Ford Ranger / B-Series :: 2001 - Radio And Wipers Only Work On High?
Aug 18, 2013
Wiper problem is that they only work on high. The symptoms are as follow. The relay is working as the controls are ran thru the intermittent steps. I have tried two control switches and they acted the same. So, I believe the problem is in the motor. There doesn't appear to be any wire problems on the plug so it must be inside the motor. Could this be that grease problem inside the motor and it just needs to be cleaned and re-greased?
Radio, Has power to the plug but doesn't work at all. It doesn't appear to have a head unit fuse that I keep reading about. I have not tried to hook it up direct yet but will try that tonight. I am trying to get this truck ready to sell and need to get these items cleared up.
It is a 2001 XLT Extra Cab 4X4 with a 3.0.
View 14 Replies
Advertisement
Just picked up the truck 1995 Ranger XLT. 3L...5spd...4x4...no power windows or door locks. The key buzzer only buzzes for a few seconds, if you move the ignition it buzzes for a few seconds each time its moved. The wipers only work when the buzzer is dinging. Also..the wipers when turned off stay in the up position. I replaced the ignition key mechanism and the on off wiper relay. What am i missing in this weird scenario??
View 1 Replies
I recently bought a 96 ranger.I noticed the fan did not work but for high. I search the internet and found how to remove it and discovered a mouse nest(village) which basically took over the housing where the evaportor core,blower motor resides. I bought a chilton but cannot remove the housing around the core so I cleaned it the best I could(air compressor and vacuum and disinfectant)...
I had to buy a new blower motor and resistor. However, I cannot find the hose that attached to the blower motor?-mouse had chewed a hole in the one- I've looked and found serveral differents names for it but seems I cannot find it at my local parts store.
My question is- is this intake hose? vent hose? I'm guessing I will have to go to dealer or, if I know the name I can look it up in a salvage yard?
View 14 Replies
This interference correlates directly to tire rotation speed, engine rpm has no effect. Under about 5mph it won't make the noise, but over that you hear a pop more or less for every rotation of the tire and when you hit say 50mph it is just a steady static noise on AM only. Haven't pulled the head unit yet, checked several body grounds under the hood and all are good. Don't know if a damaged wheel sensor could cause an issue or not.
View 4 Replies
I have a Sport trac and its killing me. The windows, radio, wipers and 4x4 does not work. I have checked all of the fuses and even replaced the GEM module and they are still not working.
View 3 Replies
I have a 2000 Ford Windstar Van with 155,000 miles on it. A problem has developed with the electrical system/components. The van will start and run fine. With the engine running, there is no instrumentation, power windows do not work, wind shield wipers do not work, radio does not work, heater blower motor does not work. After the engine has been shut off, the radio will work, windows will work, door locks until such time as you open the door, then all quits. With the key in accessory, the windows work, door locks work, radio works, etc. The neutral module was replaced (the old one, none of the contacts appeared to be burnt). Ford dealer spent an hour trouble shooting - checked body modules (2) - found nothing.
View 4 Replies
I have a 2003 F250 Lariat 6.0L Crew Cab. My wipers, radio and power windows don't work. I have painstakingly checked every one of the fuses to see if there was one or more blown. All were OK.
I removed the fuse panel under the dash and have disassembled it to look for obvious clues, burnt wires/heat damage etc. but everything looks fine. Have pushed all of the fuses in to make sure they were seated properly. No joy.
I recently replaced one of the back windows in my truck and had to detach the rear dome light and I remember one of the wires sparking. Where to start diagnosing this problem?
View 6 Replies
My wipers are just beginning to rust. I'm either taping the truck and masking off the wipers but would rather take them off. I don't understand what is holding them in place. First post on my first Ranger that I just bought.
View 4 Replies
1995 ranger 4,0 4x4... when started up, wipers go 2 times and then stop, but cant turn on again, also blower and 4WD stopped work....
View 4 Replies
I have a 2006 Dodge Caravan that when I drive at highway speeds and it's wet out, my air bad light comes on and about 50% of the time, the radio, fan, windshield wipers, and 12v outlet stop working suggesting the fuse or some other wiring is getting wet. The dealer cannot replicate and will not suggest any fixes. What do I have my local mechanic replace or seal?
I know there's a Chrysler recall on 2005-2006 Caravans, #J38, but my Caravan falls outside the specs by 2 mths (it was for vehicles in service between Jan 2005 and April 2006).
View 11 Replies
I lost the windshield wipers, speedometer, dome light, door alarm. Check all the fuses I can find all are ok. Whats wrong.
View 7 Replies
My father in law has a 2011 Prius -3 - with 135,000 miles on it. He has an interesting issue. The front windshield wipers work on low and medium. When he tries to put them on high, the wipers barely moves. When I drop the stalk back at med or low and it works as if nothing is wrong. I have checked the 30amp fuse and it looks fine. I do not hear any grinding or noise when the wipers are working. I think it could be the motor. However before I go out and purchase the motor, I wanted to make sure there was anything else I could be missing... The dealer wanted 340 for parts and install.. .I know I can do the job myself as I have worked on their other Prius - 2005 with 240,000 miles and counting.
View 10 Replies
Took the stereo out and snipped a white/red wire abd connected them back together and now my interior lights, windows, wipers and trunk button wont work.
View 3 Replies
I have a '97 Ranger 4.0 4x4 5 speed, as the title says... my radio does not work. It has an original cd radio and I had installed an aux cord. After I installed it I could only get a select amount of radio stations, last week I had went out of town so I didn't drive it at all, I came back and there was what seemed to be no power to the radio at all. No display, no sound. Only the lights on the radio controls (pre-sets, volume, seek, etc.) I have checked the fuses, pulled the radio and checked everything from behind and still nothing. Could the radio its self be bad? What else should I check?
View 1 Replies
I had the intake manifold and battery replaced on my 99 Ranger and now when I got it back it worked just fine except the factory radio wouldn't turn on. Headlights​, blinkers, AC, dash lights, etc. All worked just fine but the radio will not turn on. I bought an aftermarket radio to put in it when it got out of the shop but with the factory radio not turning on I don't want to replace it until the issue is resolved.
View 2 Replies
My 1996 Ranger Supercab XLT has the stock radio with 6-cd changer. The unit works fine but only the frequency/clock display lights up. I'm not sure where to start to fix it.
When a problem first occurred, the frequency/clock display flickered/dimmed randomly (and I think the other lights were fine). It was in the shop a few times for a fuel pump problem (the after market pump was actually not compatible and it took a bit to figure that out), and at some point after I got it back I noticed the display was fine but the remainder of lights didn't work.
I don't know if the shop did something or the failure behavior changed. What to look at? I can open the radio and fix that if needed (or replace it).
View 6 Replies
I have a 2011 Ranger. It came with Sirius radio which works with the AUX button on the head unit. This setup is not what I am use to. Anyway I want to replace the OEM unit with an aftermarket. My question is will this AUX connection effect an aftermarket radio connection?
View 11 Replies
1999 ford ranger 2X4 manual trans. My back up lights work sometimes and sometimes not.
View 1 Replies
Any schematic of the vacuum lines for a 99 Ranger with the 2.5 motor? I don't mean the general overview decal under the hood, but rather one that specifically includes the HVAC lines. I have two problems... one being that I have no MAX A/C (recirc does not work) and the other being that the vac line is busted off the heater core isolation valve and I can't find the other end of it (the end that supplies vacuum to open the valve).
View 3 Replies
I have a 96 ford ranger 4cyl 5 spd. I've only had it for a month or so, but I've noticed on cold mornings my odometer won't work. The trip or the total mileage. I can hear the odometer cable clicking. Once the cab gets warmed up it'll start working. It's only happened twice, at about 50 degrees or lower, so I can only imagine what'll happen once winter kicks in. Where to go from here? I was thinking maybe it needs to be re-lubed or something...
View 9 Replies
My oil pressure gauge does not work. I was told that it's most likely the sensor. Where would I find this to change it out?
View 3 Replies