Ford Ranger / B-Series :: 2006 - Right Rear Spark Plug Blown
Aug 5, 2014
So, last weekend the GF said she had been hearing a tick in her 2006 4L Ranger. I crawl up under it and see the right rear spark plug and wire vibrating and could tell it was loose. I jack it up, take the right front tire off, pull the liner back, and finally get a socket on the plug to tighten it. I tighten it by hand first the then the finale snug down with the ratchet.
I notice it snugged up but I just felt it was trying to slip so I stopped. Well, it lasted two days and now has fallen out again. It appears the head is stripped. I am going to pull the plug out tonight and see if I can see where the threads are stripped. I assume I will find material on the threads of the plug.
My question is, is there anyway for me to make a temp fix till there is time to pull the head and repair it properly? I saw NAPA used to have a kit for the Triton engine but when I went to their web site I couldn't even find that anymore.
View 8 Replies
Advertisement
I'm getting tired of the same problem about every 6 months. Plug #4 keeps going bad. Its been doing this for years. It starts with rough idle when first starting up that clears up quickly then eventually it leads to a misfire when accelerating. Every time this happens I replace plug #4 and its good to go. Just recently (roughly 6 months ago) did a full tune up and all new injectors. About a week or 2 ago it started its rough idle at start up and just the other day it started misfiring again. What would keep causing this??
View 14 Replies
My 2003 2.3L used to run bad... it had a lot of lag to it when i would try to accelerate. The check engine light was on so i got it checked, and the reading said o2 sensor high voltage or something like that... anyways, i purchased a new sensor (i researched, and found there is only an upstream o2 sensor), replaced it, and the truck ran WAY better, no more lag during acceleration, it was crisp. As i was driving home one day, i was accelerating up a hill, and at about 4000 RPM, the truck almost dies and starts sputtering.
The check engine light started flashing, so i new it was serious, but luckily i was able to make it back to my house. When i got home, i looked under the hood and noticed that #2 & #3 spark plug caps had popped off the spark plugs. What I don't understand is what would have caused that to happen in the first place.... Is it a clogged Catalytic convertor, or is the o2 sensor bad.... Ive read different opinions and technical diagnostic possibilities, but man, i don't want to throw a bunch of money at a truck that I'm really going to have for a few more months. but I need to get it fixed in the mean time.
View 2 Replies
2000 Excursion with the 5.4 in her. Lots of miles. Used only to tow a travel trailer. Blew out the #3 coil packet and spark plug today. Have to pull the head for sure. My question is why? Is there a more severe problem as to why it did this? Or is my old girl just worn out. 270,000 miles.
View 8 Replies
A few weeks back just after buying a new front hub assembly (so I know I have Live Axle 4x4 and 4WABS), a dude on an excavator pulled out in front of me on a blind curve on an interstate exit ramp. Almost got him, then almost got got by the car behind. The hard stop caused a rear line to blow.
When I got home, fluid was still coming out when I pushed the pedal, so the first thing I did was top off the reservoir. I was surprised it was not empty.
I finally got lines that would fit, and replaced both sides. Fast forward a few weeks and I had time to bleed the system. I hooked my vacuum pump to the right-rear wheel cylinder port, opened it and began to pump. Pump, pump, pump, and still no fluid. Tried a few times. Left the pump on, opened the port, (charged the battery), started the truck and pumped the pedal - no fluid. Also, the fluid level did not change in the master.
Master cylinder bleed? Do I need to have the ABS motor bled?
View 10 Replies
I bought a 2000 excursion a month ago and have already had 3 plugs blow out on me. They've been repaired professionally with time sert but the mechanic is starting to wonder if back pressure is building up causing this. He's suggesting to replace the catalytic converter as it's original and has 120,000 miles on it. He's made it clear that he doesn't know if this is the cause but to lose 3 in a month worries him. Is there anything else I can do?
View 14 Replies
My son has a 03 mustang GT. He called and said it was making a loud clicking sound. I investigated and it appeared to have a exhaust leak, but I couldn't feel where it was coming from. I started tearing down until I got to the plugs. One of them blew out if the head. I was shocked. Have you heard of this in a car? I'd heard the Ford trucks had problems with the plugs blowing out. Its fixed and running like a champ now.
View 14 Replies
My son has a 2001 F150 with a 4.6L V8 that's blown a sparkplug from # 3 cylinder. The plug looks as if struck by lightning and has a burn groove as deep as a kitchen match stem the full length of the threads.
How difficult is an engine swap/change using another 4.6L? Neither of us have extensive mechanical backgrounds but plenty of aptitude.
View 4 Replies
Last weekend my number 4 spark plug blew out while on the highway. The truck stayed on long enough for me to get off the highway and pull over before it died. I towed the truck home. Last night I repaired it with a helicoil and replace the spark plug and coil. Now the truck cranks but won't start. I noticed that my theft light flashes fast and doesn't stop after a few seconds or during cranking. I still haven't tested relays or fuses because it was late after the repair. I will be checking those tonight.
I will be reading and taking suggestions and posting my results tonight while I'm working on the truck. I will be checking the fuel pump and PCM relay tonight. I will also try 2 different keys and checking the Inertia switch on the fuel pump to see if that tripped. The truck is a 2001 F-150 Lariat Supercrew with 150k miles on it. 5.4 liter engine.
View 9 Replies
The spark plug in chamber 2 blew off while the vehicle was in motion (approx 35 mph). Purchased replacement plugs and when I went to install, there was nothing for the plug to grab (i.e. appears that all of the threads on the block/casing are gone . Not sure what my options are.
View 2 Replies
My 2003 Toyota Matrix xrs blew spark plug, totaled engine. My husband had trouble with it stalling, the next day I drove it about 60 miles. I did have some trouble with it stalling but on the way home it got worse and was glad to make it back.
Took it in and they said pieces of the spark plug got in on top of the piston and got so hot it cut into the piston and won't hold compression. Hence totaled engine. The shop is willing to take car in payment of work done.
View 8 Replies
I had the oil changed 2/27/11 drove it home parked it for the night next morning I went out to start it I heard loud clunk. I opened the hood and found a spark plug laying on the head seperate from the spark plug wire. What would make this happen? I have not had the sparks plug changed recently.190,000+ miles.
View 10 Replies
my car sounded very bad and upon raising the hood, noticed a spark plug had blown off. When this happened the steering and brakes got hard to use.
View 4 Replies
I have read all I could find on replacing a blown head gasket and and after absorbing everything that TigerDan posted on here, I dove in and began. After disassembling all the topside junk I finally got the intake manifold loose and got down to the head. I began undoing the head bolts and found two broken bolts. The head won't budge so I am calling in a cherrypicker. I don't know what kind of mess I'll find when the head comes off. I assume the head will be warped or the block may be damaged.
View 6 Replies
I've been driving 93 ranger 3.0 4wd since last fall. first week I went to start and fuel pump relay had blown. I put a new one in and been driving since fine, till today. Now when I try to start, if it starts it will run fine all day as long as you don't turn it off. If you turn it off and restart half the times it will pop relay again. My fuel gauge has been stuck on full since I bought it also. I'm wondering if maybe pump has got had to start and drawing too much current...
View 3 Replies
Truck has no spark except when you first turn key on it sparks or right when you let off from cranking it will give one spark. You can be cranking it and nothing and when you let off it kinda acts like it wants to start for a millisecond.
View 11 Replies
1990 ranger 2.9 ... I have put about everything new on this ranger. It has no spark, ran fine til i went across a set of railroad tracks, it died 6 months ago and never started again .. Many dollars and many hrs has gone into this thing and still no spark. It will spark when you turn the key on. Crank it and 3 more sparks and thats it. Every electrical piece has been replaced. I've checked and bought relays ,fuel shut off, new distributor pickup coil, rotor, cap, wires, plugs, coil and still no start?
View 6 Replies
Any way to tell if the ECU is faulty? I hooked my analyzer up to my friends 1988 Ford ranger 2.3L and it wouldn't even detect that the ignition switch was on. He was driving it the other day and is shut off on him while he was making a turn and it wouldn't start back up. We have rebuilt the distributor by replacing the pick-up, rotor button and cap, and we had the ignition module tested and found it was good. We have also replaced the coil. When the ignition is turned to the on position, the fuel pump comes on and never cycles off.
View 8 Replies
I have a no start no spark situation i am having trouble diagnosing
Truck started and then died it has fuel pressure but no spark I know that there is a theft light that is flashing (slowly) when the key is off. Could this bee the problem?
View 14 Replies
I have a 2000 Ranger, V6 4L, and I believe my head gasket is blown, my radiator fluid goes straight to the oil pan. It has probably been leaking for a while, I did not realize it was leaking internally, I had been adding coolant for a few months but thought it was my radiator leaking because it had a crack in the housing, so I had that changed, but then a few weeks after that It gave out. I drained, and flushed the engine twice, and just parked it. My question is, should I just have the head gasket changed, or does it need a new engine because it had been leaking for a while and not sure what kind of damage it has done internally.
View 3 Replies
997 2.3 TruckSo this has been an issue for a long time, actually one of the issues I had when I got the truck 3 years ago. After it rains or is extremely humid, my truck does not want to start. Sometimes it will after cranking and cranking and cranking for a while (stopping to cool the starter of course) and other times it won't start.
This time around, it won't start. I cranked it for a little bit and had my dad check for spark while cranking. No spark at all. What should I start looking at? Coils, crank sensor and wires are all newer. As mentioned before, EEC has been replaced. Could it just be bad luck and I got a crap crank sensor? All fuses and grounds are good.
No codes, either except for the occasional misfire code that I get for some reason after pushing in the clutch to decelerate from a higher RPM. It'll fall and start to misfire, but clear up when taking back off.
View 1 Replies
