I have a noise in my rear end, if I grab the bed of the truck, and rock the body back and forth, I hear a clunk, almost sounds like a wheel is loose, but checked them, all good, also checked the U-joints, and pulled the driveshaft to grease the spindle. Thinking it could be in the third member, maybe the Differential pinion shaft, or the lock bolt......
View 3 RepliesI have a 07 Ranger and the passenger door sounds loose when I hit any bump. Where should I start to make any adjustments on the door?
View 3 RepliesOnly clunks under power. Push in the clutch and it's fine. I haven't pulled the diff cover just yet....
View 14 RepliesI wanted to pass along the results of a brake issue I encountered in my 2010 Prius (15K miles) and report to interested Prius owners how the issue was resolved.
Problem: In the last second (or so) coming to a complete stop I noticed a few light clunk type sounds, like something was loose up front. I never experienced any degradation in the braking performance.
Allright, I seem to be having these very strange sounds at idle. Mostly when I am in Drive and waiting at a red light. In Park, it isn't as bad it seems.
One sound is knocking. A kinda slow one and irregular. Not a motor knock tho. Doesn't sound like that. It also kinda clicks from under. So, those both sounds come from under or the sides of the truck.
Should I worry about this? I've had these sounds since I've got the truck. Sometimes louder than usuall.
I've a 1993 2.3 and 1992 4.0 both with a/c systems down. On the 1993 Ranger I tried to loosen the evaporator tube nut to install the new accumulator now it looks like there's going to have to be a new evaporator. Without hardly any pressure that tube just twisted like it was nothing. Someone told me I have to spray it with wd-40 3 days prior to loosening it. I doubt that would even work. Hopefully removing the evaporator case cover under the hood won't be too time consuming because now I've got to. So I don't want to make the same mistake on my 1992 4.0. I need to change the accumulator, orifice tube, flush the evaporator, condenser, install the new hoses, and compressor before evacuating and recharging. Is there anything that makes it a breeze to loosening those evaporator and liquid line nuts without destroying the evaporator?
View 3 RepliesWhile I was trying to park, I heard a clunk, wheels stayed in the same position. The steering wheel is loose as hell, it literally feels like its buttered up and wont turn the wheels at all, what to buy to fix it? I am thinking I just need a new gearbox....
View 6 RepliesI have a 1995 Ford Ranger 4 cylinder and the other day on my way home all of a sudden sounded like a lawnmower, it was very sluggish and would take twice as long to get moving,it also smelled like gas and I used a quarter of a tank in about 24 miles. Someone said it could be the ignition coils...
View 5 RepliesAfter about 1 minute after starting the truck it sounds like the fan belt is squealing..(below 30 deg outside) Only its not the fan belt as I replaced it. Does not do it when it is engine is operating temperature. Have checked all of the Pulleys which seem to be all right. The frequency of the squealing sound is about 1/3 the engine RPM and will go away above 2k when it does do it. Stopping at a stop light after about 45 seconds it really starts to get loud. Can a Fan Clutch do this.. I beleive that this engine has a timing chain right?
View 8 RepliesI have a 2000 Ranger step side and the bed side is loose and and I'm trying to figure out how to reattach it. It's loose towards the front of the bed on the passenger side right where the actual step is. Is there an attachment point underneath the the plastic step cover?
View 2 RepliesI really love this little truck. It's got 129,000 on it, but when I shut it down I can hear the chain clattering on the guides a little. Makes me wonder how much longer it will go before jumping a tooth. The truck has always been well maintained, but is there any ballpark figure when they usually let go? Is it worth it to pull the engine and put in a new chain? I'm fairly new to the Ranger.
View 5 Replies1985 ranger 2.3L TK5 tranny. Shifter was really loose and the tranny finally got stuck in reverse. I have opened up the bottom cover, but am not sure where to move the shift forks to get it back to neutral. I bought a new shifter, but I need to get the tranny back to neutral before I can install it.
View 2 RepliesI replaced the clutch, slave, flywheel and pilot bearing. Now it sounds like gravel bouncing around under the truck.
Everything works beautifully, but there is horrible noise especially at idle. If push the clutch it will quiet a little. If I change the rpm it will get worse then quiet out then get loud again, there is a sweet spot.
What the heck did I do wrong. It's a horrible gravelly grinding sound.
When I turn on my heater full blast the most god awful squealing commences. Where to start spraying the grease?
View 10 RepliesI've been dealing with this for 2 years now and its going to snap my axle shaft one of these days. I am scared to take it out in a snow storm because the truck will clunk and then release. Its a split second thing but its enough to notice and make me worry a lot. I cant figure out why and ive done the plugs and wires but that didn't solve the problem. It only happens when its snowing or when I drive though a gust of wind that has stired up some snow. I know it must be something electrical because it only happens when there its cold and wet and not all the time. In the rain it does not matter but when it snows i just wont go out at all. The truck is a 2003 4.0 4x4 with a manual. Not a function of the 4 wheel drive it happened in 2wd as well.
View 14 RepliesI was driving up a hill an it started to loose power. i got up to the top of the highway an stopped an it just shut down. got towed home i thought it could of been the alternator but dose not seem to be. took the belt off to spin the motor an its not spinning. drained the oil an there is no metal in it to see if the motor was done. i try to start it an it just dose a click click an that's it. Is the motor done or is it a transmission problem?
View 3 RepliesWell, I had a friend put together my front brake rotor, now no more pulsating when coming to a stop, very smooth stop, new front brakes, had it aligned as well.. Also replaced the front shocks, however the passenger side came loose and rattles when going over bumps, speed bumps. I popped the hood, bounced my truck and could see it moving from left to right when bouncing front end of truck.
Question is, can i tighten it up myself, I dont have a jack, limited tools, I know, I know but i dont at the moment. My friend that worked on my truck lives a good drive and i hate to waste gas just for tightening something that should have been done but i have too, I will..
I've been having this problem for about 2 weeks now, and I am trying to figure it out. I know the video is only 5 seconds but at least you can hear the sound, it only happens in first gear, on take off, about 2-5 seconds after the take off, and the sound is coming from the rear axle area. I cant figure out if its diff or brake related.
Ford ranger Rear end noise - YouTube ....
I just bought a 5speed manual 2004 ford ranger 4x4 and when shifting usually upshiffter 1-2-3 I get a mi8ld clunk when I looked underneath I grabbed and can move the from drive shaft clockwise about 1/4 inch is this normal and if not how do I fix this?
View 3 RepliesI own a 2004 Ranger 4x4 V6 4.0 Liter engine with 118,000 miles. This summer it has been experiencing a clunking/knocking noise for the first time. The noise only happens during days where temps are above 90 degrees and I've been driving for at least 10 minutes. I can hear and also feel the low pitch clunk through the steering wheel. It is more pronounced if I hold the bottom of the steering wheel. I park on concrete and have not seen any fluid leaks under the engine. The power steering fluid is not low. I've jacked up the truck to test tires. The tires do not wobble. A Ford mechanic has inspected the suspension and cannot find anything wrong. Of course when I took the truck to the mechanic is was a cooler morning.
View 8 RepliesMy 03 Camry LE has a weird clunk/rattle in the rear driver side only. This happens when i go over bad portion of road, not like potholes just uneven bad road. When the suspension moves quickly. Car has no weight in back. It sounds like something metal is loose in that side, the other side is tight and makes no noise. The struts were replaced in january by previous owner, someone told me it was the rear links which i replaced and still same issue, checked sway bar bushings and those are good.
View 14 Replies