Ford Ranger / B-Series :: AC Compressor Turning On And Off When At Idle
Aug 11, 2010
When I am at idle, the compressor keeps turning on and off every few seconds. It seems to work fine while driving. What do I need to do to fix this?
View 14 Replies
Advertisement
My compressor on my 92 Ranger did not have any clutches on it. Where they went. I got a compressor off of a 94 at the pick and pull. It was charged and the compressor turned fine. Brought it home and tried to install it. My hoses in the back of mine(92) are different than the 94. I went back and got the hoses, condenser and evaporator off of the 94. Put it all together. The high pressure hose on the 94 has some sort of switch on the high pressure side. What is this switch for and how can I wire it in to the electrical system on the 92? I assume it is some sort of pressure switch that allows the system to flow. I'm getting 30 pounds on the low side and 150-200 ponds on the high side. Also, when I increase the RPM's, the compressor kicks on and off. It's not like it would or should normally but fast.
View 7 Replies
I have a 2001 ranger 4x4 4.0 L with what appears to be a unique a/c problem. Over the last week the compressor will not kick on immediately and seems to randomly decide when it is going to function. Once it starts, it runs properly and cools well, until I turn the engine off and it is back to square one. We have checked the coolant level and it is full. the problem seems to be getting progressively worse....At first it took about 15 minutes for it to decide to trip, then 30 minutes, and yesterday I drove for over an hour and the compressor never kicked on.
View 4 Replies
I've got a problem with my AC Compressor, with the AC on the compressor engages then disengages about every 5 seconds. Now I looked into it and some people said you can remove a washer to remove a gap. Do you think I should change the whole unit? Looked online and I can get one for $100. If I do work on the AC compressor to try and fix it or remove the whole unit do I need to drain any refrigerant etc etc. I have a hayness repair booklet and they said that to remove the ac compressor you need to get it drained by professionals. Although on the compressor I only see a electrical plug and no hoses.
View 14 Replies
I have a 2001 Mazda B3000. The a/c compressor is coming on while I'm running my heat. The air coming out while the heat is on stays warm. However, when I was running the A/C during the summer the air would start blowing out warm after it had been on for a while. Several people told me it may have something to do with the blend door or blend door actuator but both appear to be working fine. What it could be?
View 1 Replies
So I just got done with my first 2 problems of the month with this truck last week. Front end and emissions along with spark plugs. Now, 4 days later this morning, I'm driving the truck trying enjoy the investment, and the AC compressor starts seizing up and burning the clutch. Unrelated but also worth noting, about an hour later the brake pedal gets real soft and the brakes get really sloppy at stopping the truck. The truck also stalled (auto trans) crossing a highway, luckily it was 5am and no traffic was coming.
I'm at $6k invested on a truck with 116,000 miles, and I've only put 6,000 on it. The repairs don't stop, and I've got many more ahead. Like rear suspension, axle, trans, and radiator fluids, and paint, to name a few. Any suggestions on fixing the AC before I drive this truck into a lake?
View 8 Replies
I am in the process of removing the lower intake on my 99 Ranger 4.0. I was unscrewing the AC Compressor to get it out of the way and also started to unscrew a bolt on the backside of the compressor because it wasn't moving well due to the metal tube on the backside. I think this is the tube to the condenser? Anyways it started spraying air and green fluid everywhere. I got it to stop for now but if I tighten or loosen the bolt it seems to spray. Also it looks like a green o ring or gasket of sort is showing now which I don't remember. What is it and what should I do?
[URL] .....
View 7 Replies
This is a question in general about Fords. My 98 Ranger doesn't do it. He's got a 1987 Ford Mustang 5.0 with original factory a/c. He changed his compressor to a used one and it started running all the time whether the swtich was off or on. He said he switched back to his original compressor and it still does it. I figured it might be something common for Ford a/c systems so I figured I would ask. I'm not sure why it would be unless the mode switch was bad.
View 5 Replies
When I turn the control to heat the AC compressor kicks in. If turned to vent it does not kick in. Was this just a design flaw.
View 3 Replies
I have a 2003 ford ranger xlt 4.0L and here recently my ac compressor has been making a loud click noise engaging even though i am not using heat or AC, so when it engages the rpms drop and almost wants to stall and it does this in about 10-15 sec. intervals, but when I am driving it acts fine. What is going on here, I recently had a vacuum leak and i found it and fixed it, and now this issue just started.
View 2 Replies
I didn't really know where else to turn (no pun intended) every time I turn my wheel to the right the truck sputters out and dies, i checked the ignition switch, tightened her up and shes still killing the engine when i turn right. All other power remains on stereo, car charger etc. its not so bad on continuous turns i can just pop the clutch but for stopping and turning its a huge issue. Why turning left is fine but right kills the engine..wondering if maybe the prongs on the ignition switch may be bad?
View 7 Replies
The blinker in my 98 Mazda B4000 does not deactivate when turning right/left. The multi-function switch was replaced last year with an OEM part.
View 2 Replies
How to keep the freaking dome light from automatically turning itself off?? I understand it's a battery life saving function but I find it ANNOYING and would like to stop it.
View 6 Replies
It started with the cruise control turning off every once in a while. Then it would only stay on for 7-8 seconds, then eventually it would turn on, then shut right off. Now it won't even turn on.
When I did the diagnosis sequence (On, Resume, Coast, Set....) it blinked 3 times saying "Bad deactivation switch or circuit". So I replaced the blue switch on the brake pedal and it still doesn't engage.
It's a 4.0 liter with a manual tranny. I've been researching this a lot, and it seems in 2007 they changed up things probably because of the big recall.
I don't see any kind of deactivation switch around the master cylinder. It seems that was in use until 2006 or 2005.
I see a different kind of switch on the clutch pedal, thinking it must also have a deactivation switch. I see a long spring loaded type of switch with about 5-6 wires coming out of it, but I can't find any info on the web about that switch.
All three of my brake lights are working. It seemed to deteriorate rather quickly (Over the course of 3 days) and now it's completely dead.
View 5 Replies
I noticed that my ABS was engaging when I would slow down to a stop while turning left. I pulled the fuse for the ABS just to make sure that's what was causing the pulsating brake, and it was. Anyway, if it's an ABS sensor problem, would it be the front passenger side sensor if it's only happening when I turn left? Is there a way to test this. Would a scanner detect it? It hasn't been throwing a code or anything. Just the ABS engaging while braking and turning to the left when it shouldn't be.
View 6 Replies
1995 ranger 4,0 4x4... when started up, wipers go 2 times and then stop, but cant turn on again, also blower and 4WD stopped work....
View 4 Replies
Having problems with their door locks attempting to activate when turning the ignition key? If so, how can I correct it or make repairs.
View 3 Replies
While in the locked position, the steering wheel was purposely jerked hard to disable the mechanism on a 1996 Ranger. Now the truck will not steer easily or smoothly and a popping noise is evident when turning. I'm not concerned about having the wheel lock, but would like to be able to return driveability to normal.
The same guy who caused this damage also damaged the ignition. No key is needed to turn the switch now.
I'm lost as to how the steering locking mechanism works and wondering if I need to tear apart the column or if maybe there is a locking pin accessible that needs to be removed to regain driveability.
View 2 Replies
I recently acquired a 4.0 Ranger 4X4 Auto for my use in Costa Rica. It runs fine but it'll illuminate the CEL within a few seconds of starting and whenever revs fall below approx 1000. When pulling off the line or accelerating, the light will go out but comes back on when the throttle closes. The previous owner has replaced the MAF and idle air valve. I've corrected a lot of issues with the vacuum system and think it's back where it ought to be. I know I am going to need to pull the codes but I'm back in Dallas now and can't do it yet. Need general list of affected parts that I could buy here and take back down.
View 14 Replies
My 04 ranger is back at it AGAIN. It started about 3 years ago.
- Cruising along on the highway and then come into town. Idles at 2000 RPM
- Shut it off. and restart it. Again, 2000 RPM.
- Shut it off and it idles normal
- Drive it 2-3 day and then it idles high again
- I have clean and functioned the IAC and it works fine
- Cleaned throttle body and I never can get it to stick.
- Replaced throttle cable
It still was idling high
- Replaced ECM and it idled normal for about 1 year
- Replaced em again and it idled normal for about 6 months
It is back at it again. For what ever reason the EM is telling the IAC to open up and raise the idle...
View 14 Replies
Allright, I seem to be having these very strange sounds at idle. Mostly when I am in Drive and waiting at a red light. In Park, it isn't as bad it seems.
One sound is knocking. A kinda slow one and irregular. Not a motor knock tho. Doesn't sound like that. It also kinda clicks from under. So, those both sounds come from under or the sides of the truck.
Should I worry about this? I've had these sounds since I've got the truck. Sometimes louder than usuall.
View 14 Replies