I have a 2001 ford ranger xlt 2.3L and the temperature gauge has been staying a cold. And my heat doesnt heat well. I'm guessing I need to replace the thermostat. Before I do that could it be anything else?
View 9 RepliesI have a 2011 xlt extended cab with a 2.3l 4 cylinder. The truck is great... I put 120,000 miles on it in under a year.
But about a month ago the temperature gauge started malfunctioning. for what ever reason -- the truck is NOT over heating-- the gauge would increase past the "H" and then the temperature light would come on. Because the truck thinks it's overheating -- the engine goes into a "safe mode" and runs with no power. When i shut the motor off and turn it back on temperature gauge resets and the truck will run fine.
Then in another 50 or 100 miles it will do it again. Why is it doing this? I took it to the dealer here in Columbus, Ohio and the mechanic installed a new thermostat and a new "control modulator" (and a part -- not really sure what it is called) anyway, the truck is doing the same thing and the mechanic still does not know
I have noticed that my temperature gauge is indicating that usually my truck is running very cool. It seems that it is also somewhat erratic. At times it indicates what I would expect a reading in the middle of the gauge. Other times after running a while it will drop to the lower end (cool) of the gauge and stay there.
I am guessing that the thermostat is sticking open. Is there a way to test the sensors to see if they maybe bad? I have a 99 ranger with a 4cyl. It looks like I have two sensors. If one is bad, how can I determine which it is?
1991 Ranger STX, 4.0. Had a leak from the rubber seal on the thermostat. Changed the thermostat (stat 195) and seal. Now my temperature gauge is not showing a constant reading, goes to half way and when the thermo opens the gauge falls down to a quarter. The gauge is cycling this way every time the thermo opens.
View 2 RepliesMy 94 Ranger 3.0L 5speed 2wd temp gauge is staying on the cold side but the heater is working good and I used a laser pointing thermometer at the thermostat housing and got 180* after running for a while and I also noticed that the fuel economy had gone down along with the power. I was getting 340 miles to a tank but now I'm getting 280 per tank.
View 12 RepliesI have a '99 1.8T Passat. The coolant temperature gauge normally reaches operating temperature of 190 degrees within about 5 minutes and stays there. For some reason, after reaching 190, it sometimes drops by 20-30 degrees and is running cooler than normal. Once time it dropped down, then came back up again, while driving a steady 65 mph. The coolant level is full and nothing else has changed.
I guess there are a few possibilities: a thermostat stuck open too far, a failing temperature sensor, bad gauge, or loose connection at the sensor. The car has 145K miles and the thermostat and water pump were replaced at about 100K miles. What is going on? If it runs a little too cool, is that a big deal? How would I diagnose it? Where is the temperature sensor?
I have a 2007 f150 with the 5.4 in it and today I was driving it and my tempreture gauge randomly shot to cold and check engine light came on. Also can't even find the dam radiator cap due to too much plastic!!!
View 2 RepliesI have a 2000 ford ranger 4.0L v6. My problem is the abs light stays on and the speedometer won't work till i hit about 35-40mph.
View 14 RepliesThe battery light in my well used 1997 Ranger came on a few weeks ago. Only use the truck on the weekends. Battery reads 12v. Alternator putting out 14v. Replaced terminal clamps as they were in bad shape. Light is still on.
Weak battery possibly? Does it need to read higher than 12v for the light to be off, I wonder?
Where the temp sensor for the rear view mirror is located. My truck is a 2011 Ranger with the 4.0 liter, AC, automatic and 4x4. I think it is somewhere by the headlights but not sure.
View 6 RepliesIs there any way I can raise or lower the temperature without turning on the fan speed? For example if I want to raise the temperature from 68 to 72, I literally have to hit the "Lo" speed and then raise the temp.
View 1 RepliesIn the past week after work the door ajar light comes on and stays on. I've checked all doors and they are not ajar. The dome light comes on when i start the engine and goes off after a few seconds, but only when i have this door ajar problem. After I get home and shut off the engine for about 30 seconds, then restart, the dome light nor the door ajar don't come on.
View 14 RepliesI have a '96 Ranger XLT. Just recently the dome light stays on while the truck is running. I have checked both doors and door frames. For the life of me I do not see a switch. The light does go off eventually after the truck is shut off (without killing the battery). What or where is the switch for this light..
View 14 RepliesOK...When I leave in the morning and the ambient temperature is cool the truck runs fine. When I leave work and the temperature is warm to hot the truck backfires through intake, pings bad, has a miss and a surge and no power. There is no CE light, this is about to drive me nuts. I was just hoping (doubting) but hoping someone else might have had this problem so I don't just have to start replacing things until it's fixed.
View 1 RepliesI have a 94 ranger 5 speed xlt v6 4.0l 288k miles original engine. in the last month the oil pressure has gradually gone way up. a manual gauge shows 65psi at cold start ( in the 90* out side) after a minute of idle it dropped to 60psi, at 2k rpms the psi was 85+. also the water temp has gotten hotter to the point of almost being unsafe. it appears that in the hotter part of the day the psi goes higher. the oil and filter was changed 1200 miles ago. the cooling system has been update in the last year with a new radiator new thermostat. no cross contamination in the fluids, engine runs good other than gauges on dash showing water and oil getting close to unsafe range and manual gauge showing high pressure.
View 14 RepliesMy ammeter & coolant temperature gauges have quit responding. Any "easy" ways to check these circuits before I disassemble the dash? And, if the gauges DO turn out to be bad, where can I get replacements?
View 4 RepliesThe air bag light stays on & the blower in not working. I checked the fuses good.
View 2 RepliesMy 2005 ranger will blow hot air with the cab temperature control is on cold or hot. The A/C works only when it is on Max AC. What the problem may be.
View 3 RepliesI have a 97 Ranger 2.3 standard shift, No A/C, a pretty simple Ranger with 158,000 miles. About a month ago while do some checking around under the hood I noticed my coolant overflow tank was empty, so I filled it up to the proper level with some anti-freeze mixture. Thinking if the system was low on anti-freeze it would suck what it needed from the recovery tank, wrong! About two weeks ago I noticed that my temperature gauge was NOT registering in its normal position and was considerably lower towards the Cold mark. Heat coming out of the heater was normal.
I opened the radiator cap and everything looked okay. After a few days this would not go away and replaced the thermostat thinking the thermostat was stuck in the open position, wrong again! I burped the system by letting the engine run with the radiator cap off and filled the radiator with anti-freeze mixture every time some of the air was expelled. I did this for a few days and noticed that the engine would not reach normal operating temperature at idle speed! I had to put something on the gas pedal to increase idle speed so the engine would get hot, this is not normal. Finally I got to a point where the radiator would not take anymore anti-freeze mixture, but the problem still exists.
Two things I noticed that will get the engine temperature up to normal, engine speed (RPM's) and not having the heater on. Let me explain, at normal idle the engine will not reach its proper temperature, but when driving down the highway the temperature goes up to normal (about halfway on the scale) no matter if the heat is on or not. When stopped at a light or just idling I can watch the gauge slowly go down towards the cold mark, if I turn off the heater it takes longer to go down to cold. I do know the heater fan is cooling the coolant to a degree (no pun intended), but it shouldn't cool it so much as to make the temperature drop so dramatically. Okay, heater off, riding down the highway, everything normal, come to a stop and idle temperature starts falling slowly, but when I turn on the heater the temperature starts falling faster.
My diagnosis: I have no leaks of anti-freeze, checked and re-checked. I have no symptoms of a blown head gasket, no milky white appearance on dip stick indicating anti-freeze mixing with engine oil, no clouds of white smoke coming out of exhaust, checked tail pipe for anti-freeze, none found, no loss of power and no loss of gas mileage. I changed the thermostat, like I said. Do not think it could be the radiator pressure cap, normally if the cap goes bad the system will have no pressure and the engine will overheat, the opposite of the problem. Water pump, normally if the water pumps goes the coolant will not circulate through engine and will over heat, again, not the problem I am having. Could it be:
1. A long shot, I bought a defective thermostat and it is still staying open.
2. The temperature sending unit has gone bad, very improbable since it does register the correct temperature when truck is moving down the highway.
3. The coolant is spent, again unlikely, it has been in the engine only for about 3 years and still looks clean and green.
4. Have to have a cylinder pressure check to determine actually if the head gasket is really blown or not, which I doubt.
My conclusion is that I still have a huge air lock somewhere in the system and the engine is still not completely filled with coolant and when the rpm's drop not enough hot coolant is reaching the temperature gauge sending unit, but if that much coolant is not in the system, why am I still getting lots of heat blowing from the heater? The vehicles cooling system is not that complicated and there are few parts involved in its proper operation, I think I have covered them all, but somewhere I am missing something to pin point my problem.
I have a 93 accord ex sedan, 4 cylinder, automatic that I bought in August. I live in South Dakota & it's starting to get cold here. When I first bought the car the temp gauge was working fine in that it would move to the middle of hot/cold range. Recently, I've noticed the interior doesn't get warm for awhile, even after driving 20 miles. It blows warm air but it seems like it should be warmer. I've also noticed the temperature gauge barely moves, if it does at all. Most of the time it doesn't move or just stays on cold. I did some research on here & thought I would try to change the thermostat, upper & lower hose and the antifreeze. I'm hoping this will heat up the interior better because it's starting to get cold here & fix the temp gauge.
Previously, I had a 91 accord & that would warm up great, even when it was bitterly cold here. What would cause the temp gauge to do this? I'm even thinking about changing the transmission control module because I read on here that could cause the gauges to have wrong readings. The speedo & rpm gauges also seem to have wrong readings, especially in the mornings or when I first drive it. I used my gps & found the speedo to be off by as much as 10 mph. The other item I've noticed is that I only get around 23-25 mpg highway & on my other accord I was averaging 28-30 mpg highway. Not sure if this is related or not but thought the more info the better.
I have done all the basic maintenance-oil & filter, plugs & wires, valve cover gasket, air filter, tranny fluid but have never done anything with the heating/cooling system.
Tempature gauge on my 2001 sierra (4.8) has been running low for awhile. The highest it will reach is round 160. It's currently running rough/rich and bad mpg. I replaced the ECT sensor but didn't work. I'm not sure if there are two ECT sensors on this model. I don't think it's the cluster. Is there a second sensor I'm overlooking?
View 13 Replies