machined. Put it back in and all has been well. Only has about 15k miles on it. Earlier this week I went to drive it and all of the sudden it started getting harder to shift and by the end of the trip the clutch will not disengage at all when I push the pedal in.
Furthermore the pedal is much harder to push than it always has been. Checked the reservoir and it's fine. After some searching it seems to most likely be an issue with the master and/or slave cylinder either needing to be bled or replaced. Further reading revealed that bleeding and recommends just replacing the whole system, so I've priced that out. Was it a master/slave issue? Anything else I should check in case it isn't?
My 2003 tailgate locks by itself sometimes, has been just annoying, but today I can't unlock it. It has no electronic lock. What to do?
View 9 RepliesI put new batteries in the fobs, and my electric locks work using the buttons in the door.
Checked the key fobs at autozone.. they are ok.
Is there a training procedure for Ford OEM fobs?
F250 2002 4x4 5.4 Lariat Crew
Ok, I have had this problem a couple of times before, generally when it is wet and cold outside and the result is a very dead battery. The heat/ac blower fan continues to run after the truck has been shut off and the key removed. I believe that it even comes on after the truck has been shut off. What could be causing this?
View 14 RepliesIt seems that every time I put the truck into 4 low, the rear axle locks up. When turning, one tire skips no difference which way I turn. When doing this, I do not have the front hubs locked. Also noticed that when turning in 2wd one tire will spin w/o other locking up. I have spun the tire enough for the L/S to catch, but hasn't. I have heard that the locker was not available until years later. Is this true?
View 11 RepliesThe blower motor went out on my 2008 F-350,? I can't for the life of me figure out how to get it out. Do I have to remove the dash? I am positive it is fried, I ran a hot wire straight to the motor and it still wouldn't come on.
View 2 Replies15 f350 gas xlt with 8.6 Western proplus straight blade. I noticed that while only applying throttle and fully angling the plow ,the hvac system turns off and then on again and the dashboard lights also turn off with the message system also going blank. I've brought it back to the body builder, twice, that installed it and they don't acknowledge a problem. The only answer I got was it's probably a bad battery. The funny part is you can angle it all day while it idles but as soon as you apply throttle and fully angle it left or right it cause the loss of power to certain accessories. When it does this it also causes a relay to click under the dash panel on the drivers side .
View 8 RepliesMy A/C, vent fan (blower motor) keeps going in and out. Does not do it all the time, but when it goes out, it will come back on after a few moments, but will not run full speed. If you try to adjust the speed, it just cuts off again. What is causing this.
View 7 RepliesI have a bone stock (other than exhaust) F-250 SD, 6.0 auto, 185k miles. I have a substantial vibration when the torque converter locks - about 50-55 mph. Once the transmission warms up (i.e. 4-5 miles from a cold start) the vibration goes away and the transmission performs flawlessly. Backing out of the throttle and allowing the TC to unlock makes the vibration go away, as does shifting into neutral. There is no noise, just a vibration that will shake the whole truck. Transmission fluid looks good, and showing full. Have had the truck about 4 months, and have not flushed or replaced the filters on transmission.
I've seen a couple of similar threads on vibrations, but not one where the vibration will completely go away. I'm thinking replace the torque converter but wanted to get more information from the experienced experts that know these 5R110s better.
2007 F-250 King Ranch 6.0 PSD, 5R110W, 4" Turbo Back, Otherwise bone stock, 185k.