Ford Ranger / B-Series :: 2007 FX4 - Clunking Sound From Front End In 4 Wheel Drive
Dec 6, 2011
There is a clunking sound and feel from the front end of my 2007 Ranger FX4 when in 4 wheel drive. This happens sometimes but not always on engaging or disengaging 4 wheel drive, as well as sporadically while driving along. I took it back to Ford on warranty with this problem last year, and after a few attempts I had them admit that something was wrong and they finally diagnosed that it was the front drive shaft that was binding where it leaves the transfer case, this was replaced. I have now put maybe 50km (max) on in 4 wheel drive and the problem is back, I don't think the problem was ever fixed.
View 14 Replies
Advertisement
I recently replaced the oil seal on the front differential where the front drive shaft connects to the diff. I believe it is called the pinion oil seal. I had to remove the drive shaft to do the job. Got the oil seal in place and then slipped the u-joint yoke on and hand threaded the retainer nut on to get it started. I did mark the relative position of the drive shaft to the front yoke and the rear yoke. I had previously noted that the retaining nut, before I took it off had about 2.5 threads showing. I had to remove it with an impact wrench.
So...I used the impact wrench to put it back on with about the same number of threads showing. I then reinstalled the little short fronmt drive shaft...the one that comes out of the transfer case. I got the front of it on to the pinion output on the front diff...and then had to reattach it to the transfer case end which, by the way an interesting affair with a sort of metal cone that is attached by 6 8mm fine threaded bolts about 2.5 or 3 inches long. Got all that done with much grunting an groaning - I'm laying on the ground - SO the oil, leak is fixed but now ...
There is a vibration at around 40 mph and higher. like something is out of balance. did i damage the front diff pinion bearing by using an impact wrench? this vibration occurs in 2 wheel drive. as i understand it the front drive shaft doesn't even turn when in 2 wheel drive. my question is does the front diff gears spin when in 2 wheel drive? perhaps the u-joint is bad on the front drive shaft? just a bit baffled. when the speed drops to below 40mph the vibration goes away...
View 2 Replies
I bought a 99 ranger few months ago cant the 4x4 has not worked in the truck for about 4 years. Bought it off my dad. He hasn't figured it out the t case locks in the drive shaft spins but hubs will not lock in. Has new hubs in it and still not working. Trying to get it fixed so I can park the diesel for the winter and run the ranger.
View 3 Replies
My 2004 Ford Ranger has 220,000 miles, runs great, and when I bought it this summer the 4 wheel drive worked great. Starting when the weather got cold when I engage the 4 wheel drive (no lockouts electronic engagement). I will drive and it will kick in and out of 4 wheel drive when it starts to slip or I have to accelerate.
When the 4 wheel drive kicks out I will let off the gas then it will engage again on its own, but will slip out again when on ice or I start to slip. When the 4 wheel drive engages it does NOT make any strange sounds, no clunking or nothing, it engages smoothly, and disengages properly.
What it could be? a connection? Any way to fix or diagnose the problem? I have been told that it probably is not the transfer case, because if it were it would not engage or stay in 4 wheel drive at all.
View 11 Replies
first off my truck is 2001 ford ranger 4x4 with an auto. transmission. when I'm driving around in 2wd, everything is fine...
when my 4wd high is on, and I'm starting from a deadstop my truck makes a weird "clunking" noise in the front end. If I'm stuck in mud or snow, and I give gas it keeps "clunking". where the problem comes from?
View 3 Replies
My son has a 99 ranger and the 4 wheel drive quit working. Traced it to the front hubs not getting vacuum. If I jump around the vacuum solenoid(not sure if that's what it's called), the 4 wheel drive works. Looking for a wiring diagram that shows how this is supposed to work electrically?
View 5 Replies
My gf's dad said I could have his 07 Ranger 4.0 2wd with 230K on the clock if I fix the tranny 5R55E. One day he was driving home and all of a sudden had no drive. The tranny will run thru drive, neutral and reverse, but has no drive to it. Engine revs with nothing to show.
Tranny fluid was very dark and pan had nothing but the usual "metal flour" in it. I stopped there, did not pull the filter or anything else.
View 3 Replies
I have a 2001 Escape XLT, when driving thru a parking lot or otherwise at slow speed and hitting bumps, I can hear a clunking sound from the right front tire. Its especially bad if I drive over cobblestone or on a dirt road. Could this be the CV joint? Ball Joint? How can I tell what it is?
View 4 Replies
2007 Ranger 4.0l, idles rough at low rpm, in park or drive, with or without the AC on.
View 1 Replies
The trucks seems to Idle Rough in Park and Drive, Cold or Hot. It mellows out as soon as I give it gas but at stop lights or in park it goes back to a seemingly rough idle.
This is my first Ford Ranger and dont know if its normal. No code or dummy lights.
2007 2WD 4cyl
View 2 Replies
I have a 2007 Ford Ranger 3.0TDCI when I drive on a road that is bumpy or on a ground road the ABS light keeps coming on , sometimes it just flickers other times it keeps on for about 5minutes. I when for a service 3000km back but they told me the brakes is fine. What it can be?
View 1 Replies
I recently bought a 91 Ranger 4wd for my son. The guy I bought it from put new manual lock outs on it. every time I take the tire off on either side the hub comes with it! Is there a clip or retainer missing? If so what and where can I get one?
View 4 Replies
I bought a 2007 Toyota Yaris about 12,000 miles ago in March of this year. Automatic transmission, it now has around 72,500 miles on it. Recently, I have noticed a "clunking" sound/feeling when I shift from park to drive while on an incline. It doesn't matter if I am going from park to reverse, or visa versa. It is more of a feeling... like something is broken and shifting forward or backwards more quickly/violently that it should, but I can hear it slightly. There is no such sound/sensation on level ground.
Temperature/weather is not a factor. Is this a symptom of a bad motor mount/tranny mount? I had a bad motor mount on a previous car, and experienced a rattling noise while idling. There is no such noise or vibration with this car. I do not have a stable mechanic yet and would like an opinion before I try and establish a relationship with one (considering I am a small 25 year old woman who looks 17-18 years old, and I am not normally taken seriously).
View 2 Replies
I've had a rattling/clunking sound from my front left wheel recently so I jacked up that corner. As soon as the tire elevated off the ground the bottom fell inward. I could easily push the top of the tire inward and pull the bottom of the tire outward. Does this lead to a bad hub or bad ball joint(s)?
View 10 Replies
4x4 1999 Ranger ... They are a squeaking and driving me crazy. How hard are they to do, do they need a press or can they be done at home?
View 7 Replies
We have a mystery: there's a clunking sound from our right front wheel when we turn, but our mechanic can't figure out why - he says the axle, struts and ball joint there all look fine. What else could be causing the sound - is he missing something important? This sound happens about 50% of the time on turns. Note that we recently (about 10 days ago) had the ball joint and struts replaced on the LEFT front wheel - could that have done something to the balance of the axle, etc. that is making this sound happen on the right front wheel? This is an old car (a 1996 Mazda Protege with 115,000 miles on it) but it's been well-maintained and is otherwise running well.
View 16 Replies
I'm getting a high toned metal tinging sound (ting ting ting ting) from the front wheel that gets faster as I increase speed.
Shop said it's tire noise, but it's a distinctive metal sound like something rotating is hitting a thin piece of metal. It's quite loud, but I eventually don't hear it over 35mph because the vehicle moving is louder.
Eventually, around 35mph it's almost a constant tinging noise because I'm going fast.
2007 Level II, 5-speed.
View 1 Replies
This must have been asked before but I couldn't find any thread about it. Have a 2006 F350 that makes a rattling sound when engaged in front wheel drive. Sounds a bit like a loose ball from a ball bearing (or a small stone) rolling around. What might be causing this?
View 3 Replies
I have a 1999 ranger 4x4 with a 3.0. automatic, extra cab.
I have noticed that sometimes (this has happened twice so far) on slowing down, (just letting off the gas) it will make a large clunking popping noise like you hit a large pothole and bottomed the truck out (or if you had hit a small animal) However, both times nothing was in the road way and no damage was done to the truck. both times it has been in 2high.
The truck does not swerve, grab or anything funky other than make a loud CLUNK every now and then.
This has happened when you let off the gas at about 25mph and coast along. (it may be when you apply gentle throttle to keep rolling, but I can't remember, I was not driving the truck this time, the first time it happened was several weeks ago and I put it off as a freak happening). I will check the usual suspects, u joints, ect, but I was wondering if there could be something else happening...vperhaps something in the front diff? or transfer case? It kinda felt like it came from the front of the truck.
View 4 Replies
Do a 2004 Saturn view front wheel drive transmission will fit in place of an all wheel drive...
View 1 Replies
I am considering purchasing a 1999 4x4 ford ranger. The original owner has receipts for everything done on it recently. Rebuilt transmission, New ac, New shocks, new tires. I have never owned a ford but I always loved my friend's ranger. The only problem I had with it was an occasional clunking/rattling noise when test driving. I have read and was told this can be a common problem.
View 1 Replies
