Ford Super Duty (1999-2016) :: 1997 F250 - While Steering Edge Of Tire Roll?
Sep 23, 2015
I have recently bought a 1997 F250 XL and i have a steering problem. It has a lift with 35" tires on it. Its not extreme but fairly mild. But everytime i turn slowly in either forward or reverse the edges of my tire seem to roll under itself or something. It seems like the outside of my tire or inside will catch the road when i make tight turns in and out of parking spots. I can see the outside edge of my tires becoming worn and starting to take small chunks out of it. And when i turn the truck will bog down and i will have to give it some gas just to get it to move. I cannot figure out the problem. I have engage and disengaged the 4 wheel drive numerous times and it still does this.
View 4 Replies
Advertisement
My passenger rear tire is wearing out on the inside edge. Thoughts as to cause and possible fix?
View 14 Replies
What is the proper tire pressure for these trucks (F250)?
Sidewall says max is 80 PSI.
Door jam says 71 PSI.
This is coming from a guy who has traditionally driven passenger cars and trucks. I've never even gotten CLOSE to advertised max PSI ratings. 71 seems awful close to max PSI.
View 4 Replies
OK, I never heard of any "key" to lower the spare tire. However, the nice people at Discount tire weren't able to swap my tire because I'm missing some "key". How do I get a key for this and ELIMINATE the need for the key? 2000 F250 Crew Cab 4x4.
View 3 Replies
How to do this, or have had it done? I do have 35x12.50x18's on it. I did go to the tire center here in my town to have them reprogram it but only worked for a few to a week cant remember.
View 13 Replies
I have a 99 F-250 extended cab superduty 4 wd with the 7.3. I also plow during the winter. Recently I've noticed wear on the inside of the left front tire. Brought it to a tire shop and had them check the front end and alignment. They told me that the specs were "within" tolerances" for my truck. I'm stumped as to why the abnormal wear if everything is supposedly good with the alignment.
View 5 Replies
I just got my 2000 f250 a couple of months ago and my passenger tire is going balled but my driver side tire is fine this is my first ford truck so I don't know much about them. I have a tug in the steering as well...
View 3 Replies
I noticed yesterday that my tire on the driver's side has rubbed a flat spot on the rubber brake hose. I bent the metal tubing so that it doesn't rub any more, but should this be of great concern? Obviously I'd hate for it to rupture, but it looks as though it's not too bad.
View 1 Replies
I have a 2013 F250 and to day the TPMS light came on with a low tire warning message. A little back history, I put new tires on the truck when I bought it and they currently have 9200 miles on them. I didn't like having the tires at the 80psi the tire shop set them at so I lowered them to 62psi right away and haven't had any issues with the low pressure warning going off. Today I was backing into a parking spot and the warning light came on with a low tire message. I checked all the tires and they were right where they should be, but when I got home I added another 5psi to see what would happen and the light never went off after taking it on a 10 mile drive.
My question is, do I have a wheel sensor issue or is something messed up in the computer? I know the door sticker says 75psi front/80rear, but I've been running the tires at 62psi for 9200 miles without trouble so I can't think that the pressure is the culprit. Also, does the spare tire have a sensor in it? In the manual in one paragraph it seemed like it does, but in the next it said that the spare doesn't have one so the light will stay on to remind you to change the spare out.
View 10 Replies
Cat like noises coming from front driver side tire .. honestly sounds like a cat ..it gets louder the faster I go ... what it could be ?
View 7 Replies
I have a 2008 F250 XLT. When i am driving and turn the wheel a squeak is noticeable while the tire is spinning. as i speed up the squeak gets faster and slower when i slow down. I have it narrowed down to the right front tire but cant figure out what is causing it.
View 5 Replies
2010 F-250. the tire pressure warning light is on and the cruise is not working. Verified all TPMS sensors are working and sending signal with the reprogramming tool. using my scan tool, I got several U codes saying there is no communication with the instrument panel control module. I have cleared the codes, they did not return immediately and the problem persists.
View 2 Replies
Is there a steering stabilizer for a 92 Ford F-250 custom 2wd? and what's the difference between a f250 custom and a f250 heavy duty?
View 2 Replies
When my truck is parked, I go to the rear tire and shake it back and forth and hear a slight clunking noise from either the tire or rear end. Its like the axle is making the noise?
2000 7.3 Power Strke Super Crew 4x4
View 6 Replies
I just put some toyo at2 295.75.16. On my 04 250. And I've got some rubbing on the plastic and front leaf springs. If a 2.5 " spring left will take care of the rubbing or will I need wheel spacers.
View 3 Replies
I just purchased a 99 F250 Superduty 4x4. Very low mileage (63000). Everything on this truck is great except the steering. I flat towed a 73 VW Bug about 100 miles and it was the most white knuckle drive of my life. Couldn't take both hands off the wheel without the whole truck starting to wander all over the road.
Before I take it in to have the alignment checked and get told that every single part under the front of the truck needs to be replaced, I'm wondering if this is a "common" problem with this truck that others have encountered. One person has already told me to just replace the front hub assemblies, the tie rods, and the steering gear box and all will be well.
I'm hoping all those parts don't actually need to be replaced - especially since there are only 63K miles on the truck. Tie rods seem solid with no play. Not sure about steering gear or unit bearings.
View 12 Replies
I have an early 1997 F350 XL 2 wheel drive with a knapheide 8ft utility bed. Both front tires lean outward at the top.. I have read posts about the top leaning in but this one is leaning out. The front is set up with the twin I beams and just has leaf springs no coils. Couple of guys have said its normal but i would think not because when you jack up the front end they straighten out. I have tried jacking it up and grabbing the wheel at 12 and 6 and tried rocking it to see where the movement is but its pretty solid, it takes the weight of the truck to make them lean. What it could be? Indiana truck, i bought it with over 100k miles so its possible it has had a plow at one time but if so all the evidence of that has been removed.
View 1 Replies
I have a 01 f250, owned it for about 8 months now. Have done a ton of work to it, replacing all worn out parts. It's a v10, replaced so far is ball joints, all tie rods, steering dampener, front sway bar links and bushings and Monroe gas Magnum shocks all around. My biggest problem is the wandering in steering. I put a 2.5" add leaf spring pack to front when I first bought it. It has stock bullet whole wheels and new Firestone's destination a/ts. Also. Tires have been rebalanced and are smooth until I get to 60+mph, its a swirling ride after 60mph. Could I have bad wheel hubs or do I have an alignment issue? Planning to replace hubs with Napa hubs since I did everything else and I'm sure there bad with 236k miles on truck.
View 8 Replies
just bought this f250 seems to walk on the road alot, had it looked at has new balljoints, he says everything seems tight except there is lots of play at the gearbox, is it recommended to have it rebuilt or buy a reman, was told that even the reman seems to be the same way
View 14 Replies
I have a few F-250's that have been having steering problems. and they all have the same symptoms.
When taking a long slow curve, the steering wheel will jump back like 6 inches, as if the pressure is going out. like say you had the vehicle turned to about 10 oclock, the wheel would go back and forth between 10 and 11. However, you do not loose much of your turning. It just has more pressure against your hand as if the power steering goes out.
You can also do it a standing stop. Only when you turn your wheel like say to 9, you can just use a finger to hold it there and it will bounce up and down? I have asked the local Dealership, and their answer was "there is something wrong with the power steering." couldn't get much more vague than that I guess.
I have looked for leaks, none. Checked struts, not bent. Checked tires, all brand new and balanced. Checked steering wheel mounts, all good to go... ???? Just lost...
View 2 Replies
My 2001 F250 2WD does not have the steering damper that my 2004 F250 2WD has. Is that normal or is my 2001 missing it?
View 1 Replies
