Ford Ranger / B-Series :: 2011 - Temperature Sensor Location
Nov 13, 2013
Where the temp sensor for the rear view mirror is located. My truck is a 2011 Ranger with the 4.0 liter, AC, automatic and 4x4. I think it is somewhere by the headlights but not sure.
View 6 Replies
Advertisement
Have no Fan on Rad running. Cant seem to locate the temp sensor to test it? What is the location?
View 1 Replies
Where exactly is the temperature sender/sensor is located?
View 3 Replies
I have a 2011 xlt extended cab with a 2.3l 4 cylinder. The truck is great... I put 120,000 miles on it in under a year.
But about a month ago the temperature gauge started malfunctioning. for what ever reason -- the truck is NOT over heating-- the gauge would increase past the "H" and then the temperature light would come on. Because the truck thinks it's overheating -- the engine goes into a "safe mode" and runs with no power. When i shut the motor off and turn it back on temperature gauge resets and the truck will run fine.
Then in another 50 or 100 miles it will do it again. Why is it doing this? I took it to the dealer here in Columbus, Ohio and the mechanic installed a new thermostat and a new "control modulator" (and a part -- not really sure what it is called) anyway, the truck is doing the same thing and the mechanic still does not know
View 3 Replies
My truck has a bit of an interesting trait. Unless it's just about freezing, my transmission is just about always at operating temperature. If it's 50*F outside and I start the truck, the Trans temp is smack dab in the middle. If it's 30*F outside it starts just a little above cold then is "warmed up" when I drive it down my short street block, which ain't right.
All the rest of the time, it's always reading middle of the bar temperature. My old 5.4L never did this. My 7.3L does. Best I can tell is it's a fault in the temperature sensor for the transmission. I don't have a scan gauge yet to get the readings but will be getting one. Just need to know where the sensor is at so I can have a starting point.
View 3 Replies
Where the Coolant Temperature Sensor is located in the R32? Need to replace it. I searched but luck so far.
View 23 Replies
Where is this located? This is the sensor that reads the outside air temp for inside display. Looked between radiator and bumper cover pretty thoroughly.
View 4 Replies
What is the location of the Coolant Temperature Sensor? I search but I couldn't find a picture or diagram for our car.
View 2 Replies
My 2001 Hyundai Santa Fe V6 is giving out a P0118 code, and the "freeze-frame" data reports a -40F for the coolant temperature. That doesn't make sense so perhaps the sensor is faulty or perhaps the sensor connector is loose?
I'd like to take a look at the coolant temperature sensor but I cannot find it. I have scoured hmaservice, hyunda-forums but all the various pics are still not clear enough for me to actually find the sensor. I have seen all the online pics from Hyundai but I can't get my head around exactly where the sensor is - the pics are either too zoomed in or so many things have been disconnected for the purposes of taking the picture I can't get my bearings.
View 9 Replies
1999 Ranger 4x4 4.0 - P0135 O2 Sensor Heater Circuit (Bank 1 Sensor 1)
I have replaced the 02 Sensor, Passenger Side (Pre-Cat), with a Motorcraft DY831...
I reset the Check Engine fault codes, and took it out for a 50 mile journey... Check Engine light is back on, with the same exact code... What next?
I understand that it may be a fuse, and/or it may be a short in the wiring... Exactly how to test the wiring from the connector at the 02 Sensor all the way back to wherever I need to test?
I really need detailed directions, like wire colors, voltage required, or ohms, or whatever is included in this process...
View 5 Replies
I was just wondering where the interior temperature sensor of the hvac system is located?
View 2 Replies
Wife's car threw a p0711 code. It says temp sensor failure or whatever. I found the part on rockauto for 22 bucks but that's not the issue. I've tried searching about this and I seem to find some stuff about elantras and sonatas. I can't seem to find anything specific to a accent. I've read that it's inside the transmission which is fine I've changed valves before and such on old rwd transmissions. But some things I find say it's on the bottom and some say the side. Also wiring is mentioned pretty often with service bulletins.
View 28 Replies
Looking for an image of pvc valve location....2003 ranger 3.0......
View 2 Replies
OK...When I leave in the morning and the ambient temperature is cool the truck runs fine. When I leave work and the temperature is warm to hot the truck backfires through intake, pings bad, has a miss and a surge and no power. There is no CE light, this is about to drive me nuts. I was just hoping (doubting) but hoping someone else might have had this problem so I don't just have to start replacing things until it's fixed.
View 1 Replies
I have a 2001 ford ranger xlt 2.3L and the temperature gauge has been staying a cold. And my heat doesnt heat well. I'm guessing I need to replace the thermostat. Before I do that could it be anything else?
View 9 Replies
I have a 94 ranger 5 speed xlt v6 4.0l 288k miles original engine. in the last month the oil pressure has gradually gone way up. a manual gauge shows 65psi at cold start ( in the 90* out side) after a minute of idle it dropped to 60psi, at 2k rpms the psi was 85+. also the water temp has gotten hotter to the point of almost being unsafe. it appears that in the hotter part of the day the psi goes higher. the oil and filter was changed 1200 miles ago. the cooling system has been update in the last year with a new radiator new thermostat. no cross contamination in the fluids, engine runs good other than gauges on dash showing water and oil getting close to unsafe range and manual gauge showing high pressure.
View 14 Replies
My ammeter & coolant temperature gauges have quit responding. Any "easy" ways to check these circuits before I disassemble the dash? And, if the gauges DO turn out to be bad, where can I get replacements?
View 4 Replies
Where the cabin air filter is located on my 97 Ranger. I purchased the truck used one year ago and would like to check or change if necessary.
View 2 Replies
3.0 - Where is located ?
View 2 Replies
Apparently, top secret location of the oil pressure switch on the 1997 Ranger 4.0?
View 3 Replies
Where the modulater valve is on my A4LD tranny. I have a 93' ranger XLT extra cab 2wd with 4.0 engine. I have looked all over the tranny and thought it would be somewhere I could see it. I know I had one on my old full size Ford truck with C6.
View 7 Replies