Ford - Ranger :: Clunk When Shifting Or Accelerating
Oct 13, 2014
I own a 1994 Mazda B2300/Ford Ranger. Ever since I have owned it, there has been a slight "thump" when you let off the accelerator. Annoying, but for a cheap truck, I just ignored it. NOW, there is a clunk when I lift off, and when I hit the accelerator after shifting gears. There has been a loud "rumble" sort of sound for about two weeks, and I was told by a mechanic that I needed a "cat back" exhaust. Okay, but when I rev the truck in the driveway, it doesn't sound like the exhaust has issues. I DO get the rumble through the steering wheel and floor of the truck, and up until this morning, when I took the thing out of gear, or stepped on the clutch, the rumble sort of went away. Now, it doesn't.
View 4 Replies
Advertisement
So I have an issue with my 03 f150, Basically It clunks in various scenarios such as Accelerating also occurs take off and general breaking/slowing down but not really when stopping. December when it was cold and I was decelerating (not on the break just coasting) it feels like i was driving on the shoulder.
It does it much more in cold weather. Just had the truck out getting a little rough with it for 5 or so hours today and 0 issues with it.
I was thinking it was a slip yoke issue that I hear allot of trucks have the issue but I was at the dealership today and both guys and a mechanic sitting there were like "never had that issue on an 03 f150, might be your back end." They also stated the clunking would always occur and be more prominent when breaking which its not.
I am certain its not the transmission its not occurring with any shift point. Kind of hard to do it if its hard to reproduce in the heat.
View 9 Replies
I have a 93 ford escort which makes a clunking noise if I shift into reverse without letting the car warm up and idle down. It sounds as if the noise is coming from the front passenger side wheel well. The sound does not occur when shifting into reverse if the car is allowed to warm up and idle down to 1100 rpm. What's up?
View 6 Replies
2001 F-350 w/powerstroke. Tranny is the automatic w/overdrive. right at 170K miles and it has not been serviced since I've owned it (about 10 years).
Lately it is jerking when shifting, especially noticeable when I'm pulling my 5er (10K lbs). Almost a "clunk". No warning lights or OD flashing. I live at 6000 feet and play at over 9K so mountain driving is routine. Fluid is up to right spot on the dip-stick.
View 1 Replies
I just recently bought a 95 F150 with a 351. The truck has high mileage, about 190k, and I am not sure how long the transmission has left. It rides smooth down the road, but when I put the truck into reverse it hesitates for a moment then makes a loud clunking sound(as if a door is being slammed) and then jerks into gear. The reverse works great at the moment though. Should I be worried, is there anything I can do to fix this?
View 11 Replies
So I took the wife to the pumpkin farm today, and was we were pulling into the grass/mud parking lot, my tires just started spinning. I stopped because I wasn't going anywhere and I turned my truck to go into 4x4(SOTF) and it made this LOUD clunk and then went into 4x4. Everything is ok and I tried it 4-5 after that to see if it would keep making that noise and it did not.
View 14 Replies
So my '99 F350 4x4 is making a clunking sound and there is a distinct jolt in the truck while this is occurring.
Symptoms: From a stop while accelerating, there is a distinct jolt and clunk. The best way I can describe the feeling is like something isn't tightened down all the way so there is a split second while inertia is generated and the "looseness" catches up to the acceleration.
When stopping, the clunk and jolt is generated when the truck comes to a complete stop. When the truck rebounds backwards a bit because of the suspension pulls it backwards after stopping, you will hear the clunk again.
I replaced the ball joints a week ago an a wheel hub bearing on the right side. I don't recall this before these repairs, but it may have been making this noise. I was more focused on the grinding from the wheel bearing so I may not have noticed the clunk and jolt then.
Where I should start looking for the problem?
View 14 Replies
I had heard clunking when hard accelerating or hard stopping my 2003 Explorer, also heard it from Park to Reverse/Drive. I suspected u-joints, was correct, those were replaced.
After I received my car back I noticed the clunk was louder when hard accelerating or hard stopping; again from Park to Reverse/Drive. I suspected rear differential. I called my mechanic who said they noticed some play in the rear end - a little loose, that the noise would be noticeable...but that if it were him he wouldn't worry about it. He said the drive shaft was tight, that I wasn't in danger of it falling out, etc.
These are the only symptoms I have that something is wrong with the SUV. Just that clunk. If I come off slow from a stop and not hit the gas, there is no clunk. If I do not hard stop, again I can avoid the clunk. The vehicle does not vibrate or make noise on the freeway, shifts well between gears.
I was going to have my mechanic open the rear end up and see what needed to be replaced when the cold weather brakes. In the meantime, is there anything I need to be keeping an eye on, or something else I should check? My mechanic said the checked it over and couldn't find any other problems. I just want to be prepared for expenses.
It's a 2W, not 4WD. I had all the fluids done, a drain and refill on rear. Not sure if that's important to know or not.
View 3 Replies
2014. Noticed the feel and sometimes clunk when shifting to 4 high? My house sits up a hill and this time of year, routinely have to use 4X4 to get up. There is a little more noise and vibration than im use to. Usually shift coming down a semi flat dirt/ice road at low speeds, typically about 10mph. Going in for first oil change soon and was gonna ask them to check it out for peace of mind.
View 6 Replies
Ok so I'm having a problem that seems to have been getting worse. 1999 7.3, auto, 4 door, long bed, 6" lift. When I got the truck a while back I had a slight problem where if I was accelerating hard I would hear a clunk when it shifted into 3rd gear. I'm not hard on the truck that often so it took me a while to realize that the noise was the driveshaft hitting the floorboard right at the joint at the transfer case output.
The carrier bearing was flopping around a bit so I replaced that first. No better... kept driving the truck since it was only a problem while being really hard on it. But it's gotten worse so now when I tow (usually not more than 7-8k lbs) I have a bad vibration on takeoff at low speed. If I try to take off from a stop very hard with any load the driveshaft jumps into the floorboard. So I just replaced the transmission mount and checked the motor mounts, no better. Only thing I can figure at this point is axle wrap...?
View 14 Replies
I have an 02 f150 ext cab fx4 with just under 140,000 miles my first problem was when I shift from reverse to drive I have a loud clunk/bang I was trying to find out what was wrong so my brother in law was looking out the drive shaft he pushed it into the rear end now when I am over 65mph and take my foot off the gas I have a vibration but only when I take my foot off the gas and above 60-65mph the steering wheel or peddles don't vibrate but the floor does .
View 3 Replies
2003 f250 4x4 5.4triton automatic. Everything is great except...when accelerating at about 45-50mph & 2000-2200rpms and it shifts into last gear or overdrive. As it changes gears and drops rpm's to about 1500 the engine/trans kind of vibrates or sounds boggish like it doesn't want to push the weight of vehicle or some sort of compression loss? I'm far from being a mechanic. Also, it tends to be more subdued when accelerating harder up to higher speeds, it is more so when leveling out at about 50mph. It doesn't clunk, or grind, or have any other problems shifting except at 45-50 and dropping rpm's.
View 2 Replies
2005 2.3Liter 4wd Mariner, 225k miles
I have been experiencing clunk noise on the front end when braking or accelerating and turning wheels.
I have replaced: front control arms, ball joints, tie rod ends, sway bar bushings and stabilizer links and 2 days ago I replaced strut mounts and bearings.
The steering is smooth after the strut mounts replaced but I can still hear cluck noise mostly on left now when going over bumps, braking and accelerating.
Car also has new engine/trans mounts.
I am so lost right now because I cannot figure out what is it. The only thing I didn't replace are the struts but the I test them and they seem to function fine.
View 5 Replies
When stopped and accelerating normally I hear an audible clunk, but feel nothing. If I gently accelerate from stop it does not occur. 1998 ford ranger 4x4 ....
View 1 Replies
2012 f250 SC xl 6.2 - Is it normal to hear a single clunk sound on occasion when accelerating from a stop sign? Doesn't happen all the time mind you and I don't ever remember hearing it in the past.
Now just today, while backing up my driveway, as soon as I started the reverse motion, I heard the same clunk. Sounds like metal to metal and comes from the rear of the truck.
Only 7000 miles on her and I treat her like a baby...anything I should be concerned with?
View 7 Replies
The vehicle in question is not our 2006 Passat
Car in Question:
2010 CC 2.0T DSG
12,4xx miles
I have noticed that when accelerating and decelerating I feel/hear an annoying clunk. I remember reading about this issue when I was reading this section all the time when our '06 was new, but when I went back and searched there only seemed to be people complaining and no real solutions to the issue. It really is hard to describe, but it seems to happen when slowing down the most, say when approaching a speed bump. I notice that if you apply the brakes longer ahead of time the clunk is less frequent, but its not like I wait until 3ft before the bump and slam on the brakes (also when decelerating into a slow corner/highway on-ramp).
I experience the same clunk when accelerating, usually when using more throttle than less; again not flooring it or anything too aggressive. One more example where I feel/hear this a lot is when coming home; I have a long narrow driveway w/ a garage at the end that I back into everyday. When I stop and put the car in reverse I get the clunk, but not until I press the throttle slightly. One weird thing is that I notice this clunk more when I have been in the car longer, with more stop and go traffic, in and out of stores etc. I have felt this on our '06, but not to this level
Some may say that I my problem could be solved by being more gentle on the throttle, but in all honesty I think I use it normally. There should be no clunk no matter how aggressive I am.
When I was at the dealer for my 10,000 mile service I mentioned the problem to the tech and they said they would take it for a test ride and report back. They told me that it was under normal operation and that the sound I heard was the DSG transmission going into and out of gear. I do know what they mean about the DSG, but this is a different problem, and if that was the case I wouldn't hear the clunk in instances such as reversing into my driveway.
View 5 Replies
2001 F150 5.4 v8 ... In the past few months my truck has been a bit strange, but in the past few weeks it's gotten to the point I'm nervous to drive it. Usually when shifting around 30-35, the engine revs up and stops accelerating and I have to take my foot off the pedal to make it return to normal. It doesn't do this after I do that, but the past time I tried to drive I couldn't get above 35 and the rpm was in the upper 2000s going at a constant 35. When I stop for any reason such as making a turn, when it shifts it lurches forward and I hear a loud clunk.
Naturally, I've checked all the fluids and fuses and they're all fine. The mechanic I regularly visit insists that nothing is wrong with it.
View 2 Replies
The other day I was driving to work and I noticed my truck wasn't accelerating right and the transmission wasn't shifting into high gear. Its almost like the truck went into neutral around 2000 rpm. What the issue could be? I really don't want to replace my transmission if I don't have to.
View 3 Replies
Today (not 2 days after taking delivery) I was travelling on the highway. stopped for fuel and as I am decelerating on the offramp when the truck shifted from 5th to 4th it went CLUNK, It did this twice, in the same circumstance. I can't make it replicate the noise every time. But 2 times in 24 hours is enough.
View 10 Replies
Experienced a clunk when shifting from D to R, especially when in a parking situation where you might shift back and forth a few times. I always make sure the car is not rolling and my foot is firmly on the brake while shifting from D to R or vise versa, but it doesn't seem to work. Is this normal with the DSG or should i bring it in to the dealer?
View 11 Replies
I continuously read that people with 6.2 F250s averaging 13 mpg or so in a combination city/highway driving. This 2014 4x4 barely has enough power to move itself (honestly, I'd rather have my Ram 1500 back) and barely gets 10mpg. Basically have to give it about half-pedal to even get up to freeway speed and floor it if i want to pass anything. Is it just that much of a POS or does this not sound right? Other than a massive "clunk" sound when shifting from reverse to drive or vice versa, no indication of any problems.
View 14 Replies
