i'm looking to upgrade my mirrors. A friend told me to get the 08+ mirrors but I can't find anywhere online that says they will work. I'm hopefully going to be purchasing on Amazon but not sure which ones to get. When I pull up the 08+ they say "Fits Ford 2008-2015 2008 2009 2010 2011 2012 2013 2014 2015 F250 F350 F450 F550 Super Duty"
Ive got the 2000 F250 V10
I have a 00 F250 7.3 4x4 and I am looking to get better mileage out of it since it is now a dedicated work truck for towing. The two options I have in mind I think will work, but just wanted some clarification and if one is even possible.
First I will be taking the lift off and dropping back down to 33 inch tires or so. This should give me a little, but if not it should be easier on the truck for towing.
And this truck mostly see's highway miles, so I was thinking about disengaging the 4wd. I heard 4wd trucks get worse mileage, so this is the one I didn't even know if it was possible. not digging in to the computer and injectors quite yet.
Have a 2000 F-250 V-10 4x4 with 335,000 miles on the clock. Has started hesitating at 40-45. You can't really notice it at idle. Drove it around at lower speeds and just a miss here and there. Take it up to 40-45 and it's quite bad. Hasn't thrown any codes. Hooked it up to the scanner to get no additional info. My gut says coil packs but am kinda confused that I haven't gotten a misfire code yet. What to check?
View 6 RepliesA vibration has just begun on my 00 f250 power stroke it's in the left front and happens when I hit a bump I changed out the wheel bearing assembly and I switched locking hubs with another truck all with no success don't know what else it could be it does go away if I lock in the hubs so idk
View 2 RepliesI have a 2000 I got new in sept of 99 its a good truck and id like to keep it as long as I can its got 173,000 on it I take care of it garaged kept and consistent fluid/filter changes all over top and bottom few minor addons like turbo bak exhaust from Silverline,auto meter gauges so I can monitor temps ,a bigger transmission pan aluminum I did years ago ,a gear vendor 8 speed addon years ago,diablo predator tuner with the 80 horse tune been doing great for a quite a while lately I noticed if I leave it idling in park for a few minutes while in a store r sumpn it won't shift outa 3rd its like overdrive is turned off I have to pull over and kill&restart 7.3 and take off its fine what in the wide wide world a sports is happening my overdrive switch has been out for a couple years I just haven't replaced it yet it gradually got worse when using it id have to pull shift lever in to get it to engage then put in neutral then in park now cant get it to work at all hopefully I can fix it myself but my luck is never that good.
View 5 Replies2000 super duty v10 with 92,000 miles. Getting that common rattle around 2k rpm range that goes away if I give it gas or let off. I originally thought it was the inspection plate on the transmission so I removed it and went for a drive to verify. The sound is still present so the only thing I can think of is the catalytic converter is worn out??
View 10 RepliesGot a 2001 F350 diesel auto, 295k miles.
It has miss when over 2000rpm. Below 2000 its smooth.
ICP has oil in sensor, ordered new one. Gonna change oil too.
CPS is new (not sure if its black or the other one). Starts idles and drives good otherwise.
Where should I look?
What torque setting I should use for lug nuts on a 2000 F-350 dually?
View 7 RepliesI have a 2000 f 250 that will not start... I have replaced many parts all electronic sensorsm the past week i have spent in the neighborhood of 1800.00 on this truck. Cps, icp, idm, ebps, fuel filter, new oil, hpop level good, gpr, all new need starting........
View 4 RepliesI have a 2000 F-550 w/7.3. I am having a bit of a problem with the hvac system. When I turn the selector switch to floor heat only or put it on vent or both the a/c clutch kicks on and off. Not when I put it on defrost but as I said only when it is in the other positions. I do know that the clutch will kick in and out when on the defrost position. That is fine. But why would it kick in and out when in the heat only position?
View 2 RepliesThe V10 in my service truck took the long slow ride. I located and am in the middle of replacing said engine. My question is, how difficult would it be to install a second alternator in this truck, considering I have it torn down for replacement?
It a 2000 F350 with a V10. I'm looking for more power as I have mounted on the Knaphiede service body a IMT 1015 crane, 3200 lb capacity. I would like to install a power inverter to be able to run an air compressor in the field.
Am I looking for a new harness? Etc?
I want to put in a SPD Y pipe. They make 2 different ones, 99-00 and 00-04. I have a 2000 and so I've been trying to figure out which one. The SPD website's phone number goes straight to voice mail and it's inbox is full. 5 star tuning who sell's these as well told to me to just "get under the truck and see"... I'm no exhaust pro so I don't know what to look for. I just went to a ford dealership and their diagrams where the same but it did show there were different part numbers for the two different styles, so they couldn't work either. It says on SPD's website that the exhaust configuration changed somewhere in 2000. So, what to look for in the difference. Maybe a picture of a 99 y pipe and 01 y pipe would work?
View 11 RepliesAll of the sudden ignition stays on aux when the key is removed. Starts and runs fine with key , also shuts off with key. However when key is removed all aux functions still work ie touchscreen reciever will not turn off, and door chime continues to ding. 2000 excursion 4x4
View 1 Replies2000 f250 7.3. Today I tried using the 4x4 and no light or anything. Here is what i have tried so far. Swapped the relays and also swapped them with the towing relays with no change. Not getting any voltage to the t-case shift motor at the selector switch testing between pins 2 and 3 there is 4.3 volts with switch in 2wd 2.4 volts at 4 high and 1.09 volts at 4 low. Where to go from here? it worked fine 3 days ago.
View 2 RepliesI have a bucking and jerking 6.0 right now. It will buck and then won't go above 2000 rpm or it will lurch or if I hold the pedal down lose power unless I drop it below 2000rpm. If I put the pedal down the truck wont go above 2000 rpm and will go up on speed. the erg was deleted but its trowing crazy amount of white smoke from the exhaust. When the truck starts up some white smoke comes out but eventually clears up when you keep it under 2000 rpm.
When on idle you can step down the pedal and hear the truck failing on revs like an injector issue but i checked and they arent the problem. the problem got fixed for a couple of weeks when i changed the Y pipe because the other was ruptured but the problem came back and its even worse now i can use the truck for nothing.
Having a problem finding the right belt diagrams for a 2000 F53 stripped chassis in a motor home and the dealer has been no assistance even after spending a bunch on parts...
View 4 RepliesBeen searching but can't find a clue. I replaced my steering gear box. Went fine, but after starting back up. My alarm goes off, my cruise or horn doesn't work and my air bag is giving a code 32.
Is there a ground wire or something I could of missed when installing the gear box?
my 00 f250 has the air bag light on all the time. it does not flash it just stays solid. it was like this when i bought the truck @3 months ago. also the passenger air bag switch does not light up when you use it. is this causing my airbag light to stay on?
View 9 Replies I plan to be buying a 2000 F250 V10 in a couple of hours.
I had my boss run by and take a picture of the door tag so I could determine the axle code. What he sent me was this:
Other than giving me the knowledge of how bad of a photographer he is, it doesn't tell me much else. The axle code area is blank, what gives? Am I just going to have to crawl under the truck when I get there after work?
My V10 was knocking when accelerating under 2000 rpm; rain and moisture made the problem worse. I discovered that the 2-part wiper cowl under the windshield allowed water to leak into the engine compartment and onto the throttle body, which then dripped onto the left side of the engine. This caused the spark plugs to rust and the 3 back ignition coils (coil on plug) on the driver's side to crack and fail. This caused a horrible misfire/knock that was worst under 2000 rpm especially in high gear and when the environment was wet. I fixed the misfire and cowling leak. Has not returned. I caulked the cowl and changed all my spark plugs and ignition coils.
View 3 RepliesI have a 2000 F250, SuperCab, 5.4 triton, 100,000 miles. It's been a great truck - got it at 63,000 miles. Once engine warms up, it has rough idle, and shift rough. I can give it gas to RPMs up and it smooths out some but is low on power. If this was my 76 F150, I would guess the vacuum hose off the intake manifold to the transmission came loose.
View 6 Replies