Ford Ranger / B-Series :: Timing Chain Cover Leak
Nov 1, 2014
My truck has had this annoying tendency to drink coolant. I believe I took care of it by replacing the thermostat gasket. Not so, it drinks about a quart every 50 miles - so quite a bit really.
Finally bit the bullet and took it to the dealer so that they could figure out where the coolant was going.
Answer I got back was - timing cover gasket, water pump, lower radiator hose.
The water pump appears to be good, its just the gasket that's bad. So my question is - how significant is the timing chain cover leak? Poking around online it appears to be reasonably common, but sounds very expensive. The dealer indicated it would be 2 days work minimum.
View 9 Replies
Advertisement
I have 2000 V6 3.0 Ranger and it has sprung a small coolant leak from timing chain cover gasket. I think just few drips after driving a while since I don't see significant drop in coolant level (Took a month to notice level dropped in reservoir) and did not see an active leak while idling. No water in the oil.
The proper repair would be to replace the gasket, but for the age and condition of the truck, I don't think it is worth it. Searching for a cheaper solution, I found K-Seal and see lots of reviews with success. Will it damage the cooling system in anyway? I think it would be worth a try even if it doesn't fix the leak as long as it does not cause any harm.
View 2 Replies
I have an '04 Ranger Edge 3.0 with a severe coolant leak. It appears to be coming from the area where the head/water pump housing meet. I have been told I've lost the seal behind the pump on the timing cover. Is there any way to know for sure? Will I be able to tell, once the pump is out that it isn't coming from the head side? Are there any "special" instructions for re-sealing after replacing pump?
View 6 Replies
My 2003' Explorer XLT (4.0L V6) has an oil leak. I tracked it down to the passenger side, rear, bolt head on the valve cover (back by firewall). I took it to a guy who replaced the valve cover gaskets, but it is still leaking. He claimed when he had the cover off he looked for any cracks on it, but did not see any at the time.
Anyways, I was searching around and found several explorers leaking in or around the same area of the valve cover. And it turned out that there issue stemmed from bad timing chain guides, causing the valve cover to crack.
I do notice that on a cold start, I hear a rattling when I first start it up. It rattles for maybe that first 1-2 seconds when starting. Is this my timing chain rattling around? If that is the case, how much this could set a guy back on repairs?
I guess I don't know whether to just replace the valve cover, or if I should dig into it to see if the real issue is the timing chain guides/tensioner. Mileage is approximately 121,000....
View 1 Replies
I have seen this minor oil leak on the left engine side that facing the firewall for sometimes, but just found time to bring to dealer. After some searching on Internet, I suggested to them that it might be leaking from the timing chain cover.
View 19 Replies
I was changing my mom's oil at work today. I noticed her timing chain cover is leaking. Is this just an isolated occurrence? It seems to be right where the FIPG mates the timing cover to the cylinder head. It also seems right below the tensioner. However the tensioner is bone dry.
View 9 Replies
I really love this little truck. It's got 129,000 on it, but when I shut it down I can hear the chain clattering on the guides a little. Makes me wonder how much longer it will go before jumping a tooth. The truck has always been well maintained, but is there any ballpark figure when they usually let go? Is it worth it to pull the engine and put in a new chain? I'm fairly new to the Ranger.
View 5 Replies
OK... I know next to nothing about cars. I have a '99 Chevy Lumina I just bought in February. It has been one problem after another. The water pump has been changed and I just got my car back on Monday because there was a leak on the timing chain cover. Now, the car is smoking on the passenger side. Its not a light smoke, but its not heavy yet. I noticed it on the way to work this morning. I opened the hood, it is coming from the left side (looking at it, so the passenger side) of the engine maybe kinda underneath it. I dunno what to do, but I'm ready to push that thing into a lake.
View 1 Replies
I have a 2003 Eddie Bauer explorer with the 4.0L SOHC . I have a coolant leak from the passenger side that is not a water pump issue.
When removing the timing chain cover with the engine in the car, do I need to remove any accessories ( power steering , alternator etc. ) or their brackets?
View 2 Replies
I had the front timing chain cover replaced, ever since it hasn't started. It would turn over fast a couple times and then drag and then repeat.
Found out the "Tone ring" was warped, it's been replaced and now it just turns over and over and no start but it doesn't drag anymore.
We can smell the fuel, and pulled a plug and can see spark while turning over and I was told fuel came out the plug hole so there is fuel there.
Tried a new cam sensor, crank sensor and battery and no change. Is there something else in the removal and replacement of the front timing chain cover that could be causing this?
I'm not a huge believer in coincidence as the vehicle was running great before this job.
2006 Ford Escape
3.0L v6 w auto tranny.
View 10 Replies
My 2007 3.3l SF timing chain cover is leaking.It has 93,000Kms and is still covered by warranty.The Dealer said it was a 17hr break down job to do.
I am wondering if there are things I should get done/replaced when they open the engine up. I had asked at the dealer if there were other parts that should be replaced at this time, but was told that there was not.
View 1 Replies
I have a 2011 Limited and I wanted to mention that I brought it in for the ECM service campaign and to have an oil leak looked at. The reflashing went as expected, I am still trying to decide if the car behaves any different. It seems like the engine RPM drops a little bit when slowing down then bounces back up. Nowhere near enough to stall or anything.
While I had it in the shop, I had them look at an oil leak that I have been having. According to the dealer, it is leaking from the timing chain cover. They have ordered some parts and I will be taking it in for the fix next week. I don't have a full list of which parts they will be replacing, but he did mention removing the valve covers and installing a new oil pressure switch while they were in there.
View 4 Replies
My 2010 Santa Fe is leaking oil. I bought it in April & it has under 8,000 miles. After parking the car, I see oil spots that range in size from a Silver Dollar to a CD after a few hours.
First, the dealer said it was a cracked oil filter cap, so they replaced that...I brought it home and it was still leaking.
Brought it back to the dealer, and now they are saying the Timing Chain Cover Seal is leaking.
View 24 Replies
My daughter just bought a 2002 Santa Fe LX which is drooling oil all over the alternator and everything else in that area. I found what (I think) is the source (but you have to be a contortionist to see it.) I haven't been able to find any good parts identification photos of that area, but I think that this is the bottom corner of the lower timing belt cover.
I guess the repair will require going through the first several steps used when replacing a timing belt. I don't plan on going any further than needed to fix this leak, though, since the timing belt was reportedly changed about 25K miles ago.
Before I start taking all this apart, I have a couple questions:
1. What might be holding this corner out, away from the block?
2. Is the timing belt cover supposed to snap into place over a lip on the block? Or, should it be sealed with gasket sealer -- or something similar?
View 6 Replies
I noticed green coolant leaking from bottom of black, what I think is called, timing belt cover. There is 188, 000 miles, and when I changed the timing belt, I did not change the water pump, although I did change out the thermostat. I have done a lot of work on this truck in the past. I checked the oil and no signs of water or coolant mixed in. The water pump is not weeping from the top well. I rely on this truck and the way I look at it is I may just keep driving it until it goes kaput (its real beat up). Should I go to an auto parts store and see if I can buy some sealant. I would guess it is either the water pump or maybe the timing cover gasket? I have inspected all hoses, and I see nothing. The leak must be coming from somewhere under that black, plastic cover. I am capable and willing to do just about anything other than perhaps a full engine pull, although I have the wherewithal to do that too if absolutely necessary.
View 9 Replies
I have a 13 RX350 with 10,000 miles with a side engine oil leak. I looked underneath and I think it's the timing chain cover seal. Took it to the dealer and they put dye in my oil to figure out where the leak is coming from. They suspect it to the timing chain cover as well. I am aware that 07 ES350s had a know oil leak coming from the timing chain cover but haven't heard anything about the RX having this issue. My service rep said they would have to remove the engine to fix the leak.
View 11 Replies
I have a 2003 ford ranger 2.3 vin d 5 speed, this truck originally... Took it in for wires plugs front brakes fuel filter battery and added a small cold air intake. We discovered a valve cover leak and while repairing guy drops a screw into a valve and when finished he started it lodged the screw between the valve, shearing off a cam sprocket bolt. Throwing the timing. 2 valves on the exhaust side were bent and replaced. no damage to the head.
Timing was reset and the truck was running. 2 days later truck is running/had a hint of exhaust smell then started bogging dying and shaking, at which time we got an 02 bank2 lean code and fixed that. it cleared code and didn't fix it. From there we replaced coil, imrc intake bc of a crack, tried and check all vacuum, reset the timing. Timing would slip before but no longer than 10 minutes every time truck started.
Found the hole in the timing cover that holds the bolt to torque? to harmonic balancer was broke. replaced along with the diamond washers and cam sprocket bolts. timing finally held crank sensor was adjusted. truck came home for one day running good, we had removed the cold air intake and replaced the factory air intake. next day it was so slow outta first gear, you must baby the throttle, if you floor It, it sputters and kinda pops, truck stays slow all the way to about 10 mph and 2000rpm then it begins grabbing speed, 3000rpm is where this truck shifts the best, 2nd is better, third better than that.
As rpm increase the truck runs better, it idles steady at 1100-1200rpm at stops with an audible miss and then struggles again on takeoff. Here what im wondering, the truck has an abs sensor that just came on, but no codes showing now.tomorrow I wil run matko determinator 3.0 on it. and test the catalytic converter. first how do I check the timing belt to see if it stretched? do these trucks store the p.i.d.s. koer or kams that could cause one, all, or any of this and if so do I have to have it flashed from ford or can you manually do this without a drive cycle test.
View 2 Replies
On Feb 2015 I had this oil leak developing around the timing chain cover/ oil pressure plug and so i replaced the oil pressure sensor and clean the area and though problem solved...
Fast forward today and the weeping has redeveloped and has gotten larger than last time , its only a weeping issue no visible oil droplet leaks, anyways I took a mirror and when probing around and found the leak origin from the rusty looking timing chain tensioner...that what i think it is.
My question is should I just remove and replace the Rubber O-ring on it or should I just replace the entire timing tensioner unit with a new one, my original timing chain tensioner is sitting at 85k miles. The O-ring is free (i have a kit) and i can do it right now or a New Timing chain tensioner w/ new O-ring is around $20 bucks but i cannot verify the part number ...
View 3 Replies
Got an oil change yesterday and the dealer noticed a small oil leak from the timing cover on my '10 Corolla w/ 71k. Of course they could reseal it for $450. After further investigation, it looks like it is actually coming from the timing chain tensioner. I have seen on the 9th gen this is a common issue, but I haven't really seen anything on the 10th gen. Sometimes, I have noticed a short squeal or squall at cold startup, but it hasn't been enough to really diagnose. It could be some oil on the belt or something else related to this issue. Hopefully the pictures show up.... [URL] ......
View 2 Replies
2010 corolla bought new 3/29/010 has 43k dealer said timing chain tensioner was slipping and might leak oil wanted $175 to replace shouldn't this be covered under the power train warranty?
View 10 Replies
My serp belt squeaks due to contamination due to timing cover leak. I removed belt and cleaned it with mild degreaser solution and it was quiet for 1 day. If I had 100% water in cooling system, would any more leakage cause a belt squeak? I am putting off fixing timing cover gasket since it is a 5hr job. Coolant is @ 90% water concentration now.
Taurus 3.0 Vulcan motor.
View 9 Replies
