Ford Ranger / B-Series :: ABS Engaging When Slow Down To A Stop While Turning Left
Jan 25, 2017
I noticed that my ABS was engaging when I would slow down to a stop while turning left. I pulled the fuse for the ABS just to make sure that's what was causing the pulsating brake, and it was. Anyway, if it's an ABS sensor problem, would it be the front passenger side sensor if it's only happening when I turn left? Is there a way to test this. Would a scanner detect it? It hasn't been throwing a code or anything. Just the ABS engaging while braking and turning to the left when it shouldn't be.
View 6 Replies
Advertisement
The blinker in my 98 Mazda B4000 does not deactivate when turning right/left. The multi-function switch was replaced last year with an OEM part.
View 2 Replies
One last issue with my 2000 B3000 3.0L. The leak seems to be on the left (passenger) side of the water pump very near where the bottom radiator hose connects to it. I can't find any loose bolts. It does not leak while driving the truck or soon after. It has to sit for several hours or overnight before it shows up. There are usually 3 or 4 wet spots where it drips from the water pump to the frame to the driveway. It is small enough that I only have to fill up my coolant tank every 1 or 2 months. Could this just be a small gasket leak? It's been happening for about a year or so I think. I replaced the radiator about 2 years ago. I've been expecting it to get worse or bust loose and have been checking it very often. I've never seen one not leak while running like this-has me puzzled.
View 6 Replies
This has happened 3 times.
1st) pulled quickly over to side of road, shut off truck. It would not start then. Towed it to service station and it started the next morning (with no repair made). I wonder if tow ride dislodged the the blockage in fuel line(?). Always sounds like it's going to turn over, but like not getting fuel.
2nd) Went to leave work, truck wouldn't start. Towed to my mechanic and he replaced fuel pump. Thought it was fixed because it ran fine until just the other day.
3rd) Slowed down to complete stop in heavy traffic and it stalled. Would not restart. Again sounded like it was going to start but didn't seem to be getting fuel. Good samaratins pushed me off road. Had it towed to mechanic. Started the next morning without any repair or service. It's like the tow ride and bumps getting it off the tow truck dislodges what ever is blocking the fuel line.
My mechanic replaced the fuel pump, but I don't think her replaced the fuel filter.
View 6 Replies
2010 F-150 King Ranch. Randomly when turning left, it feels like the left front brake is engaging and it sounds like your anti-lock brakes when you come to a stop on slush or snow. The truck slows with your foot still on the gas, Saturday it came to a complete stop before it released.
I have had it to 2 Ford dealerships, the first could not get the symptom to occur on a test drive and told me there was nothing they could do because they did not now what to look at.
The dealer I bought it from got it to act up, replaced the IWE 2 weeks ago and 3 days later was still doing same thing. My wife dropped the truck at the dealer again Weds.morning, she told them it did it on the way there. I called at 4:30 to check and they said they drove it 2 times and it did not act up.
View 2 Replies
I've got a 1982 Courier 2.0 2wd 5speed pickup and it's been passed down through my family and has sat for quite a while so I started tinkering with it in my spare time.
I began with the motor and got it to run after 15 years of sitting around but am having issues with the transmission. When I first got it running a while back i had it in gear and when I let out on the clutch it lunged forward a little and stalled. I have since then towed it a short distance across my yard (in neutral of course), but now it seems like it isn't doing anything while it's in gear.
While its running I can put it in gear (even without the clutch) it doesn't grind jump or anything. Everything feels like it's okay as in going into all the gears. I was wondering if this is possibly clutch related or if it's the trans itself. Or maybe some electrical thing related. I haven't taken anything apart yet in hopes that it's something simple. I was curious if it might be low on fluid and maybe that would cause it not to engage properly?
View 5 Replies
I have a 2001 ranger 4x4 4.0 L with what appears to be a unique a/c problem. Over the last week the compressor will not kick on immediately and seems to randomly decide when it is going to function. Once it starts, it runs properly and cools well, until I turn the engine off and it is back to square one. We have checked the coolant level and it is full. the problem seems to be getting progressively worse....At first it took about 15 minutes for it to decide to trip, then 30 minutes, and yesterday I drove for over an hour and the compressor never kicked on.
View 4 Replies
So went today and bought a 1993 ranger 4x4 ext cab 4.0! Runs good some bad handy work that i need to fix but truck has plenty of power and good handling...
issue 1- 4x4 not engaging. the light by the push buttons does not come on and you dont hear the "clicking" of the relay trying to engage. so whats the problem and how do i fix it?
issue 2- when clutch is fully depressed and you go to shift (this is only sometimes) you can feel and hear it grind just for a quick sec. and forget about down shifting you cant do that without slowing down. so maybe new clutch?
issue 3- at 65 the vehicle does shake a little otherwise but pretty smooth. any tips on how to smooth it out? maybe new ball joints? tighten some stuff up maybe?
View 14 Replies
I have a 99 ranger 4x4 4.0 V6 with 200K miles..I just had the slave cylinder replaced and bled however, it is still hard to get into gear and when at a stop light with the clutch pedal pushed in all the way the truck tries to move forward as if its in gear. I took it back to the shop and the mechanic says that the hydraulic system is working as it should and the problem could only be the pilot bushing failing and causing the trans to partially engage. The clutch and previous slave cyl only had 25K before the slave cyl failed and started leaking!!
View 12 Replies
So that's what if feels like, in park at idle it sounds great, starts great no codes. IF you floor it it will not go over 3000 rpms in park, it feels like it has hit a rev limiter. I have 60psi fuel pressure at idle and at 3000 rpm.
When driving down the road I won't go over 55 mph and drives normal if you keep it under 3000 rpm, if you give it more gas it falls on its face?
AC is not working (clutch not engaging)I don't know if that's related or not.
We did just swap the motor the truck is a 2003 2wd drive. motor came out of an 2002 4wd. we are running the 2wd harness, computer egr delete etc.
View 6 Replies
The key cylinder is basically not engaging anything. The key rotates all the way from auxiliary to start but there's no resistance anywhere, just sort of flops back and forth. I put in a new cylinder just now and luckily it engaged the starter just enough so I was able to get the car home from my wife's work but of course once in my driveway the key would not turn the car off. So if the cylinder is good then what should I check next?
On a side note, what's an easy way to turn the car off next time this happens? Disconnecting the battery didn't work, then I couldn't find an inertia switch. I finally disconnected the alternator with lots of sparks but it did shut the engine off.
It's been a rough night already and I still need to figure out how to get the Ranger I left at my wife's work. The Bronco's got no insurance and my wife can't drive a stick anyway, same issue with the motorcycle. Thinking I'm in for a 10 mile bicycle ride.
View 14 Replies
My 88 2.3l 5 speed ranger was running fine then i went to start it up again and it wouldn't turn any of the cylinders or none of the belts move. i can hear the fuel pump turn on for about a second every time, there is weak fuel pressure at the rail. Why wouldn't the engine crank? the starter does not turn the belts and all i hear is a whizzing sound. it sounds as if the starter is spinning but not engaging.
I have had problems with the fuel pump relays but those are all taped up pretty good. I am leaning towards a clogged fuel filter or bad fuel pump. but even with a bad fuel pump or clogged filter wouldn't the engine try to crank even with low fuel pressure? I have a new battery in there. I checked all the fuses in the kick panel. I will check the inertia switch wires as the inertia switch has been disabled.
View 7 Replies
I have a 2003 ford ranger xlt 4.0L and here recently my ac compressor has been making a loud click noise engaging even though i am not using heat or AC, so when it engages the rpms drop and almost wants to stall and it does this in about 10-15 sec. intervals, but when I am driving it acts fine. What is going on here, I recently had a vacuum leak and i found it and fixed it, and now this issue just started.
View 2 Replies
1999 XTL 4.0 auto, was doing fine, replaced Interior light bulb, now wont crank over!!! i suspect the anti theft system... how do i fix or ByPass the security system, i can start the truck by Manually engaging the starter Relay under the hood.
View 1 Replies
I have a 1999 ranger 4x4 , when I'm going to a slow final stop the abs kicks in ,doesn't do it every time , there's no abs warning light , took it to the ford dealer they scanned it and said it was the left front hub & bearing assembly, said the sensor wasn't reading the back of the bearing assembly. I can't understand way the abs light isn't on, is there anyway to clean that they want to replace the hub & bearing, Is a use hub & bearing replacement a good way to go? They told me I could pull the fuse and kill the abs, but I find three fuses I pull aII three and got a speed sensor check engine code. I hate to replace that hub & bearing when there's no problem with the bearing ,Is there any way to deactivate the abs, by the way it's 4 wheel abs.
1999 FORD RANGER 4X4 4.0......
View 14 Replies
My overflow tank seems to be going empty slowly. The last time I filled it was in March and I filled it to the Full line. Now, the overflow is almost empty. I did 425 KM last night almost non-stop and the level stayed the same since that night and today. So, I am not burning any thru the gaskets. Exhaust is not white neither.
I did see one suspect thought. I have this really small rad at the bottom of the bumper and it seems a little wet around the tubes that enter it. Could it be that? I have no spots on the driveway or road when I park. Specs of my truck:
190 000 KM.
Oil changed on Saturday.
Runs well, no loss of power.
Temps are good.
View 3 Replies
Whenever I slow down for a car to turn or accelerate after a stop sign the ice cold air goes away and is replaced by warmer air but then it never turns back cold. Only when I kill the engine and start back up does it return. I just had the Freon refilled and there are no leaks.
View 3 Replies
When I turn my car to the left or right i hear a clicking sound. Usually happens when I am moving slow, like when backing into a driveway or parking spot. Could this be a tie rod, ball joint, or what? How can I be sure before just replacing parts? I need to have this fixed before I get my alignment, which has to happen before I get my rims.
View 2 Replies
I have the same clunk others have suggested may be strut mounts or something. It only happens when I'm turning hard left and going slow. it may happen only when I'm going slow because it's the only time i turn the wheel that much. it's not too loud and sounds like it's coming from the right front wheel well, somewhere around there.
It started about 3 days ago and is getting much more frequent in the last day. It now is happening every time i turn the wheel hard left, and occasionally when I turn right.I have a loose bumper right front also. it's going into the body shop next week to further diagnose by elimination.
QUESTION: is the car safe to drive if there's the possibility of a loose strut mount? i don't know too much about the suspension assembly.
View 1 Replies
i have a 02 ranger 4by4 with 4.0.every time i try to fuel the pu it spits gas back out the fill tube and i have to fill it very slow to get fuel in it.i just replaced the filler neck about 6 mos ago due to having a hole in the the hose by the local ford dealer,
View 6 Replies
I have a 97 ranger 4 cyl that's been making a whistle noise the last few weeks. The sound is literally like a whistle and the noise level varies but its never obnoxious or loud. The sound does not happen when truck is idle, seems to happen mostly when I first accelerate and slow down although sometimes it does happen when I am going 20-30. it doesn't happen all the time but lately its happening more. What this could be? The truck idles and runs great.
View 14 Replies
